Download or read book Influence of Liquid Height on Pool Boiling Heat Transfer written by Maharshi Y. Shukla and published by . This book was released on 2020 with total page 56 pages. Available in PDF, EPUB and Kindle. Book excerpt: "As technology advances due to continuous research, devices are becoming more compact, efficient, and powerful. Therefore, heat rejection from such devices becomes ever so critical to maximizing their potential. Compared to other heat extraction methods, boiling provides one of the highest heat transfer coefficients. The heat extraction due to the boiling process is limited to the Critical Heat Flux (CHF). At CHF, an insulating layer of escaping bubbles forms upon the surface to prevent boiling continuity. Subsequently, the surface temperature increases uncontrollably, leading to a system failure. Hence, the elevation of CHF is critical to boiling enhancement. Improvements to the heat transfer process can be made with either surface manipulation or liquid manipulation. Based on previous studies, it is found that the removal of bubbles from the heater surface is critical to enhancing performance. Therefore, it is hypothesized that if a bubble can be encouraged to reach liquid-gas the interface quickly, gains in the boiling performance can be achieved. Due to the vapor bubble's movement in liquid bulk, it becomes critical to understand the influence of liquid height on pool boiling for enhancement. While pool boiling enhancement using heating surface modification is extensively studied and documented, there is a research gap between understanding the effect of liquid height at high heat fluxes. Thus, this study tries to evaluate the influence of liquid height on pool boiling performance at higher heat fluxes and identify the underlying bubble movement mechanism. It is observed that as CHF increases with liquid height. Moreover, it is observed that bubble movement is more effortless at low liquid height resulting in higher HTC. On the other hand, larger liquid height provides improved rewetting of the surface resulting in higher CHF. Upon analysis of high-speed recording of the escaping bubbles, it was observed that the maximum heat transfer coefficient is observed when the liquid height is about four times the height of the departing bubble diameter."--Abstract.
Download or read book Hydrodynamic Aspects of Boiling Heat Transfer written by N. Zuber and published by . This book was released on 1959 with total page 216 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Handbook of Phase Change written by S.G. Kandlikar and published by Routledge. This book was released on 2019-01-22 with total page 786 pages. Available in PDF, EPUB and Kindle. Book excerpt: Provides a comprehensive coverage of the basic phenomena. It contains twenty-five chapters which cover different aspects of boiling and condensation. First the specific topic or phenomenon is described, followed by a brief survey of previous work, a phenomenological model based on current understanding, and finally a set of recommended design equa
Download or read book Transport Phenomena in Multiphase Systems written by Amir Faghri and published by Academic Press. This book was released on 2006 with total page 1072 pages. Available in PDF, EPUB and Kindle. Book excerpt: Engineering students in a wide variety of engineering disciplines from mechanical and chemical to biomedical and materials engineering must master the principles of transport phenomena as an essential tool in analyzing and designing any system or systems wherein momentum, heat and mass are transferred. This textbook was developed to address that need, with a clear presentation of the fundamentals, ample problem sets to reinforce that knowledge, and tangible examples of how this knowledge is put to use in engineering design. Professional engineers, too, will find this book invaluable as reference for everything from heat exchanger design to chemical processing system design and more. * Develops an understanding of the thermal and physical behavior of multiphase systems with phase change, including microscale and porosity, for practical applications in heat transfer, bioengineering, materials science, nuclear engineering, environmental engineering, process engineering, biotechnology and nanotechnology * Brings all three forms of phase change, i.e., liquid vapor, solid liquid and solid vapor, into one volume and describes them from one perspective in the context of fundamental treatment * Presents the generalized integral and differential transport phenomena equations for multi-component multiphase systems in local instance as well as averaging formulations. The molecular approach is also discussed with the connection between microscopic and molecular approaches * Presents basic principles of analyzing transport phenomena in multiphase systems with emphasis on melting, solidification, sublimation, vapor deposition, condensation, evaporation, boiling and two-phase flow heat transfer at the micro and macro levels * Solid/liquid/vapor interfacial phenomena, including the concepts of surface tension, wetting phenomena, disjoining pressure, contact angle, thin films and capillary phenomena, including interfacial balances for mass, species, momentum, and energy for multi-component and multiphase interfaces are discussed * Ample examples and end-of-chapter problems, with Solutions Manual and PowerPoint presentation available to the instructors
Download or read book Effects of High Accelerations and Heat Fluxes on Nucleate Boiling of Water in an Axisymmetric Rotating Boiler written by P. J. Marto and published by . This book was released on 1971 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt: Stable boiling in a rotating cylindrical annulus with continuous through-flow of water was obtained at heat fluxes as high as 818 000 Btu/(hr)(ft^2) (2. 58 MW/m^2) at atmospheric pressure. Incipient- and nucleate -boiling heat -transfer coefficients were obtained at accelerations up to 400 g's. Measurements were made of void fractions, radial temperature profiles, and wall pressures in the boiling fluid. Convective secondary-flow cells and fluid temperature inversions were revealed. Increased fluid thicknesses increased heat-transfer coefficients, but inlet liquid subcooling had no effect. Coefficients increased with acceleration at low heat fluxes, but at high fluxes varied less than the usual data scatter.
Download or read book VDI Heat Atlas written by VDI Gesellschaft and published by Springer Science & Business Media. This book was released on 2010-07-21 with total page 1608 pages. Available in PDF, EPUB and Kindle. Book excerpt: For more than 50 years, the Springer VDI Heat Atlas has been an indispensable working means for engineers dealing with questions of heat transfer. Featuring 50% more content, this new edition covers most fields of heat transfer in industrial and engineering applications. It presents the interrelationships between basic scientific methods, experimental techniques, model-based analysis and their transfer to technical applications.
Download or read book Handbook of Thermal Science and Engineering written by and published by Springer. This book was released on 2018-07-31 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Handbook provides researchers, faculty, design engineers in industrial R&D, and practicing engineers in the field concise treatments of advanced and more-recently established topics in thermal science and engineering, with an important emphasis on micro- and nanosystems, not covered in earlier references on applied thermal science, heat transfer or relevant aspects of mechanical/chemical engineering. Major sections address new developments in heat transfer, transport phenomena, single- and multiphase flows with energy transfer, thermal-bioengineering, thermal radiation, combined mode heat transfer, coupled heat and mass transfer, and energy systems. Energy transport at the macro-scale and micro/nano-scales is also included. The internationally recognized team of authors adopt a consistent and systematic approach and writing style, including ample cross reference among topics, offering readers a user-friendly knowledgebase greater than the sum of its parts, perfect for frequent consultation. The Handbook of Thermal Science and Engineering is ideal for academic and professional readers in the traditional and emerging areas of mechanical engineering, chemical engineering, aerospace engineering, bioengineering, electronics fabrication, energy, and manufacturing concerned with the influence thermal phenomena.
Download or read book Influence of Subcooling on Pool Boiling Heat Transfer written by Rabindra Nath Singh and published by . This book was released on 1973 with total page 208 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Handbook of Multiphase Systems written by Gad Hetsroni and published by Taylor & Francis Group. This book was released on 1982 with total page 1550 pages. Available in PDF, EPUB and Kindle. Book excerpt: Good,No Highlights,No Markup,all pages are intact, Slight Shelfwear,may have the corners slightly dented, may have slight color changes/slightly damaged spine.
Download or read book Heat Transfer in Condensation and Boiling written by Karl Stephan and published by Springer Science & Business Media. This book was released on 2013-06-29 with total page 342 pages. Available in PDF, EPUB and Kindle. Book excerpt: I welcome the opportunity to have my book translated, because of the great emphasis on two-phase flow and heat transfer in the English-speaking world, as related to research, university education, and industrial practice. The 1988 Springer-Verlag edition of "Warmeiibergang beim Kondensieren und beim Sieden" has been enlarged to include additional material on falling film evaporation (Chapter 12) and pressure drop in two-phase flow (Chapter 13). Minor errors in the original text have also been corrected. I would like to express my sincere appreciation to Professor Green, Asso ciate Professor of German at Rensselaer, for his excellent translation and co operation. My thanks go also to Professor Bergles for his close attention to technical and linguistic details. He carefully read the typescript and made many comments and suggestions that helped to improve the manuscript. I hope that the English edition will meet with' a favorable reception and contribute to better understanding and to progress in the field of heat transfer in condensation and boiling. February 1992 K. Stephan Preface to the German-Language Edition This book is a continuation of the series "Heat and Mass Transfer" edited by U. Grigull, in which three volumes have already been published. Its aim is to acquaint students and practicing engineers with heat transfer during condensa tion and boiling, and is intended primarily for students and engineers in mechanical, chemical, electrical, and industrial processing engineering.
Download or read book Heat Transfer and Fluid Flow in Minichannels and Microchannels written by Satish Kandlikar and published by Elsevier. This book was released on 2006 with total page 492 pages. Available in PDF, EPUB and Kindle. Book excerpt: &Quot;This book explores flow through passages with hydraulic diameters from about 1 [mu]m to 3 mm, covering the range of minichannels and microchannels. Design equations along with solved examples and practice problems are also included to serve the needs of practicing engineers and students in a graduate course."--BOOK JACKET.
Download or read book Proceedings Of The International Heat Transfer Conference written by Lee and published by CRC Press. This book was released on 1998-11-01 with total page 696 pages. Available in PDF, EPUB and Kindle. Book excerpt: This year's set of papers includes 23 Keynote Papers and 537 refereed General Papers, in seven volumes. Experts from around the world have combined to address the leading edge of research and practical innovations in convection, combustion, heat exchangers, two-phase flow, and much more. Whether one is involved in mechanical, chemical, nuclear, or energy engineering the quantity, international scope, and high quality of the contents make access to these volumes essential.
Download or read book Fluid Mechanics and Fluid Power written by T. Prabu and published by Springer Nature. This book was released on 2021-08-03 with total page 901 pages. Available in PDF, EPUB and Kindle. Book excerpt: div="" style="" This book comprises select proceedings of the 46th National Conference on Fluid Mechanics and Fluid Power (FMFP 2019). The contents of this book focus on aerodynamics and flow control, computational fluid dynamics, fluid structure interaction, noise and aero-acoustics, unsteady and pulsating flows, vortex dynamics, nuclear thermal hydraulics, heat transfer in nanofluids, etc. This book serves as a useful reference beneficial to researchers, academicians and students interested in the broad field of mechanics. ^
Download or read book POOL BOILING IN AN ACCELERATING SYSTEM written by Herman Merte, Jr., John A. Clark and published by . This book was released on 1960 with total page 33 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Effects of Non uniform Porosity and Bed Fluidization on Boiling Heat Transfer in Particulate Beds written by Yew Khoy Chuah and published by . This book was released on 1985 with total page 288 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Translational Research in Cardio Oncology An Issue of Heart Failure Clinics written by Ragavendra R. Baliga and published by Elsevier Health Sciences. This book was released on 2022-06-23 with total page 217 pages. Available in PDF, EPUB and Kindle. Book excerpt: In this issue of Heart Failure Clinics, guest editors Drs. Ragavendra R Baliga and George A. Mensah bring their considerable expertise to the topic of Translational Research in Cardio-Oncology. Top experts in the field cover key topics such as radiation-induced cardiac dysfunction; training and career development; cardiovascular imaging; CAR-T cell therapy and cardiovascular disease; and more. - Contains 12 relevant, practice-oriented topics including cardio-protection of high-risk individuals; myocardial metabolism; amyloidosis; arrhythmic complications associated with cancer therapies; and more. - Provides in-depth clinical reviews on translational research in cardio-oncology, offering actionable insights for clinical practice. - Presents the latest information on this timely, focused topic under the leadership of experienced editors in the field. Authors synthesize and distill the latest research and practice guidelines to create clinically significant, topic-based reviews.
Download or read book Heat Transfer to a Boiling Liquid written by Kurt Walter Forster and published by . This book was released on 1958 with total page 84 pages. Available in PDF, EPUB and Kindle. Book excerpt:
