Download or read book Pilot Scale Testing of Monosodium Titanate Mixing for the SRS Small Column Ion Exchange Process 11224 written by and published by . This book was released on 2011 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The Small Column Ion Exchange (SCIX) process is being developed to remove cesium, strontium, and select actinides from Savannah River Site (SRS) Liquid Waste using an existing waste tank (i.e., Tank 41H) to house the process. Savannah River National Laboratory (SRNL) is conducting pilot-scale mixing tests to determine the pump requirements for suspending monosodium titanate (MST), crystalline silicotitanate (CST), and simulated sludge. The purpose of this pilot scale testing is to determine the requirements for the pumps to suspend the MST particles so that they can contact the strontium and actinides in the liquid and be removed from the tank. The pilot-scale tank is a 1/10.85 linear scaled model of SRS Tank 41H. The tank diameter, tank liquid level, pump nozzle diameter, pump elevation, and cooling coil diameter are all 1/10.85 of their dimensions in Tank 41H. The pump locations correspond to the proposed locations in Tank 41H by the SCIX program (Risers B5 and B2 for two pump configurations and Risers B5, B3, and B1 for three pump configurations). The conclusions from this work follow: (i) Neither two standard slurry pumps nor two quad volute slurry pumps will provide sufficient power to initially suspend MST in an SRS waste tank. (ii) Two Submersible Mixer Pumps (SMPs) will provide sufficient power to initially suspend MST in an SRS waste tank. However, the testing shows the required pump discharge velocity is close to the maximum discharge velocity of the pump (within 12%). (iii) Three SMPs will provide sufficient power to initially suspend MST in an SRS waste tank. The testing shows the required pump discharge velocity is 66% of the maximum discharge velocity of the pump. (iv) Three SMPs are needed to resuspend MST that has settled in a waste tank at nominal 45 C for four weeks. The testing shows the required pump discharge velocity is 77% of the maximum discharge velocity of the pump. Two SMPs are not sufficient to resuspend MST that settled under these conditions.
Download or read book Engineering Monosodium Titanate for Adsorption Column Processes written by CHARLES. NASH and published by . This book was released on 2004 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: Monosodium titanate (MST) is an inorganic adsorbent powder that effectively removes strontium, plutonium, neptunium, and other trace elements from alkaline high-level waste (HLW) supernate. This work tested one commercial titanate and four general methods to engineer MST into particles large enough to use in adsorption columns. The most successful of the engineered products selected from batch contact and chemical stability testing succeeded in treating 2900 bed volumes (BV) of simulated salt waste containing dissolved plutonium and strontium. There was no detectable strontium breakthrough and only 6 per cent plutonium breakthrough--well within the processing goal--at the end of the demonstration which operated at 5.3 BV/hour. Additional column tests at nominally 15 BV/hr demonstrated similar removal performance. Batch testing of adsorbents used both actual Savannah River Site (SRS) tank supernate as well as simulated salt solutions spiked with strontium, neptunium, and plutonium. In tank waste tests, internal gelation beads produced by the Oak Ridge National Laboratory (ORNL) demonstrated a batch distribution coefficient of 35,000 +/- 4,000 mL/g for plutonium at a phase ratio of 1970 mL/g. In the same batch the sorbent demonstrated a batch distribution coefficient of 99,000 +/- 7,500 mL/g for strontium. These results indicate that this material should be able to process thousands of bed volumes of SRS salt waste before column breakthrough.
Download or read book Phase I Technical Report for the Engineering of Monosodium Titanate written by CHARLES. NASH and published by . This book was released on 2004 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: Monosodium titanate (MST) is an inorganic adsorbent that effectively removes strontium, plutonium, uranium, and other trace elements from alkaline salt supernate. Current plans use the MST in batch contact processes to treat Savannah River Site (SRS) waste solutions that require 90Sr and actinide removal to meet low level disposal criteria. More effective use of MST may be realized if the MST could be engineered into a form suitable for a continuous treatment process such as an adsorption column. The main benefits of column operation are (1) enhanced loading due to equilibration with feed adsorbate levels versus product levels, and (2) a small footprint relative to that of a batch contact tank. The current baseline MST material features particles of nominally 0.5-35 micron in size, which are much too fine for use in an adsorption column. An extensive review of the literature and consultation with technical experts identified candidate methods to produce engineered forms of MST. From this list a review team selected five candidate methods for further study. Laboratory syntheses at Savannah River National Laboratory (SRNL) and offsite produced representative samples for characterization and performance testing. Testing identified two suitable methods. The two methods include internal gelation, which is patented technology of Oak Ridge National Laboratory, and internal hydrolysis, a method in which the MST is produced within a porous substrate. A commercial sodium titanate, SrTreat(R), produced by Fortum Engineering (Finland), demonstrated good performance as well although plutonium removal kinetics appeared much slower than observed for the other engineered MST materials.
Download or read book MONOSODIUM TITANATE MULTI STRIKE TESTING written by and published by . This book was released on 2004 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: Research over the past decade has studied the adsorption of plutonium and uranium onto monosodium titanate (MST) in alkaline solutions. Tests showed that MST would remove the targeted radionuclides from simulated alkaline waste. Testing also indicated that Pu removal kinetics and Np capacity of the MST material impacts the size of equipment and waste blending plans for the Salt Waste Processing Facility (SWPF). Additionally, calculations suggested the baseline MST process may not achieve the desired decontamination in wastes containing elevated concentrations of Pu and Np. In this task, the authors investigated the performance of non-baseline process parameters and their effectiveness for treating waste feed in the Salt Waste Processing Facility. The work addresses a DOE request in support of technical needs expressed, in part, by the Engineering, Procurement, and Construction Contractors for the Salt Waste Processing Facility. The work investigated the effect of increased MST addition (up to 1.2 g/L) and the benefit of extra filtration steps with multiple additions of MST to salt waste containing actinides and strontium. Both simulant and actual waste testing occurred. Actual waste tests used a Tank 39H composite waste solution. In addition, testing to determine desorption of actinides from residual MST occurred. The release of sorbed Sr and actinides from loaded MST during the washing stages in the Salt Waste Processing Facility is an unresolved process behavior. Desorption tests assessed this potential problem using loaded MST from the residue of the MST adsorption tests. Analysis of non-radioactive Sr in the tests proved difficult due to the low concentration of nonradioactive Sr and its nearness to the method detection limit for ICP-MS. Efforts to use AMP to minimize dilution of actual waste for removal from the cell did not help for this analysis since instrument dilution still proved necessary due to the salt content.
Download or read book Nanowire Field Effect Transistor FET written by Antonio García-Loureiro and published by . This book was released on 2021 with total page 96 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the last few years, the leading semiconductor industries have introduced multi-gate non-planar transistors into their core business. These are being applied in memories and in logical integrated circuits to achieve better integration on the chip, increased performance, and reduced energy consumption. Intense research is underway to develop these devices further and to address their limitations, in order to continue transistor scaling while further improving performance. This Special Issue looks at recent developments in the field of nanowire field-effect transistors (NW-FETs), covering different aspects of the technology, physics, and modelling of these nanoscale devices.
