Download or read book Fission Gas Release in LWR Fuel Measured During Nuclear Operation written by and published by . This book was released on 1980 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A series of fuel behavior experiments are being conducted in the Heavy Boiling Water Reactor in Halden, Norway, to measure the release of Xe, Kr, and I fission products from typical light water reactor design fuel pellets. Helium gas is used to sweep the Xe and Kr fission gases out of two of the Instrumented Fuel Assembly 430 fuel rods and to a gamma spectrometer. The measurements of Xe and Kr are made during nuclear operation at steady state power, and for 135I following reactor scram. The first experiments were conducted at a burnup of 3000 MWd/t UO2, at bulk average fuel temperatures of approx. 850 K and approx. 23 kW/m rod power. The measured release-to-birth ratios (R/B) of Xe and Kr are of the same magnitude as those observed in small UO2 specimen experiments, when normalized to the estimated fuel surface-to-volume ratio. Preliminary analysis indicates that the release-to-birth ratios can be calculated, using diffusion coefficients determined from small specimen data, to within a factor of approx. 2 for the IFA-430 fuel. The release rate of 135I is shown to be approximately equal to that of 135Xe.

Download or read book Fission Gas Behaviour in Water Reactor Fuels written by and published by Paris, France : Nuclear Energy Agency, Organisation for Economic Co-operation and Development. This book was released on 2002 with total page 572 pages. Available in PDF, EPUB and Kindle. Book excerpt: Communicates the results of an international seminar which reviewed recent progress in the field of fission gas behaviour in light water reactor fuel and sought to improve the models used in computer codes predicting fission gas release. State-of-the-art knowledge is presented for both uranium-oxide and mixed-oxide fuels loaded in water reactors.

Download or read book Fission Gas Release from Fuel at High Burnup written by Ralph O. Meyer and published by . This book was released on 1978 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Assessment of FRAPCON 1 BE EM Calculated Fission Gas Release in RISO Fuel Rods written by Rosanna Chambers and published by . This book was released on 1980 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Radiation Re solution Calculation in Uranium Silicide Fuels written by and published by . This book was released on 2017 with total page 21 pages. Available in PDF, EPUB and Kindle. Book excerpt: The release of fission gas from nuclear fuels is of primary concern for safe operation of nuclear power plants. Although the production of fission gas atoms can be easily calculated from the fission rate in the fuel and the average yield of fission gas, the actual diffusion, behavior, and ultimate escape of fission gas from nuclear fuel depends on many other variables. As fission gas diffuses through the fuel grain, it tends to collect into intra-granular bubbles, as portrayed in Figure 1.1. These bubbles continue to grow due to absorption of single gas atoms. Simultaneously, passing fission fragments can cause collisions in the bubble that result in gas atoms being knocked back into the grain. This so called "re-solution" event results in a transient equilibrium of single gas atoms within the grain. As single gas atoms progress through the grain, they will eventually collect along grain boundaries, creating inter-granular bubbles. As the inter-granular bubbles grow over time, they will interconnect with other grain-face bubbles until a pathway is created to the outside of the fuel surface, at which point the highly pressurized inter-granular bubbles will expel their contents into the fuel plenum. This last process is the primary cause of fission gas release. From the simple description above, it is clear there are several parameters that ultimately affect fission gas release, including the diffusivity of single gas atoms, the absorption and knockout rate of single gas atoms in intra-granular bubbles, and the growth and interlinkage of intergranular bubbles. Of these, the knockout, or re-solution rate has an particularly important role in determining the transient concentration of single gas atoms in the grain. The re-solution rate will be explored in the following sections with regards to uranium-silicide fuels in order to support future models of fission gas bubble behavior.

Download or read book Energy Research Abstracts written by and published by . This book was released on 1994-06 with total page 544 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Fission Product Release from BWR Fuel Under LOCA Conditions written by and published by . This book was released on 1981 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book A Model for Fission gas Release from Porous Fuels in Low permeability Containers written by John W. Prados and published by . This book was released on 1961 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Modeling and Experiment of Fission Products Release and Interaction with Coolant for Defective Fuel in Light Water Reactor LWR written by Sha Xue and published by . This book was released on 2017 with total page 102 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the normal operation of light water reactor, fuel defects can reside on fuel cladding from various reason such as fuel-pellet mechanical interaction, the hydriding of the Zr clad, the grid fritting from the assembly support, the warp wire fritting with the clad and also the stress corrosion cracking (SCC). The formation of defects on fuel cladding will result water ingression to the gap and react with nuclear fuel and the cladding inner surface. The interaction of water and nuclear fuel will affect the fuel thermal properties and deteriorate the cladding by hydriding and change of oxygen potential in the fuel. The change of fuel thermal properties will decrease the thermal conductivity, lead the decrease of heat transfer coefficient which may increase the fuel melting risk. The volatile fission products and fission gas will release to the coolant through cladding defects and increase the coolant activity and the defective nuclear fuel becomes a fission product source term when reactor is under normal operation. Experimental and modeling are applied to understand the behavior of a defective fuel pin. The experimental part focuses on the dissolution test of rare earth fission products in simulated LWR coolant chemistry and the diffusion coefficient measurement of cesium iodide in simulated LWR coolant chemistry using Nuclear Magnetic Resonance (NMR) technique. Rare earth fission products significantly contribute the residual heat and large quantity of radioactivity after the core shut down or in severe accident, therefore, their dissolution kinetic parameters in LWR are important to reactor safety and the understanding the source terms.

Download or read book Uranium Dioxide written by J. Belle and published by . This book was released on 1961 with total page 744 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Proceedings of the 2023 Water Reactor Fuel Performance Meeting written by Jianqiao Liu and published by Springer Nature. This book was released on 2023-11-30 with total page 384 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Water Reactor Fuel Performance Meeting (WRFPM) held in Asia has merged with TopFuel in Europe and LWR Fuel Performance in the United States to form the globally most influential conference in the field of nuclear fuel research. WRFPM2023 is organized by Chinese Nuclear Society (CNS) in cooperation with the Atomic Energy Society of Japan (AESJ), Korean Nuclear Society (KNS), European Nuclear Society (ENS), American Nuclear Society (ANS), the Interna-tional Atomic Energy Agency (IAEA) with the support from China Nuclear Energy In¬dustry Corporation (CNEIC) and TVEL. Conference Topics: 1. Advances in water reactor fuel technology and testing 2. Operation and experience 3. Transient and off-normal fuel behaviour and safety related issues 4. Fuel cycle, used fuel storage and transportation 5. Innovative fuel and related issues 6. Fuel modelling, analysis and methodology

Download or read book Reactor Fuels Materials and Systems under Extreme Environments written by Wenzhong Zhou and published by Frontiers Media SA. This book was released on 2022-03-25 with total page 360 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Measurement of Fission Product Release During LWR Fuel Failure written by and published by . This book was released on 1979 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The PBF is a specialized test reactor consisting of an annular core and a central test space 21 cm in diameter and 91 cm high. A test loop circulates coolant through the central experimental section at typical power reactor conditions. Light-water-reactor-type fuel rods are exposed to power bursts simulating reactivity insertion transients, and to power-cooling-mismatch conditions during which the rods are allowed to operate in film boiling. Fission product concentrations in the test loop coolant are continuously monitored during these transients by a Ge(Li) detector based gamma spectrometer. Automatic batch processing of pulse height spectra results in a list of radionuclide concentrations present in the loop coolant as a function of time during the test. Fission product behavior is then correlated to test parameters and posttest examination of the fuel rods. Data are presented from Test PCM-1.

Download or read book Government Reports Annual Index written by and published by . This book was released on 1980 with total page 982 pages. Available in PDF, EPUB and Kindle. Book excerpt: Sections 1-2. Keyword Index.--Section 3. Personal author index.--Section 4. Corporate author index.-- Section 5. Contract/grant number index, NTIS order/report number index 1-E.--Section 6. NTIS order/report number index F-Z.

Download or read book The Radiochemistry of Nuclear Power Plants with Light Water Reactors written by Karl-Heinz Neeb and published by Walter de Gruyter. This book was released on 2011-06-01 with total page 740 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Noble Fission Gas Releases During Spent Fuel Cask Loading Operations written by and published by . This book was released on 2018 with total page 9 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Comprehensive Nuclear Materials written by and published by Elsevier. This book was released on 2020-07-22 with total page 4871 pages. Available in PDF, EPUB and Kindle. Book excerpt: Materials in a nuclear environment are exposed to extreme conditions of radiation, temperature and/or corrosion, and in many cases the combination of these makes the material behavior very different from conventional materials. This is evident for the four major technological challenges the nuclear technology domain is facing currently: (i) long-term operation of existing Generation II nuclear power plants, (ii) the design of the next generation reactors (Generation IV), (iii) the construction of the ITER fusion reactor in Cadarache (France), (iv) and the intermediate and final disposal of nuclear waste. In order to address these challenges, engineers and designers need to know the properties of a wide variety of materials under these conditions and to understand the underlying processes affecting changes in their behavior, in order to assess their performance and to determine the limits of operation. Comprehensive Nuclear Materials, Second Edition, Seven Volume Set provides broad ranging, validated summaries of all the major topics in the field of nuclear material research for fission as well as fusion reactor systems. Attention is given to the fundamental scientific aspects of nuclear materials: fuel and structural materials for fission reactors, waste materials, and materials for fusion reactors. The articles are written at a level that allows undergraduate students to understand the material, while providing active researchers with a ready reference resource of information. Most of the chapters from the first Edition have been revised and updated and a significant number of new topics are covered in completely new material. During the ten years between the two editions, the challenge for applications of nuclear materials has been significantly impacted by world events, public awareness, and technological innovation. Materials play a key role as enablers of new technologies, and we trust that this new edition of Comprehensive Nuclear Materials has captured the key recent developments. Critically reviews the major classes and functions of materials, supporting the selection, assessment, validation and engineering of materials in extreme nuclear environments Comprehensive resource for up-to-date and authoritative information which is not always available elsewhere, even in journals Provides an in-depth treatment of materials modeling and simulation, with a specific focus on nuclear issues Serves as an excellent entry point for students and researchers new to the field