Download or read book Rapid Assessment and Decision Making Strategies for Distortional Fatigue in Multi girder Steel Bridges written by Benjamin Mark Severtson and published by . This book was released on 2003 with total page 176 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Rapid Assessment of Girder Differential Deflection and Distortional Fatigue Stress in Multi girder Steel Bridges written by Huijuan Li and published by . This book was released on 2005 with total page 224 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Rapid Assessment of Distortional Stresses in Multi girder Steel Bridges written by Benjamin Severtson and published by . This book was released on 2004 with total page 119 pages. Available in PDF, EPUB and Kindle. Book excerpt: Multi-girder steel bridges are found as part of the transportation infrastructure of countries throughout the world. These bridges are typically constructed with a steel reinforced concrete deck rigidly attached to the top flange of steel girders. The deck and the transverse steel members distribute loads laterally between bridge girders. The weld connecting transverse stiffeners to the girder web are commonly terminated several inches away from the girder flanges to avoid overlapping with the web-to-flange connection weld, leaving a short, unstiffened portion of the girder web-the web gap. The large flexibility of the web gap region relative to the other components forces it to accommodate the majority of the distortion. Since 1998, several research efforts have investigated methods for predicting the amount of web gap stress a bridge will experience during its service life. Phase I of this research resulted in a simple equation for estimating web gap stress using data collected during field testing and subsequent finite modeling of a skew supported bridge with staggering bent-plate diaphragms. Phase II produced an approximate method for predicting diaphragm differential deflection of skew supported bridges with bent-plate diaphragms. The combined result of Phase I and Phase II was a useful method for predicting peak web gap stress in skewed multi-girder steel bridges with staggered bent-plate diaphragms. The next step was to develop a reliable procedure for the rapid assessment of distortional stresses in steel bridges that includes a test of the applicability of this procedure to bridges with geometries differing from those that formed the basis of the previous research. As a consequence of this most current research, the authors propose changes and recommend modifications of previously developed methods of field measurement and assessment.
Download or read book Analysis of Girder Differential Deflection and Web Gap Stress for Rapid Assessment of Distortional Fatigue in Multi girder Steel Bridges written by Huijuan Li and published by . This book was released on 2005 with total page 113 pages. Available in PDF, EPUB and Kindle. Book excerpt: Distortion-induced fatigue cracking in unstiffened web gaps is common in steel bridges. Previous research by the Minnesota Department of Transportation (Mn/DOT) developed methods to predict the peak web gap stress and maximum differential deflection based upon field data and finite element analyses from two skew supported steel bridges with staggered bent-plate and cross-brace diaphragms, respectively. This project aimed to test the applicability of the proposed methods to a varied spectrum of bridges in the Mn/DOT inventory. An entire bridge model (macro-model) and a model encompassing a portion of the bridge surrounding the diaphragm (micro-model) were calibrated for two instrumented bridges. Dual-level analyses using the macroand micro-models were performed to account for the uncertainties of boundary conditions. Parameter studies were conducted on the prototypical variations of the bridge models to define the sensitivity of diaphragm stress responses to typical diaphragm and bridge details. Based on these studies, the coefficient in the web gap stress formula was calibrated and a linear prediction of the coefficient was proposed for bridges with different span lengths. Additionally, the prediction of differential deflection was calibrated to include the influence of crossbrace diaphragms, truck loading configurations and additional sidewalk railings. A simple approximation was also proposed for the influence of web gap lateral deflection on web gap stress. This research studied the effect of two enzymes as soil stabilizers on two soil types to determine how and under what conditions they function. Researchers evaluated the chemical composition, mode of action, resilient modulus, and shear strength to determine the effects of the enzymes A and B on the soils I and II. The enzymes produced a high concentration of protein and observations suggest the enzymes behave like a surfactant, which effects its stabilization performance. The specimens were subjected to testing of varying lengths of time to determine their performance. Researchers observed an increase in the resilient modulus as the curing time increased but that an increase in application rate, as suggested by manufacturers, did not improve the performance of the enzymes. The study also suggests noticeable differences between the two enzymes and their effects on the soils in terms of resilient modulus and the stiffness of the soil.
Download or read book Distortion induced Fatigue in Multi girder Steel Bridges written by Dmitri Jajich and published by . This book was released on 2000 with total page 296 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report summarizes the findings of a project with the following goals: to implement a field instrumentation and monitoring program for a typical multi-girder steel bridge on skew supports that may be susceptible to web-gap distortion; to assess the frequency and magnitude of the distortional fatigue stresses at the web-stiffener connections; and to evaluate the impact of these stresses on fatigue life. Measurements from 12 independent strain gauges were continuously monitored and recorded for more than three months on Minnesota Department of Transportation (Mn/DOT) bridge #27734. Truck loading tests also were conducted. Predicted web-gap fatigue life based on the long-term monitoring data from Mn/DOT bridge #27734 ranges from 45 to 75 years. Comparison of web-gap stresses with primary design stresses reveals that web-gap distortional stresses are comparatively high. The report also highlights a detailed finite element study to better understand the web-gap stress mechanism and to compare experimental results with theoretical predictions. Study results have important implications for investigators of distortion-induced web-gap fatigue. They indicate that the actual stress at the so-called hotspot may be as much as twice the stress measured at the strain gauge. The report includes a method for estimating girder deflections and web-gap stress.
Download or read book Analysis Tools and Rapid Screening Data for Assessing Distortional Fatigue in Steel Bridge Girders written by Evan Berglund and published by . This book was released on 2001 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Distortion induced Fatigue Cracking in Steel Bridges written by John W. Fisher and published by Transportation Research Board. This book was released on 1990 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Analysis Tools and Rapid Screening Data for Distortional Fatigue in Steel Bridge Girders written by and published by . This book was released on 2001 with total page 84 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Field Testing and Finite Element Analysis of Retrofit Methods for Distortion induced Fatigue in Steel Bridges written by Yared Shifferaw Bayleyegn and published by . This book was released on 2005 with total page 194 pages. Available in PDF, EPUB and Kindle. Book excerpt: Crack formation due to out-of-plane distortion in the web-gap region has been a common occurrence in multi-girder steel bridges. These cracks result from the fatigue stresses that are induced in the web-gap due to cyclic diaphragm forces resulting from differential deflections between girders. The study presented herein investigated the different repair methods that can be used to control formation of these cracks. The study involved field testing and analytical modeling of a skewed multi-girder steel bridge designated as Design No. 1283, which is built on county road D-180 that crosses over I-380 in the state of Iowa. Different repair methods were suggested to reduce the induced stresses and strains in the web-gap under truck loads. These methods included loosening of the bolts connecting the cross-bracing to the stiffener, connecting the stiffener to the girder top flange or adding another stiffener on the opposite side of the girder web. The results indicated that the first two of these repair alternatives were effective in reducing induced stresses and strains in the web-gap region. The impact of web-gap height on the distortion induced in the web-gap was also studied. Furthermore, influence surfaces for different responses such as, web-gap strains, stresses, out-of-plane displacements at critical locations, and forces in the adjacent diaphragm were developed. Moreover, relationships between the relative out-of-plane displacements and vertical stresses induced within the web-gap region were also provided. These developed relationships and surfaces serve as a quick estimate of induced stresses at critical locations in other web-gap regions of the bridge.
Download or read book Analysis of Distortion induced Fatigue Cracking of a Trapezoidal Steel Box Girder Bridge Including Retrofit Investigation written by and published by . This book was released on 2009 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Distortion induced fatigue is a common problem for aging steel bridges. The distortion creates secondary bending stresses at web gap locations that are not accounted for in design, thereby initiating fatigue cracks. A large number of such distortion-induced fatigue cracks have recently been found on Delaware Bridge 1-501 in Newport, Delaware. This multi box steel tub girder bridge has cracking that has initiated in the weld which connects the web to the internal bracing via connection plates. To investigate this problem, global finite element models of two of the bridge's spans were created. In order to calibrate the models for use in analysis, a diagnostic load test was performed using strain transducers to measure strains associated with bending of the girders. Once the models were found to reasonably represent the actual response of the structure, the model was then refined for local modeling of the web gap region. As expected, stresses within the gap were found to be large. Reduction of the stresses within these gap locations is required to increase the remaining life of the bridge. Several retrofit methods were designed to accomplish this stress reduction, based on effective retrofits used to correct similar problems in the past. These retrofit methods include drilling holes at the crack tips, positively attaching the connection plates to flanges, increasing the length of the web gaps, and removing the diagonal elements in the diaphragms. The retrofits were modeled and analyzed under fatigue loading and the resulting stresses were compared to the original structure. Of these methods, the positive attachment was found to be most effective in reducing the web gap stresses; however, all of the approaches provided significant reductions in the stress range. Recommendations for applying this type of retrofit detail along with the drilling of holes at the end of crack tips are provided.
Download or read book Girder Differential Deflection and Assessing Distortional Fatigue in Skewed Steel Bridges written by Evan Matthew Berglund and published by . This book was released on 2002 with total page 184 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Engineering for Structural Stability in Bridge Construction written by Federal Highway Federal Highway Administration and published by . This book was released on 2020-07-19 with total page 669 pages. Available in PDF, EPUB and Kindle. Book excerpt: This manual is intended to serve as a reference. It will provide technical information which will enable Manual users to perform the following activities:Describe typical erection practices for girder bridge superstructures and recognize critical construction stagesDiscuss typical practices for evaluating structural stability of girder bridge superstructures during early stages of erection and throughout bridge constructionExplain the basic concepts of stability and why it is important in bridge erection* Explain common techniques for performing advanced stability analysis along with their advantages and limitationsDescribe how differing construction sequences effect superstructure stabilityBe able to select appropriate loads, load combinations, and load factors for use in analyzing superstructure components during constructionBe able to analyze bridge members at various stages of erection* Develop erection plans that are safe and economical, and know what information is required and should be a part of those plansDescribe the differences between local, member and global (system) stability
Download or read book Bridge Maintenance Safety Management and Life Extension written by Airong Chen and published by CRC PressI Llc. This book was released on 2014 with total page 610 pages. Available in PDF, EPUB and Kindle. Book excerpt: Extensive collection of revised expert papers on recent advances in bridge maintenance, safety, management and extension, representing a major contribution to the knowledge base of all areas of the field. It will serve as a valuable reference to all involved with bridge structure and infrastructure systems, including students, researchers and engineers from all areas of bridge engineering. Set of book comprising keynote papers and extended abstracts plus searchable, full-paper DVD-ROM.
Download or read book Fatigue Evaluation of Steel Bridges written by Mark Douglas Bowman and published by Transportation Research Board. This book was released on 2012 with total page 125 pages. Available in PDF, EPUB and Kindle. Book excerpt: "TRB's National Cooperative Highway Research Program (NCHRP) Report 721: Fatigue Evaluation of Steel Bridges provides proposed revisions to Section 7--Fatigue Evaluation of Steel Bridges of the American Association of State Highway and Transportation Officials Manual for Bridge Evaluation with detailed examples of the application of the proposed revisions."--Publisher's description.
Download or read book Fatigue and Fracture written by F. C. Campbell and published by ASM International. This book was released on 2012-01-01 with total page 699 pages. Available in PDF, EPUB and Kindle. Book excerpt: "This book emphasizes the physical and practical aspects of fatigue and fracture. It covers mechanical properties of materials, differences between ductile and brittle fractures, fracture mechanics, the basics of fatigue, structural joints, high temperature failures, wear, environmentally-induced failures, and steps in the failure analysis process."--publishers website.
Download or read book Life Cycle Civil Engineering Innovation Theory and Practice written by Airong Chen and published by CRC Press. This book was released on 2021-02-26 with total page 1758 pages. Available in PDF, EPUB and Kindle. Book excerpt: Life-Cycle Civil Engineering: Innovation, Theory and Practice contains the lectures and papers presented at IALCCE2020, the Seventh International Symposium on Life-Cycle Civil Engineering, held in Shanghai, China, October 27-30, 2020. It consists of a book of extended abstracts and a multimedia device containing the full papers of 230 contributions, including the Fazlur R. Khan lecture, eight keynote lectures, and 221 technical papers from all over the world. All major aspects of life-cycle engineering are addressed, with special emphasis on life-cycle design, assessment, maintenance and management of structures and infrastructure systems under various deterioration mechanisms due to various environmental hazards. It is expected that the proceedings of IALCCE2020 will serve as a valuable reference to anyone interested in life-cycle of civil infrastructure systems, including students, researchers, engineers and practitioners from all areas of engineering and industry.
Download or read book Steel Bridge Group written by Steel Construction Institute and published by . This book was released on 2006 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
