Download or read book Improving the Performance and Exhaust Emissions of Dual Chamber Stratified Charge Spark Ignition Engines written by Kenneth William Grandys and published by . This book was released on 1977 with total page 152 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Improving the Performance and Fuel Consumption of Dual Chamber Stratified Charge Spark Ignition Engines written by and published by . This book was released on 1979 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A combined experimental and theoretical investigation of the nature of the combustion processes in a dual chamber stratified charge spark ignition engine is described. This work concentrated on understanding the mixing process in the main chamber gases. A specially constructed single cylinder engine was used to both conduct experiments to study mixing effects and to obtain experimental data for the validation of the computer model which was constructed in the theoretical portion of the study. The test procedures are described. Studies were conducted on the effect of fuel injection timing on performance and emissions using the combination of orifice size and prechamber to main chamber flow rate ratio which gave the best overall compromise between emissions and performance. In general, fuel injection gave slightly higher oxides of nitrogen, but considerably lower hydrocarbon and carbon monoxide emissions than the carbureted form of the engine. Experiments with engine intake port redesign to promote swirl mixing indicated a substantial increase in the power output from the engine and, that an equivalent power levels, the nitric oxide emissions are approximately 30% lower with swirl in the main chamber than without swirl. The development of a computer simulation of the combustion process showed that a one-dimensional combustion model can be used to accurately predict trends in engine operation conditions and nitric oxide emissions even though the actual flame in the engine is not completely one-dimensional, and that a simple model for mixing of the main chamber and prechamber intake gases at the start of compression proved adequate to explain the effects of swirl, ignition timing, overall fuel air ratio, volumetric efficiency, and variations in prechamber air fuel ratio and fuel rate percentage on engine power and nitric oxide emissions. (LCL).
Download or read book Investigating the Performance and Exhaust Emissions of a Fuel Injected Dual Chamber Stratified Charge Engine written by James Joseph Bruckbauer and published by . This book was released on 1979 with total page 160 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Stratified Charge Engines written by Institution of Mechanical Engineers (Great Britain). Automobile Division and published by . This book was released on 1977 with total page 200 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Performance and Emissions from a Dual Chamber Stratified Charge Engine written by Chalilullah Rangkuti and published by . This book was released on 1990 with total page 550 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Automotive Spark Ignited Direct Injection Gasoline Engines written by F. Zhao and published by Elsevier. This book was released on 2000-02-08 with total page 129 pages. Available in PDF, EPUB and Kindle. Book excerpt: The process of fuel injection, spray atomization and vaporization, charge cooling, mixture preparation and the control of in-cylinder air motion are all being actively researched and this work is reviewed in detail and analyzed. The new technologies such as high-pressure, common-rail, gasoline injection systems and swirl-atomizing gasoline fuel injections are discussed in detail, as these technologies, along with computer control capabilities, have enabled the current new examination of an old objective; the direct-injection, stratified-charge (DISC), gasoline engine. The prior work on DISC engines that is relevant to current GDI engine development is also reviewed and discussed. The fuel economy and emission data for actual engine configurations have been obtained and assembled for all of the available GDI literature, and are reviewed and discussed in detail. The types of GDI engines are arranged in four classifications of decreasing complexity, and the advantages and disadvantages of each class are noted and explained. Emphasis is placed upon consensus trends and conclusions that are evident when taken as a whole; thus the GDI researcher is informed regarding the degree to which engine volumetric efficiency and compression ratio can be increased under optimized conditions, and as to the extent to which unburned hydrocarbon (UBHC), NOx and particulate emissions can be minimized for specific combustion strategies. The critical area of GDI fuel injector deposits and the associated effect on spray geometry and engine performance degradation are reviewed, and important system guidelines for minimizing deposition rates and deposit effects are presented. The capabilities and limitations of emission control techniques and after treatment hardware are reviewed in depth, and a compilation and discussion of areas of consensus on attaining European, Japanese and North American emission standards presented. All known research, prototype and production GDI engines worldwide are reviewed as to performance, emissions and fuel economy advantages, and for areas requiring further development. The engine schematics, control diagrams and specifications are compiled, and the emission control strategies are illustrated and discussed. The influence of lean-NOx catalysts on the development of late-injection, stratified-charge GDI engines is reviewed, and the relative merits of lean-burn, homogeneous, direct-injection engines as an option requiring less control complexity are analyzed.
Download or read book Injection Technologies and Mixture Formation Strategies For Spark Ignition and Dual Fuel Engines written by Alessandro Ferrari and published by SAE International. This book was released on 2022-06-24 with total page 407 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fuel injection systems and performance is fundamental to combustion engine performance in terms of power, noise, efficiency, and exhaust emissions. There is a move toward electric vehicles (EVs) to reduce carbon emissions, but this is unlikely to be a rapid transition, in part due to EV batteries: their size, cost, longevity, and charging capabilities as well as the scarcity of materials to produce them. Until these isssues are resolved, refining the spark-ignited engine is necessary address both sustainability and demand for affordable and reliable mobility. Even under policies oriented to smart sustainable mobility, spark-ignited engines remain strategic, because they can be applied to hybridized EVs or can be fueled with gasoline blended with bioethanol or bio-butanol to drastically reduce particulate matter emissions of direct injection engines in addition to lower CO2 emissions. In this book, Alessandro Ferrari and Pietro Pizzo provide a full review of spark-ignited engine fuel injection systems. The most popular typologies of fuel injection systems are considered, with special focus on state-of-the-art solutions. Dedicated sections on the methods for air mass evaluation, fuel delivery low-pressure modules, and the specific subsystems for idle, cold start, and warm-up control are also included. The authors pay special attention to mixture formation strategies, as they are a fundamental theme for SI engines. An exhaustive overview of fuel injection technologies is provided, and mixture formation strategies for spark ignited combustion engines are considered. Fuel Injection Systems illustrates the performance of these systems and will also serve as a reference for engineers who are active in the aftermarket, offering detailed information on fuel injection system solutions that are mounted in older vehicles.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1981 with total page 1740 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Engine Modifications and Exhaust Emission Control written by Wolfgang E. Meyer and published by . This book was released on 1962 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Combustion Simulation of a Dual Chamber Stratified Charge Spark Ignition Engine written by and published by . This book was released on 1979 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Devices to Improve the Performance of a Conventional Two stroke Spark Ignition Engine written by and published by . This book was released on 1995 with total page 19 pages. Available in PDF, EPUB and Kindle. Book excerpt: This paper presents research efforts made in three different phases with the objective of improving the fuel economy of and reducing exhaust emissions from conventional, carbureted, two-stroke spark ignition (SI) engines, which are widely employed in two-wheel transportation in India. A review concerning the existing two-stroke engine technology for this application is included. In the first phase, a new scavenging system was developed and tested to reduce the loss of fresh charge through the exhaust port. In die second phase, the following measures were carried out to improve the combustion process: (1) using an in-cylinder catalyst, such as copper, chromium, and nickel, in the form of coating; (2) providing moderate thermal insulation in the combustion chamber, either by depositing thin ceramic material or by metal inserts; (3) developing a high-energy ignition system; and (4) employing high-octane fuel, such as methanol, ethanol, eucalyptus oil, and orange oil, as a blending agent with gasoline. Based on the effectiveness of the above measures, an optimized design was developed in the final phase to achieve improved performance. Test results indicate that with an optimized two-stroke SI engine, the maximum percentage improvement in brake thermal efficiency is about 31%, together with a reduction of 3400 ppm in hydrocarbons (HC) and 3% by volume of carbon monoxide (CO) emissions over the normal engine (at 3 kW, 3000 rpm). Higher cylinder peak pressures (3-5 bar), lower ignition delay (2-4°CA)° and shorter combustion duration (4-10 °CA) are obtained. The knock-limited power output is also enhanced by 12.7% at a high compression ratio (CR) of 9:1. The proposed modifications in the optimized design are simple, low-cost and easy to adopt for both production and existing engines.
Download or read book Engine Emission Control Technologies written by G. Amba Prasad Rao and published by CRC Press. This book was released on 2020-06-09 with total page 448 pages. Available in PDF, EPUB and Kindle. Book excerpt: This new volume covers the important issues related to environmental emissions from SI and CI engines as well as their formation and various pollution mitigation techniques. The book addresses aspects of improvements in engine modification, such as design modifications for enhanced performance, both with conventional fuels as well as with new and alternative fuels. It also explores some new combustion concepts that will help to pave the way for complying with new emission concepts. Alternative fuels are addressed in this volume to help mitigate harmful emissions, and alternative power sources for automobiles are also discussed briefly to cover the switch over from fueled engines to electrics, including battery-powered electric vehicles and fuel cells. The authors explain the different technologies available to date to overcome the limitations of conventional prime movers (fueled by both fossil fuels and alternative fuels). Topics examined include: • Engine modifications needed to limit harmful emissions • The use of engine after-treatment devices to contain emissions • The development of new combustion concepts • Adoption of alternative fuels in existing engines • Switching over to electrics—advantages and limitations • Specifications of highly marketed automobiles • Emission measurement methods
Download or read book Assessment of Fuel Economy Technologies for Light Duty Vehicles written by National Research Council and published by National Academies Press. This book was released on 2011-06-03 with total page 373 pages. Available in PDF, EPUB and Kindle. Book excerpt: Various combinations of commercially available technologies could greatly reduce fuel consumption in passenger cars, sport-utility vehicles, minivans, and other light-duty vehicles without compromising vehicle performance or safety. Assessment of Technologies for Improving Light Duty Vehicle Fuel Economy estimates the potential fuel savings and costs to consumers of available technology combinations for three types of engines: spark-ignition gasoline, compression-ignition diesel, and hybrid. According to its estimates, adopting the full combination of improved technologies in medium and large cars and pickup trucks with spark-ignition engines could reduce fuel consumption by 29 percent at an additional cost of $2,200 to the consumer. Replacing spark-ignition engines with diesel engines and components would yield fuel savings of about 37 percent at an added cost of approximately $5,900 per vehicle, and replacing spark-ignition engines with hybrid engines and components would reduce fuel consumption by 43 percent at an increase of $6,000 per vehicle. The book focuses on fuel consumption-the amount of fuel consumed in a given driving distance-because energy savings are directly related to the amount of fuel used. In contrast, fuel economy measures how far a vehicle will travel with a gallon of fuel. Because fuel consumption data indicate money saved on fuel purchases and reductions in carbon dioxide emissions, the book finds that vehicle stickers should provide consumers with fuel consumption data in addition to fuel economy information.
Download or read book Internal Combustion Engineering Science Technology written by P.M. Weaving and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 874 pages. Available in PDF, EPUB and Kindle. Book excerpt: Sir Diarmuid Downs, CBE, FEng, FRS Engineering is about designing and making marketable artefacts. The element of design is what principally distinguishes engineering from science. The engineer is a creator. He brings together knowledge and experience from a variety of sources to serve his ends, producing goods of value to the individual and to the community. An important source of information on which the engineer draws is the work of the scientist or the scientifically minded engineer. The pure scientist is concerned with knowledge for its own sake and receives his greatest satisfaction if his experimental observations fit into an aesthetically satisfying theory. The applied scientist or engineer is also concerned with theory, but as a means to an end. He tries to devise a theory which will encompass the known experimental facts, both because an all embracing theory somehow serves as an extra validation of the facts and because the theory provides us with new leads to further fruitful experimental investigation. I have laboured these perhaps rather obvious points because they are well exemplified in this present book. The first internal combustion engines, produced just over one hundred years ago, were very simple, the design being based on very limited experimental information. The current engines are extremely complex and, while the basic design of cylinder, piston, connecting rod and crankshaft has changed but little, the overall performance in respect of specific power, fuel economy, pollution, noise and cost has been absolutely transformed.
Download or read book Stratified Charge Engines Final Report written by E. M. Withjack and published by . This book was released on 1976 with total page 118 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A One dimensional Combustion Model for a Dual Chamber Stratified Charge Spark Ignition Engine written by S. C. Sorenson and published by . This book was released on 1979 with total page 18 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A One dimensional Combustion Model for a Dual Chamber Stratified Charge Spark Ignition Engine written by and published by . This book was released on 1979 with total page 18 pages. Available in PDF, EPUB and Kindle. Book excerpt:
