Download or read book Quantitative 2 D Fuel Vapor Concentration Measurements in an Evaporating Diesel Spray Using the Exciplex Fluorescence Method written by Tongwoo Kim and published by . This book was released on 2001 with total page 216 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Two dimensional Imaging of Fuel Vapor Concentration in a Diesel Spray Via Exciplex based Fluorescence Technique written by Chi-Nan Yeh and published by . This book was released on 1993 with total page 9 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Quantitative Vapor Phase Imaging of In cylinder Diesel Fuel Sprays written by Mark Sean Beckman and published by Ann Arbor, Mich. : University Microfilms International. This book was released on 2004 with total page 252 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book On the Quantitative Application of Exciplex Fluorescence to Engine Sprays written by Philip G. Felton and published by . This book was released on 1993 with total page 9 pages. Available in PDF, EPUB and Kindle. Book excerpt: "The exciplex fluorescence technique has been used to separately visualize liquid and vapor phase fuel in engines since its development by Melton. However, as a fluorescence technique it has the potential to be quantitative and the underlying assumptions have been outlined by Melton. An ititial quantitative application of the TMPD/naphthalene system, based on assumptions, appied to a hollow-cone spray in a two-stroke engine, indicated that it substantially over-estimates the concentration of fuel vapor about TDC. The reasons for the discrepancy were investigated and it was concluded that a major factor is the effect of temperature on the photophysics of the species involved. Thus the absorption spectra of the exciplex dopants were determined at temperatures up to 700 K. These experiments showed that the increase in absorption with temperature above 500 K is responsible for the failure of the earlier calibration. Thus quantitative measurements of vapor fuel concentration at temperature is known. Other factors, such as selective vaporization of the dopants, and the development of other exciplex systems appropriate for use with gasoline are also discussed."--P. 1.
Download or read book Fuel Injection written by Daniela Siano and published by BoD – Books on Demand. This book was released on 2010-08-17 with total page 264 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fuel Injection is a key process characterizing the combustion development within Internal Combustion Engines (ICEs) and in many other industrial applications. State of the art in the research and development of modern fuel injection systems are presented in this book. It consists of 12 chapters focused on both numerical and experimental techniques, allowing its proper design and optimization.
Download or read book Atomization and Sprays written by and published by . This book was released on 2009 with total page 470 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Droplets and Sprays written by Saptarshi Basu and published by Springer. This book was released on 2017-12-11 with total page 433 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book focuses on droplets and sprays relevant to combustion and propulsion applications. The book includes fundamental studies on the heating, evaporation and combustion of individual droplets and basic mechanisms of spray formation. The contents also extend to the latest analytical, numerical and experimental techniques for investigating the behavior of sprays in devices like combustion engines and gas turbines. In addition, the book explores several emerging areas like interactions between sprays and flames and the dynamic characteristics of spray combustion systems on the fundamental side, as well as the development of novel fuel injectors for specific devices on the application side. Given its breadth of coverage, the book will benefit researchers and professionals alike.
Download or read book Diesel Fuel Spray Studies Utilizing a Caterpillar HEUI Injection System in Both Non evaporating and Evaporating Environments written by C. Paul Loeper and published by . This book was released on 2005 with total page 258 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Proceedings of the Spring Technical Conference of the ASME Internal Combustion Engine Division written by American Society of Mechanical Engineers. Internal Combustion Engine Division. Spring Technical Conference and published by . This book was released on 2002 with total page 334 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Turbulent Premixed Flames written by Nedunchezhian Swaminathan and published by Cambridge University Press. This book was released on 2011-04-25 with total page 447 pages. Available in PDF, EPUB and Kindle. Book excerpt: A work on turbulent premixed combustion is important because of increased concern about the environmental impact of combustion and the search for new combustion concepts and technologies. An improved understanding of lean fuel turbulent premixed flames must play a central role in the fundamental science of these new concepts. Lean premixed flames have the potential to offer ultra-low emission levels, but they are notoriously susceptible to combustion oscillations. Thus, sophisticated control measures are inevitably required. The editors' intent is to set out the modeling aspects in the field of turbulent premixed combustion. Good progress has been made on this topic, and this cohesive volume contains contributions from international experts on various subtopics of the lean premixed flame problem.
Download or read book Investigation of Flame front Equivalence Ratio During Stratified Engine Combustion written by David A. Rothamer and published by . This book was released on 2002 with total page 330 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advanced Direct Injection Combustion Engine Technologies and Development written by H Zhao and published by Elsevier. This book was released on 2009-12-18 with total page 761 pages. Available in PDF, EPUB and Kindle. Book excerpt: Volume 2 of the two-volume set Advanced direct injection combustion engine technologies and development investigates diesel DI combustion engines, which despite their commercial success are facing ever more stringent emission legislation worldwide. Direct injection diesel engines are generally more efficient and cleaner than indirect injection engines and as fuel prices continue to rise DI engines are expected to gain in popularity for automotive applications. Two exclusive sections examine light-duty and heavy-duty diesel engines. Fuel injection systems and after treatment systems for DI diesel engines are discussed. The final section addresses exhaust emission control strategies, including combustion diagnostics and modelling, drawing on reputable diesel combustion system research and development. Investigates how HSDI and DI engines can meet ever more stringent emission legislation Examines technologies for both light-duty and heavy-duty diesel engines Discusses exhaust emission control strategies, combustion diagnostics and modelling
Download or read book A Sub grid Droplet Source Model for High Speed Sprays Using Large Eddy Simulation written by Amol Kulkarni and published by . This book was released on 2003 with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advanced Combustion Science written by Tsuneo Someya and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 332 pages. Available in PDF, EPUB and Kindle. Book excerpt: Non-uniform combustion, as encountered in diesel and gas turbine engines, furnaces, and boilers, is responsible for the conversion of fossil fuel to energy and also for the corresponding formation of pollutants. In spite of great research efforts in the past, the mechanism of non-uniform combustion has remained less explored than that of other combustion types, since it consists of many, mostly transient processes which influence each other. In view of this background, a group research project, "Exploration of Combustion Mechanism", was established to explore the mechanism of combustion, especially that of diffusive combustion, and also to find efficient ways to control the combustion process for better utilization of fuel and the reduction of pollutant emission. The group research was started, after preparatory activity of 2 years, in April 1988, for a period of 3 years, as a project with a Grant-in-Aid for Scientific Research of Priority Area subsidized by the Ministry of Education, Science and Culture of Japan. The entire group of 43 members was set up as an organizing committee of 13 members, and five research groups, consisting of 36 members. The research groups were: (1) Steady combustion, (2) Unsteady spray combustion, (3) Control of combustion, (4) Chemistry of combustion, and (5) Effects of fuels. At the beginning of the project it was agreed that we should pursue the mechanism of combustion from a scientific viewpoint, namely, the target of the project was to obtain the fundamentals, or "know why", rather than "know how" of combustion.
Download or read book Technical Literature Abstracts written by Society of Automotive Engineers and published by . This book was released on 1998 with total page 664 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Annual Index abstracts of SAE Technical Papers written by and published by . This book was released on 2001 with total page 912 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Simultaneous Concentration Measurement of Vapor and Liquid in an Evaporating Diesel Spray written by Mamoru Suzuki and published by . This book was released on 1993 with total page 23 pages. Available in PDF, EPUB and Kindle. Book excerpt:
