Download or read book Knocking Combustion Observed in a Spark ignition Engine with Simultaneous Direct and Schlieren High speed Motion Pictures and Pressure Records written by Gordon E. Osterstrom and published by . This book was released on 1948 with total page 66 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report support simultaneous direct and schlieren photographs at 40,000 frames a second and correlated pressure records taken of knocking combustion in a special spark-ignition engine to ascertain intensity of certain end-zone reactions previously seen by schlieren photography alone.
Download or read book Knocking Combustion Observed in a Spark ignition Engine with Simultaneous Direct and Schilieren High speed Motion Pictures and Pressure Recorders written by Benjamin Pinkel and published by . This book was released on 1947 with total page 210 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Analysis of Spark ignition Engine Knock as Seen in Photographs Taken at 200 000 Frames a Second written by Cearcy D. Miller and published by . This book was released on 1946 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt: A motion-picture of the development of knock in a spark-ignition engine is presented, which consists of 20 photographs taken at intervals of 5 microseconds, or at a rate of 200,000 photographs a second, with an equivalent wide-open exposure time of 6.4 microseconds for each photograph. A motion picture of a complete combustion process, including the development of knock, taken at the rate of 40,000 photographs a second is also presented to assist the reader in orienting the photographs of the knock development taken at 200,000 frames per second are analyzed and the conclusion is made that the type of knock in the spark-ignition engine involving violent gas vibration originates as a self-propagating disturbance starting at a point in the burning or autoigniting gases and spreading out from that point through the incompletely burned gases at a rate as high as 6800 feet per second, or about twice the speed of sound in the burned gases. Apparent formation of free carbon particles in both the burning and the burned gas is observed within 10 microseconds after passage of the knock disturbance through the gases.
Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1950 with total page 578 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Relation Between Spark ignition Engine Knock Detonation Waves and Autoignition as Shown by High speed Photography written by Cearcy D. Miller and published by . This book was released on 1946 with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt: A critical review of literature bearing on the autoignition and detonation-wave theories of spark-ignition engine knock and on the nature of gas vibrations associated with combustion and knock results in the conclusion that neither the autoignition theory nor the detonation-wave theory is an adequate explanation of spark-ignition engine knock. A knock theory is proposed, combining the autoignition and detonation-wave theories, introducing the idea that the detonation wave develops in autoignited or afterburning gases, and ascribing comparatively low-pitched heavy knocks to autoignition but high-pitched pinging knocks to detonation waves with the possibility of combinations of the two types of knock.
Download or read book Report National Advisory Committee for Aeronautics written by United States. National Advisory Committee for Aeronautics and published by . This book was released on 1948 with total page 664 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Report written by United States. National Advisory Committee for Aeronautics and published by . This book was released on 1948 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Annual Report of the National Advisory Committee for Aeronautics written by United States. National Advisory Committee for Aeronautics and published by . This book was released on 1951 with total page 664 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerospace Engineering Index written by and published by . This book was released on 1951 with total page 612 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Knocking in Gasoline Engines written by Michael Günther and published by Springer. This book was released on 2017-11-21 with total page 384 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book includes the papers presented at the conference discussing approaches to prevent or reliably control knocking and other irregular combustion events. The majority of today’s highly efficient gasoline engines utilize downsizing. High mean pressures produce increased knocking, which frequently results in a reduction in the compression ratio at high specific powers. Beyond this, the phenomenon of pre-ignition has been linked to the rise in specific power in gasoline engines for many years. Charge-diluted concepts with high compression cause extreme knocking, potentially leading to catastrophic failure. The introduction of RDE legislation this year will further grow the requirements for combustion process development, as residual gas scavenging and enrichment to improve the knock limit will be legally restricted despite no relaxation of the need to reach the main center of heat release as early as possible. New solutions in thermodynamics and control engineering are urgently needed to further increase the efficiency of gasoline engines.
Download or read book End zone Water Injection as a Means of Suppressing Knock in a Spark ignition Engine written by Rinaldo J. Brun and published by . This book was released on 1944 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt: Summary: An investigation has been made of the effectiveness of water injection into the combustion end zone of a spark-ignition engine cylinder for the suppression of knock. Pressure-time recoreds obtained show that injection of water at 60° B.T.C. on the compression stroke at a water-fuel ratio of 0.3 rendered M-3 fuel as good as S-3 fuel from an antiknock consideration. The optimum crank angle for injection of water into the end zone was found to be critical. As the injection angle was increased beyond the optimum, the quantity of water required to suppress knock increased to 3.6 water-fuel ratio at 132° B.T.C. The water quantity could not be increased beyond 3.6 water-fuel ration because of injection-pump limitations; however, a further increase in the injection angle up to the earliest angle obtainable, which was 20° A.T.C. on the intake stroke, continuously increased the knock intensity. The engine operating conditions of the tests did not simulate those encountered in flight, especially with regard to the operating speed of 570 rpm. For this reason the results should only be regarded as of theoretical importance until further investigation has been made.
Download or read book Relation Between Spark ignition Engine Knock Detonation Waves and Autoignition as Shown by High speed Photography written by Cearcy D. Miller and published by . This book was released on 1949 with total page 27 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book High Speed Internal Combustion Engines written by Arthur William Judge and published by . This book was released on 1918 with total page 372 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Calculations of the Performance of a Compression ignition Engine compressor Turbine Combination written by J. C. Sanders and published by . This book was released on 1945 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt: Small high-speed single-cylinder compression-ignition engines were tested to determine their performance characteristics under high supercharging. Calculations were made on the energy available in the exhaust gas of the compression-ignition engines. The maximum power at any given maximum cylinder pressure was obtained when the compression pressure was equal to the maximum cylinder pressure. Constant-pressure combustion was found possible at an engine speed of 2200 rpm. Exhaust pressures and temperatures were determined from an analysis of indicator cards. The analysis showed that, at rich mixtures with the exhaust back pressure equal to the inlet-air pressure, there is excess energy available for driving a turbine over that required for supercharging. The presence of this excess energy indicates that a highly supercharged compression-ignition engine might be desirable as a compressor and combustion chamber for a turbine.
Download or read book Combustion Systems of High speed Piston I C Engines written by Andrzej Kowalewicz and published by . This book was released on 1984 with total page 392 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Principles of Electric Spark Ignition in Internal Combustion Engines written by John David Morgan and published by . This book was released on 1920 with total page 104 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Mixture Formation in Spark Ignition Engines written by Hans Peter Lenz and published by Springer. This book was released on 2013-11-11 with total page 417 pages. Available in PDF, EPUB and Kindle. Book excerpt: Twentyfour years have gone by since the publication of K. Lohner and H. Muller's comprehen sive work "Gemischbildung und Verbrennung im Ottomotor" in 1967 [1.1]' Naturally, the field of mixture formation and combustion in the spark-ignition engine has wit nessed great technological advances and many new findings in the intervening years, so that the time seemed ripe for presenting a summary of recent research and developments. There fore, I gladly took up the suggestion of the editors of this series of books, Professor Dr. H. List and Professor Dr. A. Pischinger, to write a book summarizing the present state of the art. A center of activity of the Institute of Internal-Combustion Engines and Automotive Engineering at the Vienna Technical University, which I am heading, is the field of mixture formation -there fore, many new results that have been achieved in this area in collaboration with the respective industry have been included in this volume. The basic principles of combustion are discussed only to that extent which seemect necessary for an understanding of the effects of mixture formation. The focal point of this volume is the mixture formation in spark-ignition engines, covering both the theory and actual design of the mixture formation units and appropriate intake manifolds. Also, the related measurement technology is explained in this work.
