Download or read book Low Reynolds Number Flow Heat Exchangers written by Sadık Kakaç and published by Springer. This book was released on 1983 with total page 1032 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Heat Transfer in Low Reynolds Number Flow written by George A. Brown and published by . This book was released on 1971 with total page 86 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Heat Transfer in Low Reynolds Number Flow written by George A. Brown and published by . This book was released on 1971 with total page 69 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book The Effect of Heat Transfer on Low Reynolds Number Downward Flow of Newtonian Fluids in a Vertical Pipe written by Victor Manuel Feliz Pérez and published by . This book was released on 1973 with total page 296 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Effect of Heat Transfer on Flow Field at Low Reynolds Numbers in Vertical Tubes written by Edward Marshall Rosen and published by . This book was released on 1959 with total page 536 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Theoretical and Experimental Investigations of Fluid Flow and Heat Transfer Around a Cylinder in the Region of Low Reynolds Number and High Prandtl Number written by Frederick Harold Shair and published by . This book was released on 1963 with total page 464 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Laminar Flow Forced Convection in Ducts written by R. K. Shah and published by Academic Press. This book was released on 2014-06-28 with total page 492 pages. Available in PDF, EPUB and Kindle. Book excerpt: Laminar Flow Forced Convection in Ducts is a sourcebook for compact heat exchanger analytical data. This book describes the analytical solutions for laminar fluid flow and forced convection heat transfer in circular and noncircular pipes, including applicable differential equations and boundary conditions involving velocity and temperature problems of fluid flow. The book also discusses fluid flow—how much power is required to pump fluids through the heat exchanger, as well as the heat transfer—the determination of q" distribution, and the temperature of fluid and walls. The text also analyzes the coolant or heat transfer fluid flows in a nuclear power reactor composed of a bundle of circular section fuel rods located inside a round tube. R.A. Axford addresses fluid flow and heat transfers results for the rod bundle geometry in "Heat Transfer in Rod Bundles." The book also provides an overview and guidelines that can be used for the designer and the applied mathematician. This book is suitable for engineers working in electronics, aerospace, instrumentation, and biomechanics that use cooling or heating exchanges or solar collection systems.

Download or read book Heat Transfer to Cylinders in Flows at Low Reynolds Number written by Guido Mario Baccaglini and published by . This book was released on 1971 with total page 226 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book HEAT TRANSFER IN LOW REYNOLDS NUMBER FLOW SYMPOSIUM WINTER ANNUAL MEETING PAPERS ASME written by and published by . This book was released on with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Low Reynolds Number Shear Flow Past a Rotating Circular Cylinder written by Channing Rex Robertson and published by . This book was released on 1969 with total page 528 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Heat Transfer at Low Reynolds Number written by John E. Porter and published by . This book was released on 1971 with total page 42 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Low Reynolds Number Flow Heat Exchangers Proceedings of the 4 NATO ASI on Heat Transfer Ankara 1981 written by and published by . This book was released on 1983 with total page 1016 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Experimental Heat Transfer to Blunt Axisymmetric Bodies Near the Limit of Continuum Flow written by J. Leith Potter and published by . This book was released on 1962 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt: Measurements of average heat-transfer rates to blunt-nosed, axisymmetric, cold-walled bodies in a low-density, hypervelocity wind tunnel are given. Stream density was such that Reynolds and Knudsen numbers, based on nose radius and conditions immediately behind the bow shock, varied from 5 to 20 and 0.11 to 0.056, respectively. Thus, scaling on the basis of Knudsen number, these conditions may be said to simulate a body of one-foot nose radius at as much as 315,500-ft altitude. Heat-transfer rates are discussed in relation to the flow model successfully used in the past for studies of flows of high Reynolds number. In this context, it was found that measured heat-transfer rates to hemispheres below shock-layer Reynolds numbers of 20 exhibited a decreasing nondimensionalized rate relative to that estimated by methods appropriate to high Reynolds number conditions. This behavior is in accord with various applicable theories. Rates for the flat-faced bodies showed no tendency to decrease, and they were somewhat higher than predicted by theories for high Reynolds numbers.

Download or read book Prediction of Heat Transfer Rates for Low Reynolds Number Turbulent Flow in Tubes written by Lowell Wesner Ormand and published by . This book was released on 1965 with total page 75 pages. Available in PDF, EPUB and Kindle. Book excerpt: The problem considered is heat transfer to fully developed turbulent flow in circular tubes. The idealized flow conditions considered are: (a) smooth circular tubes, (b) steady flow, (c) constant fluid properties, (d) fully developed velocity and temperature profiles, and (e) constant wall heat flux. A generalized velocity profile was developed from the momentum equation by using Prandtl's mixing length concept to evaluate eddy shear stresses. To obtain the necessary radial distribution for the mixing length, experimental data from the literature and continuity considerations were applied. Under the assumption of equal eddy diffusivities, the energy equation was solved. The resulting analytical predictions, in the form of Nusselt numbers based on tube diameter, were compared to recent low temperature difference, downstream measurements with air. For turbulent flow below Reynolds numbers of 10,000, the agreement between semi-empirical analysis and experimental data was closer than for previous analyses. The prediction can be represented by a Dittus-Boelter form, Nu = 0.021 Re0.8Pr0.4 to within five per cent for Reynolds numbers above 4000. (Author).

Download or read book Heat Transfer at Low Reynolds Number written by John E. Porter and published by . This book was released on 1975 with total page 30 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Local Aerodynamic Heat Transfer and Boundary layer Transition on Roughened Sphere ellipsoid Bodies at Mach Number 3 0 written by William D. Deveikis and published by . This book was released on 1961 with total page 30 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Modelling and Simulation of Turbulent Heat Transfer written by B. Sundén and published by WIT Press. This book was released on 2005-02-21 with total page 361 pages. Available in PDF, EPUB and Kindle. Book excerpt: Providing invaluable information for both graduate researchers and R & D engineers in industry and consultancy, this book focuses on the modelling and simulation of fluid flow and thermal transport phenomena in turbulent convective flows. Its overall objective is to present state-of-the-art knowledge in order to predict turbulent heat transfer processes in fundamental and idealized flows as well as in engineering applications. The chapters, which are invited contributions from some of the most prominent scientists in this field, cover a wide range of topics and follow a unified outline and presentation to aid accessibility.