Download or read book Mixture Desigh sic and Performance Prediction of Rubber modified Asphalt in Ohio written by Robert Y. Liang and published by . This book was released on 1998 with total page 278 pages. Available in PDF, EPUB and Kindle. Book excerpt: The mixture design and performance characteristics of crumb rubber modified asphalt concretes were investigated in this research project to meet the requirements of the Intermodal Surface Transportation Efficiency Act (ISTEA) of 1991, which has required each State to incorporate scrap tire rubber into its asphalt paving materials. Specifically, the objectives of this research encompass the following: (i) investigation of the rheological properties of asphalt-rubber binder to determine optimum content of crumb rubber; (ii) development of optimum mix design for various applications, including both wet and dry mix processes; (iii) characterization of mechanical properties of recommended paving mixtures, including resilient modulus, fatigue cracking behavior, low-temperature thermal cracking resistance, water sensitivity test, incremental creep test and loaded wheel track test; and (iv) comparison of performance of selected paving mixes.
Download or read book Guidelines for Implementing NCHRP 1 37A M E Design Procedures Literature review written by and published by . This book was released on 2009 with total page 126 pages. Available in PDF, EPUB and Kindle. Book excerpt: Highway agencies across the nation are moving towards implementation of the new AASHTO Mechanistic-Empirical Pavement Design Guide (MEPDG) for pavement design. The benefits of implementing the MEPDG for routine use in Ohio includes (1) achieving more cost effective and reliable pavement designs, (2) lower initial and life cycle costs to the agency, and (3) reduced highway user impact due to lane closures for maintenance and rehabilitation of pavements. Implementation of the MEPDG is a process that requires time and agency resources (staffing, training, testing facilities including equipment, and so on). A key requirement is validating the MEPDG's nationally calibrated pavement distress and smoothness prediction models when applied under Ohio conditions and performing local calibration if needed. Feasibility of using the MEPDG's national models in Ohio was investigated under this study using data from a limited number of LTPP projects located in Ohio. Results based on limited data showed inadequate goodness of fit and significant bias in a number of the MEPDG new HMA pavement and JPCP performance prediction models. Limited recalibration of these models showed promising results indicating that a full-scale recalibration effort using a more extensive database assembled from projects located throughout the state is feasible.
Download or read book Advances in Materials and Pavement Prediction written by Eyad Masad and published by CRC Press. This book was released on 2018-07-16 with total page 879 pages. Available in PDF, EPUB and Kindle. Book excerpt: Advances in Materials and Pavement Performance Prediction contains the papers presented at the International Conference on Advances in Materials and Pavement Performance Prediction (AM3P, Doha, Qatar, 16- 18 April 2018). There has been an increasing emphasis internationally in the design and construction of sustainable pavement systems. Advances in Materials and Pavement Prediction reflects this development highlighting various approaches to predict pavement performance. The contributions discuss links and interactions between material characterization methods, empirical predictions, mechanistic modeling, and statistically-sound calibration and validation methods. There is also emphasis on comparisons between modeling results and observed performance. The topics of the book include (but are not limited to): • Experimental laboratory material characterization • Field measurements and in situ material characterization • Constitutive modeling and simulation • Innovative pavement materials and interface systems • Non-destructive measurement techniques • Surface characterization, tire-surface interaction, pavement noise • Pavement rehabilitation • Case studies Advances in Materials and Pavement Performance Prediction will be of interest to academics and engineers involved in pavement engineering.
Download or read book Transportation Research Record written by and published by . This book was released on 1996 with total page 680 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Guidelines for Implementing NCHRP 1 37A M E Design Procedures Summary of findings implementation plan and next steps written by and published by . This book was released on 2009 with total page 114 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Ohio Documents written by and published by . This book was released on 1997 with total page 98 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book An Exploratory Study on Functionally Graded Materials with Application to Multilayered Pavement Design written by Ernian Pan and published by . This book was released on 2007 with total page 308 pages. Available in PDF, EPUB and Kindle. Book excerpt: The response of flexible pavement is largely influenced by the resilient modulus of the pavement profile. Different methods/approaches have been adopted in order to estimate or measure the resilient modulus of each layer assuming an average modulus within the layer. In order to account for the variation in the modulus of elasticity with depth within a layer in elastic pavement analysis, which is due to temperature or moisture variation with depth, the layer should be divided into several sublayers and the modulus should be gradually varied between the layers. A powerful and innovative computer program has been developed for elastic pavement analysis that overcomes the limitations of the existing pavement analysis programs. The new program can predict accurately and efficiently the response of the pavement consisted of any number of layers/sublayers and any number of loads. The complexity of the tire-pavement loading configuration can be modeled easily as well. Practical pavement engineering problems have been analyzed and discussed taking into consideration the modulus variation with depth as well as the complex tire-pavement loading configuration utilizing our newly developed MultiSmart3D program. The analyzed problems illustrated that powerful analytical tools, such as MultiSmart3D, are needed to study and predict the pavement response in practical and fast manners. For example, the predicted life time of the pavement can be increased or decreased by a factor more than two if the modulus of elasticity variation with depth is taken into consideration.
Download or read book Focus written by and published by . This book was released on 2008 with total page 168 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book State Planning and Research Program written by and published by . This book was released on 1999 with total page 128 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Development and Validation of Performance Prediction Models and Specifications for Asphalt Binders and Paving Mixes written by Robert L. Lytton and published by Strategic Highway Research Program (Shrp). This book was released on 1993 with total page 500 pages. Available in PDF, EPUB and Kindle. Book excerpt: A result of the Strategic Highway Research Program's asphalt research is the development of performance-based specifications for asphalt binders and mixtures to control 3 distress modes: rutting; fatigue cracking; and thermal cracking. The SHRP A-005 project developed detailed pavement performance models to support these binder and mixture specifications and performance-based mixture designs. This report documents the findings of this extensive research effort and provides supporting data for the performance-based specifications and mixture design procedure called SUPERPAVE. The A-005 contract developed and used a sophisticated, mechanistic-based pavement performance model to define the relationships between asphalt binder and mixture properties and pavement distress. A comprehensive pavement performance model was developed that predicts the amount of fatigue cracking, thermal cracking and rutting in asphalt concrete pavements with time, using results from the accelerated laboratory tests. The pavement performance models for each distress were also used to confirm the relevant binder and mixture properties established by other SHRP contractors. The model has 3 parts: a mixture evaluation model; a pavement response model; and a pavement distress model.
Download or read book Testing the HB2060 Pads written by Vishal Gossain and published by . This book was released on 2006 with total page 90 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Waste Tire Recycling and Reuse in Pennsylvania written by Pennsylvania. General Assembly. Joint State Government Commission and published by . This book was released on 2007 with total page 180 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Superpave Mix Design written by Asphalt Institute and published by . This book was released on 2001-01-01 with total page 102 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advances in Asphalt Materials written by Shin-Che Huang and published by Woodhead Publishing. This book was released on 2015-04-08 with total page 493 pages. Available in PDF, EPUB and Kindle. Book excerpt: The urgent need for infrastructure rehabilitation and maintenance has led to a rise in the levels of research into bituminous materials. Breakthroughs in sustainable and environmentally friendly bituminous materials are certain to have a significant impact on national economies and energy sustainability. This book will provide a comprehensive review on recent advances in research and technological developments in bituminous materials. Opening with an introductory chapter on asphalt materials and a section on the perspective of bituminous binder specifications, Part One covers the physiochemical characterisation and analysis of asphalt materials. Part Two reviews the range of distress (damage) mechanisms in asphalt materials, with chapters covering cracking, deformation, fatigue cracking and healing of asphalt mixtures, as well as moisture damage and the multiscale oxidative aging modelling approach for asphalt concrete. The final section of this book investigates alternative asphalt materials. Chapters within this section review such aspects as alternative binders for asphalt pavements such as bio binders and RAP, paving with asphalt emulsions and aggregate grading optimization. - Provides an insight into advances and techniques for bituminous materials - Comprehensively reviews the physicochemical characteristics of bituminous materials - Investigate asphalt materials on the nano-scale, including how RAP/RAS materials can be recycled and how asphalt materials can self-heal and rejuvenator selection
Download or read book Government Reports Announcements Index written by and published by . This book was released on 1995 with total page 872 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Guide for Pavement Friction written by and published by AASHTO. This book was released on 2008 with total page 87 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report contains guidelines and recommendations for managing and designing for friction on highway pavements. The contents of this report will be of interest to highway materials, construction, pavement management, safety, design, and research engineers, as well as others concerned with the friction and related surface characteristics of highway pavements.
Download or read book Road Engineering for Development written by Richard Robinson and published by CRC Press. This book was released on 2018-10-09 with total page 539 pages. Available in PDF, EPUB and Kindle. Book excerpt: Developing countries in the tropics have different natural conditions and different institutional and financial situations to industrialized countries. However, most textbooks on highway engineering are based on experience from industrialized countries with temperate climates, and deal only with specific problems. Road Engineering for Development (published as Highway and Traffic Engineering in Developing Countries in its first edition) provides a comprehensive description of the planning, design, construction and maintenance of roads in developing countries. It covers a wide range of technical and non-technical problems that may confront road engineers working in this area. The technical content of the book has been fully updated and current development issues are focused on. Designed as a fundamental text for civil engineering students this book also offers a broad, practical view of the subject for practising engineers. It has been written with the assistance of a number of world-renowned specialist professional engineers with many years experience in Africa, the Middle East, Asia and Central America.
