Download or read book Telemetry Theory and Methods in Flight Test written by Tingwu Yang and published by Springer Nature. This book was released on 2021-03-25 with total page 475 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book describes systematically telemetry theory and methods for aircraft in flight test. Test targets of telemetry in flight test include airplanes, helicopters, unmanned aerial vehicles, aerostatics, carrier-based aircraft, airborne equipment (systems), weapon systems, (powered) aircraft scale models, aircraft external stores (e.g., nacelle, auxiliary tanks), and ejection seats and so on. The book collects the author's telemetry research work and presents methods that have been verified in real-world tests. The book has eight chapters: the first three discuss the theoretical basis of telemetry, while the other five focus on the methods used in flight tests.Unlike other professional textbooks, this book describes the practical telemetry theory and combines theory and engineering practice to offer a comprehensive and systematic overview of telemetry in flight test for readers.
Download or read book Telemetry Theory and Methods in Flight Test written by and published by . This book was released on 2021 with total page 475 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book describes systematically telemetry theory and methods for aircraft in flight test. Test targets of telemetry in flight test include airplanes, helicopters, unmanned aerial vehicles, aerostatics, carrier-based aircraft, airborne equipment (systems), weapon systems, (powered) aircraft scale models, aircraft external stores (e.g., nacelle, auxiliary tanks), and ejection seats and so on. The book collects the author's telemetry research work and presents methods that have been verified in real-world tests. The book has eight chapters: the first three discuss the theoretical basis of telemetry, while the other five focus on the methods used in flight tests. Unlike other professional textbooks, this book describes the practical telemetry theory and combines theory and engineering practice to offer a comprehensive and systematic overview of telemetry in flight test for readers.
Download or read book Introduction to Flight Testing written by James W. Gregory and published by John Wiley & Sons. This book was released on 2021-05-19 with total page 352 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introduction to Flight Testing Introduction to Flight Testing Provides an introduction to the basic flight testing methods employed on general aviation aircraft and unmanned aerial vehicles Introduction to Flight Testing provides a concise introduction to the basic flight testing methods employed on general aviation aircraft and unmanned aerial vehicles for courses in aeronautical engineering. There is particular emphasis on the use of modern on-board instruments and inexpensive, off-the-shelf portable devices that make flight testing accessible to nearly any student. This text presents a clear articulation of standard methods for measuring aircraft performance characteristics. Topics covered include aircraft and instruments, digital data acquisition techniques, flight test planning, the standard atmosphere, uncertainty analysis, level flight performance, airspeed calibration, stall, climb and glide, take-off and landing, level turn, static and dynamic longitudinal stability, lateral-directional stability, and flight testing of unmanned aircraft systems. Unique to this book is a detailed discussion of digital data acquisition (DAQ) techniques, which are an integral part of modern flight test programs. This treatment includes discussion of the analog-to-digital conversion, sample rate, aliasing, and filtering. These critical details provide the flight test engineer with the insight needed to understand the capabilities and limitations of digital DAQ. Key features: Provides an introduction to the basic flight testing methods and instrumentation employed on general aviation aircraft and unmanned aerial vehicles. Includes examples of flight testing on general aviation aircraft such as Cirrus, Diamond, and Cessna aircraft, along with unmanned aircraft vehicles. Suitable for courses on Aircraft Flight Test Engineering. Introduction to Flight Testing provides resources and guidance for practitioners in the rapidly-developing field of drone performance flight test and the general aviation flight test community.
Download or read book Flight Test System Identification written by Roger Larsson and published by Linköping University Electronic Press. This book was released on 2019-05-15 with total page 326 pages. Available in PDF, EPUB and Kindle. Book excerpt: With the demand for more advanced fighter aircraft, relying on unstable flight mechanical characteristics to gain flight performance, more focus has been put on model-based system engineering to help with the design work. The flight control system design is one important part that relies on this modeling. Therefore, it has become more important to develop flight mechanical models that are highly accurate in the whole flight envelope. For today’s modern fighter aircraft, the basic flight mechanical characteristics change between linear and nonlinear as well as stable and unstable as an effect of the desired capability of advanced maneuvering at subsonic, transonic and supersonic speeds. This thesis combines the subject of system identification, which is the art of building mathematical models of dynamical systems based on measurements, with aeronautical engineering in order to find methods for identifying flight mechanical characteristics. Here, some challenging aeronautical identification problems, estimating model parameters from flight-testing, are treated. Two aspects are considered. The first is online identification during flight-testing with the intent to aid the engineers in the analysis process when looking at the flight mechanical characteristics. This will also ensure that enough information is available in the resulting test data for post-flight analysis. Here, a frequency domain method is used. An existing method has been developed further by including an Instrumental Variable approach to take care of noisy data including atmospheric turbulence and by a sensor-fusion step to handle varying excitation during an experiment. The method treats linear systems that can be both stable and unstable working under feedback control. An experiment has been performed on a radio-controlled demonstrator aircraft. For this, multisine input signals have been designed and the results show that it is possible to perform more time-efficient flight-testing compared with standard input signals. The other aspect is post-flight identification of nonlinear characteristics. Here the properties of a parameterized observer approach, using a prediction-error method, are investigated. This approach is compared with four other methods for some test cases. It is shown that this parameterized observer approach is the most robust one with respect to noise disturbances and initial offsets. Another attractive property is that no user parameters have to be tuned by the engineers in order to get the best performance. All methods in this thesis have been validated on simulated data where the system is known, and have also been tested on real flight test data. Both of the investigated approaches show promising results.
Download or read book On Subscale Flight Testing written by Alejandro Sobron and published by Linköping University Electronic Press. This book was released on 2018-11-05 with total page 112 pages. Available in PDF, EPUB and Kindle. Book excerpt: Downscaled physical models, also referred to as subscale models, have played an essential role in the investigation of the complex physics of flight until the recent disruption of numerical simulation. Despite the fact that improvements in computational methods are slowly pushing experimental techniques towards a secondary role as verification or calibration tools, real-world testing of physical prototypes still provides an unmatched confidence. Physical models are very effective at revealing issues that are sometimes not correctly identified in the virtual domain, and hence can be a valuable complement to other design tools. But traditional wind-tunnel testing cannot always meet all of the requirements of modern aeronautical research and development. It is nowadays too expensive to use these scarce facilities to explore different design iterations during the initial stages of aircraft development, or to experiment with new and immature technologies. Testing of free-flight subscale models, referred to as Subscale Flight Testing (SFT), could offer an affordable and low-risk alternative for complementing conventional techniques with both qualitative and quantitative information. The miniaturisation of mechatronic systems, the advances in rapid-prototyping techniques and power storage, as well as new manufacturing methods, currently enable the development of sophisticated test objects at scales that were impractical some decades ago. Moreover, the recent boom in the commercial drone industry has driven a quick development of specialised electronics and sensors, which offer nowadays surprising capabilities at competitive prices. These recent technological disruptions have significantly altered the cost-benefit function of SFT and it is necessary to re-evaluate its potential in the contemporary aircraft development context. This thesis aims to increase the comprehension and knowledge of the SFT method in order to define a practical framework for its use in aircraft design; focusing on low-cost, short-time solutions that don’t require more than a small organization and few resources. This objective is approached from a theoretical point of view by means of an analysis of the physical and practical limitations of the scaling laws; and from an empirical point of view by means of field experiments aimed at identifying practical needs for equipment, methods, and tools. A low-cost data acquisition system is developed and tested; a novel method for semi-automated flight testing in small airspaces is proposed; a set of tools for analysis and visualisation of flight data is presented; and it is also demonstrated that it is possible to explore and demonstrate new technology using SFT with a very limited amount of economic and human resources. All these, together with a theoretical review and contextualisation, contribute to increasing the comprehension and knowledge of the SFT method in general, and its potential applications in aircraft conceptual design in particular.
Download or read book Flight Test Instrumentation written by International Flight Test Instrumentation Symposium and published by . This book was released on 1964 with total page 312 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Review of Recent Developments in Flight Test Techniques at the Ames Research Center Dryden Flight Research Facility written by and published by . This book was released on 1984 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Introduction to Aircraft Flight Test Engineering written by Hubert C. Smith and published by . This book was released on 1974 with total page 138 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1990 with total page 980 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The High Cost of Duplicating Post Flight Data Centers written by Dr. Stephen R. Vickers and published by Lulu.com. This book was released on 2017-10-24 with total page 166 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book was written based on the doctorate dissertation "Examining the Duplication of Flight Test Data Center (c)" of this author which studied the cost of post-flight data system duplication. Studied was why aerospace companies continue to duplicate PFP data centers, comparison to non-aerospace companies, the cost involved in equipment, and multiple relocations affecting FTEs. The research was performed from 2008 to 2011 and is applicable today.
Download or read book Introduction to Flight Test Engineering written by Donald T. Ward and published by Elsevier Publishing Company. This book was released on 1993 with total page 334 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Flight Test Instrumentation written by Martin Arthur Perry and published by . This book was released on 1967 with total page 468 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aircraft and Rotorcraft System Identification written by Mark Brian Tischler and published by AIAA Education. This book was released on 2012 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Although many books have been written on the theory of system identification, few are available that provide a complete engineering treatment of system identification and how to successfully apply it to flight vehicles. This book presents proven methods, practical guidelines, and real-world flight-test results for a wide range of state-of-the-art flight vehicles, from small uncrewed aerial vehicles (UAVs) to large manned aircraft/rotorcraft.
Download or read book Flight Testing of Aircraft written by and published by . This book was released on 1967 with total page 410 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Automatic Flight Control Systems written by Mohammad Sadraey and published by Springer Nature. This book was released on 2022-05-31 with total page 159 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides readers with a design approach to the automatic flight control systems (AFCS). The AFCS is the primary on-board tool for long flight operations, and is the foundation for the airspace modernization initiatives. In this text, AFCS and autopilot are employed interchangeably. It presents fundamentals of AFCS/autopilot, including primary subsystems, dynamic modeling, AFCS categories/functions/modes, servos/actuators, measurement devices, requirements, functional block diagrams, design techniques, and control laws. The book consists of six chapters. The first two chapters cover the fundamentals of AFCS and closed-loop control systems in manned and unmanned aircraft. The last four chapters present features of Attitude control systems (Hold functions), Flight path control systems (Navigation functions), Stability augmentation systems, and Command augmentation systems, respectively.
Download or read book A Technique for Identifying Pilot Describing Functions from Routine Flight test Records written by Rodney C. Wingrove and published by . This book was released on 1969 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Air University Quarterly Review written by and published by . This book was released on 1956 with total page 568 pages. Available in PDF, EPUB and Kindle. Book excerpt:
