Download or read book Laser and Ion Beam Modification of Materials written by I. Yamada and published by Elsevier. This book was released on 2013-10-22 with total page 646 pages. Available in PDF, EPUB and Kindle. Book excerpt: Laser and Ion Beam Modification of Materials is a compilation of materials from the proceedings of the symposium U: Material Synthesis and Modification by Ion beams and Laser Beams. This collection discusses the founding of the KANSAI Science City in Japan, and the structures, equipment, and research projects of two institutions are discussed pertaining to eV-MeV ion beams. A description of ion beams as used in materials research and in manufacturing processes, along with trends in ion implantation technology in semiconductors, is discussed. Research into ion beams by China and its industrial uses in non-semiconductor area is noted. For industrial applications, developing technology in terms of high speed, large surface modifications and use of high doses is important. Thus, the development of different ion beam approaches is examined. Industrial applications of ion and laser processing are discussed as cluster beams are used in solid state physics and chemistry. Mention is made on a high power discharge pumped solid state physics (ArF) excimer laser as a potential light source for better material processing. Under ion beam material processing is nanofabrication using focused ion beams, important for research work in mesoscopic systems. Progress in the use of ion-beam mixing using kinetic energy of ion-beams to mingle with pre-deposited surface layers of substrate materials has shown promise. Advanced materials researchers and scientists, as well as academicians in the field of nuclear physics, will find this collection helpful.
Download or read book Ion Beam Modification of Materials written by J.S. Williams and published by Newnes. This book was released on 2012-12-02 with total page 1157 pages. Available in PDF, EPUB and Kindle. Book excerpt: This conference consisted of 15 oral sessions, including three plenary papers covering areas of general interest, 22 specialist invited papers and 51 contributed presentations as well as three poster sessions. There were several scientific highlights covering a diverse spectrum of materials and ion beam processing methods. These included a wide range of conventional and novel applications such as: optical displays and opto-electronics, motor vehicle and tooling parts, coatings tailored for desired properties, studies of fundamental defect properties, the production of novel (often buried) compounds, and treating biomedical materials. The study of nanocrystals produced by ion implantation in a range of host matrices, particularly for opto-electronics applications, was one especially new and exciting development. Despite several decades of study, major progress was reported at the conference in understanding defect evolution in semiconductors and the role of defects in transient impurity diffusion. The use of implantation to tune or isolate optical devices and in forming optically active centres and waveguides in semiconductors, polymers and oxide ceramics was a major focus of several presentations at the conference. The formation of hard coatings by ion assisted deposition or direct implantation was also an area which showed much recent progress. Ion beam techniques had also developed apace, particularly those based on plasma immersion ion implantation or alternative techniques for large area surface treatment. Finally, the use of ion beams for the direct treatment of cancerous tissue was a particularly novel and interesting application of ion beams.
Download or read book Oxides Oxide written by E. Nakamura and published by Springer Science & Business Media. This book was released on 1989-12-12 with total page 494 pages. Available in PDF, EPUB and Kindle. Book excerpt: Volume III/28 is a supplement to volume III/16a+b Ferroelectrics and Related Substances. It also consists of two parts a and b. The present subvolume III/28a contains data on ferroelectric oxides, supplementing III/16a which appeared in 1981. Subvolume III/28b, due in 1990, will cover non-oxides, supplementing III/16b (published in 1982). Reliable data on both pure compounds and solid solutions, published mostly between 1978 and 1986 and some data from the literature up to early 1988 are critically evaluated and included. The dielectric and ferroelectric behaviour, as well as all other properties relevant to the characterization of these substances are presented in tables and figures. About 22,000 references have been surveyed with the aid of a computer. All values are given in SI units. Rapid localization of the required data is facilitated by an alphabetical index of substances and a two-dimensional survey of substances and properties dealt with in both subvolumes III/28a and III/16a.
Download or read book Non oxides Nicht Oxide written by M. Adachi and published by Springer Science & Business Media. This book was released on 1990-12-19 with total page 860 pages. Available in PDF, EPUB and Kindle. Book excerpt: Volume III/28 is a supplement to volume III/16a+b Ferroelectrics and Related Substances. It also consists of two parts a and b. Subvolume III/28a which came out in December 1989, contains data on ferroelectric oxides, supplementing III/16a which appeared in 1981. The present subvolume III/28b covers non-oxides, supplementing III/16b (published in 1982). Reliable data on both pure compounds and solid solutions, published mostly between 1978 and 1986 and some data from the literature up to early 1988 are critically evaluated and included. The dielectric and ferroelectric behaviour, as well as all other properties relevant to the characterization of these substances are presented in tables and figures. About 22,000 references have been surveyed with the aid of a computer. All values are given in SI units. Rapid localization of the required data is facilitated by an alphabetical index of substances and a two-dimensional survey of substances and properties dealt with in both subvolumes III/28b and III/16b.
Download or read book Cyclotrons And Their Applications Proceedings Of The 14th International Conference written by John Christopher Cornell and published by World Scientific. This book was released on 1996-06-12 with total page 894 pages. Available in PDF, EPUB and Kindle. Book excerpt: These conference proceedings will be of interest to all accelerator scientists and engineers, as well as those concerned with the application of cyclotrons in various fields. The conference covers the latest developments in the science, technology and use of cyclotrons, and includes more than 25 invited talks by specialists in their respective fields. Contributions include papers on newly operating cyclotrons and facilities under construction, compact cyclotrons, cooler rings and post-accelerators, ion sources, beam dynamics, beam diagnostics, cyclotron components, systems and technologies, as well as medical applications — including radiotherapy and radioisotope production — non-medical applications, radioactive beam facilities and new projects and proposals.
Download or read book Review written by and published by . This book was released on 1979 with total page 260 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Surface Engineering written by R. Kossowsky and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 766 pages. Available in PDF, EPUB and Kindle. Book excerpt: Over the last few years there has been increasing need for systematic and straregically designed experiments of surface morphology evolution resulting form ion bombardment induced sputtering. Although there is an impressive number of investi gations {1} concerned with semiconductor materials as a result of immediate applications, the most systematic investigations have been conducted with fcc metals with particular interest on single crystal Cu {2,3}. Evidence now exists that within certain para meters (i. e ion species (Ar+), ion energy (20-44 KeV), substrate 2 temperature (80-550° K), dose rate (100-500 gA cm- ) , residual x 5 9 pressure (5 10- to 5x10- mm Hg) and polar and azimuthal angle of ion incidence {4} reproducible surface morphology (etch pits and pyramids) is achieved on the (11 3 1) specific crystallographic orientation. The temporal development of individual surface features was alsoobserved in this laterstudy {4}, by employing an in situ ion source in the scanning electron microscope at Salford, a technique also empolyed in studies of the influence of polar angle of ion incidence {5} and surface contaminants {6} on the topographyof Ar+ bombarded Si. Studies have also been made on the variation of incident ion species with the (11 3 1) Cu surface and it was fully recognized {7} that residual surface contaminants when present could playa major role in dictating the morhological evolution.
Download or read book SiC Natural and Synthetic Diamond and Related Materials written by A.A. Gippius and published by Elsevier. This book was released on 1992-04-24 with total page 392 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume addresses the burgeoning field of wide band gap materials. The 64 contributed and invited papers will do much to stimulate the well-justified ongoing work, both theoretical and experimental, in this area. The high standard of the papers attests to the significant progress that has been made in this field, as well as reporting on the challenging problems that still remain to be solved.
Download or read book NRL Review written by and published by . This book was released on 1980 with total page 260 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Chemical Abstracts Service Source Index written by American Chemical Society. Chemical Abstracts Service and published by . This book was released on 1907 with total page 2064 pages. Available in PDF, EPUB and Kindle. Book excerpt: A key source to journal and conference abbreviations in the sciences. Although it focuses on chemistry, other scientific and engineering disciplines are also well represented. In addition to the abbreviation and full title, each entry also contains publishing info, title changes, language and frequency of publication, and libraries owning that title. Over 130,000 entries representing more than 70,000 publications dating back to 1907 are included.
Download or read book Tribology for Scientists and Engineers written by Pradeep L. Menezes and published by Springer Science & Business Media. This book was released on 2013-12-04 with total page 940 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book describes available tribology technologies and introdces a comprehensive overview of tribology. General, up-to-date knowledge on how tribology is approached in various related areas of research, both experimental and computational is provided.
Download or read book Ion Beam Modification of Solids written by Werner Wesch and published by Springer. This book was released on 2016-07-14 with total page 547 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents the method of ion beam modification of solids in realization, theory and applications in a comprehensive way. It provides a review of the physical basics of ion-solid interaction and on ion-beam induced structural modifications of solids. Ion beams are widely used to modify the physical properties of materials. A complete theory of ion stopping in matter and the calculation of the energy loss due to nuclear and electronic interactions are presented including the effect of ion channeling. To explain structural modifications due to high electronic excitations, different concepts are presented with special emphasis on the thermal spike model. Furthermore, general concepts of damage evolution as a function of ion mass, ion fluence, ion flux and temperature are described in detail and their limits and applicability are discussed. The effect of nuclear and electronic energy loss on structural modifications of solids such as damage formation, phase transitions and amorphization is reviewed for insulators and semiconductors. Finally some selected applications of ion beams are given.
Download or read book Index of Conference Proceedings Received written by British Library. Lending Division and published by . This book was released on 1983 with total page 850 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Ion Implantation And Ion Beam Equipmen Proceedings Of The International Conference written by Karpuzov D S and published by #N/A. This book was released on 1991-07-16 with total page 604 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Energy Research Abstracts written by and published by . This book was released on 1993 with total page 622 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Treatise on Heavy Ion Science written by D.A. Bromley and published by Springer Science & Business Media. This book was released on 2012-11-27 with total page 446 pages. Available in PDF, EPUB and Kindle. Book excerpt: For 75 years the stopping of energetic ions in matter has been a subject of great theoretical and experimental interest. The theoretical treatment of the stopping of ions in matter is largely due to the work of Bohr, 1-3 Bethe,4-6 Bloch,7. s and Lindhard,9-12 and it has been reviewed by Bohr,3 Fano,13 17 20 Jackson,14 Sigmund,15 Ahlen,16 and Ziegler et al. - Soon after the discovery of energetic particle emission from radioactive materials, there was interest in how these corpuscles were slowed down in traversing matter. In 1900, Marie Curie stated 21 the hypothesis that Hies rayons alpha sont des projectiles materiels susceptibles de perdre de leur vitesse en travers ant la matiere." Early attempts to evaluate this were incon clusive for there was not yet an accurate proposed model of the atom. Enough experimental evidence was collected in the next decade to make stopping power theory one of the central concerns of those attempting to develop an atomic model. J.J. Thomson, director of the prestigious Cavendish Laboratory, and Niels Bohr, a fresh postdoctoral scientist at Rutherford's Manchester Laboratory, both published almost simultaneously22. 23 an analysis of the stopping of charged particles by matter, and each contained many of their divergent ideas on the model of an atom. Thomson ignored in his paper the Rutherford alpha-particle scattering 24 experiment of a year before. But the nuclear atom with a heavy positively 25 charged core was the basis of Bohr's ideas.
Download or read book EPAC 90 written by P. Marin and published by Atlantica Séguier Frontières. This book was released on 1990 with total page 1054 pages. Available in PDF, EPUB and Kindle. Book excerpt:
