Download or read book Experimental Investigation of a Supersonic Compressor Cascade written by Sanford Fleeter and published by . This book was released on 1975 with total page 338 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report describes in detail the experimental investigation of a stationary, linear, supersonic compressor cascade with blades of constant spanwise geometry and constant thickness linear sidewalls. The selected blade element was representative of streamline 19 of an advanced compressor configuration resulting from the Aerospace Research Laboratories axial compressor research program. The investigation covered the range of inlet relative Mach numbers of 1.535 - 1.683 and a range of static pressure ratios of approximately 1.1 - 2.3 and included laser velocimeter measurements of the flow within and around the cascade at the design Mach number.

Download or read book Experimental Investigation of the Performance of a Supersonic Compressor Cascade written by National Aeronautics and Space Administration (NASA) and published by Createspace Independent Publishing Platform. This book was released on 2018-07-03 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt: Results are presented from an experimental investigation of a linear, supersonic, compressor cascade tested in the supersonic cascade wind tunnel facility at the DFVLR in Cologne, Federal Republic of Germany. The cascade design was derived from the near-tip section of a high-through-flow axial flow compressor rotor with a design relative inlet Mach number of 1.61. Test data were obtained over a range of inlet Mach numbers from 1.23 to 1.71, and a range of static pressure ratios and axial-velocity-density ratios (AVDR) at the design inlet condition. Flow velocity measurements showing the wave pattern in the cascade entrance region were obtained using a laser transit anemometer. From these measurements, some unique-incidence conditions were determined, thus relating the supersonic inlet Mach number to the inlet flow direction. The influence of static pressure ratio and AVDR on the blade passage flow and the blade-element performance is described, and an empirical correlation is used to show the influence of these two (independent) parameters on the exit flow angle and total-pressure loss for the design inlet condition. Tweedt, D. L. and Schreiber, H. A. and Starken, H. Glenn Research Center RTOP 505-62-61...

Download or read book Experimental Investigation of the Mixing Loss Behind Trailing Edge of a Cascade of Three 90 Supersonic Turning Passages written by Luke L. Liccini and published by . This book was released on 1950 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Experimental Investigation of an Axial flow Supersonic Compressor Having Sharp Leading edge Blades with an 8 percent Mean Thickness chord Ratio written by Theodore J. Goldberg and published by . This book was released on 1955 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Experimental Investigation of a Transonic Compressor Cascade and Test Results for Four Blade Sections written by James C. Emery and published by . This book was released on 1960 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1994 with total page 892 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book A Selected Listing of NASA Scientific and Technical Reports for written by and published by . This book was released on 1949 with total page 750 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Research in Progress written by and published by . This book was released on with total page 424 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Index of NACA Technical Publications written by United States. National Advisory Committee for Aeronautics and published by . This book was released on 1959 with total page 388 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Monthly Catalogue United States Public Documents written by and published by . This book was released on 1990 with total page 1300 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Monthly Catalog of United States Government Publications written by and published by . This book was released on 1990 with total page 548 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Experimental Investigation of a Large scale Two dimensional Mixed compression Inlet System written by Norman D. Wong and published by . This book was released on 1971 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt: A large-scale, variable-geometry inlet model with a design Mach number of 3.0 was tested at Mach numbers from 1.55 to 3.2. Variable features of the inlet for off-design operation are an adjustable-height ramp system and a translating cowl. This report presents experimental results for a diffuser and boundary-layer bleed configuration which was optimized at the design Mach number. Overall performance was high with throat-mounted vortex generators, which were effective in reducing flow distortion in the subsonic diffuser at the higher Mach numbers.

Download or read book Proceedings Of The International Heat Transfer Conference written by Lee and published by CRC Press. This book was released on 1998-11-01 with total page 696 pages. Available in PDF, EPUB and Kindle. Book excerpt: This year's set of papers includes 23 Keynote Papers and 537 refereed General Papers, in seven volumes. Experts from around the world have combined to address the leading edge of research and practical innovations in convection, combustion, heat exchangers, two-phase flow, and much more. Whether one is involved in mechanical, chemical, nuclear, or energy engineering the quantity, international scope, and high quality of the contents make access to these volumes essential.

Download or read book Aeronautical Engineering written by and published by . This book was released on 1971 with total page 580 pages. Available in PDF, EPUB and Kindle. Book excerpt: A selection of annotated references to unclassified reports and journal articles that were introduced into the NASA scientific and technical information system and announced in Scientific and technical aerospace reports (STAR) and International aerospace abstracts (IAA)

Download or read book Masters Theses in the Pure and Applied Sciences written by Wade H. Shafer and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 341 pages. Available in PDF, EPUB and Kindle. Book excerpt: Masters Theses in the Pure and Applied Sciences was first conceived, published, and disseminated by the Center for Information and Numerical Data Analysis and Synthesis (CINDAS)* at Purdue University in 1957, starting its coverage of theses with the academic year 1955. Beginning with Volume 13, the printing and dis semination phases of the activity were transferred to University Microfilms/Xerox of Ann Arbor, Michigan, with the thought that such an arrangement would be more beneficial to the academic and general scientific and technical community. After five years of this jOint undertaking we had concluded that it was in the interest of all concerned if the printing and distribution of the volumes were handled by an international publishing house to assure improved service and broader dissemination. Hence, starting with Volume 18, Masters Theses in the Pure and Applied Sciences has been disseminated on a worldwide basis by Plenum Publishing Corporation of New York, and in the same year the coverage was broadened to include Canadian universities. All back issues can also be ordered from Plenum. We have reported in Volume 40 (thesis year 1995) a total of 10,746 thesis titles from 19 Canadian and 144 United States universities. We are sure that this broader base for these titles reported will greatly enhance the value of this impor tant annual reference work. While Volume 40 reports theses submitted in 1995, on occasion, certain uni versities do report theses submitted in previous years but not reported at the time.

Download or read book Engineering Turbulence Modelling and Experiments 5 written by W. Rodi and published by Elsevier. This book was released on 2002-08-21 with total page 1029 pages. Available in PDF, EPUB and Kindle. Book excerpt: Turbulence is one of the key issues in tackling engineering flow problems. As powerful computers and accurate numerical methods are now available for solving the flow equations, and since engineering applications nearly always involve turbulence effects, the reliability of CFD analysis depends increasingly on the performance of the turbulence models. This series of symposia provides a forum for presenting and discussing new developments in the area of turbulence modelling and measurements, with particular emphasis on engineering-related problems. The papers in this set of proceedings were presented at the 5th International Symposium on Engineering Turbulence Modelling and Measurements in September 2002. They look at a variety of areas, including: Turbulence modelling; Direct and large-eddy simulations; Applications of turbulence models; Experimental studies; Transition; Turbulence control; Aerodynamic flow; Aero-acoustics; Turbomachinery flows; Heat transfer; Combustion systems; Two-phase flows. These papers are preceded by a section containing 6 invited papers covering various aspects of turbulence modelling and simulation as well as their practical application, combustion modelling and particle-image velocimetry.

Download or read book 2023 Asia Pacific International Symposium on Aerospace Technology APISAT 2023 Proceedings written by Song Fu and published by Springer Nature. This book was released on with total page 1991 pages. Available in PDF, EPUB and Kindle. Book excerpt: