Download or read book Novel Thin film CuInSe2 Fabrication written by A. M. Gabor and published by . This book was released on 1994 with total page 7 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Novel Thin film CuInSe2 Fabrication Annual Subcontract Report 1 May 1992 31 October 1993 written by and published by . This book was released on 1994 with total page 18 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report describes work exploring a new technique for the formation of Culn(subscript x)Ga{sub 1-x}Se2 thin films. The cu deposition was separated fro the Ga+In deposition such that precursor films with compositions of either Cu(subscript x)Se or (In(subscript x)Ga{sub 1-x})2Se3 were formed. These precursors were exposed to either (a) In+Ga+Se or (b) cu+Se at substrate temperatures> 500 C to form Galn(subscript x)Ga{sub 1-x}Se2. Films made from the Cu(subscript x)Se precursors were unexceptional, but films made from the (In(subscript x)Ga{sub 1-x})2Se3 precursors were of exceptional smoothness and density. During the period covered in this report, a device made fro one of these films resulted in what, at the time, was the highest total-area efficiency measured for any non-single-crystal, thin-film solar cell, at 15.9%.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1994-11 with total page 486 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Government Reports Annual Index written by and published by . This book was released on 1994 with total page 1374 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Handbook of Photovoltaic Science and Engineering written by Antonio Luque and published by John Wiley & Sons. This book was released on 2011-01-31 with total page 1172 pages. Available in PDF, EPUB and Kindle. Book excerpt: The most comprehensive, authoritative and widely cited reference on photovoltaic solar energy Fully revised and updated, the Handbook of Photovoltaic Science and Engineering, Second Edition incorporates the substantial technological advances and research developments in photovoltaics since its previous release. All topics relating to the photovoltaic (PV) industry are discussed with contributions by distinguished international experts in the field. Significant new coverage includes: three completely new chapters and six chapters with new authors device structures, processing, and manufacturing options for the three major thin film PV technologies high performance approaches for multijunction, concentrator, and space applications new types of organic polymer and dye-sensitized solar cells economic analysis of various policy options to stimulate PV growth including effect of public and private investment Detailed treatment covers: scientific basis of the photovoltaic effect and solar cell operation the production of solar silicon and of silicon-based solar cells and modules how choice of semiconductor materials and their production influence costs and performance making measurements on solar cells and modules and how to relate results under standardised test conditions to real outdoor performance photovoltaic system installation and operation of components such as inverters and batteries. architectural applications of building-integrated PV Each chapter is structured to be partially accessible to beginners while providing detailed information of the physics and technology for experts. Encompassing a review of past work and the fundamentals in solar electric science, this is a leading reference and invaluable resource for all practitioners, consultants, researchers and students in the PV industry.
Download or read book Clean Electricity From Photovoltaics written by Mary D Archer and published by World Scientific. This book was released on 2001-06-04 with total page 870 pages. Available in PDF, EPUB and Kindle. Book excerpt: Photovoltaic cells provide clean, reversible electrical power from the sun. Made from semiconductors, they are durable, silent in operation and free of polluting emissions. In this book, experts from all sectors of the PV community — materials scientists, physicists, production engineers, economists and environmentalists — give their critical appraisals of where the technology is now and what its prospects are./a
Download or read book Hydrogen and Fuel Cells written by International Energy Agency and published by Simon and Schuster. This book was released on 2004 with total page 208 pages. Available in PDF, EPUB and Kindle. Book excerpt: Hydrogen and fuel cells are vital technologies to ensure a secure and CO2-free energy future. Their development will take decades of extensive public and private effort to achieve technology breakthroughs and commercial maturity. Government research programs are indispensable for catalyzing the development process. This report maps the IEA countries' current efforts to research, develop and deploy the interlocking elements that constitute a "hydrogen economy", including CO2 capture and storage when hydrogen is produced out of fossil fuels. It provides an overview of what is being done, and by whom, covering an extensive complexity of national government R & D programs. The survey highlights the potential for exploiting the benefits of the international cooperation. This book draws primarily upon information contributed by IEA governments. In virtually all the IEA countries, important R & D and policy efforts on hydrogen and fuel cells are in place and expanding. Some are fully-integrated, government-funded programs, some are a key element in an overall strategy spread among multiple public and private efforts. The large amount of information provided in this publication reflects the vast array of technologies and logistics required to build the "hydrogen economy."--Publisher description.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1979 with total page 1038 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Solar Energy written by Christoph Richter and published by Springer. This book was released on 2012-11-29 with total page 744 pages. Available in PDF, EPUB and Kindle. Book excerpt: Gathering some 30 entries from the Encyclopedia of Sustainability Science and Technology, this book presents fundamental principles and technologies for sustainably harnessing solar energy. Covers photovoltaics, solar thermal energy, solar radiation and more.
Download or read book Photovoltaic Fundamentals written by Gary Cook and published by . This book was released on 1991 with total page 70 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Alternative Energy Systems in Building Design GreenSource Books written by Peter Gevorkian and published by McGraw Hill Professional. This book was released on 2009-09-07 with total page 545 pages. Available in PDF, EPUB and Kindle. Book excerpt: Design High-Performance Alternative Energy Systems for Buildings A comprehensive reference for architects and engineers, this GreenSource book provides practical design and installation guidelines for some of the most commercially viable alternative energy technologies. Construction materials, system deployment, typical installations, and environmental impact are covered. Alternative Energy Systems in Building Design includes information on LEED design, energy conservation, and solar power financing and return on investment. Power purchase agreements (PPAs) and national and international carbon cap and trade are also discussed. Valuable appendices contain detailed design data tables and certified equipment listings. Alternative Energy Systems in Building Design covers: Solar power system physics and technologies California solar initiative program Energy conservation Passive heating solar technologies Fuel cell technology Wind energy technologies Ocean energy technologies Hydroelectric and micro-hydro turbine power Geothermal energy Biofuel, biogas, and thermal depolymerization technologies Fission- and fusion-type nuclear power Air pollution abatement
Download or read book Solar Cells and Modules written by Arvind Shah and published by Springer Nature. This book was released on 2020-07-16 with total page 357 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book gives a comprehensive introduction to the field of photovoltaic (PV) solar cells and modules. In thirteen chapters, it addresses a wide range of topics including the spectrum of light received by PV devices, the basic functioning of a solar cell, and the physical factors limiting the efficiency of solar cells. It places particular emphasis on crystalline silicon solar cells and modules, which constitute today more than 90 % of all modules sold worldwide. Describing in great detail both the manufacturing process and resulting module performance, the book also touches on the newest developments in this sector, such as Tunnel Oxide Passivated Contact (TOPCON) and heterojunction modules, while dedicating a major chapter to general questions of module design and fabrication. Overall, it presents the essential theoretical and practical concepts of PV solar cells and modules in an easy-to-understand manner and discusses current challenges facing the global research and development community.
Download or read book Lecture Notes on Principles of Plasma Processing written by Francis F. Chen and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 213 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plasma processing of semiconductors is an interdisciplinary field requiring knowledge of both plasma physics and chemical engineering. The two authors are experts in each of these fields, and their collaboration results in the merging of these fields with a common terminology. Basic plasma concepts are introduced painlessly to those who have studied undergraduate electromagnetics but have had no previous exposure to plasmas. Unnecessarily detailed derivations are omitted; yet the reader is led to understand in some depth those concepts, such as the structure of sheaths, that are important in the design and operation of plasma processing reactors. Physicists not accustomed to low-temperature plasmas are introduced to chemical kinetics, surface science, and molecular spectroscopy. The material has been condensed to suit a nine-week graduate course, but it is sufficient to bring the reader up to date on current problems such as copper interconnects, low-k and high-k dielectrics, and oxide damage. Students will appreciate the web-style layout with ample color illustrations opposite the text, with ample room for notes. This short book is ideal for new workers in the semiconductor industry who want to be brought up to speed with minimum effort. It is also suitable for Chemical Engineering students studying plasma processing of materials; Engineers, physicists, and technicians entering the semiconductor industry who want a quick overview of the use of plasmas in the industry.
Download or read book Terrestrial Photovoltaic Measurements written by and published by . This book was released on 1975 with total page 200 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Suggestology written by Georgi Lozanov and published by Routledge. This book was released on 2004-08-02 with total page 503 pages. Available in PDF, EPUB and Kindle. Book excerpt: First Published in 1992. Routledge is an imprint of Taylor & Francis, an informa company.
Download or read book Photovoltaic Manufacturing written by Monika Freunek Muller and published by John Wiley & Sons. This book was released on 2021-08-16 with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt: PHOTOVOLTAIC MANUFACTURING This book covers the state-of-the-art and the fundamentals of silicon wafer solar cells manufacturing, written by world-class researchers and experts in the field. High quality and economic photovoltaic manufacturing is central to realizing reliable photovoltaic power supplies at reasonable cost. While photovoltaic silicon wafer manufacturing is at a mature, industrial and mass production stage, knowing and applying the fundamentals in solar manufacturing is essential to anyone working in this field. This is the first book on photovoltaic wet processing for silicon wafers, both mono- and multi-crystalline. The comprehensive book provides information for process, equipment, and device engineers and researchers in the solar manufacturing field. The authors of the chapters are world-class researchers and experts in their field of endeavor. The fundamentals of wet processing chemistry are introduced, covering etching, texturing, cleaning and metrology. New developments, innovative approaches, as well as current challenges are presented. Benefits of reading the book include: The book includes a detailed discussion of the important new development of black silicon, which is considered to have started a new wave in photovoltaics and become the new standard while substantially lowering the cost. Photovoltaics are central to any country’s “New Green Deal” and this book shows how to manufacture competitively. The book’s central goal is to show photovoltaic manufacturing can be done with enhanced quality and lowering costs. Audience Engineers, chemists, physicists, process technologists, in both academia and industry, that work with photovoltaics and their manufacture.
Download or read book Mean Field Magnetohydrodynamics and Dynamo Theory written by F. Krause and published by Elsevier. This book was released on 2016-01-22 with total page 272 pages. Available in PDF, EPUB and Kindle. Book excerpt: Mean-Field Magnetohydrodynamics and Dynamo Theory provides a systematic introduction to mean-field magnetohydrodynamics and the dynamo theory, along with the results achieved. Topics covered include turbulence and large-scale structures; general properties of the turbulent electromotive force; homogeneity, isotropy, and mirror symmetry of turbulent fields; and turbulent electromotive force in the case of non-vanishing mean flow. The turbulent electromotive force in the case of rotational mean motion is also considered. This book is comprised of 17 chapters and opens with an overview of the general concept of mean-field magnetohydrodynamics, followed by a discussion on the back-reaction of the magnetic field on motion; the structure of the turbulent electromotive force; homogeneous and two-scale turbulence; turbulent electromotive force in the case of rotational mean motion; and the dynamo problem of magnetohydrodynamics. The dynamo theory, which is based on mean-field magnetohydrodynamics, is explained and its applications to cosmical objects are described. The remaining chapters explore toroidal and poloidal vector fields; a simple model of an a-effect dynamo; and spherical models of turbulent dynamos as suggested by cosmical bodies. This monograph will be of interest to physicists.
