Download or read book Stabilization of Polymers and Stabilizer Processes written by American Chemical Society and published by . This book was released on 1967 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Stabilization of Polymers and Stabilizer Processes written by and published by . This book was released on 1968 with total page 332 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Stabilization of Polymers and Stabilizer Processes written by Norbert A. J. Platzer and published by . This book was released on 1968 with total page 360 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Stabilization of Polymeric Materials written by Hans Zweifel and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 225 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plastics are used worldwide in everyday life, e.g. as food packaging, electronics, construction, automotive parts, and household appliances. To produce these products with the desired service lifetimes the use of suitable stabilizers is necessary. This book provides a concise and comprehensive overview of the basic mechanisms of plastic degradation processes caused by heat and light. At its core is a detailed description of the stabilization of different polymers, including an explanation of stabilization mechanisms and the influence of commonly used additives such as fillers, flame retardents and pigments on the stability of plastic. Every polymer scientist, material technologist, or application engineer dealing with the design of the properties of plastics will benefit from this new overview.
Download or read book Aging and Stabilization of Polymers written by M. B. Neiman and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 374 pages. Available in PDF, EPUB and Kindle. Book excerpt: The need for a broad development of the production of polymer ma terials has become evident. All these materials are subject to various types of aging (destruction); hence, stabilizers which permit the stor age, reprocessing, and use of polymer materials without any appreci able change in their properties must be introduced into them. In recent years, this problem of stabilizing polymers has attracted the attention of many scientists and technologists, both in the USSR and abroad. The scientific basis of the foreign studies will be found in a number of theo retical premises, but chiefly the theory of chain reactions with un branched chains. In the Soviet Union, the concepts of Academician N. N. Semenov on chain reactions with degenerate branches have become the starting point of theoretical studies of the stabilization and destruction of polymers. Soviet scientists have developed a theory of critical concentrations of antioxidants and have shown that the processes of stabilization have a very complex chemical character. The nature of the polymers them selves greatly affects these processes and consequently, different stabil izers are required for polymers of different structures. In addition, it has been shown that the antioxidants used thus far can not only cause chain termination, but can also initiate oxidation and give rise to de generate branches.
Download or read book Polymer Degradation and Stabilization written by W. L. Hawkins and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 129 pages. Available in PDF, EPUB and Kindle. Book excerpt: The development of polymers as an important class of material was inhibited at the first by the premature failure of these versatile compounds in many applications. The deterioration of important properties of both natural and synthetic polymers is the result of irreversible changes in composition and structure of polymers molecules. As a result of these reactions, mechanical, electrical and/or aesthetic properties are degraded beyond acceptable limits. It is now generally recognized that stabilization against degradation is necessary if the useful life of polymers is to be extended sufficiently to meet design requirements for long-term applications. Polymers degrade by a wide variety of mechanisms, several of which affect all polymers through to varying degree. This monograph will concentrate on those degradation mechanisms which result from reactions of polymers with oxygen in its various forms and which are accelerated by heat and/or radiation. Those stabilization mechanisms are discussed which are based on an understanding of degradation reaction mechanisms that are reasonably well established. The stabilization of polymers is still undergoing a transition from an art to a science as mechanisms of degradation become more fully developed. A scientific approach to stabilization can only be approached when there is an understanding of the reactions that lead to degradation. Stabilization against biodegradation and burning will not be discussed since there is not a clear understanding of how polymers degrade under these conditions.
Download or read book Polymer Degradation and Stabilisation written by Norman Grassie and published by CUP Archive. This book was released on 1988-04-14 with total page 236 pages. Available in PDF, EPUB and Kindle. Book excerpt: The study of polymer degradation and stabilisation is of considerable practical importance as the industrial uses of polymeric materials continue to expand. In this book, the authors lucidly relate technological phenomena to the chemistry and physics of degradation and stabilisation processes. Degradation embraces a variety of technologically important phenomena ranging from relatively low temperature processes such as 'weathering' of plastics, 'fatigue' of rubbers through the processing of polymers in shearing mixers to very high temperature processes such as flammability and ablation. All these technological phenomena have in common certain basic chemical reactions. Thus 'weathering' has its roots in photo-oxidation, 'fatigue' and melt-degradation in mechano-oxidation and flammability, and ablation in ablation in pyrolysis and vapour phase oxidation.
Download or read book PVC Degradation and Stabilization written by George Wypych and published by Elsevier. This book was released on 2015-03-18 with total page 500 pages. Available in PDF, EPUB and Kindle. Book excerpt: PVC stabilization, the most important aspect of formulation and performance of this polymer, is discussed in details. This book contains all information required to design successful stabilization formula for any product made out of PVC. Separate chapters review information on chemical structure, PVC manufacturing technology, morphology, degradation by thermal energy, UV, gamma, other forms of radiation, mechanodegradation, and chemical degradation. The chapter on analytical methods used in studying of degradative and stabilization processes helps in establishing system of checking results of stabilization with different stabilizing systems. Stabilization and stabilizers are discussed in full detail in the most important chapter of this book. The final chapter contains information on the effects of PVC and its additives on health, safety and environment. This book contains analysis of all essential papers and patents published until recently on the above subject. It either locates the answers to relevant questions and offers solutions or gives references in which such answers can be found. PVC Degradation and Stabilization is must to have for chemists, engineers, scientists, university teachers and students, designers, material scientists, environmental chemists, and lawyers who work with polyvinyl chloride and its additives or have any interest in these products. This book is the one authoritative source on the subject. A practical and up-to-date reference guide for engineers and scientists designing with PVC Covers thermal, UV, gamma radiation, chemical, and other forms of degradation Includes a critical discussion of the sustainability issues faced by PVC and its additives, as well as health and safety concerns
Download or read book Photostabilization of Polymers written by J.F. Rabek and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 607 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the last two decades, the production of polymers and plastics has been increasing rapidly. In spite of developing new polymers and polymeric materials, only 40-60 are used commercially on a large scale. It has been estimated that half of the annual production of polymers is employed outdoors. Increasing the stability of polymers and plastics towards heat, light, atmospheric oxygen and other environmental agents and weathering conditions has always been a very important problem. The photochemical instability of most of polymers limits them to outdoor application, where they are photo degraded fast over periods ranging from months to a few years. To the despair of technologists and consumers alike, photodegrada tion and environmental ageing of polymers occur much faster than can be expected from knowledge collected in laboratories. In many cases, improved methods of preparation and purification of both monomers and polymers yield products of better quality and higher resistance to heat and light. However, without stabilization of polymers by applica tion of antioxidants (to decrease thermal oxidative degradation) and photostabilizers (to decrease photo-oxidative degradation) it would be impossible to employ polymers and plastics in everyday use.
Download or read book Plastics Additives written by G. Pritchard and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 650 pages. Available in PDF, EPUB and Kindle. Book excerpt: Although plastics are extremely successful commercially, they would never reach acceptable performance standards either in properties or processing without the incorporation of additives. With the inclusion of additives, plastics can be used in a variety of areas competing directly with other materials, but there are still many challenges to overcome. Some additives are severely restricted by legislation, others interfere with each other-in short their effectiveness varies with circumstances. Plastics Additives explains these issues in an alphabetical format making them easily accessible to readers, enabling them to find specific information on a specific topic. Each additive is the subject of one or more articles, providing a suffinct account of each given topic. An international group of experts in additive and polymer science, from many world class companies and institutes, explain the recent rapid changes in additive technology. They cover novel additives (scorch inhibitors, compatibilizers, surface-modified particulates etc.), the established varieties (antioxidants, biocides, antistatic agents, nucleating agents, fillers, fibres, impact modifiers, plasticizers) and many others, the articles also consider environmental concerns, interactions between additives and legislative change. With a quick reference guide and introductory articles that provide the non-specialist and newcomer with relevant information, this reference book is essential reading for anyone concerned with plastics and additives.
Download or read book Developments in Polymer Stabilisation written by Gerald Scott and published by Elsevier Science & Technology. This book was released on 1981 with total page 283 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Organic Polymer Chemistry written by K. J. Saunders and published by Springer Science & Business Media. This book was released on 2013-03-09 with total page 480 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book deals with the organic chemistry of polymers which find technological use as adhesives, fibres, paints, plastics and rubbers. For the most part, only polymers which are of commercial significance are considered and the primary aim of the book is to relate theoretical aspects to industrial practice. The book is mainly intended for use by students in technical institutions and universities who are specializing in polymer science and by graduates who require an introduction to this field. Several excellent books have recently appeared dealing with the physical chemistry of polymers but the organic chemistry of polymers has not received so much attention. In recognition of this situation and because the two aspects of polymer chemistry are often taught separately, this book deals specifically with organic chemistry and topics of physical chemistry have been omitted. Also, in this way the book has been kept to a reasonable size. This is not to say that integration of the two areas of polymer science is undesirable; on the contrary, it is of the utmost importance that the inter-relationship should b~ appreciated. I wish to record my thanks to my colleagues with whom I have had many helpful discussions, particularly Mrs S. L. Radchenko. I also thank Miss E. Friesen for obtaining many books and articles on my behalf and Mr H. Harms for encouragement and assistance. I am also grateful to Mrs M. Stevens who skilfully prepared the manuscript. Department of Chemical and Metallurgical Technology, Ryerson Polytechnical Institute, K. J. S.
Download or read book Photodegradation and Light Stabilization of Heterochain Polymers written by Niyazi and published by CRC Press. This book was released on 2006-11-14 with total page 195 pages. Available in PDF, EPUB and Kindle. Book excerpt: Photodegradation and light stabilization are very important aspects of polymer aging. Polymer degradation includes different types of processes: thermodegradation, oxidation, acting of ozone, photodegradation, radiation, hydrolysis, mechanical degradation, and biodegradation. It is very important to know the mechanism of polymer degradation in order to select stabilizers against the degradation. This volume presents the analysis of achievements in the field of photodegradation of polymers. It includes, first of all, data of Russian investigators who have decisively contributed in the development of this field of knowledge (the schools headed by academicians V.V. Korshak, N.M. Emanuel, N.S. Enikolopov, A.A. Berlin, and many others).
Download or read book Encyclopedia of Chemical Processing and Design written by John J. McKetta Jr and published by CRC Press. This book was released on 1977-02-01 with total page 520 pages. Available in PDF, EPUB and Kindle. Book excerpt: "Written by engineers for engineers (with over 150 International Editorial Advisory Board members),this highly lauded resource provides up-to-the-minute information on the chemical processes, methods, practices, products, and standards in the chemical, and related, industries. "
Download or read book Encyclopedia of Polymer Science and Technology Concise written by Herman F. Mark and published by John Wiley & Sons. This book was released on 2013-10-16 with total page 1490 pages. Available in PDF, EPUB and Kindle. Book excerpt: The compact, affordable reference, revised and updated The Encyclopedia of Polymer Science and Technology, Concise Third Edition provides the key information from the complete, twelve-volume Mark's Encyclopedia in an affordable, condensed format. Completely revised and updated, this user-friendly desk reference offers quick access to all areas of polymer science, including important advances in nanotechnology, imaging and analytical techniques, controlled polymer architecture, biomimetics, and more, all in one volume. Like the twelve-volume full edition, the Encyclopedia of Polymer Science and Technology, Concise Third Edition provides both SI and common units, carefully selected key references for each article, and hundreds of tables, charts, figures, and graphs.
Download or read book Fundamentals of Polymer Degradation and Stabilization written by N.S. Allen and published by Springer Science & Business Media. This book was released on 1992-10-31 with total page 218 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the past decade, the field of polymer degradation and stabilization has become a subject of central importance in polymer science and technology. This book provides a fundamental source of information designed for those with only a basic understanding of the background of the field.
Download or read book Photochemical Behavior of Multicomponent Polymeric based Materials written by Dan Rosu and published by Springer. This book was released on 2016-11-21 with total page 405 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book offers in-depth insights into the photochemical behavior of multicomponent polymeric-based materials, with a particular emphasis on the photodegradation and photostabilization of these materials. Studying various classes of materials bases such as polysaccharides, wood, synthetic polymers, rubber blends, and nanocomposites, it offers a valuable reference source for graduate and postgraduate students, engineering students, research scholars and polymer engineers working in industry.
