Download or read book Geophysical Exploration for Engineering and Environmental Investigations written by and published by . This book was released on 1995 with total page 150 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Geophysical Exploration for Engineering and Environmental Investigations written by United States. Army. Corps of Engineers and published by American Society of Civil Engineers. This book was released on 1998 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This manual provides an introduction to geo-physical exploration for engineering; geological, and environmental investigations. A broad overview of geophysical applications to engineering and environmental problems is presented, in addition to descriptions of the most commonly conducted geophysical procedures. The procedural evaluation, use, and deployment of the generalized geophysical approach is discussed and geophysical methodologies are examined.
Download or read book Geophysical Exploration for Engineering and Environmental Investigations written by United States Army Corps of Engineers and published by . This book was released on 2005 with total page 220 pages. Available in PDF, EPUB and Kindle. Book excerpt: This manual provides an introduction to geophysical exploration for engineering, geological, and environmental (to include Hazardous, Toxic and Radioactive Waste (HTRW)) investigations. Descriptions and guidance are provided for the geophysical methods typically used in these investigations. The manual furnishes a broad overview of geophysical applications to common engineering, environmental and geological problems. Descriptions of the most commonly conducted geophysical procedures are given. These contents are not proposed to explicitly develop field procedures and data reduction techniques for geophysical surveys. Chapter 2 develops the procedural evaluation, use, and deployment of the generalized geophysical approach. Subsequent chapters address particular geophysical methodologies.
Download or read book Applied Geophysics with Case Studies on Environmental Exploration and Engineering Geophysics written by Ali Ismet Kanlı and published by BoD – Books on Demand. This book was released on 2019-06-05 with total page 152 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a general introduction to the most important methods of applied geophysics with a variety of case studies. These methods represent a primary tool for investigation of the subsurface and are applicable to a very wide range of problems. Applied geophysics is based on physics principles that collect and interpret data on subsurface conditions for practical purposes, including oil and gas exploration, mineral prospecting, geothermal exploration, groundwater exploration, engineering applications, archeological interests, and environmental concerns. The depth of investigation into applied geophysics is shallow, typically from the ground surface to several kilometers deep, where economic, cultural, engineering, or environmental concerns often arise. Applied geophysics uses almost all of the current geophysical methods, including electrical, magnetic, electromagnetic, gravimetric, geothermal, seismic, seismoelectric, magnetotelluric, nuclear, and radioactive methods. In applied geophysics, geophysicists are usually required to have a good understanding of math and physics principles, knowledge of geology and computer skills, and hands-on experience of electronic instruments. A geophysicist's routine job includes survey designs, data acquisition, data processing, and data interpretation with detailed explanation of the study. Applied geophysics consists of three main subject and interest areas, which are exploration geophysics, engineering geophysics, and environmental geophysics.
Download or read book Geophysical Exploration for Engineering and Environmental Investigations Scholar s Choice Edition written by Department of Army U S Army Corps of E and published by Scholar's Choice. This book was released on 2015-02-16 with total page 212 pages. Available in PDF, EPUB and Kindle. Book excerpt: This work has been selected by scholars as being culturally important, and is part of the knowledge base of civilization as we know it. This work was reproduced from the original artifact, and remains as true to the original work as possible. Therefore, you will see the original copyright references, library stamps (as most of these works have been housed in our most important libraries around the world), and other notations in the work. This work is in the public domain in the United States of America, and possibly other nations. Within the United States, you may freely copy and distribute this work, as no entity (individual or corporate) has a copyright on the body of the work.As a reproduction of a historical artifact, this work may contain missing or blurred pages, poor pictures, errant marks, etc. Scholars believe, and we concur, that this work is important enough to be preserved, reproduced, and made generally available to the public. We appreciate your support of the preservation process, and thank you for being an important part of keeping this knowledge alive and relevant.
Download or read book An Introduction to Applied and Environmental Geophysics written by John M. Reynolds and published by John Wiley and Sons. This book was released on 2011-03-31 with total page 1214 pages. Available in PDF, EPUB and Kindle. Book excerpt: An Introduction to Applied and Environmental Geophysics, 2nd Edition, describes the rapidly developing field of near-surface geophysics. The book covers a range of applications including mineral, hydrocarbon and groundwater exploration, and emphasises the use of geophysics in civil engineering and in environmental investigations. Following on from the international popularity of the first edition, this new, revised, and much expanded edition contains additional case histories, and descriptions of geophysical techniques not previously included in such textbooks. The level of mathematics and physics is deliberately kept to a minimum but is described qualitatively within the text. Relevant mathematical expressions are separated into boxes to supplement the text. The book is profusely illustrated with many figures, photographs and line drawings, many never previously published. Key source literature is provided in an extensive reference section; a list of web addresses for key organisations is also given in an appendix as a valuable additional resource. Covers new techniques such as Magnetic Resonance Sounding, Controlled- Source EM, shear-wave seismic refraction, and airborne gravity and EM techniques Now includes radioactivity surveying and more discussions of down-hole geophysical methods; hydrographic and Sub-Bottom Profiling surveying; and UneXploded Ordnance detection Expanded to include more forensic, archaeological, glaciological, agricultural and bio-geophysical applications Includes more information on physio-chemical properties of geological, engineering and environmental materials Takes a fully global approach Companion website with additional resources available at www.wiley.com/go/reynolds/introduction2e Accessible core textbook for undergraduates as well as an ideal reference for industry professionals The second edition is ideal for students wanting a broad introduction to the subject and is also designed for practising civil and geotechnical engineers, geologists, archaeologists and environmental scientists who need an overview of modern geophysical methods relevant to their discipline. While the first edition was the first textbook to provide such a comprehensive coverage of environmental geophysics, the second edition is even more far ranging in terms of techniques, applications and case histories.
Download or read book Geotechnical and Environmental Geophysics Environmental and groundwater written by Stanley H. Ward and published by . This book was released on with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book An Introduction to Geophysical Exploration written by Philip Kearey and published by John Wiley & Sons. This book was released on 2013-04-16 with total page 292 pages. Available in PDF, EPUB and Kindle. Book excerpt: This new edition of the well-established Kearey and Brooks text is fully updated to reflect the important developments in geophysical methods since the production of the previous edition. The broad scope of previous editions is maintained, with even greater clarity of explanations from the revised text and extensively revised figures. Each of the major geophysical methods is treated systematically developing the theory behind the method and detailing the instrumentation, field data acquisition techniques, data processing and interpretation methods. The practical application of each method to such diverse exploration applications as petroleum, groundwater, engineering, environmental and forensic is shown by case histories. The mathematics required in order to understand the text is purposely kept to a minimum, so the book is suitable for courses taken in geophysics by all undergraduate students. It will also be of use to postgraduate students who might wish to include geophysics in their studies and to all professional geologists who wish to discover the breadth of the subject in connection with their own work.
Download or read book Near surface Geophysics written by Dwain K. Butler and published by SEG Books. This book was released on 2005 with total page 734 pages. Available in PDF, EPUB and Kindle. Book excerpt: Part 1, "fundamentals", includes magnetic and electrical methods, subsurface geophysics, near-surface seismology, electromagnetic induction, and ground-penetrating radar. Part 2, "applications", includes determination of physical properties, multimethod surveys and integrated interpretations, and model-based survey planning, execution, and interpretation.
Download or read book Seeing into the Earth written by National Research Council and published by National Academies Press. This book was released on 2000-05-26 with total page 156 pages. Available in PDF, EPUB and Kindle. Book excerpt: Just below our feet is an environment that supports our infrastructure, yields water, provides for agriculture, and receives our waste. Our capacity to describe, or characterize, this environment is crucial to the solution of many resource, environmental, and engineering problems. And just as medical imaging technologies have reduced the need for exploratory surgeries, a variety of technologies hold the promise for rapid, relatively inexpensive noninvasive characterization of the Earth's subsurface. Seeing into the Earth examines why noninvasive characterization is important and how improved methods can be developed and disseminated. Looking at the issues from both the commercial and public perspectives, the volume makes recommendations for linking characterization and cost savings, closing the gap between the state of science and the state of the practice, and helping practitioners make the best use of the best methods. The book provides background on: The role of noninvasive subsurface characterization in contaminant cleanup, resource management, civil engineering, and other areas. The physical, chemical, biological, and geological properties that are characterized. Methods of characterization and prospects for technological improvement. Certain to be important for earth scientists and engineers alike, this book is also accessible to interested lay readers.
Download or read book Applied Geophysics with Case Studies on Environmental Exploration and Engineering Geophysics written by Ali Ismet Kanlı and published by . This book was released on 2019 with total page 150 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a general introduction to the most important methods of applied geophysics with a variety of case studies. These methods represent a primary tool for investigation of the subsurface and are applicable to a very wide range of problems. Applied geophysics is based on physics principles that collect and interpret data on subsurface conditions for practical purposes, including oil and gas exploration, mineral prospecting, geothermal exploration, groundwater exploration, engineering applications, archeological interests, and environmental concerns. The depth of investigation into applied geophysics is shallow, typically from the ground surface to several kilometers deep, where economic, cultural, engineering, or environmental concerns often arise. Applied geophysics uses almost all of the current geophysical methods, including electrical, magnetic, electromagnetic, gravimetric, geothermal, seismic, seismoelectric, magnetotelluric, nuclear, and radioactive methods. In applied geophysics, geophysicists are usually required to have a good understanding of math and physics principles, knowledge of geology and computer skills, and hands-on experience of electronic instruments. A geophysicist's routine job includes survey designs, data acquisition, data processing, and data interpretation with detailed explanation of the study. Applied geophysics consists of three main subject and interest areas, which are exploration geophysics, engineering geophysics, and environmental geophysics.
Download or read book Geophysics for the Mineral Exploration Geoscientist written by Michael Dentith and published by Cambridge University Press. This book was released on 2014-04-24 with total page 1083 pages. Available in PDF, EPUB and Kindle. Book excerpt: Providing a balance between principles and practice, this state-of-the-art overview of geophysical methods takes readers from the basic physical phenomena, through the acquisition and processing of data, to the creation of geological models of the subsurface and data interpretation to find hidden mineral deposits. Detailed descriptions of all the commonly used geophysical methods are given, including gravity, magnetic, radiometric, electrical, electromagnetic and seismic methods. Each technique is described in a consistent way and without complex mathematics. Emphasising extraction of maximum geological information from geophysical data, the book also explains petrophysics, data modelling and common interpretation pitfalls. Packed with full-colour figures, also available online, the text is supported by selected examples from around the world, including all the major deposit types. Designed for advanced undergraduate and graduate courses in minerals geoscience, this is also a valuable reference for professionals in the mining industry wishing to make greater use of geophysical methods. In 2015, Dentith and Mudge won the ASEG Lindsay Ingall Memorial Award for their combined effort in promoting geophysics to the wider community with the publication of this title.
Download or read book Environmental and Engineering Geophysics written by P. Vallabh Sharma and published by Cambridge University Press. This book was released on 1997-11-20 with total page 496 pages. Available in PDF, EPUB and Kindle. Book excerpt: This advanced undergraduate textbook comprehensively describes principal geophysical surveying techniques for environmental and engineering problems.
Download or read book Geophysics in Engineering Investigations written by P. W. McDowell and published by . This book was released on 2002 with total page 262 pages. Available in PDF, EPUB and Kindle. Book excerpt: The full potential of geophysics in engineering investigations is still to be realised. The many available techniques can provide important information about the ground, its mass properties, its small-scale variations, and its anomalies of structure or content. The advantage of a geophysical survey is that it enables information to be obtained for large volumes of ground that cannot be investigated by direct methods due to cost. The applications of geophysics in the characterisation of contaminated land are still developing, but have great potential for example in the distribution and migration of pollutants in the ground and groundwater. Geophysics is still insufficiently or inappropriately used in engineering and the newer capabilities are not appreciated, so there is a need for up-to-date guidance about how to apply geophysical investigations.This report is published in co-operation with the Geological Society and presents a logical guide through the process of using geophysical investigation methods in site characterisation. It explores the roles of geophysical methods and provides the background to geophysics as an investigative tool. The procurement, management and reporting frameworks for a geophysical investigation are set out, and the importance of the involvement of a recognised geophysics specialist adviser with the work is emphasised. The report explains the need for a conceptual ground model to enable appropriate investigative methods to be chosen. The underlying science and current practices of the main techniques are explained as well as the processes of data acquisition, handling and presentation. The different targets determinable by geophysical methods are considered in separate sections for geological, geotechnical, geo-environmental and structural engineering applications. The report concludes with recommendations for practice. The guide is aimed at geotechnical and civil engineers, geologists and engineering geologists, specialist geophysics contractors, contractors, consultants and clients.
Download or read book Integrated Geophysical Exploration Models and Techniques written by Meju and published by . This book was released on 2018-01-26 with total page 350 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Near Surface Applied Geophysics written by Mark E. Everett and published by Cambridge University Press. This book was released on 2013-04-25 with total page 419 pages. Available in PDF, EPUB and Kindle. Book excerpt: Just a few meters below the Earth's surface lie features of great importance, from geological faults which can produce devastating earthquakes, to lost archaeological treasures. This refreshing, up-to-date book explores the foundations of interpretation theory and the latest developments in near-surface techniques, used to complement traditional geophysical methods for deep-exploration targets. Clear but rigorous, the book explains theory and practice in simple physical terms, supported by intermediate-level mathematics. Techniques covered include magnetics, resistivity, seismic reflection and refraction, surface waves, induced polarization, self-potential, electromagnetic induction, ground-penetrating radar, magnetic resonance, interferometry, seismoelectric and more. Sections on data analysis and inverse theory are provided and chapters are illustrated by case studies, giving students and professionals the tools to plan, conduct and analyze a near-surface geophysical survey. This is an important textbook for advanced-undergraduate and graduate students in geophysics and a valuable reference for practising geophysicists, geologists, hydrologists, archaeologists, and civil and geotechnical engineers.
Download or read book Applications of Geophysics in Environmental Investigations written by John P. Greenhouse and published by . This book was released on 1998 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
