EBookClubs

Read Books & Download eBooks Full Online

EBookClubs

Read Books & Download eBooks Full Online

Book Initial Investigation of Niobium and Niobium base Alloys

Download or read book Initial Investigation of Niobium and Niobium base Alloys written by Henry A. Saller and published by . This book was released on 1955 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Investigation of Some Niobium based Alloys

Download or read book Investigation of Some Niobium based Alloys written by Stan J. Paprocki and published by . This book was released on 1956 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Investigation of Some Niobium base Alloys

Download or read book Investigation of Some Niobium base Alloys written by Stan J. Paprocki and published by . This book was released on 1956 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Development of Niobium base Alloys

Download or read book Development of Niobium base Alloys written by Richard T. Begley and published by . This book was released on 1960 with total page 162 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Report of Investigations

Download or read book Report of Investigations written by and published by . This book was released on 1964 with total page 454 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Preparation of Ingots of Uranium niobium Alloys

Download or read book Preparation of Ingots of Uranium niobium Alloys written by and published by . This book was released on 1956 with total page 14 pages. Available in PDF, EPUB and Kindle. Book excerpt: A study was made of the preparation of a uranium - 10 w/O niobium alloy by the bomb reduction of a suitable form of niobium and uranium tetrafluoride with calcium. A compound with a probable formula of Na2NbOF5 proved to be most satisfactory as the source of niobium. High yields and good metal-slag separations were obtained. Chemical analysis and density determinations showed the composition to be 10 ℗± 0.5 w/o niobium. Fifteen pounds of alloy were melted in BeO and cast into a graphite mold.

Book Nuclear Science Abstracts

Download or read book Nuclear Science Abstracts written by and published by . This book was released on 1975 with total page 1146 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Hardness Behavior of Binary and Ternary Niobium Alloys at 77 and 300 K

Download or read book Hardness Behavior of Binary and Ternary Niobium Alloys at 77 and 300 K written by Joseph R. Stephens and published by . This book was released on 1974 with total page 18 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Investigation Into Recrystallization of Niobium and Its Alloys

Download or read book Investigation Into Recrystallization of Niobium and Its Alloys written by YE M. SAVITSKIY and published by . This book was released on 1960 with total page 15 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Metallurgical Studies of Niobium uranium Alloys

Download or read book Metallurgical Studies of Niobium uranium Alloys written by John A. DeMastry and published by . This book was released on 1959 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt: In a continuing program, fabrication characteristics, physical and mechanical properties, and corrosion behavior in air, CO2, NaK, water, and steam were studied for . binary niobium fuel alloys containing 10, 20, 30, 40, 50, and 60 wt.% uranium To evaluate the effects of two major impurities of niobium, oxygen, and zirconium, three niobium base stocks, differing according to the level of these impurities, were used for each alloy. The impurity combinations employed were 600 ppm oxygen and 0.74 wt.% zirconium, 700 ppm oxygen, and 0.17 wt.% zirconium, and 300 ppm oxygen and 0.02 wt.% zirconium, Representative specimens of these alloys retained their hardness up to 900 deg C The 10 and 20 wt.% uraniuin alloys were successfully rorged at 2500 deg F and rolled at 1800 deg F to sheet. Fabrication characteristics of the remaining alloys are under investigation. The 0.2% offset yield strength of the 10 wt.% uranium alloy was 57,200 psi at room temperature and 36,900 psi at 1600 deg F. For the 20 wt.% uranium alloy it was 93,200 psi at room temperature and 71.000 psi at 1600 deg F. The corrosion life of all of the alloys in air at 572 deg F and in CO2 at 600 deg F was superior to that of unalloyed niobium. In 1000- hr exposures to 600 deg F water most of the alloys exhibited corrosion rates only two or three times greater than that of Zircaloy-2. All oi the alloys appear compatible with NaK at 1600 deg F. The impurity combinations employed in the base niobium appeared to have no effect on the corrosion behavior and mechanical properties of the alloys. (auth).

Book U S  Government Research Reports

Download or read book U S Government Research Reports written by and published by . This book was released on 1956 with total page 430 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Oxidation Studies of Niobium Base Alloys

Download or read book Oxidation Studies of Niobium Base Alloys written by Per Kofstad and published by . This book was released on 1960 with total page 65 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Minerals Yearbook

Download or read book Minerals Yearbook written by and published by . This book was released on 1958 with total page 1376 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Niobium Alloys and Compounds

Download or read book Niobium Alloys and Compounds written by M. Neuberger and published by Springer. This book was released on 2014-01-23 with total page 70 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report was prepared by Hughes Aircraft Company, Culver City, California under Contract No. F33615-70-C-1348. The work was administered under the direction of the Air Force Materials Laboratory, Air Force Systems Cornrnand, Wright-Patterson Air Force Base, Ohio, with Mr. B. Emrich, Project Engineer. The Electronic Properties Information Center (EPIC) is a designated inforrnation Analysis Center of the Departrnent of Defense, authorized to provide inforrnation to the entire DoD cornrnunity. The purpose of the Center is to provide a highly competent source of inforrnation and data on the electronic, optical and magnetic properties of materials of value to the Department of Defense. Its major function is to evaluate, compile and publish the experimental data from the world's unclassified literature concerned with the properties of materials. All materials relevant to the field of electronics are within the scope of EPIC: insulators, semiconductors, metals, superconductors, ferrites, ferroelectrics, ferromagnetics, electro luminescents, therrnionic emitters and optical materials. The Center's scope includes inforrnation on over 100 basic properties of materials; information generally regarded as being in the area of devices and/or circuitry is excluded. Grateful acknowledgement is made for the review and comments of Dr. G. D. Cody of RCA Laboratories and Dr. B. W. Roberts of General Electric Co. V CONTENTS Introduction •. . ••••. . . ••••. . . . . . •• 1 Superconductivity Applications •••• 3 Niobium-Hydrogen •. . ••. •. ••. ••. . •• 15 Niobium-Antimony. • . . . • . • • • • . • • . • • .

Book Catalog of Technical Reports

    Book Details:
  • Author : United States. Dept. of Commerce. Office of Technical Services
  • Publisher :
  • Release :
  • ISBN :
  • Pages : 600 pages

Download or read book Catalog of Technical Reports written by United States. Dept. of Commerce. Office of Technical Services and published by . This book was released on with total page 600 pages. Available in PDF, EPUB and Kindle. Book excerpt: