Download or read book Flow Boiling Heat Transfer and Visualization in Narrow Channels written by Marta Cortina Diaz and published by . This book was released on 2008 with total page 177 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Flow Boiling Heat Transfer in Narrow Vertical Channels written by and published by Cuvillier Verlag. This book was released on 2004-10-14 with total page 136 pages. Available in PDF, EPUB and Kindle. Book excerpt: Saturated flow boiling heat transfer and flow visualization experiments were carried out in three vertical rectangular channels with dimensions (width×height) 2.0×4.0, 0.86×2.0 and 0.54×1.60 mm² (corresponding to hydraulic diameters 2.67, 1.20 and 0.81 mm, respectively). The channels were heated from three sides. Deionized water was used as the working fluid. The channel exit was at atmospheric pressure. Benchmark experiments of single-phase flow were also conducted for pressure drop and heat transfer. Experimental results show that for the 0.54×1.60 mm² channel, the singlephase friction factor is higher than predicted by well-accepted correlations, while for the other two channels it can be well correlated. The heat transfer performance for both laminar and turbulent regimes under asymmetric heating conditions is different from that under uniform heating conditions on which the existing correlations are based. Therefore single-phase heat transfer correlations were modified so that they could be incorporated into the two-phase heat transfer correlations employed for asymmetric heating conditions. For flow boiling, three basic flow patterns are observed for all the channels, viz., bubbly, slug and annular flow. However, based on the developed flow pattern maps, the transition from slug to annular flow for the 2.0×4.0 mm² channel occurs at a lower superficial vapor velocity than for the two small channels. This suggests that the nucleate boiling mechanism, which generally corresponds to slug flow, is more important for the two small channels. Saturated flow boiling heat transfer characteristics were investigated under different heat flux, mass flux and vapor quality. The experimental local heat transfer coefficient for the 2.0×4.0 mm² channel is in good agreement with the modified Kandlikar correlation and the Shah correlation. For the smaller channels (0.86×2.0 mm² and 0.54×1.60 mm²), the heat transfer characteristics are not dominated by the convective boiling mechanism. On the contrary, the nucleate boiling term of the Kandlikar correlation predicts the experimental heat transfer coefficient relatively well. Two new correlations have been developed in which the local two-phase heat transfer coefficient is related to the single-phase heat transfer coefficient by a twophase multiplier, which is a function of the Boiling number and thermodynamic vapor quality. The developed correlations show rather good agreement with experimental results.
Download or read book Flow Boiling Heat Transfer in Narrow Vertical Channels written by Jianyun Shuai and published by Cuvillier Verlag. This book was released on 2004 with total page 131 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Flow Boiling in Microgap Channels written by Tamanna Alam and published by Springer Science & Business Media. This book was released on 2013-08-26 with total page 88 pages. Available in PDF, EPUB and Kindle. Book excerpt: Flow Boiling in Microgap Channels: Experiment, Visualization and Analysis presents an up-to-date summary of the details of the confined to unconfined flow boiling transition criteria, flow boiling heat transfer and pressure drop characteristics, instability characteristics, two phase flow pattern and flow regime map and the parametric study of microgap dimension. Advantages of flow boiling in microgaps over microchannels are also highlighted. The objective of this Brief is to obtain a better fundamental understanding of the flow boiling processes, compare the performance between microgap and conventional microchannel heat sinks, and evaluate the microgap heat sink for instabilities and hotspot mitigation.
Download or read book Nya frim rksklubbens och Sk nska social demokratens utst llning Min hobby i Jacob Hansens hus H lsingborg 16 18 maj 1953 written by and published by . This book was released on 1953 with total page 15 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Heat Transfer and Fluid Flow in Minichannels and Microchannels written by Satish Kandlikar and published by Elsevier. This book was released on 2006 with total page 492 pages. Available in PDF, EPUB and Kindle. Book excerpt: &Quot;This book explores flow through passages with hydraulic diameters from about 1 [mu]m to 3 mm, covering the range of minichannels and microchannels. Design equations along with solved examples and practice problems are also included to serve the needs of practicing engineers and students in a graduate course."--BOOK JACKET.
Download or read book Heat Transfer and Pressure Drop in Flow Boiling in Microchannels written by Sujoy Kumar Saha and published by Springer. This book was released on 2015-07-08 with total page 63 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Brief addresses the phenomena of heat transfer and pressure drop in flow boiling in micro channels occurring in high heat flux electronic cooling. A companion edition in the Springer Brief Subseries on Thermal Engineering and Applied Science to “Critical Heat Flux in Flow Boiling in Micro channels,” by the same author team, this volume is idea for professionals, researchers and graduate students concerned with electronic cooling.
Download or read book Flow Boiling in Microgap Channels written by Tamanna Alam and published by Springer. This book was released on 2013-08-26 with total page 84 pages. Available in PDF, EPUB and Kindle. Book excerpt: Flow Boiling in Microgap Channels: Experiment, Visualization and Analysis presents an up-to-date summary of the details of the confined to unconfined flow boiling transition criteria, flow boiling heat transfer and pressure drop characteristics, instability characteristics, two phase flow pattern and flow regime map and the parametric study of microgap dimension. Advantages of flow boiling in microgaps over microchannels are also highlighted. The objective of this Brief is to obtain a better fundamental understanding of the flow boiling processes, compare the performance between microgap and conventional microchannel heat sinks, and evaluate the microgap heat sink for instabilities and hotspot mitigation.
Download or read book Convective Boiling and Condensation written by John G. Collier and published by Clarendon Press. This book was released on 1994-05-19 with total page 646 pages. Available in PDF, EPUB and Kindle. Book excerpt: * Third edition of a well-known and well established text both in industry and for teaching * Fully up-to-date and includes extra problems This book is an aid to heat exchanger design written primarily for design and development engineers in the chemical process, power generation, and refrigeration industries. It provides a comprehensive reference on two-phase flows, boiling, and condensation. The text covers all the latest advances like flows over tube bundles and two-phase heat transfer regarding refrigerants and petrochemicals. Another feature of this third edition is many new problems at chapter ends to enhance its use as a teaching text for graduate and post-graduate courses on two-phase flow and heat transfer. - ;This book is written for practising engineers as a comprehensive reference on two-phase flows, boiling, and condensation. It deals with methods for estimating two-phase flow pressure drops and heat transfer rates. It is a well-known reference book in its third edition and is also used as a text for advanced university courses. Both authors write from practical experience as both are professional engineers. -
Download or read book Flow Boiling in Expanding Microchannels written by Tamanna Alam and published by Springer. This book was released on 2017-05-24 with total page 89 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Brief presents an up to date summary of details of the flow boiling heat transfer, pressure drop and instability characteristics; two phase flow patterns of expanding microchannels. Results obtained from the different expanding microscale geometries are presented for comparison and addition to that, comparison with literatures is also performed. Finally, parametric studies are performed and presented in the brief. The findings from this study could help in understanding the complex microscale flow boiling behavior and aid in the design and implementation of reliable compact heat sinks for practical applications.
Download or read book Flow Boiling Heat Transfer in a Single Narrow Channel written by M. R. Aligoodarz and published by . This book was released on 1998 with total page 254 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book VDI Heat Atlas written by VDI Gesellschaft and published by Springer Science & Business Media. This book was released on 2010-07-21 with total page 1608 pages. Available in PDF, EPUB and Kindle. Book excerpt: For more than 50 years, the Springer VDI Heat Atlas has been an indispensable working means for engineers dealing with questions of heat transfer. Featuring 50% more content, this new edition covers most fields of heat transfer in industrial and engineering applications. It presents the interrelationships between basic scientific methods, experimental techniques, model-based analysis and their transfer to technical applications.
Download or read book Flow boiling and condensation in microscale channels written by Fabio Toshio Kanizawa and published by Springer Nature. This book was released on 2021-04-30 with total page 290 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book covers aspects of multiphase flow and heat transfer during phase change processes, focusing on boiling and condensation in microscale channels. The authors present up-to-date predictive methods for flow pattern, void fraction, pressure drop, heat transfer coefficient and critical heat flux, pointing out the range of operational conditions that each method is valid. The first four chapters are dedicated on the motivation to study multiphase flow and heat transfer during phase change process, and the three last chapters are focused on the analysis of heat transfer process during boiling and condensation. During the description of the models and predictive methods, the trends are discussed and compared with experimental findings.
Download or read book Thermal Design of Electronic Equipment written by Ralph Remsburg and published by CRC Press. This book was released on 2017-12-19 with total page 440 pages. Available in PDF, EPUB and Kindle. Book excerpt: In a field where change and growth is inevitable, new electronic packaging problems continually arise. Smaller, more powerful devices are prone to overheating, causing intermittent system failures, corrupted signals, lower MTBF, and outright system failure. Since convection cooling is the heat transfer path most engineers take to deal with thermal problems, it is appropriate to gain as much understanding about the underlying mechanisms of fluid motion as possible. Thermal Design of Electronic Equipment is the only book that specifically targets the formulas used by electronic packaging and thermal engineers. It presents heat transfer equations dealing with polyalphaolephin (PAO), silicone oils, perfluorocarbons, and silicate ester-based liquids. Instead of relying on theoretical expressions and text explanations, the author presents empirical formulas and practical techniques that allow you to quickly solve nearly any thermal engineering problem in electronic packaging.
Download or read book Flow Visualization of Microscale Thermal Mechanics of Boiling in Small Channels written by and published by . This book was released on 1995 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Instability in Flow Boiling in Microchannels written by Sujoy Kumar Saha and published by Springer. This book was released on 2015-09-14 with total page 63 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Brief addresses the phenomena of instability in flow boiling in microchannels occurring in high heat flux electronic cooling. A companion edition in the SpringerBrief Subseries on Thermal Engineering and Applied Science to “Critical Heat Flux in Flow Boiling in Microchannels,” and "Heat Transfer and Pressure Drop in Flow Boiling in Microchannels,"by the same author team, this volume is idea for professionals, researchers, and graduate students concerned with electronic cooling.
Download or read book Encyclopedia of Two Phase Heat Transfer and Flow IV written by John R Thome and published by World Scientific Publishing. This book was released on 2018-05-18 with total page 1372 pages. Available in PDF, EPUB and Kindle. Book excerpt: Set IV is a new addition to the previous Sets I, II and III. It contains 23 invited chapters from international specialists on the topics of numerical modeling of pulsating heat pipes and of slug flows with evaporation; lattice Boltzmann modeling of pool boiling; fundamentals of boiling in microchannels and microfin tubes, CO2 and nanofluids; testing and modeling of micro-two-phase cooling systems for electronics; and various special topics (flow separation in microfluidics, two-phase sensors, wetting of anisotropic surfaces, ultra-compact heat exchangers, etc.). The invited authors are leading university researchers and well-known engineers from leading corporate research laboratories (ABB, IBM, Nokia Bell Labs). Numerous 'must read' chapters are also included here for the two-phase community. Set IV constitutes a 'must have' engineering and research reference together with previous Sets I, II and III for thermal engineering researchers and practitioners.
