Download or read book Investigation of Flow Instabilities in the Inlet Ducts of DP 1C VTOL Aircraft written by National Aeronaut Administration (Nasa) and published by . This book was released on 2020-08-07 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt: Technical Report Lepicovsky, Jan Glenn Research Center NASA/CR-2008-215216, E-16504 NNC06BA07B; WBS 561581.02.08.03.11.01 FLOW VISUALIZATION; ENGINE TESTS; FLOW STABILITY; ENGINE INLETS; VERTICAL LANDING; DUCTS; VERTICAL TAKEOFF AIRCRAFT; PROPULSION SYSTEM PERFORMANCE; NOSE WHEELS; INLET FLOW; INGESTION (ENGINES); UNDERCARRIAGES
Download or read book Investigations of Flow Instabilities in the Inlet Ducts of DP 1C VTOL Aircraft written by Jan Lepicovsky and published by . This book was released on 2008 with total page 43 pages. Available in PDF, EPUB and Kindle. Book excerpt: An investigation of flow instabilities in the inlet ducts of a two-engine vertical takeoff and landing aircraft DP-1C is described in this report. Recent tests revealed that the engines stall during run ups while the aircraft is operating on the ground. These pop stalls occurred at relatively low power levels, sometimes as low as 60 percent of the engine full speed. Inability to run the engines up to the full speed level is attributed to in-ground effects associated with hot gas ingestion. Such pop stalls were never experienced when the aircraft was tested on a elevated grid platform, which ensured that the aircraft was operating in out-of-the-ground-effect conditions. Based on available information on problems experienced with other vertical takeoff and landing aircraft designs, it was assumed that the engine stalls were caused by partial ingestion of hot gases streaming forward from the main exit nozzle under the aircraft inlets, which are very close to the ground. After running a short three-day series of tests with fully instrumented engine inlets, it is now believed the most probable reason for engine pop stalls are random ingestions of a vortex generated between the two streams moving in opposite directions: outbound hot gas stream from the main nozzle close to the ground and inbound inlet flow above.
Download or read book Experimental Investigation of Flow Control Within a Compact Inlet Duct written by Brian W. Debronsky and published by . This book was released on 2012 with total page 136 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aeroacoustics of Flight Vehicles written by Harvey H. Hubbard and published by . This book was released on 1991 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerodynamics of V STOL Flight written by Barnes Warnock McCormick and published by Courier Corporation. This book was released on 1999-01-01 with total page 356 pages. Available in PDF, EPUB and Kindle. Book excerpt: An extremely practical overview of V/STOL (vertical/short takeoff and landing) aerodynamics, this volume offers a presentation of general theoretical and applied aerodynamic principles, covering propeller and helicopter rotor theory for both the static and forward flight cases. Both a text for students and a reference for professionals, the book can be used for advanced undergraduate or graduate courses. Numerous detailed figures, plus exercises. 1967 edition. Preface. Appendix. Index.
Download or read book Propulsion and Power written by Joachim Kurzke and published by Springer. This book was released on 2018-05-28 with total page 766 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book is written for engineers and students who wish to address the preliminary design of gas turbine engines, as well as the associated performance calculations, in a practical manner. A basic knowledge of thermodynamics and turbomachinery is a prerequisite for understanding the concepts and ideas described. The book is also intended for teachers as a source of information for lecture materials and exercises for their students. It is extensively illustrated with examples and data from real engine cycles, all of which can be reproduced with GasTurb (TM). It discusses the practical application of thermodynamic, aerodynamic and mechanical principles. The authors describe the theoretical background of the simulation elements and the relevant correlations through which they are applied, however they refrain from detailed scientific derivations.
Download or read book Aeronautical Engineer s Data Book written by Cliff Matthews and published by Elsevier. This book was released on 2001-10-17 with total page 282 pages. Available in PDF, EPUB and Kindle. Book excerpt: Aeronautical Engineer's Data Bookis an essential handy guide containing useful up to date information regularly needed by the student or practising engineer. Covering all aspects of aircraft, both fixed wing and rotary craft, this pocket book provides quick access to useful aeronautical engineering data and sources of information for further in-depth information. Quick reference to essential data Most up to date information available
Download or read book Understanding Aerospace Chemical Propulsion written by H. S. Mukunda and published by . This book was released on 2017-02-28 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Explores aeronautical and space chemical propulsion. The book provides an understanding of propulsion systems through illustrative description of the systems; analysis of modeled systems; examination of the performance of real systems in this light; and a comparative assessment of aeronautical and space propulsion system elements.
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1991 with total page 296 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fundamentals of Aircraft and Rocket Propulsion written by Ahmed F. El-Sayed and published by Springer. This book was released on 2016-05-25 with total page 1025 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a comprehensive basics-to-advanced course in an aero-thermal science vital to the design of engines for either type of craft. The text classifies engines powering aircraft and single/multi-stage rockets, and derives performance parameters for both from basic aerodynamics and thermodynamics laws. Each type of engine is analyzed for optimum performance goals, and mission-appropriate engines selection is explained. Fundamentals of Aircraft and Rocket Propulsion provides information about and analyses of: thermodynamic cycles of shaft engines (piston, turboprop, turboshaft and propfan); jet engines (pulsejet, pulse detonation engine, ramjet, scramjet, turbojet and turbofan); chemical and non-chemical rocket engines; conceptual design of modular rocket engines (combustor, nozzle and turbopumps); and conceptual design of different modules of aero-engines in their design and off-design state. Aimed at graduate and final-year undergraduate students, this textbook provides a thorough grounding in the history and classification of both aircraft and rocket engines, important design features of all the engines detailed, and particular consideration of special aircraft such as unmanned aerial and short/vertical takeoff and landing aircraft. End-of-chapter exercises make this a valuable student resource, and the provision of a downloadable solutions manual will be of further benefit for course instructors.
Download or read book Gas Turbine Performance written by Philip P. Walsh and published by John Wiley & Sons. This book was released on 2008-04-15 with total page 664 pages. Available in PDF, EPUB and Kindle. Book excerpt: A significant addition to the literature on gas turbine technology, the second edition of Gas Turbine Performance is a lengthy text covering product advances and technological developments. Including extensive figures, charts, tables and formulae, this book will interest everyone concerned with gas turbine technology, whether they are designers, marketing staff or users.
Download or read book Marine Propellers and Propulsion written by John Carlton and published by Butterworth-Heinemann. This book was released on 2012-10-30 with total page 539 pages. Available in PDF, EPUB and Kindle. Book excerpt: The early development of the screw propeller. Propeller geometry. The propeller environment. The ship wake field, propeller performance characteristics.
Download or read book Distributed Propulsion Technology written by Amir S. Gohardani and published by Nova Science Publishers. This book was released on 2014 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Distributed propulsion technology is one of the revolutionary candidates for future aircraft propulsion. In this book, which serves as the very first reference book on distributed propulsion technology, the potential role of distributed propulsion technology in future aviation is investigated. Following a historical journey that revisits distributed propulsion technology in unmanned air vehicles, commercial aircrafts, and military aircrafts, features of this specific technology are highlighted in synergy with an electric aircraft concept and a first-of-its-kind comparison between commercial and military aircrafts employing distributed propulsion arrangements. In light of propulsionairframe integration and complementary technologies, such as boundary layer ingestion, thrust vectoring and circulation control, transpired opportunities and challenges are addressed in addition to a number of identified research directions proposed for future aircrafts. Moreover, a diverse set of distributed propulsion arrangements are considered. These include: small engines, gas-driven multi-fan architectures, turboelectric systems featuring superconductive and non-superconducting electrical machine technology, and electromagnetic fans. This book features contributions by the National Aeronautics and Space Administration (NASA) and the United States Air Force (USAF), and includes the first proposed official definition for distributed propulsion technology in subsonic fixed wing aircrafts.
Download or read book Aerodynamics Aeronautics and Flight Mechanics written by Barnes W. McCormick and published by John Wiley & Sons. This book was released on 1994-09-28 with total page 677 pages. Available in PDF, EPUB and Kindle. Book excerpt: A New Edition of the Most Effective Text/Reference in the Field! Aerodynamics, Aeronautics, and Flight Mechanics, Second Edition Barnes W. McCormick, Pennsylvania State University 57506-2 When the first edition of Aerodynamics, Aeronautics, and Flight Mechanics was published, it quickly became one of the most important teaching and reference tools in the field. Not only did generations of students learn from it, they continue to use it on the job-the first edition remains one of the most well-thumbed guides you'll find in an airplane company. Now this classic text/reference is available in a bold new edition. All new material and the interweaving of the computer throughout make the Second Edition even more practical and current than before! A New Edition as Complete and Applied as the First Both analytical and applied in nature, Aerodynamics, Aeronautics, and Flight Mechanics presents all necessary derivations to understand basic principles and then applies this material to specific examples. You'll find complete coverage of the full range of topics, from aerodynamics to propulsion to performance to stability and control. Plus, the new Second Edition boasts the same careful integration of concepts that was an acclaimed feature of the previous edition. For example, Chapters 9, 10, and 11 give a fully integrated presentation of static, dynamic, and automatic stability and control. These three chapters form the basis of a complete course on stability and control. New Features You'll Find in the Second Edition * A new chapter on helicopter and V/STOL aircraft- introduces a phase of aerodynamics not covered in most current texts * Even more material than the previous edition, including coverage of stealth airplanes and delta wings * Extensive use of the computer throughout- each chapter now contains several computer exercises * A computer disk with programs written by the author is available
Download or read book Aircraft Design written by Daniel P. Raymer and published by AIAA (American Institute of Aeronautics & Astronautics). This book was released on 2006 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Winner of the Summerfield Book Award Winner of the Aviation-Space Writers Association Award of Excellence. --Over 30,000 copies sold, consistently the top-selling AIAA textbook title This highly regarded textbook presents the entire process of aircraft conceptual designfrom requirements definition to initial sizing, configuration layout, analysis, sizing, and trade studiesin the same manner seen in industry aircraft design groups. Interesting and easy to read, the book has more than 800 pages of design methods, illustrations, tips, explanations, and equations, and extensive appendices with key data essential to design. It is the required design text at numerous universities around the world, and is a favorite of practicing design engineers.
Download or read book Advances in Manufacturing and Industrial Engineering written by Ranganath M. Singari and published by Springer Nature. This book was released on 2021-01-13 with total page 1180 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents selected peer reviewed papers from the International Conference on Advanced Production and Industrial Engineering (ICAPIE 2019). It covers a wide range of topics and latest research in mechanical systems engineering, materials engineering, micro-machining, renewable energy, industrial and production engineering, and additive manufacturing. Given the range of topics discussed, this book will be useful for students and researchers primarily working in mechanical and industrial engineering, and energy technologies.
Download or read book Gas Turbine Theory written by G.F.C. Rogers and published by Pearson Higher Ed. This book was released on 2017-06-07 with total page 625 pages. Available in PDF, EPUB and Kindle. Book excerpt: When the First Edition of this book was written in 1951, the gas turbine was just becoming established as a powerplant for military aircraft. It took another decade before the gas turbine was introduced to civil aircraft, and this market developed so rapidly that the passenger liner was rendered obsolete. Other markets like naval propulsion, pipeline compression and electrical power applications grew steadily. In recent years the gas turbine, in combination with the steam turbine, has played an ever-increasing role in power generation. Despite the rapid advances in both output and efficiency, the basic theory of the gas turbine has remained unchanged. The layout of this new edition is broadly similar to the original, but greatly expanded and updated, comprising an outline of the basic theory, aerodynamic design of individual components, and the prediction of off-design performance. The addition of a chapter devoted to the mechanical design of gas turbines greatly enhances the scope of the book. Descriptions of engine developments and current markets make this book useful to both students and practising engineers.
