Download or read book Feasibility and Limitations of Premixed Diesel Combustion in Multi cylinder Engines written by Guntram Arnulf Lechner and published by . This book was released on 2003 with total page 378 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Investigation and Comparison of Multi Cylinder Partially Premixed Combustion Characteristics for Diesel and Gasoline Fuels written by Magnus Lewander and published by . This book was released on 2011 with total page 14 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Dissertation Abstracts International written by and published by . This book was released on 2003 with total page 778 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book American Doctoral Dissertations written by and published by . This book was released on 2002 with total page 776 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Gasoline Compression Ignition Technology written by Gautam Kalghatgi and published by Springer Nature. This book was released on 2022-01-17 with total page 339 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book focuses on gasoline compression ignition (GCI) which offers the prospect of engines with high efficiency and low exhaust emissions at a lower cost. A GCI engine is a compression ignition (CI) engine which is run on gasoline-like fuels (even on low-octane gasoline), making it significantly easier to control particulates and NOx but with high efficiency. The state of the art development to make GCI combustion feasible on practical vehicles is highlighted, e.g., on overcoming problems on cold start, high-pressure rise rates at high loads, transients, and HC and CO emissions. This book will be a useful guide to those in academia and industry.

Download or read book Application of Liquid Biofuels to Internal Combustion Engines written by Soo-Young No and published by Springer Nature. This book was released on 2020-02-17 with total page 480 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a comprehensive overview of the application of liquid biofuels to internal combustion (IC) engines. Biofuels are one of the most promising renewable and sustainable energy sources. Particularly, liquid biofuels obtained from biomass could become a valid alternative to the use of fossil fuels in the light of increasingly stringent environmental constraints. In this book, the discussion is limited to liquid biofuels obtained from triglycerides and lignocellulose among the many different kinds of biomass. Several liquid biofuels from triglycerides, straight vegetable oil, biodiesel produced from inedible vegetable oil, hydrotreated vegetable oil, and pyrolytic oil have been selected for discussion, as well as biofuels from lignocellulose bio-oil, alcohols such as methanol, ethanol and butanol, and biomass-to-liquids diesel. This book includes three chapters on the application of methanol, ethanol and butanol to advanced compression ignition (CI) engines such as LTC, HCCI, RCCI and DF modes. Further, the application of other higher alcohols and other drop-in fuels such as DMF, MF, MTHF, and GVL are also discussed. The book will be a valuable resource for graduate students, researchers and engine designers who are interested in the application of alcohols and other biofuels in advanced CI engines, and also useful for alternative energy planners selecting biofuels for CI engines in the future.

Download or read book Effect of Premixed Fuel Preparation for Partially Premixed Combustion with a Low Octane Gasoline on a Light Duty Multi Cylinder Compression Ignition Engine written by and published by . This book was released on 2015 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Gasoline compression ignition concepts with the majority of the fuel being introduced early in the cycle are known as partially premixed combustion (PPC). Previous research on single- and multi-cylinder engines has shown that PPC has the potential for high thermal efficiency with low NOx and soot emissions. A variety of fuel injection strategies has been proposed in the literature. These injection strategies aim to create a partially stratified charge to simultaneously reduce NOx and soot emissions while maintaining some level of control over the combustion process through the fuel delivery system. The impact of the direct injection strategy to create a premixed charge of fuel and air has not previously been explored, and its impact on engine efficiency and emissions is not well understood. This paper explores the effect of sweeping the direct injected pilot timing from -91° to -324° ATDC, which is just after the exhaust valve closes for the engine used in this study. During the sweep, the pilot injection consistently contained 65% of the total fuel (based on command duration ratio), and the main injection timing was adjusted slightly to maintain combustion phasing near top dead center. A modern four cylinder, 1.9 L diesel engine with a variable geometry turbocharger, high pressure common rail injection system, wide included angle injectors, and variable swirl actuation was used in this study. The pistons were modified to an open bowl configuration suitable for highly premixed combustion modes. The stock diesel injection system was unmodified, and the gasoline fuel was doped with a lubricity additive to protect the high pressure fuel pump and the injectors. The study was conducted at a fixed speed/load condition of 2000 rpm and 4.0 bar brake mean effective pressure (BMEP). The pilot injection timing sweep was conducted at different intake manifold pressures, swirl levels, and fuel injection GTP-15-1067, Dempsey 2 pressures. The gasoline used in this study has relatively high fuel reactivity with a research octane number of 68. The results of this experimental campaign indicate that the highest brake thermal efficiency and lowest emissions are achieved simultaneously with the earliest pilot injection timings (i.e., during the intake stroke).

Download or read book Simulation and Optimization of Internal Combustion Engines written by Zhiyu Han and published by SAE International. This book was released on 2021-12-28 with total page 372 pages. Available in PDF, EPUB and Kindle. Book excerpt: Simulation and Optimization of Internal Combustion Engines provides the fundamentals and up-to-date progress in multidimensional simulation and optimization of internal combustion engines. While it is impossible to include all the models in a single book, this book intends to introduce the pioneer and/or the often-used models and the physics behind them providing readers with ready-to-use knowledge. Key issues, useful modeling methodology and techniques, as well as instructive results, are discussed through examples. Readers will understand the fundamentals of these examples and be inspired to explore new ideas and means for better solutions in their studies and work. Topics include combustion basis of IC engines, mathematical descriptions of reactive flow with sprays, engine in-cylinder turbulence, fuel sprays, combustions and pollutant emissions, optimization of direct-injection gasoline engines, and optimization of diesel and alternative fuel engines.

Download or read book Diesel Combustion and Emissions written by Society of Automotive Engineers and published by . This book was released on 1981 with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Characteristics of Partially premixed Compression ignition Combustion Using Diesel Biodiesel and Gasoline in a Multi cylinder Direct injection Diesel Engine written by Adam James Weall and published by . This book was released on 2010 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Greener and Scalable E fuels for Decarbonization of Transport written by Avinash Kumar Agarwal and published by Springer Nature. This book was released on 2021-12-10 with total page 424 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book highlights ways of using gaseous and liquid e-fuels like hydrogen (H2), methane (CH4), methanol (CH3OH), DME (CH3-O-CH3), Ammonia (NH3), synthetic petrol and diesel, etc in existing engines and their effects on tailpipe emissions. The contents also cover calibration and optimization procedure for adaptation of these fuels. the volume also discusses the economical aspect of these fuels. Chapters include recent results and are focused on current trends of automotive sector. This book will be of interest to those in academia and industry involved in fuels, IC engines, engine instrumentation, and environmental research.

Download or read book Emerging Trends in Mechanical and Industrial Engineering written by Xianguo Li and published by Springer Nature. This book was released on 2023-01-01 with total page 1062 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book presents the select proceedings of the International Conference on Emerging Trends in Mechanical and Industrial Engineering (ICETMIE 2022). It covers the latest trends in the area of mechanical engineering. The broad topics covered in the book are engineering design, industrial and production engineering, Industry 4.0, energy and process engineering, mechatronics, control and robotics, material science, and automotive engineering. The book is useful for students, researchers, and professionals working in the various areas of mechanical engineering.

Download or read book Proceedings of the ASME Dynamic Systems and Control Division written by and published by . This book was released on 2006 with total page 864 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Characterization and control of single injection partially premixed combustion in a multi cylinder engine written by Magnus Lewander and published by . This book was released on 2009 with total page 42 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Computer Analysis of Multi cylinder Diesel Engine Mechanism Dynamics written by P. Deravi and published by . This book was released on 1980 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Control of a Multicylinder Homogeneous Charge Compression Ignition Engine written by William Lee Gans and published by . This book was released on 2003 with total page 250 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Alternative Fuels for Compression Ignition Engines written by Zainal Ambri Abdul Karim and published by Springer. This book was released on 2018-02-19 with total page 88 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book examines the development and utilization of alternative fuels in order to reduce or control the environmental impact of internal combustion engine exhaust gases. Discussing alternative fuels such as dual fuel techniques, rubber seed/palm oil biodiesel, syngas dual-fuelling, water-in-diesel emulsions and gasification of date palm seeds, it is a valuable resource for researchers in the field of engine development and on alternative fuels.