Download or read book Heat Transfer and Pressure Drop in Two phase Swirl Flow written by Tova Mindel Tarshish and published by . This book was released on 1996 with total page 208 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Two Phase Gas Liquid Flow in Pipes with Different Orientations written by Afshin J. Ghajar and published by Springer Nature. This book was released on 2020-03-14 with total page 136 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides design engineers using gas-liquid two-phase flow in different industrial applications the necessary fundamental understanding of the two-phase flow variables. Two-phase flow literature reports a plethora of correlations for determination of flow patterns, void fraction, two- phase pressure drop and non-boiling heat transfer correlations. However, the validity of a majority of these correlations is restricted over a narrow range of two -phase flow conditions. Consequently, it is quite a challenging task for the end user to select an appropriate correlation/model for the type of two-phase flow under consideration. Selection of a correct correlation also requires some fundamental understanding of the two-phase flow physics and the underlying principles/assumptions/limitations associated with these correlations. Thus, it is of significant interest for a design engineer to have knowledge of the flow patterns and their transitions and their influence on two-phase flow variables. To address some of these issues and facilitate selection of appropriate two-phase flow models, this volume presents a succinct review of the flow patterns, void fraction, pressure drop and non-boiling heat transfer phenomenon and recommend some of the well scrutinized modeling techniques.

Download or read book Single and Two Phase Flow Pressure Drop and Heat Transfer in Tubes written by Afshin J. Ghajar and published by . This book was released on 2022 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Part I of this book provides design engineers an elemental understanding of the variables that influence pressure drop and heat transfer in plain and micro-fin tubes to thermal systems using liquid single-phase flow in different industrial applications. The author and his colleagues were the first to determine experimentally the very important relationship between inlet geometry and transition. On the basis of their results, they developed practical and easy to use correlations for the isothermal and non-isothermal friction factor (pressure drop) and heat transfer coefficient (Nusselt number) in the transition region as well as the laminar and turbulent flow regions for different inlet configurations and fin geometry. The work presented in Part I of the book provides the thermal systems design engineer the necessary design tools. Part II of this book provides design engineers using gas-liquid two-phase flow in different industrial applications the necessary fundamental understanding of the two-phase flow variables. Two-phase flow literature reports a plethora of correlations for determination of flow patterns, void fraction, two- phase pressure drop and non-boiling heat transfer correlations. However, the validity of a majority of these correlations is restricted over a narrow range of two-phase flow conditions. Consequently, it is quite a challenging task for the end user to select an appropriate correlation/model for the type of two-phase flow under consideration. Selection of a correct correlation also requires some fundamental understanding of the two-phase flow physics and the underlying principles/assumptions/limitations associated with these correlations. Thus, it is of significant interest for a design engineer to have knowledge of the flow patterns and their transitions and their influence on two-phase flow variables. To address some of these issues and facilitate selection of appropriate two-phase flow models, Part II of this book presents a succinct review of the flow patterns, void fraction, pressure drop and non-boiling heat transfer phenomenon and recommend some of the well scrutinized modeling techniques. Reviews pressure drop, heat transfer coefficient, and inlet configuration effect in the transition region Includes void fraction correlations for flow patterns, pipe orientations, models for pressure drop calculations Presents non-boiling two-phase flow heat transfer correlations for different flow patterns and pipe orientations.

Download or read book Modelling and Experimentation in Two Phase Flow written by Volfango Bertola and published by Springer. This book was released on 2014-05-04 with total page 433 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is an up-to-date review of recent advances in the study of two-phase flows, with focus on gas-liquid flows, liquid-liquid flows, and particle transport in turbulent flows. The book is divided into several chapters, which after introducing basic concepts lead the reader through a more complex treatment of the subjects. The reader will find an extensive review of both the older and the more recent literature, with abundance of formulas, correlations, graphs and tables. A comprehensive (though non exhaustive) list of bibliographic references is provided at the end of each chapter. The volume is especially indicated for researchers who would like to carry out experimental, theoretical or computational work on two-phase flows, as well as for professionals who wish to learn more about this topic.

Download or read book Advances in Two Phase Flow and Heat Transfer written by Sadik Kakaç and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 459 pages. Available in PDF, EPUB and Kindle. Book excerpt: Over the past two decades, two-phase flow and heat transfer problems associated with two-phase phenomena have been a challenge to many investigators. Two-phase flow applications are found in a wide range of engineering systems, such as nuclear and conventional power plants, evaporators of refrigeration systems and a wide vari ety of evaporative and condensive heat exchangers in the chemical industry. This publication is based on the invited lectures presented at the NATO Advanced Research Workshop on the Advances in Two-Phase Flow and Heat Transfer. The Horkshop was attended by more than 50 leading scientists and practicing engineers who work actively on two-phase flow and heat transfer research and applications in dif ferent sectors (academia, government, industry) of member countries of NATO. Some scientific leaders and experts on the subject matter from the non-NATO countries were also invited. They convened to discuss the state-of-the-art in two-phase flow and heat transfer and formulated recommendations for future research directions. To achieve these goals, invited key papers and a limited number of contributions were presented and discussed. The specific aspects of the subject were treated in depth in the panel sessions, and the unresolved problems identified. Suitable as a practical reference, these volumes incorporate a systematic approach to two-phase flow analysis.

Download or read book Heat Transfer and Pressure Drop Studies in Two phase Flow of Air and Water written by Raghunath Vinayak Date and published by . This book was released on 1961 with total page 82 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Two phase Flow in Pipelines and Heat Exchangers written by Duncan Chisholm and published by . This book was released on 1983 with total page 328 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Advances in Two Phase Flow and Heat Transfer written by Sadik Kakaç and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 465 pages. Available in PDF, EPUB and Kindle. Book excerpt: Over the past two decades, two-phase flow and heat transfer problems associated with two-phase phenomena have been a challenge to many investigators. Two-phase flow applications are found in a wide range of engineering systems, such as nuclear and conventional power plants, evaporators of refrigeration systems and a wide vari ety of evaporative and condensive heat exchangers in the chemical industry. This publication is based on the invited lectures presented at the NATO Advanced Research Workshop on the Advances in Two-Phase Flow and Heat Transfer. The Horkshop was attended by more than 50 leading scientists and practicing engineers who work actively on two-phase flow and heat transfer research and applications in dif ferent sectors (academia, government, industry) of member countries of NATO. Some scientific leaders and experts on the subject matter from the non-NATO countries were also invited. They convened to discuss the state-of-the-art in two-phase flow and heat transfer and formulated recommendations for future research directions. To achieve these goals, invited key papers and a limited number of contributions were presented and discussed. The specific aspects of the subject were treated in depth in the panel sessions, and the unresolved problems identified. Suitable as a practical reference, these volumes incorporate a systematic approach to two-phase flow analysis.

Download or read book Two phase Flow and Heat Transfer written by United Kingdom Atomic Energy Authority. Research Group and published by . This book was released on 1977 with total page 552 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Pressure Drop in Two phase Flow written by D. H. Weiss and published by . This book was released on 1953 with total page 100 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this study was to investigate experimentally two-phase flow in a single vertical channel which was uniformly heated. The channel was a 0.174 inches I.D., 24 inches long, electrically heated stainless steel tube through which distilled water was passed.

Download or read book Pressure Drop and Heat Transfer in Two phase Flow in a Vertical Tube written by David E. Schoeffel and published by . This book was released on 1952 with total page 136 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Heat Transfer and Pressure Drop in Swirl Flow Through Rough Tubes written by Ronald Alan Lee and published by . This book was released on 1968 with total page 132 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Two phase Flow and Heat Transfer in the Power and Process Industries written by A. E. Bergles and published by McGraw-Hill Companies. This book was released on 1981 with total page 736 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Pressure Drop and Heat Transfer Study of Two phase Flow in Small Channels written by Thanh Nhon Tran and published by . This book was released on 1998 with total page 452 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Two Phase Flow Boiling and Condensation written by S. Mostafa Ghiaasiaan and published by Cambridge University Press. This book was released on 2017-01-11 with total page 1322 pages. Available in PDF, EPUB and Kindle. Book excerpt: Providing a comprehensive introduction to the fundamentals and applications of flow and heat transfer in conventional and miniature systems, this fully enhanced and updated edition covers all the topics essential for graduate courses on two-phase flow, boiling, and condensation. Beginning with a concise review of single-phase flow fundamentals and interfacial phenomena, detailed and clear discussion is provided on a range of topics, including two-phase hydrodynamics and flow regimes, mathematical modeling of gas-liquid two-phase flows, pool and flow boiling, flow and boiling in mini and microchannels, external and internal-flow condensation with and without noncondensables, condensation in small flow passages, and two-phase choked flow. Numerous solved examples and end-of-chapter problems that include many common design problems likely to be encountered by students, make this an essential text for graduate students. With up-to-date detail on the most recent research trends and practical applications, it is also an ideal reference for professionals and researchers in mechanical, nuclear, and chemical engineering.

Download or read book Heat Transfer and Pressure Drop During Single and Two phase Flow Through Unconsolidated Porous Media written by Mohammad Reza Izadpanah and published by . This book was released on 1999 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Two phase Flow and Heat Transfer written by P. B. Whalley and published by Oxford University Press, USA. This book was released on 1996 with total page 104 pages. Available in PDF, EPUB and Kindle. Book excerpt: This concise and well illustrated book is intended for students of chemical and mechanical engineering. It is concerned exclusively with gas-liquid flows. The first part deals with adiabatic flows, that is, flows without the addition or removal of heat. The second part deals with heat-transfer in two-phase flows: boiling and condensation. The various types of heat transfer are identified and methods to calculate them given. Two-phase flow and heat transfer are commonly encountered in heat exchangers (distillation and condensation) and in pipelines, and are therefore fundamental to many industrial chemistry processes.