Download or read book In cylinder Particulate Size Distribution Measurements in a Direct injection Diesel Engine written by Lang Luo and published by . This book was released on 1990 with total page 354 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Size Distribution and Mass Output of Particulates from Diesel Engine Exhausts written by John A. Breslin and published by . This book was released on 1976 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Time Resolved Exhaust Sampling from In direct Injection Diesel Engine written by Moh'-dhair Abukdais and published by . This book was released on 1991 with total page 338 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Experimental Investigations on Particle Number Emissions from GDI Engines written by Markus Bertsch and published by Logos Verlag Berlin GmbH. This book was released on 2016-12-31 with total page 170 pages. Available in PDF, EPUB and Kindle. Book excerpt: This thesis discusses experimental investigations to reduce particle number emissions from gasoline engines with direct injection. Measures on a single cylinder research engine with combined usage of a particle number measurement system, a particle size distribution measurement system as well as optical diagnostics and thermodynamic analysis enable an in-depth assessment of particle formation and oxidation. Therefore, numerous optical diagnostic techniques for spray visualisation (Mie-scattering, High-Speed PIV) and soot detection (High-Speed-Imaging, Fiber optical diagnostics) are deployed. Two injectors with different hydraulic flows but identical spray-targeting are characterised and compared by measurements in a pressurised chamber. The operation at higher engine load and low engine speed is in the focus of the experimental work at the engine test bench. Thereby, the low flow velocities in the combustion chamber, caused by the low engine speed, as well as the large amount of fuel injected are major challenges for the mixture formation process. A substantial part of the thesis thus focusses on the detailed analysis of the mixture formation process, which is consisting of fuel injection, interaction of the in-cylinder charge motion with the fuel injected and the fuel properties. Measures for the optimisation of the mixture formation process and the minimisation of the particle number emissions are analysed and evaluated. The charge motion is manipulated by the impression of a directed flow, the variation of the valve timings and valve open curve. The injection process is influenced by a reduction of the hydraulic flow of the injector and an increase of the injection pressure up to 50 MPa. The investigations show fundamental effects and potentials of different variation parameters concerning their emissions reduction potential at the exemplary operation at high engine load. Due to the simultaneous analysis of the in-cylinder charge motion and a thermodynamic analysis, the results can be transferred to different engines.
Download or read book Effect of Engine Operating Conditions on the Size and Morphology of Diesel Particulate Emissions written by Adam Neer and published by . This book was released on 2005 with total page 118 pages. Available in PDF, EPUB and Kindle. Book excerpt: "The size, morphology and volume fraction of sub-micron particulate matter emitted from a compression ignition (diesel) engine was investigated using thermophoretic sampling experiments followed by direct visual characterizations under transmission electron microscopy"--Abstract, leaf iii.
Download or read book Size Distribution and Mass Output of Particulates from Diesel Engine Exhausts written by John A. Breslin and published by . This book was released on 1976 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Soot Particle Size and Number Density Measurements in a Direct Injection Diesel Engine Using Light Scattering Radiation and Extinction written by Dale Reif Tree and published by . This book was released on 1992 with total page 452 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Health Effects of Transport related Air Pollution written by Michal Krzyzanowski and published by WHO Regional Office Europe. This book was released on 2005 with total page 205 pages. Available in PDF, EPUB and Kindle. Book excerpt: Diseases related to the air pollution caused by road transport affect tens of thousands of people in the WHO Europe region each year. This publication considers the policy challenges involved in the need to reduce the related risks to public health and the environment, whilst meeting socio-economic requirements for effective transport systems. It sets out a systematic review of the literature and a comprehensive evaluation of the health hazards of transport-related air pollution, including factors determining emissions, the contribution of traffic to pollution levels, human exposure and the results of epidemiological and toxicological studies to identify and measure the health effects, and suggestions for policy actions and further research.
Download or read book Engine Exhaust Particulates written by Avinash Kumar Agarwal and published by Springer. This book was released on 2018-11-01 with total page 269 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a comparative analysis of both diesel and gasoline engine particulates, and also of the emissions resulting from the use of alternative fuels. Written by respected experts, it offers comprehensive insights into motor vehicle particulates, their formation, composition, location, measurement, characterisation and toxicology. It also addresses exhaust-gas treatment and legal, measurement-related and technological advancements concerning emissions. The book will serve as a valuable resource for academic researchers and professional automotive engineers alike.
Download or read book Particulate Matter Formation Mechanisms in a Direct injection Gasoline Engine written by Jared Cromas and published by . This book was released on 2003 with total page 356 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Analysis and In cylinder Measurement of Particulate Radiant Emissions and Temperature in a Direct Injection Diesel Engine written by Jingde Yan and published by . This book was released on 1988 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Diesel Particulate Emissions Landmark Research 1994 2001 written by John H Johnson and published by SAE International. This book was released on 2002-02-20 with total page 636 pages. Available in PDF, EPUB and Kindle. Book excerpt: The need for manufacturers to meet U.S. Environmental Protection Agency (EPA) mobile source diesel emissions standards for on-highway light duty and heavy duty vehicles has been the driving force for the control of diesel particulate and NOx emissions reductions. Diesel Particulate Emissions: Landmark Research 1994-2001 contains the latest research and development findings that will help guide engineers to achieve low particulate emissions from future engines. Based on extensive SAE literature from the past seven years, the 45 papers in this book have been selected from the SAE Transactions Journals.
Download or read book Characterization of Particulate Matter Morphology and Volatility for Two Direct injection Engines written by Brian M. Graves and published by . This book was released on 2015 with total page 106 pages. Available in PDF, EPUB and Kindle. Book excerpt: Particulate matter emitted from two direct injection engines has been characterized by morphology, volatility, mass-mobility exponent, effective density, and size distribution using tandem measurements from a centrifugal particle mass analyzer (CPMA) and differential mobility analyzers (DMA). The engines consisted of a heavy duty, natural gas, compression ignition engine fitted with a high pressure direct injection (HPDI) system, and a four cylinder gasoline direct injection (GDI) engine fueled with gasoline and ethanol blends. The HPDI engine was tested at six conditions which varied load, speed, EGR fraction, and fuel delivery strategy. The GDI was tested at three engine loads at 2250 RPM (4%, 13%, and 26% of maximum load) in addition to an idle condition, while it was fueled using gasoline mixed with ethanol fractions of 0% (E0), 10% (E10), and 50% (E50) by volume. An increase in engine load increased particle number concentration for both engines, but the GDI idle condition produced approximately as many particles as at 13% load. An increase in ethanol fraction in the GDI decreased number concentration, but E10 produced more particles than E0 at idle and 26% load. HPDI size distributions were log-normal whereas GDI size distributions were not log-normal and were instead skewed. The fraction of the number of purely volatile particles to total number of particles (number volatile fraction, fN) for the HPDI engine decreased as load increased, although the low-speed, partially premixed mode had the lowest fN. The fN for the GDI both overall and as a function of particle mobility-equivalent diameter was under 10 percent at all engine conditions and fuels. The size-segregated ratio of the mass of internally mixed volatile material to total particle mass (fm) was similarly low for the GDI. The fm for the HPDI was higher; however it decreased with an increase in load and with particle mobility-equivalent diameter. HPDI effective density was seen to collapse to approximately a single line, but engine modes with higher fm values had slightly higher effective densities suggesting that the soot structures have collapsed into more dense shapes. Effective density and mass-mobility exponent for the GDI engine increased with load. Effective density decreased with an increase in ethanol fraction and a slight decrease in mass-mobility exponent was also observed for all conditions except idle. Effective density trends from both engines were compared to data from other GDI engines, a port fuel injection engine, and diesels, and the data is relatively similar between all engine types, with 90% of data points being within ±27% of a common trend line.
Download or read book Analysis of Reduction of Particulate Matter Concentration and Size Distribution of Di Diesel Engine by Seawater Spray written by Pramnath Ravi and published by . This book was released on 2012 with total page 57 pages. Available in PDF, EPUB and Kindle. Book excerpt: Air pollution is a major environmental problem in most of the developing countries in the world. Air pollution is largely contributed as a consequence of the combustion of fossil fuels. Air pollutants are able not only to cause harm to our health but also to our environment. The after combustion or exhaust by the internal combustion engines, especially by compression ignition (CI) engines produces a complex mixture of pollutants that comprises both primary emissions, such as diesel soot particles, lead and sulfate particles formed from the burning of sulphur-containing fuel. The aim of this project is to measure reduction of diesel particulate matter (DPM) by diesel engine experiment using seawater spray and to utilize natural seawater. The diesel engine experiment was conducted with YANMAR TF120M single cylinder four stroke direct injection diesel engine set-up at variable engine speed namely at 2400, 2100, 1800, 1500 and 1200 rpm with and without seawater spray. An average of 26.1 % of DPM, 27.8 % of SOF and 19.5 % of DS has been reduced by using the seawater spray system. Overall DPM diameter size distribution able to be reduced.
Download or read book Automotive Spark Ignited Direct Injection Gasoline Engines written by F. Zhao and published by Elsevier. This book was released on 2000-02-08 with total page 129 pages. Available in PDF, EPUB and Kindle. Book excerpt: The process of fuel injection, spray atomization and vaporization, charge cooling, mixture preparation and the control of in-cylinder air motion are all being actively researched and this work is reviewed in detail and analyzed. The new technologies such as high-pressure, common-rail, gasoline injection systems and swirl-atomizing gasoline fuel injections are discussed in detail, as these technologies, along with computer control capabilities, have enabled the current new examination of an old objective; the direct-injection, stratified-charge (DISC), gasoline engine. The prior work on DISC engines that is relevant to current GDI engine development is also reviewed and discussed. The fuel economy and emission data for actual engine configurations have been obtained and assembled for all of the available GDI literature, and are reviewed and discussed in detail. The types of GDI engines are arranged in four classifications of decreasing complexity, and the advantages and disadvantages of each class are noted and explained. Emphasis is placed upon consensus trends and conclusions that are evident when taken as a whole; thus the GDI researcher is informed regarding the degree to which engine volumetric efficiency and compression ratio can be increased under optimized conditions, and as to the extent to which unburned hydrocarbon (UBHC), NOx and particulate emissions can be minimized for specific combustion strategies. The critical area of GDI fuel injector deposits and the associated effect on spray geometry and engine performance degradation are reviewed, and important system guidelines for minimizing deposition rates and deposit effects are presented. The capabilities and limitations of emission control techniques and after treatment hardware are reviewed in depth, and a compilation and discussion of areas of consensus on attaining European, Japanese and North American emission standards presented. All known research, prototype and production GDI engines worldwide are reviewed as to performance, emissions and fuel economy advantages, and for areas requiring further development. The engine schematics, control diagrams and specifications are compiled, and the emission control strategies are illustrated and discussed. The influence of lean-NOx catalysts on the development of late-injection, stratified-charge GDI engines is reviewed, and the relative merits of lean-burn, homogeneous, direct-injection engines as an option requiring less control complexity are analyzed.
Download or read book Particulate Emissions from Vehicles written by Peter Eastwood and published by John Wiley & Sons. This book was released on 2008-04-15 with total page 512 pages. Available in PDF, EPUB and Kindle. Book excerpt: The public health risks posed by automotive particulate emissions are well known. Such particles are sufficiently small to reach the deepest regions of the lungs; and moreover act as carriers for many potentially toxic substances. Historically, diesel engines have been singled out in this regard, but recent research shows the need to consider particulate emissions from gasoline engines as well. Already implicated in more than one respiratory disease, the strongest evidence in recent times points to particle-mediated cardiovascular disorders (strokes and heart attacks). Accordingly, legislation limiting particulate emissions is becoming increasingly stringent, placing great pressure on the automotive industry to produce cleaner vehicles - pressure only heightened by the ever-increasing number of cars on our roads. Particulate Emissions from Vehicles addresses a field of increased international interest and research activity; discusses the impact of new legislation globally on the automotive industry; and explains new ways of measuring particle size, number and composition that are currently under development. The expert analysis and summary of the state-of-the-art, which encompasses the key areas of combustion performance, measurement techniques and toxicology, will appeal to R&D practitioners and engineers working in the automotive industry and related mechanical fields, as well as postgraduate students and researchers of engine technology, air pollution and life/ environmental science. The public health aspects will also appeal to the biomedical research community.
Download or read book Analysis and In cylinder Measurement of Particulate Radiant Emissions and Temperature in a Direct Injection Diesel Engine by Jingde Yan and Gary L Borman written by Jingde Yan and published by . This book was released on 1988 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
