Download or read book Large Eddy Simulation of Premixed Combustion Using Flamelets written by Ivan Langella and published by . This book was released on 2016 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Large Eddy Simulation of Premixed and Partially Premixed Combustion written by Ionuţ Porumbel and published by . This book was released on 2006 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Large Eddy Simulation (LES) of bluff body stabilized premixed and partially premixed combustion close to the flammability limit is carried out in this thesis. The LES algorithm has no ad-hoc adjustable model parameters and is able to respond automatically to variations in the inflow conditions. Algorithm validation is achieved by comparison with reactive and non-reactive experimental data. In the reactive flow, two scalar closure models, Eddy Break-Up (EBULES) and Linear Eddy Mixing (LEMLES), are used and compared. Over important regions, the flame lies in the Broken Reaction Zone regime. Here, the EBU model assumptions fail. The flame thickness predicted by LEMLES is smaller and the flame is faster to respond to turbulent fluctuations, resulting in a more significant wrinkling of the flame surface. As a result, LEMLES captures better the subtle effects of the flame-turbulence interaction. Three premixed (equivalence ratio = 0.6, 0.65, and 0.75) cases are simulated. For the leaner case, the flame temperature is lower, the heat release is reduced and vorticity is stronger. As a result, the flame in this case is found to be unstable. In the rich case, the flame temperature is higher, and the spreading rate of the wake is increased due to the higher amount of heat release Partially premixed combustion is simulated for cases where the transverse profile of the inflow equivalence ratio is variable. The simulations show that for mixtures leaner in the core the vortical pattern tends towards anti-symmetry and the heat release decreases, resulting also in instability of the flame. For mixtures richer in the core, the flame displays sinusoidal flapping resulting in larger wake spreading. More accurate predictions of flame stability will require the use of detailed chemistry, raising the computational cost of the simulation. To address this issue, a novel algorithm for training Artificial Neural Networks (ANN) for prediction of the chemical source terms has been implemented and tested. Compared to earlier methods, the main advantages of the ANN method are in CPU time and disk space and memory reduction.
Download or read book Turbulent Combustion Modeling written by Tarek Echekki and published by Springer Science & Business Media. This book was released on 2010-12-25 with total page 496 pages. Available in PDF, EPUB and Kindle. Book excerpt: Turbulent combustion sits at the interface of two important nonlinear, multiscale phenomena: chemistry and turbulence. Its study is extremely timely in view of the need to develop new combustion technologies in order to address challenges associated with climate change, energy source uncertainty, and air pollution. Despite the fact that modeling of turbulent combustion is a subject that has been researched for a number of years, its complexity implies that key issues are still eluding, and a theoretical description that is accurate enough to make turbulent combustion models rigorous and quantitative for industrial use is still lacking. In this book, prominent experts review most of the available approaches in modeling turbulent combustion, with particular focus on the exploding increase in computational resources that has allowed the simulation of increasingly detailed phenomena. The relevant algorithms are presented, the theoretical methods are explained, and various application examples are given. The book is intended for a relatively broad audience, including seasoned researchers and graduate students in engineering, applied mathematics and computational science, engine designers and computational fluid dynamics (CFD) practitioners, scientists at funding agencies, and anyone wishing to understand the state-of-the-art and the future directions of this scientifically challenging and practically important field.
Download or read book Turbulent Premixed Flames written by Nedunchezhian Swaminathan and published by Cambridge University Press. This book was released on 2011-04-25 with total page 447 pages. Available in PDF, EPUB and Kindle. Book excerpt: A work on turbulent premixed combustion is important because of increased concern about the environmental impact of combustion and the search for new combustion concepts and technologies. An improved understanding of lean fuel turbulent premixed flames must play a central role in the fundamental science of these new concepts. Lean premixed flames have the potential to offer ultra-low emission levels, but they are notoriously susceptible to combustion oscillations. Thus, sophisticated control measures are inevitably required. The editors' intent is to set out the modeling aspects in the field of turbulent premixed combustion. Good progress has been made on this topic, and this cohesive volume contains contributions from international experts on various subtopics of the lean premixed flame problem.
Download or read book Large Eddy Simulation of Premixed Combustion written by John F. Keays and published by . This book was released on 2007 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Large Eddy Simulation of Premixed and Non premixed Combustion in a Stagnation Point Reverse Flow Combustor written by Satish Undapalli and published by . This book was released on 2008 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A new combustor, referred to as Stagnation Point Reverse Flow (SPRF) combustor has been developed at Georgia Tech to meet increasingly stringent emission regulations. The combustor incorporates a novel design to meet the conflicting requirements of low pollution and high efficiency in both premixed and non-premixed modes. The objective of this thesis is to perform Large Eddy Simulations (LES) on this lab-scale combustor and explain the underlying physics. To achieve this, numerical simulations are performed in both the premixed and non-premixed combustion modes. The velocity field, species field, entrainment characteristics, flame structure, emissions and mixing characteristics are then analyzed. Simulations have been carried out first for a non-reactive case and the flow features in the combustor are analyzed. Next, the simulations have been extended for the premixed reactive case by employing different sub-grid scale combustion chemistry closures - Eddy Break Up (EBU), Artificially Thickened Flame (TF) and Linear Eddy Mixing (LEM) models. Only LEMLES which is an advanced scalar approach is able to accurately predict both the velocity and species field in the combustor. The results from LEM with LES (LEMLES) using a reduced chemical mechanism have been analyzed in the premixed mode. The results showed that mass entrainment occurs along the shear layer in the combustor. The entrained mass carried products into the reactant stream and provided preheating. The product entrainment enhances the reaction rates and stabilizes the flame even at very lean conditions. These products are shown to enter into the flame through local extinction zones present on the flame surface. The flame structure is further analyzed and the combustion mode is found to be primarily in thin reaction zones. The emissions in the combustor are studied using simple global mechanisms for NOx. Computations show extremely low NOx values comparable to the measured emissions. These low emissions are shown to be primarily due to the low temperatures in the combustor. LEMLES computations are also performed with detailed chemistry to capture more accurately the flame structure. The flame in the detailed chemistry case is more sensitive to strain effects and show more extinction zones very near to the injector. LEMLES approach is also used to resolve the combustion mode in the non-premixed case. The studies indicate that mixing of fuel and air close to the injector controls the combustion process. The predictions in the near field are shown to be very sensitive to the inflow conditions. Analysis shows that fuel and air mixing occurs to lean proportions in the combustor before any burning takes place. The flame structure in the non-premixed mode is very similar to the premixed mode. Along with fuel-air mixing, the products also mix with the reactants and provide the preheating effects to stabilize the flame in the downstream region of the combustor.
Download or read book Large Eddy Simulation of Turbulent Premixed Combustion in Gas Turbines written by Ashoke De and published by . This book was released on 2010 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Turbulent Combustion written by Norbert Peters and published by Cambridge University Press. This book was released on 2000-08-15 with total page 322 pages. Available in PDF, EPUB and Kindle. Book excerpt: The combustion of fossil fuels remains a key technology for the foreseeable future. It is therefore important that we understand the mechanisms of combustion and, in particular, the role of turbulence within this process. Combustion always takes place within a turbulent flow field for two reasons: turbulence increases the mixing process and enhances combustion, but at the same time combustion releases heat which generates flow instability through buoyancy, thus enhancing the transition to turbulence. The four chapters of this book present a thorough introduction to the field of turbulent combustion. After an overview of modeling approaches, the three remaining chapters consider the three distinct cases of premixed, non-premixed, and partially premixed combustion, respectively. This book will be of value to researchers and students of engineering and applied mathematics by demonstrating the current theories of turbulent combustion within a unified presentation of the field.
Download or read book Large Eddy Simulation of Premixed Combustion Using Artificial Flame Thickening Coupled with Tabulated Chemistry written by Guido Künne and published by . This book was released on 2012 with total page 282 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Large Eddy Simulations of Premixed Turbulent Flame Dynamics written by Gaurav Kewlani and published by . This book was released on 2014 with total page 300 pages. Available in PDF, EPUB and Kindle. Book excerpt: High efficiency, low emissions and stable operation over a wide range of conditions are some of the key requirements of modem-day combustors. To achieve these objectives, lean premixed flames are generally preferred as they achieve efficient and clean combustion. A drawback of lean premixed combustion, however, is that the flames are more prone to dynamics. The unsteady release of sensible heat and flow dilatation in combustion processes create pressure fluctuations which, particularly in premixed flames, can couple with the acoustics of the combustion system. This acoustic coupling creates a feedback loop with the heat release that can lead to severe thermoacoustic instabilities that can damage the combustor. Understanding these dynamics, predicting their onset and proposing passive and active control strategies are critical to large-scale implementation. For the numerical study of such systems, large eddy simulation (LES) techniques with appropriate combustion models and reaction mechanisms are highly appropriate. These approaches balance the computational complexity and predictive accuracy. This work, therefore, aims to explore the applicability of these methods to the study of premixed wake stabilized flames. Specifically, finite rate chemistry LES models that can effectively capture the interaction between different turbulent scales and the combustion fronts have been implemented, and applied for the analysis of premixed turbulent flame dynamics in laboratory-scale combustor configurations. Firstly, the artificial flame thickening approach, along with an appropriate reduced chemistry mechanism, is utilized for modeling turbulence-combustion interactions at small scales. A novel dynamic formulation is proposed that explicitly incorporates the influence of strain on flame wrinkling by solving a transport equation for the latter rather than using local-equilibrium-based algebraic models. Additionally, a multiple-step combustion chemistry mechanism is used for the simulations. Secondly, the presumed-PDF approach, coupled with the flamelet generated manifold (FGM) technique, is also implemented for modeling turbulence-combustion interactions. The proposed formulation explicitly incorporates the influence of strain via the scalar dissipation rate and can result in more accurate predictions especially for highly unsteady flame configurations. Specifically, the dissipation rate is incorporated as an additional coordinate to presume the PDF and strained flamelets are utilized to generate the chemistry databases. These LES solvers have been developed and applied for the analysis of reacting flows in several combustor configurations, i.e. triangular bluff body in a rectangular channel, backward facing step configuration, axi-symmetric bluff body in cylindrical chamber, and cylindrical sudden expansion with swirl, and their performance has been be validated against experimental observations. Subsequently, the impact of the equivalence ratio variation on flame-flow dynamics is studied for the swirl configuration using the experimental PIV data as well as the numerical LES code, following which dynamic mode decomposition of the flow field is performed. It is observed that increasing the equivalence ratio can appreciably influence the dominant flow features in the wake region, including the size and shape of the recirculation zone(s), as well as the flame dynamics. Specifically, varying the heat loading results in altering the dominant flame stabilization mechanism, thereby causing transitions across distinct- flame configurations, while also modifying the inner recirculation zone topology significantly. Additionally, the LES framework has also been applied to gain an insight into the combustion dynamics phenomena for the backward-facing step configuration. Apart from evaluating the influence of equivalence ratio on the combustion process for stable flames, the flame-flow interactions in acoustically forced scenarios are also analyzed using LES and dynamic mode decomposition (DMD). Specifically, numerical simulations are performed corresponding to a selfexcited combustion instability configuration as observed in the experiments, and it is observed that LES is able to suitably capture the flame dynamics. These insights highlight the effect of heat release variation on flame-flow interactions in wall-confined combustor configurations, which can significantly impact combustion stability in acoustically-coupled systems. The fidelity of the solvers in predicting the system response to variation in heat loading and to acoustic forcing suggests that the LES framework can be suitably applied for the analysis of flame dynamics as well as to understand the fundamental mechanisms responsible for combustion instability. KEY WORDS - large eddy simulation, LES, wake stabilized flame, turbulent premixed combustion, combustion modeling, artificially thickened flame model, triangular bluff body, backward facing step combustor, presumed-PDF model, flamelet generated manifold, axi-symmetric bluff body, cylindrical swirl combustor, particle image velocimetry, dynamic mode decomposition, combustion instability, forced response.
Download or read book Large eddy Simulation of Premixed Turbulent Combustion Using Flame Surface Density Approach written by Wen Lin and published by . This book was released on 2010 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Large Eddy Simulation of Premixed Turbulent Combustion written by Evatt Hawkes and published by . This book was released on 2000 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Large Eddy Simulations of Turbulence written by M. Lesieur and published by Cambridge University Press. This book was released on 2005-08-22 with total page 240 pages. Available in PDF, EPUB and Kindle. Book excerpt: Large-Eddy Simulations of Turbulence is a reference for LES, direct numerical simulation and Reynolds-averaged Navier-Stokes simulation.
Download or read book Turbulence and Interactions written by Michel Deville and published by Springer Science & Business Media. This book was released on 2009-03-20 with total page 166 pages. Available in PDF, EPUB and Kindle. Book excerpt: Contains seven keynote lectures of the TI 2006 conference that was held in Porquerolles, May 29-June 2, 2006. This book offers a view on theory, experiments and numerical simulations in the field of turbulence.
Download or read book Large Eddy Simulation of Premixed Turbulent Combustion written by Evatt Hawkes and published by . This book was released on 2000 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Subfilter Scale Combustion Modelling for Large Eddy Simulation of Turbulent Premixed Flames written by Nasim Shahbazian and published by . This book was released on 2015 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Large Eddy Simulation of Turbulent Premixed and Partially Premixed Combustion written by Eric Baudoin and published by . This book was released on 2010 with total page 63 pages. Available in PDF, EPUB and Kindle. Book excerpt:
