Download or read book Turbulent Premixed Flames written by Nedunchezhian Swaminathan and published by Cambridge University Press. This book was released on 2011-04-25 with total page 447 pages. Available in PDF, EPUB and Kindle. Book excerpt: A work on turbulent premixed combustion is important because of increased concern about the environmental impact of combustion and the search for new combustion concepts and technologies. An improved understanding of lean fuel turbulent premixed flames must play a central role in the fundamental science of these new concepts. Lean premixed flames have the potential to offer ultra-low emission levels, but they are notoriously susceptible to combustion oscillations. Thus, sophisticated control measures are inevitably required. The editors' intent is to set out the modeling aspects in the field of turbulent premixed combustion. Good progress has been made on this topic, and this cohesive volume contains contributions from international experts on various subtopics of the lean premixed flame problem.
Download or read book Turbulent Combustion written by Norbert Peters and published by Cambridge University Press. This book was released on 2000-08-15 with total page 322 pages. Available in PDF, EPUB and Kindle. Book excerpt: The combustion of fossil fuels remains a key technology for the foreseeable future. It is therefore important that we understand the mechanisms of combustion and, in particular, the role of turbulence within this process. Combustion always takes place within a turbulent flow field for two reasons: turbulence increases the mixing process and enhances combustion, but at the same time combustion releases heat which generates flow instability through buoyancy, thus enhancing the transition to turbulence. The four chapters of this book present a thorough introduction to the field of turbulent combustion. After an overview of modeling approaches, the three remaining chapters consider the three distinct cases of premixed, non-premixed, and partially premixed combustion, respectively. This book will be of value to researchers and students of engineering and applied mathematics by demonstrating the current theories of turbulent combustion within a unified presentation of the field.
Download or read book Turbulent Combustion Modeling written by Tarek Echekki and published by Springer Science & Business Media. This book was released on 2010-12-25 with total page 496 pages. Available in PDF, EPUB and Kindle. Book excerpt: Turbulent combustion sits at the interface of two important nonlinear, multiscale phenomena: chemistry and turbulence. Its study is extremely timely in view of the need to develop new combustion technologies in order to address challenges associated with climate change, energy source uncertainty, and air pollution. Despite the fact that modeling of turbulent combustion is a subject that has been researched for a number of years, its complexity implies that key issues are still eluding, and a theoretical description that is accurate enough to make turbulent combustion models rigorous and quantitative for industrial use is still lacking. In this book, prominent experts review most of the available approaches in modeling turbulent combustion, with particular focus on the exploding increase in computational resources that has allowed the simulation of increasingly detailed phenomena. The relevant algorithms are presented, the theoretical methods are explained, and various application examples are given. The book is intended for a relatively broad audience, including seasoned researchers and graduate students in engineering, applied mathematics and computational science, engine designers and computational fluid dynamics (CFD) practitioners, scientists at funding agencies, and anyone wishing to understand the state-of-the-art and the future directions of this scientifically challenging and practically important field.
Download or read book Modeling and Simulation of Turbulent Combustion written by Santanu De and published by Springer. This book was released on 2017-12-12 with total page 663 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents a comprehensive review of state-of-the-art models for turbulent combustion, with special emphasis on the theory, development and applications of combustion models in practical combustion systems. It simplifies the complex multi-scale and nonlinear interaction between chemistry and turbulence to allow a broader audience to understand the modeling and numerical simulations of turbulent combustion, which remains at the forefront of research due to its industrial relevance. Further, the book provides a holistic view by covering a diverse range of basic and advanced topics—from the fundamentals of turbulence–chemistry interactions, role of high-performance computing in combustion simulations, and optimization and reduction techniques for chemical kinetics, to state-of-the-art modeling strategies for turbulent premixed and nonpremixed combustion and their applications in engineering contexts.
Download or read book Combustion Theory written by Forman A. Williams and published by CRC Press. This book was released on 2018-03-05 with total page 549 pages. Available in PDF, EPUB and Kindle. Book excerpt: Combustion Theory delves deeper into the science of combustion than most other texts and gives insight into combustions from a molecular and a continuum point of view. The book presents derivations of the basic equations of combustion theory and contains appendices on the background of subjects of thermodynamics, chemical kinetics, fluid dynamics, and transport processes. Diffusion flames, reactions in flows with negligible transport and the theory of pre-mixed flames are treated, as are detonation phenomena, the combustion of solid propellents, and ignition, extinction, and flamibility pehnomena.
Download or read book Lectures in Mathematical Models of Turbulence written by Brian Edward Launder and published by . This book was released on 1979 with total page 188 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1995 with total page 692 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Theoretical and Numerical Combustion written by Thierry Poinsot and published by R.T. Edwards, Inc.. This book was released on 2005 with total page 544 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introducing numerical techniques for combustion, this textbook describes both laminar and turbulent flames, addresses the problem of flame-wall interaction, and presents a series of theoretical tools used to study the coupling phenomena between combustion and acoustics. The second edition incorporates recent advances in unsteady simulation methods,
Download or read book Oxyfuel Combustion for Clean Energy Applications written by Medhat A. Nemitallah and published by Springer. This book was released on 2019-02-11 with total page 378 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book aims to be the reference book in the area of oxyfuel combustion, covering the fundamentals, design considerations and current challenges in the field. Its first part provides an overview of the greenhouse gas emission problem and the current carbon capture and sequestration technologies. The second part introduces oxy-fuel combustion technologies with emphasis on system efficiency, combustion and emission characteristics, applications and related challenges. The third part focuses on the recent developments in ion transport membranes and their performance in both oxygen separation units and oxygen transport reactors (OTRs). The fourth part presents novel approaches for clean combustion in gas turbines and boilers. Computational modelling and optimization of combustion in gas turbine combustors and boiler furnaces are presented in the fifth part with some numerical results and detailed analyses.
Download or read book Enclosure Fire Dynamics written by Bjorn Karlsson and published by CRC Press. This book was released on 1999-09-28 with total page 338 pages. Available in PDF, EPUB and Kindle. Book excerpt: The increasing complexity of technological solutions to both fire safety design issues and fire safety regulations demand higher levels of training and continuing education for fire protection engineers. Historical precedents on how to deal with fire hazards in new or unusual buildings are seldom available, and new performance-based building codes
Download or read book Numerical Experiments in Homogeneous Turbulence written by Robert Sugden Rogallo and published by . This book was released on 1981 with total page 98 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Coarse Grained Simulation and Turbulent Mixing written by Fenando F. Grinstein and published by Cambridge University Press. This book was released on 2016-06-30 with total page 481 pages. Available in PDF, EPUB and Kindle. Book excerpt: Reviews our current understanding of the subject. For graduate students and researchers in computational fluid dynamics and turbulence.
Download or read book Fluid Dynamics and Transport of Droplets and Sprays written by W. A. Sirignano and published by Cambridge University Press. This book was released on 2010-01-11 with total page 481 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book discusses the theoretical foundations of spray and droplet applications relevant to the technology for active control of sprays applied to new products and applications, improved product performance, cost reductions, and improved environmental outcomes. It also covers theory related to power and propulsion; materials processing and manufacturing technologies including droplet-based net form processing, coating, and painting; medication; pesticides and insecticides; and other consumer uses.
Download or read book Direct and Large Eddy Simulation III written by Peter R. Voke and published by Springer Science & Business Media. This book was released on 2013-03-09 with total page 452 pages. Available in PDF, EPUB and Kindle. Book excerpt: The practical importance of turbulence led the U.K. Royal Academy of Engineering to launch an Initiative on Turbulence, the most important outcome of which was the definition and agreement of the 1999 Newton Institute Research Programme on Turbulence. The main aim of the- month programme, held at the institute in Cambridge, was to bring together the mathematics and engineering communities involved in the turbulence area to address the many problems and to map out future strategy. As a part of the Research Programme, a Symposium on Direct and Large-Eddy Simulation was jointly organised with ERCOFfAC through their Large-Eddy Simulation Interest Group and took place in May 1999. Two previous ERCOFf AC Workshops had already taken place on these closely related varieties of turbulence simulation, at The University of Surrey in 1994 and at Universite Joseph Fourier, Grenoble in 1996. The Symposium at Cambridge was therefore the third in the ERCOFTAC series, enhanced by the presence of leading figures in the field from Europe and the USA who were resident at INI for that period of the Research Programme. Professors M. Germano, A. Leonard, J. Jimenez, R. Kerr and S. Sarkar gave the invited lectures, text versions of which will be found in this volume. As occurred at the previous two ERCOFT AC workshops, there were almost one hundred participants mostly from Europe but including some from Japan and the USA, including on this occasion resident scientists of the INI Research Programme.
Download or read book Unsteady Combustor Physics written by Tim C. Lieuwen and published by Cambridge University Press. This book was released on 2012-08-27 with total page 427 pages. Available in PDF, EPUB and Kindle. Book excerpt: Developing clean, sustainable energy systems is a pre-eminent issue of our time. Most projections indicate that combustion-based energy conversion systems will continue to be the predominant approach for the majority of our energy usage. Unsteady combustor issues present the key challenge associated with the development of clean, high-efficiency combustion systems such as those used for power generation, heating or propulsion applications. This comprehensive study is unique, treating the subject in a systematic manner. Although this book focuses on unsteady combusting flows, it places particular emphasis on the system dynamics that occur at the intersection of the combustion, fluid mechanics and acoustic disciplines. Individuals with a background in fluid mechanics and combustion will find this book to be an incomparable study that synthesises these fields into a coherent understanding of the intrinsically unsteady processes in combustors.
Download or read book Learning from Data written by Vladimir Cherkassky and published by John Wiley & Sons. This book was released on 2007-09-10 with total page 560 pages. Available in PDF, EPUB and Kindle. Book excerpt: An interdisciplinary framework for learning methodologies—covering statistics, neural networks, and fuzzy logic, this book provides a unified treatment of the principles and methods for learning dependencies from data. It establishes a general conceptual framework in which various learning methods from statistics, neural networks, and fuzzy logic can be applied—showing that a few fundamental principles underlie most new methods being proposed today in statistics, engineering, and computer science. Complete with over one hundred illustrations, case studies, and examples making this an invaluable text.
Download or read book Multicomponent Flow Modeling written by Vincent Giovangigli and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 334 pages. Available in PDF, EPUB and Kindle. Book excerpt: The goal of this is book to give a detailed presentation of multicomponent flow models and to investigate the mathematical structure and properties of the resulting system of partial differential equations. These developments are also illustrated by simulating numerically a typical laminar flame. Our aim in the chapters is to treat the general situation of multicomponent flows, taking into account complex chemistry and detailed transport phe nomena. In this book, we have adopted an interdisciplinary approach that en compasses a physical, mathematical, and numerical point of view. In par ticular, the links between molecular models, macroscopic models, mathe matical structure, and mathematical properties are emphasized. We also often mention flame models since combustion is an excellent prototype of multicomponent flow. This book still does not pretend to be a complete survey of existing models and related mathematical results. In particular, many subjects like multi phase-flows , turbulence modeling, specific applications, porous me dia, biological models, or magneto-hydrodynamics are not covered. We rather emphasize the fundamental modeling of multicomponent gaseous flows and the qualitative properties of the resulting systems of partial dif ferential equations. Part of this book was taught at the post-graduate level at the Uni versity of Paris, the University of Versailles, and at Ecole Poly technique in 1998-1999 to students of applied mathematics.
