Download or read book External Measurement System for Robot Dynamics written by Yana Sosnovskaya and published by . This book was released on 2017 with total page 110 pages. Available in PDF, EPUB and Kindle. Book excerpt: Robots require testing to verify modeling assumptions, confirm performance characteristics, and quantify their limits. One requirement for formal robot testing is an external measurement system (EMS), that measures the robot’s dynamics without relying on the robot’s modeling assumptions or using any component of the robot’s control system. Most robot dynamics measurement systems in literature are not external: they connect to the robot’s instruments, and/or rely on its modeling assumptions. In this work, I present a new, inertial sensor-based EMS, that consists of a set of inertial sensors, data acquisition hardware, and precisely specified calibration procedures. Static and dynamic calibration algorithms are tested for accelerometers, with static shown to be superior. Monte Carlo-based calibration algorithms are presented, to quantify calibration uncertainties, which can then be propagated to uncertainties in measurements. The EMS is tested on a Hopper robot, demonstrating its usefulness for dynamics measurement, and certain limitations for position measurement.
Download or read book Dynamics of Manipulation Robots written by M. Vukobratovic and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 319 pages. Available in PDF, EPUB and Kindle. Book excerpt: This monograph represents the first book of the series entitled "SCI ENTIFIC FUNDAMENTALS OF ROBOTICS". The aim of this monograph is to ap proach the dynamics of active mechanisms from the standpoint of its application to the synthesis of complex motion and computer-aided de sign of manipulation mechanisms with some optimal performances. The rapid development of a new class of mechanisms, which may be referred to as active mechanisms, contributed to their application in various environments (from underwater to cosmic) . Because of some specific fea tures, these mechanisms require very careful description, both in a mechanical sense (kinematic and dynamic) and in the synthesis of algo rithms for precise tracking of the above motion under insufficiently defined operating conditions. Having also in mind the need for a very fast (even real-time) calculation of system dynamics and for eliminating, in principle, the errors made when forming mathematical models "by hand" this monograph will primarily present methods for automatic for mUlation of dynamic equations of motion of active spatial mechanisms. Apart from these computer-oriented methods, mention will be made of all those methods which have preceded the computer-oriented procedures, predominantly developed for different problems of rigid body dynamics. If we wish to systematically establish the origins of the scientific discipline, which could be called robot dynamics, we must recall some groups and individuals, who, by solving actual problems in the synthe sis and control of artificial motion, have contributed to a gradual formation of this discipline.
Download or read book Journal of Dynamic Systems Measurement and Control written by and published by . This book was released on 2004 with total page 960 pages. Available in PDF, EPUB and Kindle. Book excerpt: Publishes theoretical and applied original papers in dynamic systems. Theoretical papers present new theoretical developments and knowledge for controls of dynamical systems together with clear engineering motivation for the new theory. Applied papers include modeling, simulation, and corroboration of theory with emphasis on demonstrated practicality.
Download or read book Robot Control 1991 SYROCO 91 written by I. Troch and published by Elsevier. This book was released on 2014-05-23 with total page 583 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume contains 92 papers on the state-of-the-art in robotics research. In this volume topics on modelling and identification are treated first as they build the basis for practically all control aspects. Then, the most basic control tasks are discussed i.e. problems of inverse kinematics. Groups of papers follow which deal with various advanced control aspects. They range from rather general methods to more specialized topics such as force control and control of hydraulic robots. The problem of path planning is addressed and strategies for robots with one arm, for mobile robots and for multiple arm robots are presented. Also covered are computational improvements and software tools for simulation and control, the integration of sensors and sensor signals in robot control.
Download or read book State Estimation and Stabilization of Nonlinear Systems written by Abdellatif Ben Makhlouf and published by Springer Nature. This book was released on 2023-11-06 with total page 439 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents the separation principle which is also known as the principle of separation of estimation and control and states that, under certain assumptions, the problem of designing an optimal feedback controller for a stochastic system can be solved by designing an optimal observer for the system's state, which feeds into an optimal deterministic controller for the system. Thus, the problem may be divided into two halves, which simplifies its design. In the context of deterministic linear systems, the first instance of this principle is that if a stable observer and stable state feedback are built for a linear time-invariant system (LTI system hereafter), then the combined observer and feedback are stable. The separation principle does not true for nonlinear systems in general. Another instance of the separation principle occurs in the context of linear stochastic systems, namely that an optimum state feedback controller intended to minimize a quadratic cost is optimal for the stochastic control problem with output measurements. The ideal solution consists of a Kalman filter and a linear-quadratic regulator when both process and observation noise are Gaussian. The term for this is linear-quadratic-Gaussian control. More generally, given acceptable conditions and when the noise is a martingale (with potential leaps), a separation principle, also known as the separation principle in stochastic control, applies when the noise is a martingale (with possible jumps).
Download or read book Modeling Identification and Control of Robots written by W. Khalil and published by Butterworth-Heinemann. This book was released on 2004-07-01 with total page 503 pages. Available in PDF, EPUB and Kindle. Book excerpt: Written by two of Europe’s leading robotics experts, this book provides the tools for a unified approach to the modelling of robotic manipulators, whatever their mechanical structure. No other publication covers the three fundamental issues of robotics: modelling, identification and control. It covers the development of various mathematical models required for the control and simulation of robots. · World class authority· Unique range of coverage not available in any other book· Provides a complete course on robotic control at an undergraduate and graduate level
Download or read book Advanced Multibody System Dynamics written by Werner Schiehlen and published by Springer Science & Business Media. This book was released on 2013-04-17 with total page 491 pages. Available in PDF, EPUB and Kindle. Book excerpt: The German Research Council (DFG) decided 1987 to establish a nationwide five year research project devoted to dynamics of multibody systems. In this project universities and research centers cooperated with the goal to develop a general pur pose multibody system software package. This concept provides the opportunity to use a modular structure of the software, i.e. different multibody formalisms may be combined with different simulation programmes via standardized interfaces. For the DFG project the database RSYST was chosen using standard FORTRAN 77 and an object oriented multibody system datamodel was defined. The project included • research on the fundamentals of the method of multibody systems, • concepts for new formalisms of dynamical analysis, • development of efficient numerical algorithms and • realization of a powerful software package of multibody systems. These goals required an interdisciplinary cooperation between mathematics, compu ter science, mechanics, and control theory. ix X After a rigorous reviewing process the following research institutions participated in the project (under the responsibility of leading scientists): Technical University of Aachen (Prof. G. Sedlacek) Technical University of Darmstadt (Prof. P. Hagedorn) University of Duisburg M. Hiller) (Prof.
Download or read book Robot Dynamics And Control written by Mark W Spong and published by John Wiley & Sons. This book was released on 2008-08-04 with total page 356 pages. Available in PDF, EPUB and Kindle. Book excerpt: This self-contained introduction to practical robot kinematics and dynamics includes a comprehensive treatment of robot control. It provides background material on terminology and linear transformations, followed by coverage of kinematics and inverse kinematics, dynamics, manipulator control, robust control, force control, use of feedback in nonlinear systems, and adaptive control. Each topic is supported by examples of specific applications. Derivations and proofs are included in many cases. The book includes many worked examples, examples illustrating all aspects of the theory, and problems.
Download or read book Design of an Intelligent Embedded System for Condition Monitoring of an Industrial Robot written by Alaa Abdulhady Jaber and published by Springer. This book was released on 2016-09-08 with total page 302 pages. Available in PDF, EPUB and Kindle. Book excerpt: This thesis introduces a successfully designed and commissioned intelligent health monitoring system, specifically for use on any industrial robot, which is able to predict the onset of faults in the joints of the geared transmissions. However the developed embedded wireless condition monitoring system leads itself very well for applications on any power transmission equipment in which the loads and speeds are not constant, and access is restricted. As such this provides significant scope for future development. Three significant achievements are presented in this thesis. First, the development of a condition monitoring algorithm based on vibration analysis of an industrial robot for fault detection and diagnosis. The combined use of a statistical control chart with time-domain signal analysis for detecting a fault via an arm-mounted wireless processor system represents the first stage of fault detection. Second, the design and development of a sophisticated embedded microprocessor base station for online implementation of the intelligent condition monitoring algorithm, and third, the implementation of a discrete wavelet transform, using an artificial neural network, with statistical feature extraction for robot fault diagnosis in which the vibration signals are first decomposed into eight levels of wavelet coefficients.
Download or read book Informatics in Control Automation and Robotics written by Oleg Gusikhin and published by Springer Nature. This book was released on 2022-01-01 with total page 647 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book focuses the latest endeavours relating researches and developments conducted in fields of Control, Robotics and Automation. Through more than ten revised and extended articles, the present book aims to provide the most up-to-date state-of-art of the aforementioned fields allowing researcher, PhD students and engineers not only updating their knowledge but also benefiting from the source of inspiration that represents the set of selected articles of the book. The deliberate intention of editors to cover as well theoretical facets of those fields as their practical accomplishments and implementations offers the benefit of gathering in a same volume a factual and well-balanced prospect of nowadays research in those topics. A special attention toward “Intelligent Robots and Control” may characterize another benefit of this book.
Download or read book Soft Computing for Intelligent Robotic Systems written by Toshio Fukuda and published by Physica. This book was released on 2013-04-17 with total page 244 pages. Available in PDF, EPUB and Kindle. Book excerpt: Research results using some of the most advanced soft computing techniques in intelligent robotic systems are presented. The main purpose of this book is to show how the power of soft computing techniques can be exploited in intelligent robotic systems. The main emphasis is on control system for a mobile robot, behavior arbitration for a mobile robot, reinforcement learning of a robot, manipulation of a robot, collision avoidance and automatic design of robots. This book will be useful for application engineers, scientists and researchers who wish to use some of the most advanced soft computing techniques in robotics.
Download or read book Robot Calibration written by Roger Bernard and published by Springer Science & Business Media. This book was released on 1993-10-31 with total page 330 pages. Available in PDF, EPUB and Kindle. Book excerpt: Calibration is playing an increasingly important role in industrial robotics. Higher accuracy demands are being placed on flexible assembly and manufacturing systems which in turn require robot manufacturers to produce higher quality precision robots.
Download or read book Development of an Automated Guidance and Dynamic Measurement System for Coordinate Measuring Machines and Robotic Devices written by Kam Chiu Lau and published by . This book was released on 1981 with total page 448 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Autonomous Mobile Robots and Multi Robot Systems written by Eugene Kagan and published by John Wiley & Sons. This book was released on 2019-09-02 with total page 344 pages. Available in PDF, EPUB and Kindle. Book excerpt: Offers a theoretical and practical guide to the communication and navigation of autonomous mobile robots and multi-robot systems This book covers the methods and algorithms for the navigation, motion planning, and control of mobile robots acting individually and in groups. It addresses methods of positioning in global and local coordinates systems, off-line and on-line path-planning, sensing and sensors fusion, algorithms of obstacle avoidance, swarming techniques and cooperative behavior. The book includes ready-to-use algorithms, numerical examples and simulations, which can be directly implemented in both simple and advanced mobile robots, and is accompanied by a website hosting codes, videos, and PowerPoint slides Autonomous Mobile Robots and Multi-Robot Systems: Motion-Planning, Communication and Swarming consists of four main parts. The first looks at the models and algorithms of navigation and motion planning in global coordinates systems with complete information about the robot’s location and velocity. The second part considers the motion of the robots in the potential field, which is defined by the environmental states of the robot's expectations and knowledge. The robot's motion in the unknown environments and the corresponding tasks of environment mapping using sensed information is covered in the third part. The fourth part deals with the multi-robot systems and swarm dynamics in two and three dimensions. Provides a self-contained, theoretical guide to understanding mobile robot control and navigation Features implementable algorithms, numerical examples, and simulations Includes coverage of models of motion in global and local coordinates systems with and without direct communication between the robots Supplemented by a companion website offering codes, videos, and PowerPoint slides Autonomous Mobile Robots and Multi-Robot Systems: Motion-Planning, Communication and Swarming is an excellent tool for researchers, lecturers, senior undergraduate and graduate students, and engineers dealing with mobile robots and related issues.
Download or read book MICCAI 2005 written by James Duncan and published by Springer Science & Business Media. This book was released on 2005-10-11 with total page 1057 pages. Available in PDF, EPUB and Kindle. Book excerpt: The two-volume set LNCS 3749 and LNCS 3750 constitutes the refereed proceedings of the 8th International Conference on Medical Image Computing and Computer-Assisted Intervention, MICCAI 2005, held in Palm Springs, CA, USA, in October 2005. Based on rigorous peer reviews the program committee selected 237 carefully revised full papers from 632 submissions for presentation in two volumes. The first volume includes all the contributions related to image analysis and validation, vascular image segmentation, image registration, diffusion tensor image analysis, image segmentation and analysis, clinical applications - validation, imaging systems - visualization, computer assisted diagnosis, cellular and molecular image analysis, physically-based modeling, robotics and intervention, medical image computing for clinical applications, and biological imaging - simulation and modeling. The second volume collects the papers related to robotics, image-guided surgery and interventions, image registration, medical image computing , structural and functional brain analysis, model-based image analysis, image-guided intervention: simulation, modeling and display, and image segmentation and analysis.
Download or read book Modeling Identification and Control of Robots written by Wisama Khalil and published by CRC Press. This book was released on 2002 with total page 508 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Theory of Robot Control written by Carlos Canudas de Wit and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 392 pages. Available in PDF, EPUB and Kindle. Book excerpt: A study of the latest research results in the theory of robot control, structured so as to echo the gradual development of robot control over the last fifteen years. In three major parts, the editors deal with the modelling and control of rigid and flexible robot manipulators and mobile robots. Most of the results on rigid robot manipulators in part I are now well established, while for flexible manipulators in part II, some problems still remain unresolved. Part III deals with the control of mobile robots, a challenging area for future research. The whole is rounded off with an appendix reviewing basic definitions and the mathematical background for control theory. The particular combination of topics makes this an invaluable source of information for both graduate students and researchers.
