Download or read book Flow Measurement Handbook written by R. C. Baker and published by Cambridge University Press. This book was released on 2000-05-29 with total page 562 pages. Available in PDF, EPUB and Kindle. Book excerpt: Practical, comprehensive advice on the design, operation, and performance of flowmeters.
Download or read book Continuous Measurement of Unsteady Flow written by Georgiĭ Petrovich Katys and published by Pergamon. This book was released on 1964 with total page 236 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Flow Measurement Handbook written by Roger C. Baker and published by Cambridge University Press. This book was released on 2016-08-25 with total page 793 pages. Available in PDF, EPUB and Kindle. Book excerpt: Flow Measurement Handbook is a reference for engineers on flow measurement techniques and instruments. It strikes a balance between laboratory ideas and the realities of field experience and provides practical advice on design, operation and performance of flowmeters. It begins with a review of essentials: accuracy, flow, selection and calibration methods. Each chapter is then devoted to a flowmeter class and includes information on design, application installation, calibration and operation. Among the flowmeters discussed are differential pressure devices such as orifice and Venturi, volumetric flowmeters such as positive displacement, turbine, vortex, electromagnetic, magnetic resonance, ultrasonic, acoustic, multiphase flowmeters and mass meters, such as thermal and Coriolis. There are also chapters on probes, verification and remote data access.
Download or read book Fluid Mechanics of Flow Metering written by Wolfgang Merzkirch and published by Springer Science & Business Media. This book was released on 2005 with total page 280 pages. Available in PDF, EPUB and Kindle. Book excerpt: Flow meters measure the volumetric flow rate in a pipeline. Most meters are based on deriving a signal from the fluid flow and calibrating the signal against the volumetric flow rate. The calibration is done in fully-developed flow, and the same state of flow must exist at the meter’s position when it is in practical use. Because the field of flow metering has been neglected by fluid mechanicists for a long time, this book addresses two major fluid mechanical problems in flow metering: the analysis of signal generation in turbulent pipe flow, which explains the function of the meter beyond a simple calibration, and the possible use of a meter in non-developed flows. These problems are investigated with reference to, and examples from, a variety of meters, e.g. ultrasound cross-correlation meters, vortex meters, and turbine meters. Studying these problems requires consideration of specific phenomena in turbulent non-developed pipe flow, as caused by installations, and finding special solutions with signal processing, both of which are included in the book.
Download or read book Flow Measurement of Fluids written by H. H. Dijstelbergen and published by . This book was released on 1978 with total page 610 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Instrumentation for Fluid Particle Flow written by S.L. Soo and published by Elsevier. This book was released on 1999-10-01 with total page 431 pages. Available in PDF, EPUB and Kindle. Book excerpt: Some of the most original and productive research specialists in the field of particle-fluid flow systems are assembled in this book, which is an important and current reference volume. The book focuses on methods of measurement and options for engineers
Download or read book Pipeline Engineering 2004 written by Henry Liu and published by CRC Press. This book was released on 2017-11-22 with total page 444 pages. Available in PDF, EPUB and Kindle. Book excerpt: Pipeline engineering has struggled to develop as a single field of study due to the wide range of industries and government organizations using different types of pipelines for all types of solids, liquids, and gases. This fragmentation has impeded professional development, job mobility, technology transfer, the diffusion of knowledge, and the movement of manpower. No single, authoritative course or book has existed to unite practitioners. In response, Pipeline Engineering covers the essential aspects and types of pipeline engineering in a single volume. This work is divided into two parts. Part I, Pipe Flows, delivers an integrated treatment of all variants of pipe flow including incompressible and compressible, Newtonian and non-Newtonian, slurry and multiphase flows, capsule flows, and pneumatic transport of solids. Part II, Engineering Considerations, summarizes the equipment and methods required for successful planning, design, construction, operation, and maintenance of pipelines. By addressing the fundamentals of pipeline engineering-concepts, theories, equations, and facts-this groundbreaking text identifies the cornerstones of the discipline, providing engineers with a springboard to success in the field. It is a must-read for all pipeline engineers.
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1995 with total page 704 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fluid Mechanics Measurements written by R. Goldstein and published by Routledge. This book was released on 2017-11-13 with total page 740 pages. Available in PDF, EPUB and Kindle. Book excerpt: This revised edition provides updated fluid mechanics measurement techniques as well as a comprehensive review of flow properties required for research, development, and application. Fluid-mechanics measurements in wind tunnel studies, aeroacoustics, and turbulent mixing layers, the theory of fluid mechanics, the application of the laws of fluid mechanics to measurement techniques, techniques of thermal anemometry, laser velocimetry, volume flow measurement techniques, and fluid mechanics measurement in non-Newtonian fluids, and various other techniques are discussed.
Download or read book Fluid Flow Measurement written by Paul J. LaNasa and published by Butterworth-Heinemann. This book was released on 2014-04-12 with total page 297 pages. Available in PDF, EPUB and Kindle. Book excerpt: There is a tendency to make flow measurement a highly theoretical and technical subject but what most influences quality measurement is the practical application of meters, metering principles, and metering equipment and the use of quality equipment that can continue to function through the years with proper maintenance have the most influence in obtaining quality measurement. This guide provides a review of basic laws and principles, an overview of physical characteristics and behavior of gases and liquids, and a look at the dynamics of flow. The authors examine applications of specific meters, readout and related devices, and proving systems. Practical guidelines for the meter in use, condition of the fluid, details of the entire metering system, installation and operation, and the timing and quality of maintenance are also included. This book is dedicated to condensing and sharing the authors' extensive experience in solving flow measurement problems with design engineers, operating personnel (from top supervisors to the newest testers), academically-based engineers, engineers of the manufacturers of flow meter equipment, worldwide practitioners, theorists, and people just getting into the business. - The authors' many years of experience are brought to bear in a thorough review of fluid flow measurement methods and applications - Avoids theory and focuses on presentation of practical data for the novice and veteran engineer - Useful for a wide range of engineers and technicians (as well as students) in a wide range of industries and applications
Download or read book Hydrodynamic and Mass Transport at Freshwater Aquatic Interfaces written by Paweł Rowiński and published by Springer. This book was released on 2016-01-27 with total page 352 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents selected contributions of the 34th International School of Hydraulics that was held in May 2015 in Zelechów, Poland. It gives an overview about the state of the art in environmental hydraulics. A special emphasis is put upon physical, biochemical and ecological processes that act at interfaces in natural surface water bodies but also other important hydraulic problems are considered. The achievements of well-known researchers from all over the world as well as the results obtained by young researchers, among others within a Marie Curie funded Initial Training Network, led by the University of Padua (HYTECH - HYdrodynamic Transport at Ecologically Critical Heterogeneous Interfaces) are gathered in this volume.
Download or read book Water Resources Research Catalog written by and published by . This book was released on 1966 with total page 1464 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book EBOOK Fluid Mechanics Fundamentals and Applications SI units written by Yunus Cengel and published by McGraw Hill. This book was released on 2013-10-16 with total page 1033 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fluid Mechanics: Fundamentals and Applications is written for the first fluid mechanics course for undergraduate engineering students, with sufficient material for a two-course sequence. This Third Edition in SI Units has the same objectives and goals as previous editions: Communicates directly with tomorrow’s engineers in a simple yet precise manner Covers the basic principles and equations of fluid mechanics in the context of numerous and diverse real-world engineering examples and applications Helps students develop an intuitive understanding of fluid mechanics by emphasizing the physical underpinning of processes and by utilizing numerous informative figures, photographs, and other visual aids to reinforce the basic concepts Encourages creative thinking, interest and enthusiasm for fluid mechanics New to this edition All figures and photographs are enhanced by a full color treatment. New photographs for conveying practical real-life applications of materials have been added throughout the book. New Application Spotlights have been added to the end of selected chapters to introduce industrial applications and exciting research projects being conducted by leaders in the field about material presented in the chapter. New sections on Biofluids have been added to Chapters 8 and 9. Addition of Fundamentals of Engineering (FE) exam-type problems to help students prepare for Professional Engineering exams.
Download or read book Hydraulic Structure Equipment and Water Data Acquisition Systems Volume II written by Jan Malan Jordaan and published by EOLSS Publications. This book was released on 2009-11-25 with total page 358 pages. Available in PDF, EPUB and Kindle. Book excerpt: Hydraulic Structure, Equipment and Water Data Acquisition Systems is a component of Encyclopedia of Water Sciences, Engineering and Technology Resources in the global Encyclopedia of Life Support Systems (EOLSS), which is an integrated compendium of twenty one Encyclopedias. Hydraulic structures occupied a vital role in the development of civilization from the earliest recorded history up to the present, and undoubtedly will do so in the future. Humanity in ancient times settled mostly near perennial rivers, nomadic people frequented oases and springs, and to augment these natural ephemeral supplies, established societies built primitive dams and dug wells. This 4-volume set contains several chapters, each of size 5000-30000 words, with perspectives, applications and extensive illustrations. It carries state-of-the-art knowledge in the fields of Hydraulic Structure, Equipment and Water Data Acquisition Systems. In these volumes the historical origins, modern developments, and future perspectives in the field of water supply engineering are discussed. Various types of hydraulic structures, their associated equipment, and the various systems for collecting data are described. These four volumes are aimed at the following five major target audiences: University and College Students Educators, Professional Practitioners, Research Personnel and Policy Analysts, Managers, and Decision Makers, NGOs and GOs.
Download or read book Proceedings of the Royal Irish Academy written by and published by . This book was released on 1980 with total page 278 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Computational Hydraulics and Hydrology written by Nicolas G. Adrien and published by CRC Press. This book was released on 2003-08-13 with total page 468 pages. Available in PDF, EPUB and Kindle. Book excerpt: Computational hydraulics and hydrologic modeling are rapidly developing fields with a wide range of applications in areas ranging from wastewater disposal and stormwater management to civil and environmental engineering. These fields are full of promise, but the abundance of literature that now exists contains many new terms that are not always defined. Computational Hydraulics and Hydrology: An Illustrated Dictionary defines more that 4,000 basic terms and phrases related to water conveyance with emphasis on computational hydraulics and hydrologic modeling. Compiled by Nicolas G. Adrien, a noted consulting engineer with three decades of experience, this dictionary includes detailed references to actual modeling studies, nearly 100 illustrations, 150 equations and formulas, and many notations. It also includes a chapter of application examples and another containing more than 6,000 related terms with a list of resources where interested readers can find additional definitions. Other dictionaries and glossaries related to these areas tend to be either dated or much narrower in scope. This dictionary offers broad, practice-based coverage of terms culled directly from the latest texts, references, and actual engineering reports. Computational Hydraulics and Hydrology: An Illustrated Dictionary stands alone in providing ready access to the vocabulary of these subjects.
Download or read book Particle Image Velocimetry written by Markus Raffel and published by Springer Science & Business Media. This book was released on 2007-08-09 with total page 460 pages. Available in PDF, EPUB and Kindle. Book excerpt: This immensely practical guide to PIV provides a condensed, yet exhaustive guide to most of the information needed for experiments employing the technique. This second edition has updated chapters on the principles and extra information on microscopic, high-speed and three component measurements as well as a description of advanced evaluation techniques. What’s more, the huge increase in the range of possible applications has been taken into account as the chapter describing these applications of the PIV technique has been expanded.
