Download or read book State s Successful Practices Weigh in motion Handbook written by Bill McCall and published by . This book was released on 1997 with total page 150 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book High Speed Weigh in motion System Calibration Practices written by A. T. Papagiannakis and published by Transportation Research Board. This book was released on 2008 with total page 413 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book ICWIM 5 Proceedings of the International Conference on Heavy Vehicles written by Bernard Jacob and published by John Wiley & Sons. This book was released on 2013-03-04 with total page 534 pages. Available in PDF, EPUB and Kindle. Book excerpt: Weigh-in-motion (WIM) is a process of measuring the dynamic tire forces of a moving vehicle and estimating the corresponding tire loads of the static vehicle. This collection of lectures from the International Conference on Weigh-in-Motion details applications such as: collection of statistical traffic data, support of commercial vehicle enforcement, roadway and bridge cost allocation, and traffic management.
Download or read book Equipment for Collecting Traffic Load Data written by Mark E. Hallenbeck and published by Transportation Research Board. This book was released on 2004 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introduction -- Types of equipment -- Technology descriptions -- A process for selecting equipment -- Best practices for equipment use -- Abbreviations used without definitions in TRB publications.
Download or read book ITS Sensors and Architectures for Traffic Management and Connected Vehicles written by Lawrence A. Klein and published by CRC Press. This book was released on 2017-08-07 with total page 574 pages. Available in PDF, EPUB and Kindle. Book excerpt: An intelligent transportation system (ITS) offers considerable opportunities for increasing the safety, efficiency, and predictability of traffic flow and reducing vehicle emissions. Sensors (or detectors) enable the effective gathering of arterial and controlled-access highway information in support of automatic incident detection, active transportation and demand management, traffic-adaptive signal control, and ramp and freeway metering and dispatching of emergency response providers. As traffic flow sensors are integrated with big data sources such as connected and cooperative vehicles, and cell phones and other Bluetooth-enabled devices, more accurate and timely traffic flow information can be obtained. The book examines the roles of traffic management centers that serve cities, counties, and other regions, and the collocation issues that ensue when multiple agencies share the same space. It describes sensor applications and data requirements for several ITS strategies; sensor technologies; sensor installation, initialization, and field-testing procedures; and alternate sources of traffic flow data. The book addresses concerns related to the introduction of automated and connected vehicles, and the benefits that systems engineering and national ITS architectures in the US, Europe, Japan, and elsewhere bring to ITS. Sensor and data fusion benefits to traffic management are described, while the Bayesian and Dempster–Shafer approaches to data fusion are discussed in more detail. ITS Sensors and Architectures for Traffic Management and Connected Vehicles suits the needs of personnel in transportation institutes and highway agencies, and students in undergraduate or graduate transportation engineering courses.
Download or read book Department of Transportation and Related Agencies Appropriations for 2000 written by United States. Congress. House. Committee on Appropriations. Subcommittee on Dept. of Transportation and Related Agencies Appropriations and published by . This book was released on 1999 with total page 1798 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Second European Conference on Weigh in motion of Road Vehicles Lisbon 14th 16th September 1998 written by European Commission and published by Office for Official Publications of the European Communities. This book was released on 1998 with total page 498 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Informatics in Control Automation and Robotics written by Jean-Louis Ferrier and published by Springer. This book was released on 2014-11-04 with total page 425 pages. Available in PDF, EPUB and Kindle. Book excerpt: The present book includes a set of selected papers from the tenth “International Conference on Informatics in Control Automation and Robotics” (ICINCO 2013), held in Reykjavík, Iceland, from 29 to 31 July 2013. The conference was organized in four simultaneous tracks: “Intelligent Control Systems and Optimization”, “Robotics and Automation”, “Signal Processing, Sensors, Systems Modeling and Control” and “Industrial Engineering, Production and Management”. The book is based on the same structure. ICINCO 2013 received 255 paper submissions from 50 countries, in all continents. After a double blind paper review performed by the Program Committee only 30% were published and presented orally. A further refinement was made after the conference, based also on the assessment of presentation quality, so that this book includes the extended and revised versions of the very best papers of ICINCO 2013.
Download or read book Monitoring and Safety Evaluation of Existing Concrete Structures written by fib Fédération internationale du béton and published by fib Fédération internationale du béton. This book was released on 2003 with total page 316 pages. Available in PDF, EPUB and Kindle. Book excerpt: The condition assessment of aged structures is becoming a more and more important issue for civil infrastructure management systems. The continued use of existing systems is, due to environmental, economical and socio-political assets, of great significance and is growing larger every year. Thus the extent of necessary repair of damaged reinforced concrete structures is of major concern in most countries today. Monitoring techniques may have a decisive input to limit expenditures for maintenance and repair of existing structures. Modern test and measurement methods as well as computational mechanics open the door for a wide variety of monitoring applications. The need for quantitative and qualitative knowledge has led to the development and improvement of surveillance techniques, which have already found successful application in other disciplines such as medicine, physics and chemistry. The design of experimental test and measurement systems is inherently an interdisciplinary activity. The specification of the instrumentation to measure the structural response will involve the skills of civil, electrical and computer engineers. The main aim of fib Commission 5, Structural servicer life aspects, is to provide a rational procedure to obtain an optimal technical-economic performance of concrete structures in service and to ensure a feedback of experience gained to design, execution, maintenance and rehabilitation. Against this background fib Task Group 5.1 Monitoring and Safety Evaluation of Existing Concrete Structures had been established to evaluate the existing practice worldwide. The objective of this state-of-art report is to summarize the most important inspection and measuring methods, to describe the working process and to evaluate the applicability to structural monitoring. Particular emphasis is placed upon non-destructive systems, lifetime monitoring, data evaluation and safety aspects.
Download or read book Smart Civil Structures written by You-Lin Xu and published by CRC Press. This book was released on 2017-04-11 with total page 714 pages. Available in PDF, EPUB and Kindle. Book excerpt: A smart civil structure integrates smart materials, sensors, actuators, signal processors, communication networks, power sources, diagonal strategies, control strategies, repair strategies, and life-cycle management strategies. It should function optimally and safely in its environment and maintain structural integrity during strong winds, severe earthquakes, and other extreme events. This book extends from the fundamentals to the state-of-the-art. It covers the elements of smart civil structures, their integration, and their functions. The elements consist of smart materials, sensors, control devices, signal processors, and communication networks. Integration refers to multi-scale modelling and model updating, multi-type sensor placement, control theory, and collective placement of control devices and sensors. And the functions include structural health monitoring, structural vibration control, structural self-repairing, and structural energy harvesting, with emphasis on their synthesis to form truly smart civil structures. It suits civil engineering students, professionals, and researchers with its blend of principles and practice.
Download or read book Department of Transportation and Related Agencies Appropriations for 1999 written by United States. Congress. House. Committee on Appropriations. Subcommittee on Department of Transportation and Related Agencies Appropriations and published by . This book was released on 1998 with total page 2014 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Requirements and Recommendations for Development of a California Weigh in motion Test Facility written by Wei-Bin Zhang and published by . This book was released on 2014 with total page 136 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Marquette Interchange Perpetual Pavement Instrumentation Project written by Nicholas J. Hornyak and published by . This book was released on 2008 with total page 164 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Initial Investigation for Traffic Monitoring Equipment Evaluation Facility written by and published by . This book was released on 2004 with total page 98 pages. Available in PDF, EPUB and Kindle. Book excerpt: This project investigated funding sources, design options, and viable locations for a traffic monitoring equipment evaluation facility. The project provided research and development to design a generic facility to evaluate traffic data collection equipment and sensors and perform traffic data collection research. This report covers the first 9 months of this 2-year project, identifying potential funding sources and candidate sites for further consideration.
Download or read book Department of Transportation and Related Agencies Appropriations for 1998 written by United States. Congress. House. Committee on Appropriations. Subcommittee on Dept. of Transportation and Related Agencies Appropriations and published by . This book was released on 1997 with total page 1660 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advances in Natural Computation written by Licheng Jiao and published by Springer. This book was released on 2006-09-28 with total page 1030 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is volume I of the proceedings of the Second International Conference on Natural Computation, ICNC 2006. After a demanding review process 168 carefully revised full papers and 86 revised short papers were selected from 1915 submissions for presentation in two volumes. This first volume includes 130 papers related to artificial neural networks, natural neural systems and cognitive science, neural network applications, as well as evolutionary computation: theory and algorithms.
Download or read book Synthesis of Pavement Issues Related to High speed Corridors written by Joe W. Button and published by . This book was released on 2004 with total page 180 pages. Available in PDF, EPUB and Kindle. Book excerpt: The objective of this research project was to produce a synthesis of available information to support specific areas related to pavements for the safe, economical development of the Trans Texas Corridor (TTC). This synthesis is divided into nine sections, each of which deals with a specific topic or topics. These specific areas include (1) pavement design for heavy vehicles, (2) pavement design for light vehicles, (3) skid resistance issues on high-speed corridors, (4) issues related to traffic characterization, (5) smart pavements for high-speed corridors, (6) pavement material response to dynamic loads and performance prediction, (7) safety issues related to splash and spray, and (8) ride quality for high-speed corridors. Regarding these stated issues, this synthesis recommends state-of-the-art technology to the Texas Department of Transportation (TxDOT) for use during development of the TTC. It provides recommendations for future research to fill gaps in knowledge and to take emerging technology to the stage where it can be implemented during the design and construction of the TTC pavements. This is the first synthesis study to address issues related to the TTC. A secondary objective of this project was to determine if additional synthesis studies in other areas of transportation related to the TTC should be conducted and, if so, how the process might be improved. This synthesis recommends that future syntheses should be more focused on specific, maybe critical, issue(s); the researcher should be instructed to present only those findings that are really new, innovative, and potentially implementable. One element of the study should pursue non-transportation related technology that might be adapted to transportation issues.
