Download or read book Heat of Vaporization and Species Evolution During Gasoline Evaporation Measured by DSC TGA MS for Blends of C1 to C4 Alcohols in Commercial Gasoline Blendstock written by Gina M. Fioroni and published by . This book was released on 2019 with total page 13 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Heat of Vaporization and Species Evolution During Gasoline Evaporation Measured by DSC TGA MS for Blends of C1 to C4 Alcohols in Commercial Gasoline Blendstocks written by and published by . This book was released on 2019 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Evaporative cooling of the fuel-air charge by fuel evaporation is an important feature of direct-injection spark-ignition engines that improves fuel knock resistance and reduces pumping losses at intermediate load but, in some cases, may increase fine particle emissions. We have reported on experimental approaches for measuring both total heat of vaporization and examination of the evaporative heat effect as a function of fraction evaporated for gasolines and ethanol blends. In this paper we extend this work to include other low-molecular-weight alcohols and additionally present results on species evolution during fuel evaporation by coupling of a mass spectrometer to our differential scanning calorimetry/thermogravimetric analysis instrument (DSC/TGA/MS). The alcohols examined were methanol, ethanol, 1-propanol (n-propanol), isopropanol, 2-butanol, and isobutanol at 10, 20, and 30 vol%. The results show that total HOV of the alcohol gasoline blends is in line with the decreasing HOV in kJ/kg with increasing alcohol carbon number, as expected. MS results show that methanol fully evaporates at significantly lower fraction evaporated relative to other alcohols even though it is present at higher molar concentration. Certain alcohols, especially methanol and ethanol can suppress the evaporation of aromatic compounds such as cumene during the evaporation process in some samples. While the use of mass spectrometry to analyze the composition of the evolving gas mixture provided useful results for a relatively simple research gasoline (FACE B), additional research is required to practically apply this methodology to more complex commercial gasolines.
Download or read book Heat of Vaporization by Measurement Using DSC TGA versus Estimation Using Detailed Hydrocarbon Analysis Preprint written by and published by . This book was released on 2015 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: One important property in assessing the knock resistance of ethanol-gasoline blends is heat of vaporization (HOV). Both estimation and direct measurement of the HOV have been problematic due to several factors. In this work, two different approaches were taken toward determination of the HOV. One was direct measurement by DSC/TGA. The other was by estimating the HOV by DHA.
Download or read book Guide to ASTM Test Methods for the Analysis of Petroleum Products and Lubricants written by R. A. Nadkarni and published by Astm International. This book was released on 2000 with total page 389 pages. Available in PDF, EPUB and Kindle. Book excerpt: Summarizes the essential elements of all analytical tests used to characterize petroleum products. The 350 plus entries are alphabetically arranged by chemical and physical properties, such as apparent viscosity, density, metal analysis, sulfur determination, vapor pressure, and water. Each entry co
Download or read book Fuels and Lubricants Handbook written by and published by . This book was released on 2003 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Natural Gas Conversion written by A. Holmen and published by Elsevier. This book was released on 1991-05-27 with total page 585 pages. Available in PDF, EPUB and Kindle. Book excerpt: These proceedings reflect the extensive fundamental and applied research efforts that are currently being made on the conversion of gas, in particular on the direct conversion of methane. The Symposium in Oslo focused on the following topics: Direct conversion of methane, Fischer-Tropsch chemistry, methanol conversion and natural gas conversion processes. The main aim was to present the state-of-the-art and progress currently being made within each of these areas. The book contains the papers presented and includes plenary lectures, short communications and posters. The papers will be of interest to scientists and engineers working in the field of gas conversion, transportation fuels, primary petrochemicals and catalysis.
Download or read book Advanced Direct Injection Combustion Engine Technologies and Development written by H Zhao and published by Elsevier. This book was released on 2014-01-23 with total page 325 pages. Available in PDF, EPUB and Kindle. Book excerpt: Direct injection enables precise control of the fuel/air mixture so that engines can be tuned for improved power and fuel economy, but ongoing research challenges remain in improving the technology for commercial applications. As fuel prices escalate DI engines are expected to gain in popularity for automotive applications. This important book, in two volumes, reviews the science and technology of different types of DI combustion engines and their fuels. Volume 1 deals with direct injection gasoline and CNG engines, including history and essential principles, approaches to improved fuel economy, design, optimisation, optical techniques and their applications. Reviews key technologies for enhancing direct injection (DI) gasoline engines Examines approaches to improved fuel economy and lower emissions Discusses DI compressed natural gas (CNG) engines and biofuels
Download or read book Recent Progress in Bioconversion of Lignocellulosics written by George T. Tsao and published by Springer Science & Business Media. This book was released on 1999-09-02 with total page 297 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume reports the latest advances in the science and technology related to the conversion of lignocellulosics. A portion of the volume is devoted to molecular biology of the enzymes and the microbes involved in the conversion. Hydrolysis of cellulose continues to be of prime importance in the overall conversion scheme. Reaction kinetics and mechanisms of cellulases as well as the state-of-the-art methods of cellulase production by submerged fermentation and also by solid state fermentation are included in the volume. The latest advances made in dilute acid hydrolysis of cellulose are described. Finally, some exciting methods and perspectives for bioconverion of lignocellulosics into ethanol, organic acids and other value-added products are described. This volume should be useful to researchers in this area. It should also be helpful to those who want a concise overview of lignocellulosics.
Download or read book Zeolite Catalysts written by Subhash Bhatia and published by CRC Press. This book was released on 2020-07-24 with total page 302 pages. Available in PDF, EPUB and Kindle. Book excerpt: Presented in an easy-to-read form, this book on zeolite catalysis cover all aspects of the subject. It focuses on synthesis, structure, diffusion, deactivation, and industrial applications. This book is an ideal text for courses on catalysis or as a supplementary text for those studying applied or industrial chemistry. It is also a useful resource for anyone who works with zeolites as catalysts in the laboratory, pilot plants, or commercial installations.
Download or read book Internal Combustion Engine Handbook written by Richard Van Basshuysen and published by SAE International. This book was released on 2016-03-07 with total page 1152 pages. Available in PDF, EPUB and Kindle. Book excerpt: More than 120 authors from science and industry have documented this essential resource for students, practitioners, and professionals. Comprehensively covering the development of the internal combustion engine (ICE), the information presented captures expert knowledge and serves as an essential resource that illustrates the latest level of knowledge about engine development. Particular attention is paid toward the most up-to-date theory and practice addressing thermodynamic principles, engine components, fuels, and emissions. Details and data cover classification and characteristics of reciprocating engines, along with fundamentals about diesel and spark ignition internal combustion engines, including insightful perspectives about the history, components, and complexities of the present-day and future IC engines. Chapter highlights include: • Classification of reciprocating engines • Friction and Lubrication • Power, efficiency, fuel consumption • Sensors, actuators, and electronics • Cooling and emissions • Hybrid drive systems Nearly 1,800 illustrations and more than 1,300 bibliographic references provide added value to this extensive study. “Although a large number of technical books deal with certain aspects of the internal combustion engine, there has been no publication until now that covers all of the major aspects of diesel and SI engines.” Dr.-Ing. E. h. Richard van Basshuysen and Professor Dr.-Ing. Fred Schäfer, the editors, “Internal Combustion Engines Handbook: Basics, Components, Systems, and Perpsectives”
Download or read book Lignocellulose Conversion written by Vincenza Faraco and published by Springer Science & Business Media. This book was released on 2013-06-12 with total page 207 pages. Available in PDF, EPUB and Kindle. Book excerpt: Bioethanol has been recognized as a potential alternative to petroleum-derived transportation fuels. Even if cellulosic biomass is less expensive than corn and sugarcane, the higher costs for its conversion make the near-term price of cellulosic ethanol higher than that of corn ethanol and even more than that of sugarcane ethanol. Conventional process for bioethanol production from lignocellulose includes a chemical/physical pre-treatment of lignocellulose for lignin removal, mostly based on auto hydrolysis and acid hydrolysis, followed by saccharification of the free accessible cellulose portions of the biomass. The highest yields of fermentable sugars from cellulose portion are achieved by means of enzymatic hydrolysis, currently carried out using a mix of cellulases from the fungus Trichoderma reesei. Reduction of (hemi)cellulases production costs is strongly required to increase competitiveness of second generation bioethanol production. The final step is the fermentation of sugars obtained from saccharification, typically performed by the yeast Saccharomyces cerevisiae. The current process is optimized for 6-carbon sugars fermentation, since most of yeasts cannot ferment 5-carbon sugars. Thus, research is aimed at exploring new engineered yeasts abilities to co-ferment 5- and 6-carbon sugars. Among the main routes to advance cellulosic ethanol, consolidate bio-processing, namely direct conversion of biomass into ethanol by a genetically modified microbes, holds tremendous potential to reduce ethanol production costs. Finally, the use of all the components of lignocellulose to produce a large spectra of biobased products is another challenge for further improving competitiveness of second generation bioethanol production, developing a biorefinery.
Download or read book Dense Phase Carbon Dioxide written by Murat O. Balaban and published by John Wiley & Sons. This book was released on 2012-04-05 with total page 337 pages. Available in PDF, EPUB and Kindle. Book excerpt: Dense phase carbon dioxide (DPCD) is a non-thermal method for food and pharmaceutical processing that can ensure safe products with minimal nutrient loss and better preserved quality attributes. Its application is quite different than, for example, supercritical extraction with CO 2 where the typical solubility of materials in CO 2 is in the order of 1% and therefore requires large volumes of CO 2. In contrast, processing with DPCD requires much less CO 2 (between 5 to 8% CO 2 by weight) and the pressures used are at least one order of magnitude less than those typically used in ultra high pressure (UHP) processing. There is no noticeable temperature increase due to pressurization, and typical process temperatures are around 40°C. DPCD temporarily reduces the pH of liquid foods and because oxygen is removed from the environment, and because the temperature is not high during the short process time (typically about five minutes in continuous systems), nutrients, antioxidant activity, and vitamins are much better preserved than with thermal treatments. In pharmaceutical applications, DPCD facilitates the production of micronized powders of controlled particle size and distribution. Although the capital and operating costs are higher than that of thermal treatments, they are much lower than other non-thermal technology operations. This book is the first to bring together the significant amount of research into DPCD and highlight its effectiveness against microorganisms and enzymes as well as its potential in particle engineering. It is directed at food and pharmaceutical industry scientists and technologists working with DPCD and other traditional or non-thermal technologies that can potentially be used in conjunction with DPCD. It will also be of interest to packaging specialists and regulatory agencies.
Download or read book Inorganic Trace Analytics written by Henryk Matusiewicz and published by Walter de Gruyter GmbH & Co KG. This book was released on 2017-12-18 with total page 460 pages. Available in PDF, EPUB and Kindle. Book excerpt: Highly accurate chemical speciation is of great importance in environmental, clinical, and food sciences, as well as in archaeometry. Trace analysis via atomic spectrometry, mass spectroscopy, gas chromatography, electron microprobing, or X-ray absorption spectroscopy provides detailed information on surface and sub-surface domain of samples. The book comprehensively presents modern techniques, timely application, and data modeling.
Download or read book Motor Gasolines written by and published by . This book was released on 1975 with total page 80 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Hydrogenation written by S. David Jackson and published by Walter de Gruyter GmbH & Co KG. This book was released on 2018-09-24 with total page 326 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book gives a comprehensive overview of modern hydrogenation methods used in organic synthesis. In clearly structured chapters, the authors cover the catalysts, scope and limitations of their application, and the techniques for hydrogenation of carbon-carbon, carbon-heteroatom and heteroatom-heteroatom multiple bonds.
Download or read book Fresh from the Farm 6pk written by Rigby and published by . This book was released on 2006 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Kumba Africa written by Sampson Ejike Odum and published by iUniverse. This book was released on 2020-11-03 with total page 123 pages. Available in PDF, EPUB and Kindle. Book excerpt: ‘KUMBA AFRICA’, is a compilation of African Short Stories written as fiction by Sampson Ejike Odum, nostalgically taking our memory back several thousands of years ago in Africa, reminding us about our past heritage. It digs deep into the traditional life style of the Africans of old, their beliefs, their leadership, their courage, their culture, their wars, their defeat and their victories long before the emergence of the white man on the soil of Africa. As a talented writer of rich resource and superior creativity, armed with in-depth knowledge of different cultures and traditions in Africa, the Author throws light on the rich cultural heritage of the people of Africa when civilization was yet unknown to the people. The book reminds the readers that the Africans of old kept their pride and still enjoyed their own lives. They celebrated victories when wars were won, enjoyed their New yam festivals and villages engaged themselves in seasonal wrestling contest etc; Early morning during harmattan season, they gathered firewood and made fire inside their small huts to hit up their bodies from the chilling cold of the harmattan. That was the Africa of old we will always remember. In Africa today, the story have changed. The people now enjoy civilized cultures made possible by the influence of the white man through his scientific and technological process. Yet there are some uncivilized places in Africa whose people haven’t tested or felt the impact of civilization. These people still maintain their ancient traditions and culture. In everything, we believe that days when people paraded barefooted in Africa to the swarmp to tap palm wine and fetch firewood from there farms are almost fading away. The huts are now gradually been replaced with houses built of blocks and beautiful roofs. Thanks to modern civilization. Donkeys and camels are no longer used for carrying heavy loads for merchants. They are now been replaced by heavy trucks and lorries. African traditional methods of healing are now been substituted by hospitals. In all these, I will always love and remember Africa, the home of my birth and must respect her cultures and traditions as an AFRICAN AUTHOR.
