Download or read book Numerical Simulations of Partially Premixed Methane Combustion in Laminar and Turbulent Flows written by Hyderuddin Mohammad and published by . This book was released on 2004 with total page 290 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Turbulent Combustion written by Norbert Peters and published by Cambridge University Press. This book was released on 2000-08-15 with total page 322 pages. Available in PDF, EPUB and Kindle. Book excerpt: The combustion of fossil fuels remains a key technology for the foreseeable future. It is therefore important that we understand the mechanisms of combustion and, in particular, the role of turbulence within this process. Combustion always takes place within a turbulent flow field for two reasons: turbulence increases the mixing process and enhances combustion, but at the same time combustion releases heat which generates flow instability through buoyancy, thus enhancing the transition to turbulence. The four chapters of this book present a thorough introduction to the field of turbulent combustion. After an overview of modeling approaches, the three remaining chapters consider the three distinct cases of premixed, non-premixed, and partially premixed combustion, respectively. This book will be of value to researchers and students of engineering and applied mathematics by demonstrating the current theories of turbulent combustion within a unified presentation of the field.
Download or read book Numerical Simulation of Non premixed Laminar and Turbulent Flames by Means of Flamelet Modelling Approaches written by and published by . This book was released on 2002 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Deep knowledge of combustion phenomena is of great scientific and technological interest. In fact, better design of combustion equipments (furnaces, boilers, engines, etc) can contribute both in the energy efficiency and in the reduction of pollutant formation. One of the limitations to design combustion equipments, or even predict simple flames, is the resolution of the mathematical formulation. Analytical solutions are not feasible, and recently numerical techniques have received enormous interest. Even though the ever-increasing computational capacity, the numerical resolution requires large computational resources due to the inherent complexity of the phenomenon (viz. multidimensional flames, finite rate kinetics, radiation in participating media, turbulence, etc). Thus, development of capable mathematical models reducing the complexity and the stiffness as well as efficient numerical techniques are of great interest. The main contribution of the thesis is the analysis and application of the laminar flamelet concept to the numerical simulation of both laminar and turbulent non-premixed flames. Assuming a one-dimensional behavior of combustion phenomena in the normal direction to the flame front, and considering an appropriate coordinates transformation, flamelet approaches reduce the complexity of the problem. The numerical methodology employed is based on the finite volume technique and a parallel multiblock algorithm is used obtaining an excellent parallel efficiency. A post-processing verification tool is applied to assess the quality of the numerical solutions. Before dealing with flamelet approaches, a co-flow partially premixed methane/air laminar flame is studied for different levels of partial premixing. A comprehensive study is performed considering different mathematical formulations based on the full resolution of the governing equations and their validation against experimental data from the literature. Special attention is paid to the prediction of.
Download or read book Modeling and Simulation of Turbulent Combustion written by Santanu De and published by Springer. This book was released on 2017-12-12 with total page 663 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents a comprehensive review of state-of-the-art models for turbulent combustion, with special emphasis on the theory, development and applications of combustion models in practical combustion systems. It simplifies the complex multi-scale and nonlinear interaction between chemistry and turbulence to allow a broader audience to understand the modeling and numerical simulations of turbulent combustion, which remains at the forefront of research due to its industrial relevance. Further, the book provides a holistic view by covering a diverse range of basic and advanced topics—from the fundamentals of turbulence–chemistry interactions, role of high-performance computing in combustion simulations, and optimization and reduction techniques for chemical kinetics, to state-of-the-art modeling strategies for turbulent premixed and nonpremixed combustion and their applications in engineering contexts.
Download or read book Experiments and Numerical Simulations of Diluted Spray Turbulent Combustion written by Bart Merci and published by Springer Science & Business Media. This book was released on 2011-06-20 with total page 180 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book reflects the outcome of the 1st International Workshop on Turbulent Spray Combustion held in 2009 in Corsica (France). The focus is on reporting the progress of experimental and numerical techniques in two-phase flows, with emphasis on spray combustion. The motivation for studies in this area is that knowledge of the dominant phenomena and their interactions in such flow systems is essential for the development of predictive models and their use in combustor and gas turbine design. This necessitates the development of accurate experimental methods and numerical modelling techniques. The workshop aimed at providing an opportunity for experts and young researchers to present the state-of-the-art, discuss new developments or techniques and exchange ideas in the areas of experimentations, modelling and simulation of reactive multiphase flows. The first two papers reflect the contents of the invited lectures, given by experts in the field of turbulent spray combustion. The first concerns computational issues, while the second deals with experiments. These lectures initiated very interesting and interactive discussions among the researchers, further pursued in contributed poster presentations. Contributions 3 and 4 focus on some aspects of the impact of the interaction between fuel evaporation and combustion on spray combustion in the context of gas turbines, while the final article deals with the interaction between evaporation and turbulence.
Download or read book Direct Numerical Simulation of Turbulent Non premixed Methane air Flames written by and published by . This book was released on 1995 with total page 13 pages. Available in PDF, EPUB and Kindle. Book excerpt: Turbulent non-premixed stoichiometric methane-air flames have been studied using the direct numerical simulation approach. A global one- step mechanism is used to describe the chemical kinetics, and molecular transport is modeled with constant Lewis numbers for individual species. The effect of turbulence on the internal flame structure and extinction characteristics of methane-air flames is evaluated. The flame is wrinkled and in some regions extinguished by the turbulence, while the turbulence is weakened in the vicinity of the flame due to a combination of dilatation and a 25:1 increase in kinematic viscosity across the flame. Reignition followed by partially-premixed burning is observed in the present results. Local curvature effects are found to be important in determining the local stoichiometry of the flame, and hence, the location of the peak reaction rate relative to the stoichiometric surface. The results presented in this study demonstrate the feasibility of incorporating global-step kinetics for the oxidation of methane into direct numerical simulations of homogeneous turbulence to study the flame structure.
Download or read book Direct Numerical Simulation of Premixed Turbulent Methane Flames Modeled with Various Reduced Mechanisms written by Negin Angoshtari and published by . This book was released on 2003 with total page 164 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Numerical Simulation of Premixed Turbulent Methane Combustion written by Robert Cheng and published by . This book was released on 2003 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: With adaptive-grid computational methodologies and judicious use of compressible and low Mach number combustion models, we are carrying out three-dimensional, time-dependent direct numerical simulations of a laboratory-scale turbulent premixed methane burner. In the laboratory experiment, turbulence is generated by a grid located in the throat of a 50mm diameter circular nozzle; swirl is be introduced by four tangential air jets spaced uniformly around the circumference of the nozzle just above the turbulence grid. A premixed methane flame is stabilized above the nozzle in the central core region where a velocity deficit is induced7the swirling flow. The time-dependent flow field inside the nozzle, from the turbulence grid and the high-speed jets, to the nozzle exit plane is simulated using an adaptive-grid embedded-boundary compressible Navier-Stokes solver. The compressible calculation then provides time-dependent boundary conditions for an adaptive low Mach number model of the swirl-stabilized premixed flame. The low Mach model incorporates detailed chemical kinetics and species transport using 20 species and 84 reactions. Laboratory diagnostics available for comparisons include characterizations of the flow field just down stream of the nozzle exit plane, and flame surface statistics, such as mean location, wrinkling and crossing frequencies.
Download or read book Turbulent Combustion Modeling written by Tarek Echekki and published by Springer Science & Business Media. This book was released on 2010-12-25 with total page 496 pages. Available in PDF, EPUB and Kindle. Book excerpt: Turbulent combustion sits at the interface of two important nonlinear, multiscale phenomena: chemistry and turbulence. Its study is extremely timely in view of the need to develop new combustion technologies in order to address challenges associated with climate change, energy source uncertainty, and air pollution. Despite the fact that modeling of turbulent combustion is a subject that has been researched for a number of years, its complexity implies that key issues are still eluding, and a theoretical description that is accurate enough to make turbulent combustion models rigorous and quantitative for industrial use is still lacking. In this book, prominent experts review most of the available approaches in modeling turbulent combustion, with particular focus on the exploding increase in computational resources that has allowed the simulation of increasingly detailed phenomena. The relevant algorithms are presented, the theoretical methods are explained, and various application examples are given. The book is intended for a relatively broad audience, including seasoned researchers and graduate students in engineering, applied mathematics and computational science, engine designers and computational fluid dynamics (CFD) practitioners, scientists at funding agencies, and anyone wishing to understand the state-of-the-art and the future directions of this scientifically challenging and practically important field.
Download or read book Mathematical Modeling in Combustion and Related Topics written by Claude-Michel Brauner and published by Springer Science & Business Media. This book was released on 1988-03-31 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume contains invited lectures and contributed papers presented at the NATO Advanced Research Workshop on Mathematical Modeling in Combustion and related topics, held in. Lyon (France), April 27 - 30, 1987. This conference was planned to fit in with the two-month visit of Professor G.S.S. Ludford to the Ecole Centrale de Lyon. He kindly agreed to chair the Scientific and Organizing Committee and actively helped to initiate the meeting. His death in December 1986 is an enormous loss to the scientific community in general, and in particular, to the people involved in the present enterprise. The subject of mathematical modeling in combustion is too large for a single conference, and the selection of topics re flects both areas of recent research activity and areas of in terest to Professor G.S.S. Ludford, to whose memory the Advanced Workshop and this present volume are dedicated. The meeting was divided into seven specialized sessions detonation theory, mathematical analysis, numerical treatment of combustion problems, flame theory, experimental and industrial aspects, complex chemistry, and turbulent combustion. It brought together researchers and engineers from University and Industry (see below the closing remarks of the workshop by Prof. N. Peters). The articles in this volume have been judged and accepted on their scientific quality, and language corrections may have been sacrificed in order to allow quick dissemination of knowledge to prevail.
Download or read book Fundamentals of Premixed Turbulent Combustion written by Andrei Lipatnikov and published by CRC Press. This book was released on 2012-10-24 with total page 548 pages. Available in PDF, EPUB and Kindle. Book excerpt: Lean burning of premixed gases is considered to be a promising combustion technology for future clean and highly efficient gas turbine combustors. Yet researchers face several challenges in dealing with premixed turbulent combustion, from its nonlinear multiscale nature and the impact of local phenomena to the multitude of competing models. Filling
Download or read book Turbulent Premixed Flames written by Nedunchezhian Swaminathan and published by Cambridge University Press. This book was released on 2011-04-25 with total page 447 pages. Available in PDF, EPUB and Kindle. Book excerpt: A work on turbulent premixed combustion is important because of increased concern about the environmental impact of combustion and the search for new combustion concepts and technologies. An improved understanding of lean fuel turbulent premixed flames must play a central role in the fundamental science of these new concepts. Lean premixed flames have the potential to offer ultra-low emission levels, but they are notoriously susceptible to combustion oscillations. Thus, sophisticated control measures are inevitably required. The editors' intent is to set out the modeling aspects in the field of turbulent premixed combustion. Good progress has been made on this topic, and this cohesive volume contains contributions from international experts on various subtopics of the lean premixed flame problem.
Download or read book Direct Numerical Simulations of Premixed Turbulent Flame with Variable Density written by Songwei Zhang and published by . This book was released on 1994 with total page 292 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Numerical Simulation of Premixed Turbulent Methane Combustion written by and published by . This book was released on 2001 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: In this paper we study the behavior of a premixed turbulent methane flame in three dimensions using numerical simulation. The simulations are performed using an adaptive time-dependent low Mach number combustion algorithm based on a second-order projection formulation that conserves both species mass and total enthalpy. The species and enthalpy equations are treated using an operator-split approach that incorporates stiff integration techniques for modeling detailed chemical kinetics. The methodology also incorporates a mixture model for differential diffusion. For the simulations presented here, methane chemistry and transport are modeled using the DRM-19 (19-species, 84-reaction) mechanism derived from the GRIMech-1.2 mechanism along with its associated thermodynamics and transport databases. We consider a lean flame with equivalence ratio 0.8 for two different levels of turbulent intensity. For each case we examine the basic structure of the flame including turbulent flame speed and flame surface area. The results indicate that flame wrinkling is the dominant factor leading to the increased turbulent flame speed. Joint probability distributions are computed to establish a correlation between heat release and curvature. We also investigate the effect of turbulent flame interaction on the flame chemistry. We identify specific flame intermediates that are sensitive to turbulence and explore various correlations between these species and local flame curvature. We identify different mechanisms by which turbulence modulates the chemistry of the flame.
Download or read book Turbulent Combustion written by L. Vervisch and published by . This book was released on 2005 with total page 536 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Direct Numerical Simulations of Strained Laminar and Turbulent Nonpremixed Flames written by Chunsang Yoo and published by . This book was released on 2005 with total page 352 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Numerical Flow Simulation III written by Ernst Heinrich Hirschel and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 293 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume contains eighteen reports on work, which is conducted since 2000 in the Collaborative Research Programme 'Numerical Flow Simulation' of the Centre National de la Recherche Scientifique (CNRS) and the Deutsche Forschungsgemeinschaft (DFG). French and German engineers and mathematicians present their joint research on the topics 'Development of Solution Techniques', 'Crystal Growth and Melts', 'Flows of Reacting Gases, Sound Generation' and 'Turbulent Flows'. In the background of their work is the still strong growth of the performance of super-computer architectures, which, together with large advances in algorithms, is opening vast new application areas of numerical flow simulation in research and industrial work. Results of this programme from the period 1996 to 1998 have been presented in NNFM 66 (1998), and NNFM75 (2001).
