Download or read book Some Studies on the Deformation and Fracture of Normalized Mild Steel Under Cyclic Conditions written by S. Keshavan and published by . This book was released on 1967 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Some Studies on the Deformation and Fracture of Normalised Mild Steel Under Cyclic Conditions written by S. Keshavan and published by . This book was released on 1967 with total page 244 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Communications on the Deformation and Fracture of Mild Steel Under Cyclic Stresses written by and published by . This book was released on 1939 with total page 17 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Cyclic Stress strain Behavior analysis Experimentation and Failure Prediction written by and published by ASTM International. This book was released on 1971 with total page 293 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Deformation and Fracture of Mild Steel Under Cyclic Stresses in Relation to Crystalline Structure written by H. J. Gough and published by . This book was released on 1939 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Canadian Theses written by National Library of Canada and published by . This book was released on 1967 with total page 634 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book M moires written by International Association for Bridge and Structural Engineering and published by . This book was released on 1974 with total page 888 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fatigue and Deformation of Normalized Mild Steel Subjected to Cyclic Biaxial Loading written by D.G. Harvard and published by . This book was released on 1970 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Effects of Temperature and Deformation Rate on Cyclic Strength and Fracture of Low Carbon Steel written by H. Abdel-Raouf and published by . This book was released on 1971 with total page 30 pages. Available in PDF, EPUB and Kindle. Book excerpt: Cyclic deformation behavior and fracture mechanisms of Ferrovac E iron under low cycle fatigue conditions are studied at temperatures ranging from 23 to 540 C, cyclic deformation rates from 4 x 10-4 to 2 x 10-1 s-1, and strain ranges from 0.010 to 0.040. The stress response during strain cycling shows three stages, primary hardening, steady state behavior, and secondary hardening. Both the onset and duration of secondary hardening are dependent on deformation rate and temperature through the process of dynamic strain aging. Stress response sensitivity to deformation rate increases under conditions which permit changes in both internal and effective stress components. There is a variation in the internal stress component at the blue brittleness temperature (370 C) caused by an increase in total dislocation density due to dynamic strain aging. However, at higher temperatures (485 to 540 C) a variation in the internal stress component is caused by accelerated thermal recovery. Steady state cyclic deformation in this temperature range is observed to be consistent with models for steady state creep and hot-working. The fracture mechanism and fatigue life are mainly influenced by the characteristics of stress and strain redistribution and the inhomogeneity of plastic-strains. This inhomogeneity of deformation results from dynamic strain aging effects during fatigue. A parameter which controls stress response, fatigue behavior, and fracture mode under dynamic strain aging conditions is presented.
Download or read book Low Cycle Fatigue written by Harvey D. Solomon and published by ASTM International. This book was released on 1988 with total page 1289 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book ASTM Special Technical Publication written by and published by . This book was released on 1988 with total page 1322 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fatigue Testing and Design written by R. G. Bathgate and published by . This book was released on 1976 with total page 466 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Proceedings of the Society for Experimental Stress Analysis written by Society for Experimental Stress Analysis and published by . This book was released on 1972 with total page 306 pages. Available in PDF, EPUB and Kindle. Book excerpt: Vol. 1, no. 1 contains Proceedings of the 17th (or the last) Eastern Photoelasticity Conference.
Download or read book Nuclear Science Abstracts written by and published by . This book was released on 1976 with total page 1292 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Proceedings Institution of Civil Engineers written by Institution of Civil Engineers (Great Britain) and published by . This book was released on 1978 with total page 1024 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Comprehensive Dissertation Index written by and published by . This book was released on 1984 with total page 760 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Study of Brittle Fracture Initiation in Mild Steel written by F. W. Barton and published by . This book was released on 1962 with total page 226 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this investigation was to study the conditions of brittle-fracture initiation in low-carbon steel. An elastic-plastic stress analysis was developed from which the state of stress along the minimum section of a notched specimen could be determined as a function of the average applied stress and the yield stress. A series of tests on plate-type specimens, with the same notch configuration as that used in the stress analysis, provided experimental values of average fracture stress under various test conditions. Application of the elastic-plastic stress analysis to the experimental results provided a theoretical prediction of the state of stress at the instant location of fracture initation and also an indication of the position of the elastic-plastic boundary at fracture. It was found that the stress condition necessary for brittle fracture initiation, in the mild-steel specimens studied, was achieved when the maximum tensile stress reached a critical value of approximately 246,000 psi. (Author).
