Download or read book Atmospheric Pressure Plasma written by Anton Nikiforov and published by BoD – Books on Demand. This book was released on 2019-04-24 with total page 146 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plasma as the fourth state of matter is an ionized gas consisting of both negative and positive ions, electrons, neutral atoms, radicals, and photons. In the last few decades, atmospheric-pressure plasmas have started to attract increasing attention from both scientists and industry due to a variety of potential applications. Because of increasing interest in the topic, the focus of this book is on providing engineers and scientists with a fundamental understanding of the physical and chemical properties of different atmospheric-pressure plasmas via plasma diagnostic techniques and their applications. The book has been organized into two parts. Part I focuses on the latest achievements in advanced diagnostics of different atmospheric-pressure plasmas. Part II deals with applications of different atmospheric-pressure plasmas.
Download or read book Computer Simulation of Low Pressure Plasma Discharges written by Justin David Bukowski and published by . This book was released on 1996 with total page 402 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Plasma Diagnostics written by Orlando Auciello and published by Academic Press. This book was released on 2013-10-22 with total page 470 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plasma Diagnostics, Volume 1: Discharge Parameters and Chemistry covers seven chapters on the important diagnostic techniques for plasmas and details their use in particular applications. The book discusses optical diagnostic techniques for low pressure plasmas and plasma processing; plasma diagnostics for electrical discharge light sources; as well as Langmuir probes. The text also describes the mass spectroscopy of plasmas, microwave diagnostics, paramagnetic resonance diagnostics, and diagnostics in thermal plasma processing. Electrical engineers, nuclear engineers, microwave engineers, chemists, and technical personnel in universities, industry, and national laboratories will find the book invaluable.
Download or read book Introduction to Simulation Methods for Gas Discharge Plasmas written by Ismail Rafatov and published by Myprint. This book was released on 2020-12-13 with total page 124 pages. Available in PDF, EPUB and Kindle. Book excerpt: Gas discharge plasma is the most common type of low-temperature plasma, with a large number of practical applications covering almost all areas of modern science and technology. This book is an introduction to the numerical modeling methods for gas discharge plasmas. It is intended to assist and direct graduate students and junior researchers, whose research activity deals with computational plasma physics. Topics covered include the essentials of basic modelling approaches (particle, fluid, and hybrid) for gas discharges, and the implementation of these methods with examples of glow (DC and RF) discharges. Numerical studies of nonlinear dynamics and formation of spatio-temporal patterns in gas discharge systems are also presented. Key Features Focuses solely on gas discharge plasmas Covers basic modelling techniques, including particle, fluid, and hybrid Provides details of applications and implementation for the considered methods Special emphasis is given to the applicability and reliability of different modelling techniques Provides specific examples of numerical simulations of the gas discharge plasmas
Download or read book Principles of Plasma Discharges and Materials Processing written by Michael A. Lieberman and published by John Wiley & Sons. This book was released on 2024-10-15 with total page 837 pages. Available in PDF, EPUB and Kindle. Book excerpt: A new edition of this industry classic on the principles of plasma processing Plasma-based technology and materials processes have been central to the revolution of the last half-century in micro- and nano-electronics. From anisotropic plasma etching on microprocessors, memory, and analog chips, to plasma deposition for creating solar panels and flat-panel displays, plasma-based materials processes have reached huge areas of technology. As key technologies scale down in size from the nano- to the atomic level, further developments in plasma materials processing will only become more essential. Principles of Plasma Discharges and Materials Processing is the foundational introduction to the subject. It offers detailed information and procedures for designing plasma-based equipment and analyzing plasma-based processes, with an emphasis on the abiding fundamentals. Now fully updated to reflect the latest research and data, it promises to continue as an indispensable resource for graduate students and industry professionals in a myriad of technological fields. Readers of the third edition of Principles of Plasma Discharges and Materials Processing will also find: Extensive figures and tables to facilitate understanding A new chapter covering the recent development of processes involving high-pressure capacitive discharges New subsections on discharge and processing chemistry, physics, and diagnostics Principles of Plasma Discharges and Materials Processing is ideal for professionals and process engineers in the field of plasma-assisted materials processing with experience in the field of science or engineering. It is the premiere world-wide basic text for graduate courses in the field.
Download or read book The Modelling and Characterization of Dielectric Barrier Discharge Based Cold Plasma Jets written by G Divya Deepak and published by Cambridge Scholars Publishing. This book was released on 2020-01-15 with total page 152 pages. Available in PDF, EPUB and Kindle. Book excerpt: Non-equilibrium atmospheric pressure plasma jets (APPJs) are of intense interest in current low-temperature plasma research because of their immense potential for material processing and biomedical applications. Depending on the jet configuration and the electrical excitation, plasma characteristics including heat, charged particle, electric field, and chemically active species may differ significantly. Other important parameters of importance in these studies are the kind of utilized working gas and gas flow rate. This book presents the electrical characterization of DBD-based APPJs for three electrode arrangements: ring electrode, pin electrode and floating helix electrode configurations. The analysis presented here will serve to help in establishing an optimum range of operation for a cold plasma jet without arcing and without any physical damage to the electrodes. Furthermore, the experimental results provided in the book establish the significance of the type of working gas on the power consumption and on the jet length obtained. These developed cold DBD-based APPJs of larger lengths may be useful for diverse biological applications and surface treatments.
Download or read book Low Temperature Plasma Technology written by Paul K. Chu and published by CRC Press. This book was released on 2013-07-15 with total page 497 pages. Available in PDF, EPUB and Kindle. Book excerpt: Written by a team of pioneering scientists from around the world, Low Temperature Plasma Technology: Methods and Applications brings together recent technological advances and research in the rapidly growing field of low temperature plasmas. The book provides a comprehensive overview of related phenomena such as plasma bullets, plasma penetration into biofilms, discharge-mode transition of atmospheric pressure plasmas, and self-organization of microdischarges. It describes relevant technology and diagnostics, including nanosecond pulsed discharge, cavity ringdown spectroscopy, and laser-induced fluorescence measurement, and explores the increasing research on atmospheric pressure nonequilibrium plasma jets. The authors also discuss how low temperature plasmas are used in the synthesis of nanomaterials, environmental applications, the treatment of biomaterials, and plasma medicine. This book provides a balanced and thorough treatment of the core principles, novel technology and diagnostics, and state-of-the-art applications of low temperature plasmas. It is accessible to scientists and graduate students in low-pressure plasma physics, nanotechnology, plasma medicine, and materials science. The book is also suitable as an advanced reference for senior undergraduate students.
Download or read book Plasma Jets in the Development of New Materials Technology written by O.P. Solonenko and published by CRC Press. This book was released on 2023-01-27 with total page 731 pages. Available in PDF, EPUB and Kindle. Book excerpt: The demands of industry for creating new functional materials with predetermined properties have stimulated an increasing interest in the investigation of processes occurring in plasma jets of complex chemical composition (homogeneous and heterogeneous) as well as their interaction with hard surfaces. This Proceedings volume contains contributions from leading international specialists on plasma science and technology which were presented at the 2nd International Workshop ''Plasma Jets in the Development in of New Materials Technology'', 3--9 September 1990, Frunze (USSR). The scope of the workshop incorporated the following aspects: modelling of the processes of momentum heat and mass transfer in homogeneous and heterogeneous plasma jets as well as interaction between the particles and the base; diagnostics of the parameters of gas and disperse phases in plasma flows; plasma-spraying processes investigations; processes of treatment and production of materials, including powder materials.
Download or read book Journal of Research of the National Institute of Standards and Technology written by and published by . This book was released on 1995 with total page 842 pages. Available in PDF, EPUB and Kindle. Book excerpt: Reports NIST research and development in the physical and engineering sciences in which the Institute is active. These include physics, chemistry, engineering, mathematics, and computer sciences. Emphasis on measurement methodology and the basic technology underlying standardization.
Download or read book Plasma Processing of Materials written by National Research Council and published by National Academies Press. This book was released on 1991-02-01 with total page 88 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plasma processing of materials is a critical technology to several of the largest manufacturing industries in the worldâ€"electronics, aerospace, automotive, steel, biomedical, and toxic waste management. This book describes the relationship between plasma processes and the many industrial applications, examines in detail plasma processing in the electronics industry, highlights the scientific foundation underlying this technology, and discusses education issues in this multidisciplinary field. The committee recommends a coordinated, focused, and well-funded research program in this area that involves the university, federal laboratory, and industrial sectors of the community. It also points out that because plasma processing is an integral part of the infrastructure of so many American industries, it is important for both the economy and the national security that America maintain a strong leadership role in this technology.
Download or read book Plasma Diagnostics Discharge parameters and chemistry written by Orlando Auciello and published by . This book was released on 1989 with total page 480 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1991 with total page 1460 pages. Available in PDF, EPUB and Kindle. Book excerpt: Lists citations with abstracts for aerospace related reports obtained from world wide sources and announces documents that have recently been entered into the NASA Scientific and Technical Information Database.
Download or read book Non Equilibrium Air Plasmas at Atmospheric Pressure written by K.H. Becker and published by CRC Press. This book was released on 2004-11-29 with total page 704 pages. Available in PDF, EPUB and Kindle. Book excerpt: Atmospheric-pressure plasmas continue to attract considerable research interest due to their diverse applications, including high power lasers, opening switches, novel plasma processing applications and sputtering, EM absorbers and reflectors, remediation of gaseous pollutants, excimer lamps, and other noncoherent light sources. Atmospheric-pressure plasmas in air are of particular importance as they can be generated and maintained without vacuum enclosure and without any additional feed gases. Non-Equilibrium Air Plasmas at Atmospheric Pressure reviews recent advances and applications in the generation and maintenance of atmospheric-pressure plasmas. With contributions from leading international researchers, the coverage includes advances in atmospheric-pressure plasma source development, diagnostics and characterization, air plasma chemistry, modeling and computational techniques, and an assessment of the status and prospects of atmospheric-pressure air plasma applications. The extensive application sections make this book attractive for practitioners in many fields where technologies based on atmospheric-pressure air plasmas are emerging.
Download or read book Plasma Spectroscopy written by Takashi Fujimoto and published by Clarendon Press. This book was released on 2004-06-17 with total page 300 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book focuses on the characteristics of optical radiation, or a spectrum, emitted by various plasmas. In plasma, the same atomic species can produce quite different spectra, or colours, depending on the nature of the plasma. This book gives a theoretical framework by which a particular spectrum can be interpreted correctly and coherently. The uniqueness of the book lies in its comprehensive treatment of the intensity distribution of spectral lines and the population density distribution among the atomic levels in plasmas. It is intended to provide beginners with a good perspective of the field, laying out the physics in an extremely clear manner and starting from an elementary level. A useful feature of the book is the asterisked sections and chapters which can be skipped by readers who only wish to gain a quick and basic introduction to plasma spectroscopy. It will also be useful to researchers working actively in the field, acting as a guide for carrying out experiments and interpreting experimental observations.
Download or read book Cold Plasma in Food and Agriculture written by NN Misra and published by Academic Press. This book was released on 2016-07-15 with total page 382 pages. Available in PDF, EPUB and Kindle. Book excerpt: Cold Plasma in Food and Agriculture: Fundamentals and Applications is an essential reference offering a broad perspective on a new, exciting, and growing field for the food industry. Written for researchers, industry personnel, and students interested in nonthermal food technology, this reference will lay the groundwork of plasma physics, chemistry, and technology, and their biological applications. Food scientists and food engineers interested in understanding the theory and application of nonthermal plasma for food will find this book valuable because it provides a roadmap for future developments in this emerging field. This reference is also useful for biologists, chemists, and physicists who wish to understand the fundamentals of plasma physics, chemistry, and technology and their biological interactions through applying novel plasma sources to food and other sensitive biomaterials. - Examines the topic of cold plasma technology for food applications - Demonstrates state-of-the-art developments in plasma technology and potential solutions to improve food safety and quality - Presents a solid introduction for readers on the topics of plasma physics and chemistry that are required to understand biological applications for foods - Serves as a roadmap for future developments for food scientists, food engineers, and biologists, chemists, and physicists working in this emerging field
Download or read book Plasma Catalysis written by Annemie Bogaerts and published by MDPI. This book was released on 2019-04-02 with total page 248 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plasma catalysis is gaining increasing interest for various gas conversion applications, such as CO2 conversion into value-added chemicals and fuels, N2 fixation for the synthesis of NH3 or NOx, methane conversion into higher hydrocarbons or oxygenates. It is also widely used for air pollution control (e.g., VOC remediation). Plasma catalysis allows thermodynamically difficult reactions to proceed at ambient pressure and temperature, due to activation of the gas molecules by energetic electrons created in the plasma. However, plasma is very reactive but not selective, and thus a catalyst is needed to improve the selectivity. In spite of the growing interest in plasma catalysis, the underlying mechanisms of the (possible) synergy between plasma and catalyst are not yet fully understood. Indeed, plasma catalysis is quite complicated, as the plasma will affect the catalyst and vice versa. Moreover, due to the reactive plasma environment, the most suitable catalysts will probably be different from thermal catalysts. More research is needed to better understand the plasma–catalyst interactions, in order to further improve the applications.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1995 with total page 782 pages. Available in PDF, EPUB and Kindle. Book excerpt:
