Download or read book Structure and Stabilization of Hydrogen rich Transverse written by and published by . This book was released on 2014 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt: This paper reports the results of a joint experimental and numerical study of the ow characteristics and flame stabilization of a hydrogen rich jet injected normal to a turbulent, vitiated cross ow of lean methane combustion products. Simultaneous high-speed stereoscopic PIV and OH PLIF measurements were obtained and analyzed alongside three-dimensional direct numerical simulations of inert and reacting JICF with detailed H2/CO chemistry. Both the experiment and the simulation reveal that, contrary to most previous studies of reacting JICF stabilized in low-to-moderate temperature air cross ow, the present conditions lead to an autoigniting, burner-attached flame that initiates uniformly around the burner edge. Significant asymmetry is observed, however, between the reaction zones located on the windward and leeward sides of the jet, due to the substantially different scalar dissipation rates. The windward reaction zone is much thinner in the near field, while also exhibiting significantly higher local and global heat release than the much broader reaction zone found on the leeward side of the jet. The unsteady dynamics of the windward shear layer, which largely control the important jet/cross flow mixing processes in that region, are explored in order to elucidate the important flow stability implications arising in the reacting JICF. Vorticity spectra extracted from the windward shear layer reveal that the reacting jet is globally unstable and features two high frequency peaks, including a fundamental mode whose Strouhal number of ~0.7 agrees well with previous non-reacting JICF stability studies. The paper concludes with an analysis of the ignition, ame stabilization, and global structure of the burner-attached flame. Chemical explosive mode analysis (CEMA) shows that the entire windward shear layer, and a large region on the leeward side of the jet, are highly explosive prior to ignition and are dominated by non-premixed flame structures after ignition. The predominantly mixing limited nature of the flow after ignition is confirmed by computing the Takeno flame index, which shows that ~70% of the heat release occurs in non-premixed regions.
Download or read book Structure and Stabilization of Hydrogen rich Transverse Jets in a Vitiated Turbulent Flow written by and published by . This book was released on 2013 with total page 8 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advanced Turbulent Combustion Physics and Applications written by N. Swaminathan and published by Cambridge University Press. This book was released on 2022-01-06 with total page 485 pages. Available in PDF, EPUB and Kindle. Book excerpt: Explore a thorough overview of the current knowledge, developments and outstanding challenges in turbulent combustion and application.
Download or read book Gaseous Detonations written by M.A. Nettleton and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 266 pages. Available in PDF, EPUB and Kindle. Book excerpt: My introduction to the fascinating phenomena associated with detonation waves came through appointments as an external fellow at the Department of Physics, University College of Wales, and at the Department of Mechanical Engineering, University of Leeds. Very special thanks for his accurate guidance through the large body of information on gaseous detonations are due to Professor D. H. Edwards of University College of Wales. Indeed, the onerous task of concisely enumerating the key features of unidimensional theories of detonations was undertaken by him, and Chapter 2 is based on his initial draft. When the text strays to the use of we, it is a deserved acknow ledgement of his contribution. Again, I should like to thank Professor D. Bradley of Leeds University for his enthusiastic encouragement of my efforts at developing a model of the composition limits of detonability through a relationship between run-up distance and composition of the mixture. The text has been prepared in the context of these fellowships, and I am grateful to the Central Electricity Generating Board for its permission to accept these appointments.
Download or read book Acoustics of Ducts and Mufflers written by M. L. Munjal and published by John Wiley & Sons. This book was released on 2014-02-04 with total page 379 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fully updated second edition of the premier reference book on muffler and lined duct acoustical performance Engine exhaust noise pollutes the street environment and ventilation fan noise enters dwellings along with fresh air. People have become conscious of their working environment. Governments of most countries have responded to popular demand with mandatory restrictions on sound emitted by automotive engines, and a thorough knowledge of acoustics of ducts and mufflers is needed for the design of efficient muffler configurations. This fully updated Second Edition of Acoustics of Ducts and Mufflers deals with propagation, reflection and dissipation/absorption of sound along ducts/pipes/tubes, area discontinuities, perforated elements and absorptive linings that constitute the present-day mufflers and silencers designed to control noise of exhaust and intake systems of automotive engines, diesel-generator sets, compressors and HVAC systems. It includes equations, figures, tables, references, and solved examples and unsolved exercises with answers, so it can be used as a text book as well as a reference book. It also offers a complete presentation and analysis of the major topics in sound suppression and noise control for the analysis and design of acoustical mufflers, air conditioning and ventilation duct work. Both the fundamentals and the latest technology are discussed, with an emphasis on applications. Deals with reactive mufflers, dissipative silencers, the frequency-domain approach, and the time-domain approach. Fully updated second edition of the premier reference book on muffler and lined duct acoustical performance, in one complete volume Presents original new research on topics including baffle silencers and louvers, 3D analytical techniques, and flow-acoustic analysis of multiply-connected perforated-element mufflers Includes a general design procedure to help muffler designers in the automotive industry, exhaust noise being a major component of automobile and traffic noise pollution Written by an expert with four decades’ experience in teaching to graduate students, publishing extensively in reputed international journals, and consulting with industry for noise control as well as designing for quietness
Download or read book Structure and Thermoplasticity of Coal written by Ikuo Komaki and published by Nova Publishers. This book was released on 2005 with total page 214 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is broadly divided into two sections. A number of main themes are discussed in the first section, 'Chemical Structure and Thermoplastic Properties of Coal', covering such topics as the relationships between the chemical structures of coals and thermoplastic phenomena under heating, studies of higher-ordered agglutination structure of coals, kinetic analyses of thermal decomposition reactions, oxidation and dilatation/contraction of coal particles, and formation mechanisms of coke structure. In the second section, 'Simulation of Coal Pyrolysis and Coke Formation', mathematical formulation models are presented to show thermoplastic phenomena of coals, strengths of produced coke, and phenomena observed when heating coal particles in packed beds.
Download or read book Nuclear Science Abstracts written by and published by . This book was released on 1974 with total page 1014 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Turbulent Premixed Flames written by Nedunchezhian Swaminathan and published by Cambridge University Press. This book was released on 2011-04-25 with total page 447 pages. Available in PDF, EPUB and Kindle. Book excerpt: A work on turbulent premixed combustion is important because of increased concern about the environmental impact of combustion and the search for new combustion concepts and technologies. An improved understanding of lean fuel turbulent premixed flames must play a central role in the fundamental science of these new concepts. Lean premixed flames have the potential to offer ultra-low emission levels, but they are notoriously susceptible to combustion oscillations. Thus, sophisticated control measures are inevitably required. The editors' intent is to set out the modeling aspects in the field of turbulent premixed combustion. Good progress has been made on this topic, and this cohesive volume contains contributions from international experts on various subtopics of the lean premixed flame problem.
Download or read book Jet in Supersonic Crossflow written by Mingbo Sun and published by Springer. This book was released on 2019-02-18 with total page 284 pages. Available in PDF, EPUB and Kindle. Book excerpt: Based on research into jets in supersonic crossflow carried out by the authors’ team over the past 15 years, this book summarizes and presents many cutting-edge findings and analyses on this subject. It tackles the complicated mixing process of gas jets and atomization process of liquid jets in supersonic crossflow, and studies their physical mechanisms. Advanced experimental and numerical techniques are applied to further readers’ understanding of atomization, mixing, and combustion of fuel jets in supersonic crossflow, which can promote superior fuel injection design in scramjet engines. The book offers a valuable reference guide for all researchers and engineers working on the design of scramjet engines, and will also benefit graduate students majoring in aeronautical and aerospace engineering.
Download or read book The Nature of the Hydrogen Bond written by Gastone Gilli and published by OUP Oxford. This book was released on 2009-06-25 with total page 330 pages. Available in PDF, EPUB and Kindle. Book excerpt: Hydrogen bond (H-bond) effects are known: it makes sea water liquid, joins cellulose microfibrils in trees, shapes DNA into genes and polypeptide chains into wool, hair, muscles or enzymes. Its true nature is less known and we may still wonder why O-H...O bond energies range from less than 1 to more than 30 kcal/mol without apparent reason. This H-bond puzzle is re-examined here from its very beginning and presented as an inclusive compilation of experimental H-bond energies and geometries. New concepts emerge from this analysis: new classes of systematically strong H-bonds (CAHBs and RAHBs: charge- and resonance-assisted H-bonds); full H-bond classification in six classes (the six chemical leitmotifs); and assessment of the covalent nature of strong H-bonds. This leads to three distinct but inter-consistent models able to rationalize the H-bond and predict its strength, based on classical VB theory, matching of donor-acceptor acid-base parameters (PA or pKa), or shape of the H-bond proton-transfer pathway. Applications survey a number of systems where strong H-bonds play an important functional role, namely drug-receptor binding, enzymatic catalysis, ion-transport through cell membranes, crystal design and molecular mechanisms of functional materials.
Download or read book Data Analysis for Direct Numerical Simulations of Turbulent Combustion written by Heinz Pitsch and published by Springer Nature. This book was released on 2020-05-28 with total page 294 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents methodologies for analysing large data sets produced by the direct numerical simulation (DNS) of turbulence and combustion. It describes the development of models that can be used to analyse large eddy simulations, and highlights both the most common techniques and newly emerging ones. The chapters, written by internationally respected experts, invite readers to consider DNS of turbulence and combustion from a formal, data-driven standpoint, rather than one led by experience and intuition. This perspective allows readers to recognise the shortcomings of existing models, with the ultimate goal of quantifying and reducing model-based uncertainty. In addition, recent advances in machine learning and statistical inferences offer new insights on the interpretation of DNS data. The book will especially benefit graduate-level students and researchers in mechanical and aerospace engineering, e.g. those with an interest in general fluid mechanics, applied mathematics, and the environmental and atmospheric sciences.
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1995 with total page 440 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Concise Encyclopedia of Composite Materials written by Andreas Mortensen and published by Elsevier. This book was released on 2006-12-08 with total page 989 pages. Available in PDF, EPUB and Kindle. Book excerpt: Concise Encyclopedia of Composite Materials draws its material from the award-winning Encyclopedia of Materials: Science and Technology, and includes updates and revisions not available in the original set. This customized collection of articles provides a handy reference for materials scientists and engineers with an interest in composite materials made from polymers, metals, ceramics, carbon, biocomposites, nanocomposites, wood, cement, fibers, etc. Brings together articles from the Encyclopedia of Materials: Science & Technology that focus on the essentials of composite materials, including recent updates Every article has been commissioned and written by an internationally recognized expert and provides a concise overview of a particular aspect of the field Enables rapid reference; extensive bibliographies, cross-referencing and indexes guide the user to the most relevant reading in the primary literature Covers areas of active research, such as biomaterials and porous materials
Download or read book Lyotropic Liquid Crystals written by Ingo Dierking and published by Oxford University Press. This book was released on 2024-07-16 with total page 225 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book aims to review the field of lyotropic liquid crystals from amphiphilic to colloidal systems, bridging the gap between the two worlds of lyotropics and thermotropics by showing that many of the features observed in standard thermotropic liquid crystals may also be observed in lyotropic systems and vice versa. Indeed, for a long time, lyotropic liquid crystals have been overshadowed by their thermotropic counterparts, mainly due to the potential for application of the latter in the display industry. This picture has somewhat shifted over the last decade, with numerous novel lyotropic systems having been discovered and formulated, bringing to light their importance in wider scientific research. For example, the understanding of viruses forming self-assembled ordered phases has largely increased as mineral liquid crystals and clays have experienced a renaissance leading to fundamental research and work on structure formation in nanotechnology. Similarly, nano-rods, nano-wires, nanotubes and 2D materials like graphene oxide and others have been shown to exhibit liquid crystalline behaviour, which may be exploited in self-assembly, drug delivery or biosensors. Cellulose nanocrystals have become an important and popular field of research. The self-assembly of short chain DNA fragments has led to liquid crystal behaviour previously thought to be impossible. Chromonics were shown to exhibit fascinating physical properties, and the combination of active fluids with liquid crystals has opened a whole new field of research to be explored - 'living liquid crystals'.
Download or read book Electronic Structure of Quantum Confined Atoms and Molecules written by K.D. Sen and published by Springer. This book was released on 2014-09-19 with total page 260 pages. Available in PDF, EPUB and Kindle. Book excerpt: The present volume is a collection of review articles highlighting the fundamental advances made in this area by the internationally acclaimed research groups , most of them being pioneers themselves and coming together for the first time.
Download or read book Water in Biological and Chemical Processes written by Biman Bagchi and published by Cambridge University Press. This book was released on 2013-11-14 with total page 383 pages. Available in PDF, EPUB and Kindle. Book excerpt: A unified overview of the dynamical properties of water and its unique and diverse role in biological and chemical processes.
Download or read book Fire Research Abstracts and Reviews written by and published by . This book was released on 1973 with total page 670 pages. Available in PDF, EPUB and Kindle. Book excerpt:
