Download or read book Optical Transient Grating Measurements of Micro nanoscale Thermal Transport and Mechanical Properties written by Jeffrey Kristian Eliason and published by . This book was released on 2015 with total page 119 pages. Available in PDF, EPUB and Kindle. Book excerpt: The laser-based transient grating technique was used to study phonon mediated thermal transport in bulk and nanostructured semiconductors and surface wave propagation in a monolayer of micron sized spheres. In the transient grating technique two picosecond pulses are crossed to generate a spatially periodic intensity profile. The spatially periodic profile generates a material excitation with a well-defined wave vector. The time dependence of the spatially periodic material response is measured by monitoring the diffracted signal of an incident probe beam. Non-diffusive thermal transport was observed in thin Si membranes as well as bulk GaAs at relatively short (micron) transient grating periods. First-principles calculations of the phonon mean free paths in Si and GaAs were compared with experimental results and showed good agreement. Preliminary measurements on promising thermoelectric materials such as PbTe and Bi2Te3 are presented showing evidence of non-diffusive transport at short length scales. The transient grating technique was used to measure the thermal conductivity of Si membranes with thickness ranging from 15 nm to 1518 nm. Using the Fuchs-Sondheimer suppression function along with first-principles results, the thermal conductivity as a function of membrane thickness was calculated. The calculations showed excellent agreement with experimental measurements. A convex optimization algorithm was employed to reconstruct the phonon mean free path distribution from experimental measurements. This marks the first experimental determination of the mean free path distribution for a bulk material. Thermal conductivity measurements at low temperatures in a 200 nm Si membrane indicate the breakdown of the diffuse boundary scattering approximation. The transient grating technique was used to generate surface acoustic waves and measure their dispersion in a monolayer of 0.5 - 1 [mu]m diameter silica spheres. The measured dispersion curves show "avoided crossing" behavior due to the interaction between an axial contact resonance of the microspheres and the surface acoustic wave at a frequency of -200MHz for the 1 [mu]m spheres and -700 MHz for the 0.5 [m spheres. The experimental measurements were fit with an analytical model in which the contact stiffness was the only fitting parameter. Preliminary results of surface acoustic wave propagation in microsphere waveguides, transmission through a microsphere strip, and evidence of a nonlinear response in a 2D array of microspheres are presented.
Download or read book Functional Thin Films Technology written by Sam Zhang and published by CRC Press. This book was released on 2021-08-09 with total page 446 pages. Available in PDF, EPUB and Kindle. Book excerpt: Functional Thin Films Technology features the functional aspects of thin films, such as their application in solar selective absorbers, fiber lasers, solid oxide fuel cells, piezo-related areas, catalysts, superhydrophobicity, semiconductors, and trace pesticides detection. It highlights developments and advances in the preparation, characterization, and applications of functional micro-/nano-scaled films and coatings. This book Presents technologies aimed at functionality used in nanoelectronics, solar selective absorbers, solid oxide fuel cells, piezo-applications, and sensors Covers absorbers, catalysts, anodic aluminum oxide, superhydrophobics, and semiconductor devices Features a chapter on transport phenomena associated to structures Discusses transport phenomena and material informatics This second volume in the two-volume set, Protective Thin Coatings and Functional Thin Films Technology, will benefit industry professionals and researchers working in areas related to semiconductors, optoelectronics, plasma technology, solid-state energy storages, and 5G, as well as advanced students studying electrical, mechanical, chemical, and materials engineering.
Download or read book Nanoscale Energy Transport and Conversion written by Gang Chen and published by Oxford University Press. This book was released on 2005-03-03 with total page 570 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is a graduate level textbook in nanoscale heat transfer and energy conversion that can also be used as a reference for researchers in the developing field of nanoengineering. It provides a comprehensive overview of microscale heat transfer, focusing on thermal energy storage and transport. Chen broadens the readership by incorporating results from related disciplines, from the point of view of thermal energy storage and transport, and presents related topics on the transport of electrons, phonons, photons, and molecules. This book is part of the MIT-Pappalardo Series in Mechanical Engineering.
Download or read book Nano Microscale Heat Transfer written by Zhuomin M. Zhang and published by Springer Nature. This book was released on 2020-06-23 with total page 780 pages. Available in PDF, EPUB and Kindle. Book excerpt: This substantially updated and augmented second edition adds over 200 pages of text covering and an array of newer developments in nanoscale thermal transport. In Nano/Microscale Heat Transfer, 2nd edition, Dr. Zhang expands his classroom-proven text to incorporate thermal conductivity spectroscopy, time-domain and frequency-domain thermoreflectance techniques, quantum size effect on specific heat, coherent phonon, minimum thermal conductivity, interface thermal conductance, thermal interface materials, 2D sheet materials and their unique thermal properties, soft materials, first-principles simulation, hyperbolic metamaterials, magnetic polaritons, and new near-field radiation experiments and numerical simulations. Informed by over 12 years use, the author’s research experience, and feedback from teaching faculty, the book has been reorganized in many sections and enriched with more examples and homework problems. Solutions for selected problems are also available to qualified faculty via a password-protected website.• Substantially updates and augments the widely adopted original edition, adding over 200 pages and many new illustrations;• Incorporates student and faculty feedback from a decade of classroom use;• Elucidates concepts explained with many examples and illustrations;• Supports student application of theory with 300 homework problems;• Maximizes reader understanding of micro/nanoscale thermophysical properties and processes and how to apply them to thermal science and engineering;• Features MATLAB codes for working with size and temperature effects on thermal conductivity, specific heat of nanostructures, thin-film optics, RCWA, and near-field radiation.
Download or read book Optical Measurements written by Franz Mayinger and published by Springer Science & Business Media. This book was released on 2013-03-14 with total page 462 pages. Available in PDF, EPUB and Kindle. Book excerpt: Increasing possibilities of computer-aided data processing have caused a new revival of optical techniques in many areas of mechanical and chemical en gineering. Optical methods have a long tradition in heat and mass transfer and in fluid dynamics. Global experimental information is not sufficient for developing constitution equations to describe complicated phenomena in fluid dynamics or in transfer processes by a computer program . Furthermore, a detailed insight with high local and temporal resolution into the thermo-and fluiddynamic situations is necessary. Sets of equations for computer program in thermo dynamics and fluid dynamics usually consist of two types of formulations: a first one derived from the conservation laws for mass, energy and momentum, and a second one mathematically modelling transport processes like laminar or turbulent diffusion. For reliably predicting the heat transfer, for example, the velocity and temperature field in the boundary layer must be known, or a physically realistic and widely valid correlation describing the turbulence must be avail able. For a better understanding of combustion processes it is necessary to know the local concentration and temperature just ahead of the flame and in the ignition zone.
Download or read book Laser Induced Dynamic Gratings written by Hans Joachim Eichler and published by Springer. This book was released on 2013-06-29 with total page 270 pages. Available in PDF, EPUB and Kindle. Book excerpt: The invention ofthe laser 25years ago resulted in powerfullight sources which led to the observation of unexpected and striking phenomena. New fields of science such as holography and nonlinear optics developed constituting the basis of this volume. The classical principle of linear superposition of light wavesdoes not hold anymore. Two laser beams crossing in a suitable material may produce a set of new beams with different directions and frequencies. The interaction of light waves can be understood by considering the optical grating structures which develop in the overlap region. The optical properties of matter become spatially modulated in the interference region of two light waves. Permanent holographic gratings have been produced in this way by photographic processes for many years. In contrast, dynamic or transient gratings disappear after the inducing light source, usually a laser, has been switched off. The grating amplitude is controlled by the light intensity. Dynamic gratings have been induced in a large number ofsolids, liquids, and gases, and are detected by diffraction, 'forced light scattering' of a third probing beam, or by self-diffraction of the light waves inducing the grating. The combined interference and diffraction effect corresponds to four-wave mixing (FWM) in the language of nonlinear optics. The process is called degenerate ifthe frequenciesofthe three incident wavesand the scattered wave are equal. Degenerate four-wave mixing (DFWM) is a simple method to achieve phase conjugation, i.e. to generate a wave which propagates time reversed with respect to an incident wave.
Download or read book American Doctoral Dissertations written by and published by . This book was released on 2001 with total page 776 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Micro and Nanoscale Fluid Mechanics written by Brian J. Kirby and published by Cambridge University Press. This book was released on 2010-07-26 with total page 536 pages. Available in PDF, EPUB and Kindle. Book excerpt: This text focuses on the physics of fluid transport in micro- and nanofabricated liquid-phase systems, with consideration of gas bubbles, solid particles, and macromolecules. This text was designed with the goal of bringing together several areas that are often taught separately - namely, fluid mechanics, electrodynamics, and interfacial chemistry and electrochemistry - with a focused goal of preparing the modern microfluidics researcher to analyse and model continuum fluid mechanical systems encountered when working with micro- and nanofabricated devices. This text serves as a useful reference for practising researchers but is designed primarily for classroom instruction. Worked sample problems are included throughout to assist the student, and exercises at the end of each chapter help facilitate class learning.
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1994 with total page 716 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Microscale and Nanoscale Heat Transfer written by C.B. Sobhan and published by CRC Press. This book was released on 2008-06-12 with total page 440 pages. Available in PDF, EPUB and Kindle. Book excerpt: Through analyses, experimental results, and worked-out numerical examples, Microscale and Nanoscale Heat Transfer: Fundamentals and Engineering Applications explores the methods and observations of thermophysical phenomena in size-affected domains. Compiling the most relevant findings from the literature, along with results from their own re
Download or read book Springer Handbook of Lasers and Optics written by Frank Träger and published by Springer Science & Business Media. This book was released on 2012-05-05 with total page 1704 pages. Available in PDF, EPUB and Kindle. Book excerpt: This new edition features numerous updates and additions. Especially 4 new chapters on Fiber Optics, Integrated Optics, Frequency Combs and Interferometry reflect the changes since the first edition. In addition, major complete updates for the chapters: Optical Materials and Their Properties, Optical Detectors, Nanooptics, and Optics far Beyond the Diffraction Limit. Features Contains over 1000 two-color illustrations. Includes over 120 comprehensive tables with properties of optical materials and light sources. Emphasizes physical concepts over extensive mathematical derivations. Chapters with summaries, detailed index Delivers a wealth of up-to-date references.
Download or read book Thermoplasmonics written by Guillaume Baffou and published by Cambridge University Press. This book was released on 2017-10-19 with total page 310 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plasmonics is an important branch of optics concerned with the interaction of metals with light. Under appropriate illumination, metal nanoparticles can exhibit enhanced light absorption, becoming nanosources of heat that can be precisely controlled. This book provides an overview of the exciting new field of thermoplasmonics and a detailed discussion of its theoretical underpinning in nanophotonics. This topic has developed rapidly in the last decade, and is now a highly-active area of research due to countless applications in nanoengineering and nanomedicine. These important applications include photothermal cancer therapy, drug and gene delivery, nanochemistry and photothermal imaging. This timely and self-contained text is suited to all researchers and graduate students working in plasmonics, nano-optics and thermal-induced processes at the nanoscale.
Download or read book Femtosecond Laser Micromachining written by Roberto Osellame and published by Springer Science & Business Media. This book was released on 2012-03-05 with total page 485 pages. Available in PDF, EPUB and Kindle. Book excerpt: Femtosecond laser micromachining of transparent material is a powerful and versatile technology. In fact, it can be applied to several materials. It is a maskless technology that allows rapid device prototyping, has intrinsic three-dimensional capabilities and can produce both photonic and microfluidic devices. For these reasons it is ideally suited for the fabrication of complex microsystems with unprecedented functionalities. The book is mainly focused on micromachining of transparent materials which, due to the nonlinear absorption mechanism of ultrashort pulses, allows unique three-dimensional capabilities and can be exploited for the fabrication of complex microsystems with unprecedented functionalities.This book presents an overview of the state of the art of this rapidly emerging topic with contributions from leading experts in the field, ranging from principles of nonlinear material modification to fabrication techniques and applications to photonics and optofluidics.
Download or read book Heat Transfer in Polymer Composite Materials written by Nicolas Boyard and published by John Wiley & Sons. This book was released on 2016-03-28 with total page 464 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book addresses general information, good practices and examples about thermo-physical properties, thermo-kinetic and thermo-mechanical couplings, instrumentation in thermal science, thermal optimization and infrared radiation.
Download or read book Lab on Fiber Technology written by Andrea Cusano and published by Springer. This book was released on 2014-07-29 with total page 377 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book focuses on a research field that is rapidly emerging as one of the most promising ones for the global optics and photonics community: the “lab-on-fiber” technology. Inspired by the well-established "lab on-a-chip" concept, this new technology essentially envisages novel and highly functionalized devices completely integrated into a single optical fiber for both communication and sensing applications. Based on the R&D experience of some of the world's leading authorities in the fields of optics, photonics, nanotechnology, and material science, this book provides a broad and accurate description of the main developments and achievements in the lab-on-fiber technology roadmap, also highlighting the new perspectives and challenges to be faced. This book is essential for scientists interested in the cutting-edge fiber optic technology, but also for graduate students.
Download or read book Chemical Abstracts written by and published by . This book was released on 2002 with total page 2692 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fabrication Engineering at the Micro and Nanoscale written by Stephen A. Campbell and published by OUP USA. This book was released on 2008-01-10 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Designed for advanced undergraduate or first-year graduate courses in semiconductor or microelectronic fabrication, the third edition of Fabrication Engineering at the Micro and Nanoscale provides a thorough and accessible introduction to all fields of micro and nano fabrication.
