Download or read book Plugging of Closed and Open ended Pipe Piles in Sands written by Wissam Hadi Shijhait and published by LAP Lambert Academic Publishing. This book was released on 2014-02-28 with total page 128 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plugging of pipe piles is an important phenomenon, which is not adequately accounted for in the current design recommendations of open ended pipe piles. An open-ended pipe pile is said to be plugged when the soil inside the pile moves down with the pile, resulting in the pile becoming effectively closed-ended. Plugging is believed to result in an increase in horizontal stresses between the pile and the surrounding soil, which results in an increase in skin friction. The present study investigates the effect of plug on pile load capacity and effect of plug removal. Different parameters are considered such as pile diameter to length ratio, type of installation in sand of different densities, removal of plug in three stages (50%, 75% and 100%) with respect to length of plug. Kerbala sand, which is used as a foundation soil is poorly graded clean sand. The sand was prepared at different densities using a raining technique. To simulate the pile load test in the field, a new apparatus was manufactured. A driving-pressing system for pile installation was manufactured in this study. The soil plug is removed by a device manufactured to remove the soil column entrapped inside the pipe piles
Download or read book Geotechnics for Sustainable Infrastructure Development written by Phung Duc Long and published by Springer Nature. This book was released on 2019-11-28 with total page 1417 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents 09 keynote and invited lectures and 177 technical papers from the 4th International Conference on Geotechnics for Sustainable Infrastructure Development, held on 28-29 Nov 2019 in Hanoi, Vietnam. The papers come from 35 countries of the five different continents, and are grouped in six conference themes: 1) Deep Foundations; 2) Tunnelling and Underground Spaces; 3) Ground Improvement; 4) Landslide and Erosion; 5) Geotechnical Modelling and Monitoring; and 6) Coastal Foundation Engineering. The keynote lectures are devoted by Prof. Harry Poulos (Australia), Prof. Adam Bezuijen (Belgium), Prof. Delwyn Fredlund (Canada), Prof. Lidija Zdravkovic (UK), Prof. Masaki Kitazume (Japan), and Prof. Mark Randolph (Australia). Four invited lectures are given by Prof. Charles Ng, ISSMGE President, Prof.Eun Chul Shin, ISSMGE Vice-President for Asia, Prof. Norikazu Shimizu (Japan), and Dr.Kenji Mori (Japan).
Download or read book Pile Design and Construction Practice written by Willis H. Thomas and published by CRC Press. This book was released on 2007-12-06 with total page 566 pages. Available in PDF, EPUB and Kindle. Book excerpt: This international handbook is essential for geotechnical engineers and engineering geologists responsible for designing and constructing piled foundations. It explains general principles and practice and details current types of pile, piling equipment and methods. It includes calculations of the resistance of piles to compressive loads, pile group
Download or read book Behavior of Pipe Piles in Sand written by Magued Iskander and published by Springer Science & Business Media. This book was released on 2011-01-17 with total page 273 pages. Available in PDF, EPUB and Kindle. Book excerpt: One of the major difficulties in predicting the capacity of pipe piles in sand has resulted from a lack of understanding of the physical processes that control the behavior of piles during installation and loading. This monograph presents a detailed blue print for developing experimental facilities necessary to identify these processes. These facilities include a unique instrumented double-walled pipe-pile that is used to delineate the frictional stresses acting against the external and internal surfaces of the pile. The pile is fitted with miniature pore-pressure transducers to monitor the generation of pore water pressure during installation and loading. A fast automatic laboratory pile hammer capable of representing the phenomena that occur during pile driving was also developed and used.
Download or read book Basics of Foundation Design written by Bengt Fellenius and published by Lulu.com. This book was released on 2017-03-17 with total page 488 pages. Available in PDF, EPUB and Kindle. Book excerpt: The "Red Book" presents a background to conventional foundation analysis and design. The text is not intended to replace the much more comprehensive 'standard' textbooks, but rather to support and augment these in a few important areas, supplying methods applicable to practical cases handled daily by practising engineers and providing the basic soil mechanics background to those methods. It concentrates on the static design for stationary foundation conditions. Although the topic is far from exhaustively treated, it does intend to present most of the basic material needed for a practising engineer involved in routine geotechnical design, as well as provide the tools for an engineering student to approach and solve common geotechnical design problems.
Download or read book ICP Design Methods for Driven Piles in Sands and Clays written by Richard Jardine and published by Thomas Telford Limited. This book was released on 2005 with total page 120 pages. Available in PDF, EPUB and Kindle. Book excerpt: Broadening the recommendations published by Jardine and Chow in 1996, this volume provides procedures that can be applied by geotechnical engineers, supported by worked examples for sands and clays. It also offers guidance on application to a range of pile types, geotechnical profiles and loading conditions.
Download or read book Soil Foundation Structure Interaction written by Rolando P. Orense and published by CRC Press. This book was released on 2010-07-20 with total page 258 pages. Available in PDF, EPUB and Kindle. Book excerpt: Soil-Foundation-Structure Interaction contains selected papers presented at the International Workshop on Soil-Foundation-Structure Interaction held in Auckland, New Zealand from 26-27 November 2009. The workshop was the venue for an international exchange of ideas, disseminating information about experiments, numerical models and practical en
Download or read book Marine Structural Design Calculations written by Mohamed A. El-Reedy and published by Butterworth-Heinemann. This book was released on 2014-09-30 with total page 457 pages. Available in PDF, EPUB and Kindle. Book excerpt: The perfect guide for veteran structural engineers or for engineers just entering the field of offshore design and construction, Marine Structural Design Calculations offers structural and geotechnical engineers a multitude of worked-out marine structural construction and design calculations. Each calculation is discussed in a concise, easy-to-understand manner that provides an authoritative guide for selecting the right formula and solving even the most difficult design calculation. Calculation methods for all areas of marine structural design and construction are presented and practical solutions are provided. Theories, principles, and practices are summarized. The concentration focuses on formula selection and problem solving. A “quick look up guide , Marine Structural Design Calculations includes both fps and SI units and is divided into categories such as Project Management for Marine Structures; Marine Structures Loads and Strength; Marine Structure Platform Design; and Geotechnical Data and Pile Design. The calculations are based on industry code and standards like American Society of Civil Engineers and American Society of Mechanical Engineers, as well as institutions like the American Petroleum Institute and the US Coast Guard. Case studies and worked examples are included throughout the book. Calculations are based on industry code and standards such as American Society of Civil Engineers and American Society of Mechanical Engineers Complete chapter on modeling using SACS software and PDMS software Includes over 300 marine structural construction and design calculations Worked-out examples and case studies are provided throughout the book Includes a number of checklists, design schematics and data tables
Download or read book Effect of Pile Installation Method on Pipe Pile Behavior in Sands written by K. Paik and published by . This book was released on 2004 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: Open-ended pipe piles are often used for the foundations of both land and offshore structures because of their relatively low driving resistance. In this study, calibration chamber tests were conducted on model pipe piles installed in sands with different soil conditions in order to investigate the effects of the pile installation method on penetration parameters and bearing capacity. Results of the test program showed that both the hammer blow count necessary to install the piles and the incremental filling ratio (IFR), which is used to indicate the degree of soil plugging in open-ended piles, decreased (1) with increasing hammer weight for the same driving energy, and (2) with increasing hammer weight at the same fall height. The base and shaft load capacities of the piles were observed to increase (1) with increasing hammer weight for the same driving energy, and (2) with increasing hammer weight for the same fall height. It was also observed that the noise level observed during pile driving decreases (1) as the driving energy decreases and (2) as the hammer weight increases for the same driving energy. Model jacked piles were also installed and tested. The jacked piles were found to have higher bearing capacities than identical driven piles under similar conditions, mostly due to the more effective development of soil plugging in jacking than in driving.
Download or read book Proceedings of GeoShanghai 2018 International Conference Advances in Soil Dynamics and Foundation Engineering written by TONG Qiu and published by Springer. This book was released on 2018-05-06 with total page 840 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is the sixth volume of the proceedings of the 4th GeoShanghai International Conference that was held on May 27 - 30, 2018. This volume, entitled “Advances in Soil Dynamics and Foundation Engineering”, covers the recent advances and technologies in soil dynamics and foundation engineering. These papers are grouped into four categories: (1) soil dynamics and earthquake engineering, (2) deep excavations and retaining structures, (3) shafts and deep foundations, and (4) offshore geotechnics. It presents the state-of-the-art theories, experiments, methodologies and findings in the related areas. The book may benefit researchers and scientists from the academic fields of soil dynamics and earthquake engineering, geotechnical engineering, geoenvironmental engineering, transportation engineering, geology, mining and energy, as well as practical engineers from the industry. Each of the papers included in this book received at least two positive peer reviews. The editors would like to express their sincerest appreciation to all of the anonymous reviewers all over the world, for their diligent work.
Download or read book Introduction to Permanent Plug and Abandonment of Wells written by Mahmoud Khalifeh and published by Springer Nature. This book was released on 2020-01-27 with total page 285 pages. Available in PDF, EPUB and Kindle. Book excerpt: This open access book offers a timely guide to challenges and current practices to permanently plug and abandon hydrocarbon wells. With a focus on offshore North Sea, it analyzes the process of plug and abandonment of hydrocarbon wells through the establishment of permanent well barriers. It provides the reader with extensive knowledge on the type of barriers, their functioning and verification. It then discusses plug and abandonment methodologies, analyzing different types of permanent plugging materials. Last, it describes some tests for verifying the integrity and functionality of installed permanent barriers. The book offers a comprehensive reference guide to well plugging and abandonment (P&A) and well integrity testing. The book also presents new technologies that have been proposed to be used in plugging and abandoning of wells, which might be game-changing technologies, but they are still in laboratory or testing level. Given its scope, it addresses students and researchers in both academia and industry. It also provides information for engineers who work in petroleum industry and should be familiarized with P&A of hydrocarbon wells to reduce the time of P&A by considering it during well planning and construction.
Download or read book Analysis and Design of Shallow and Deep Foundations written by Lymon C. Reese and published by John Wiley & Sons. This book was released on 2005-11-25 with total page 608 pages. Available in PDF, EPUB and Kindle. Book excerpt: One-of-a-kind coverage on the fundamentals of foundation analysis and design Analysis and Design of Shallow and Deep Foundations is a significant new resource to the engineering principles used in the analysis and design of both shallow and deep, load-bearing foundations for a variety of building and structural types. Its unique presentation focuses on new developments in computer-aided analysis and soil-structure interaction, including foundations as deformable bodies. Written by the world's leading foundation engineers, Analysis and Design of Shallow and Deep Foundations covers everything from soil investigations and loading analysis to major types of foundations and construction methods. It also features: * Coverage on computer-assisted analytical methods, balanced with standard methods such as site visits and the role of engineering geology * Methods for computing the capacity and settlement of both shallow and deep foundations * Field-testing methods and sample case studies, including projects where foundations have failed, supported with analyses of the failure * CD-ROM containing demonstration versions of analytical geotechnical software from Ensoft, Inc. tailored for use by students in the classroom
Download or read book Engineering Properties of Soils and Their Measurement written by Joseph E. Bowles and published by McGraw-Hill Companies. This book was released on 1978 with total page 446 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book 100 Years of Prandtl s Wedge written by S. Van Baars and published by IOS Press. This book was released on 2018-04-17 with total page 144 pages. Available in PDF, EPUB and Kindle. Book excerpt: The biggest problem for a shallow foundation, just as for any other type of foundation, is a failure due to an overestimation of the bearing capacity. This means that the correct prediction of the bearing capacity of the foundation is often the most important part of the design of a civil structure. That is why the publication by Prandtl in 1920 about the hardness of a plastic body, was a major step in solving the bearing capacity of shallow foundations, although it is well possible that he never realised this, because his solution was not made for civil engineering purposes, but for mechanical purposes. Over the last 100 years, a lot of extensions have been made, for example with inclination factors and shape factors. Also many laboratory experiments have been done and numerical calculations have been made. Some even try to extrapolate the failure mechanism for shallow foundations to the failure mechanism around the tip of a pile. All this scientific work leads back to the first publication by Ludwig Prandtl in 1920. This book, “100 Years of Prandtl’s Wedge”, is intended for all those who are interested in these fundamentals of foundation engineering and their history. The Appendices include a copy of Prandtl’s Über die Härte plastischer Körper and of Reissner’s publication of 1924, Zum Erddruckproblem.
Download or read book Theory and Practice of Pile Foundations written by Wei Dong Guo and published by CRC Press. This book was released on 2012-11-14 with total page 576 pages. Available in PDF, EPUB and Kindle. Book excerpt: Pile Foundations are an essential basis for many structures. It is vital that they be designed with the utmost reliability, because the cost of failure is potentially huge. Covering a whole range of design issues relating to pile design, this book presents economical and efficient design solutions and demonstrates them using real world examples. Co
Download or read book Concrete Pressure Pipe 3rd Ed written by American Water Works Association and published by American Water Works Association. This book was released on 2008 with total page 286 pages. Available in PDF, EPUB and Kindle. Book excerpt: This comprehensive manual of water supply practices explains the design, selection, specification, installation, transportation, and pressure testing of concrete pressure pipes in potable water service.
Download or read book Design of Pile Foundations written by Aleksandar Sedmak Vesić and published by Transportation Research Board. This book was released on 1977-01-01 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt:
