Download or read book Electrical Characterization of CdTe Grain boundary Properties from As processed CdTe CdS Solar Cells written by Lawrence M. Woods and published by . This book was released on 1998 with total page 4 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Electrical Characterization of Etched Grain Boundary Properties from As Processed Px CdTe Based Solar Cells written by and published by . This book was released on 1998 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: An ability to lift off or separate the thin-film polycrystalline CdTe from the CdS, without the use of chemical etches, has enabled direct electrical characterization of the as-processed CdTe near the CdTe/CdS heterointerface. We use this ability to understand how a back-contact, nitric-phosphoric (NP) etch affects the grain boundaries throughout the film. Quantitative determination of the grain-boundary barrier potentials and estimates of doping density near the grain perimeter are determined from theoretical fits to measurements of the current vs. temperature. Estimates of the bulk doping are determined from high-frequency resistivity measurements. Also, a variable doping density within the grains of non-etched material has been determined. These results allow a semi-quantitative grain-boundary band diagram to be drawn that should aid in determining more-accurate two-dimensional models for polycrystalline CdTe solar cells.

Download or read book Advanced Characterization Techniques for Thin Film Solar Cells written by Daniel Abou-Ras and published by John Wiley & Sons. This book was released on 2016-07-13 with total page 760 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book focuses on advanced characterization methods for thin-film solar cells that have proven their relevance both for academic and corporate photovoltaic research and development. After an introduction to thin-film photovoltaics, highly experienced experts report on device and materials characterization methods such as electroluminescence analysis, capacitance spectroscopy, and various microscopy methods. In the final part of the book simulation techniques are presented which are used for ab-initio calculations of relevant semiconductors and for device simulations in 1D, 2D and 3D. Building on a proven concept, this new edition also covers thermography, transient optoelectronic methods, and absorption and photocurrent spectroscopy.

Download or read book Thin Film Solar Cells written by Jef Poortmans and published by John Wiley & Sons. This book was released on 2006-10-16 with total page 504 pages. Available in PDF, EPUB and Kindle. Book excerpt: Thin-film solar cells are either emerging or about to emerge from the research laboratory to become commercially available devices finding practical various applications. Currently no textbook outlining the basic theoretical background, methods of fabrication and applications currently exist. Thus, this book aims to present for the first time an in-depth overview of this topic covering a broad range of thin-film solar cell technologies including both organic and inorganic materials, presented in a systematic fashion, by the scientific leaders in the respective domains. It covers a broad range of related topics, from physical principles to design, fabrication, characterization, and applications of novel photovoltaic devices.

Download or read book Organic Nanostructured Thin Film Devices and Coatings for Clean Energy written by Sam Zhang and published by CRC Press. This book was released on 2010-06-18 with total page 256 pages. Available in PDF, EPUB and Kindle. Book excerpt: Authored by leading experts from around the world, the three-volume Handbook of Nanostructured Thin Films and Coatings gives scientific researchers and product engineers a resource as dynamic and flexible as the field itself. The first two volumes cover the latest research and application of the mechanical and functional properties of thin films an

Download or read book Electrical Characterization of Electrodeposited N CdS p CdTe Polycrystalline Thin film Solar Cells written by Roshanak Hakimzadeh and published by . This book was released on 1987 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book SERI Photovoltaic Advanced Research and Development Bibliography 1982 1985 written by and published by . This book was released on 1986 with total page 180 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Chalcogenide Photovoltaics written by Roland Scheer and published by John Wiley & Sons. This book was released on 2011-03-31 with total page 398 pages. Available in PDF, EPUB and Kindle. Book excerpt: This first comprehensive description of the most important material properties and device aspects closes the gap between general books on solar cells and journal articles on chalcogenide-based photovoltaics. Written by two very renowned authors with years of practical experience in the field, the book covers II-VI and I-III-VI2 materials as well as energy conversion at heterojunctions. It also discusses the latest semiconductor heterojunction models and presents modern analysis concepts. Thin film technology is explained with an emphasis on current and future techniques for mass production, and the book closes with a compendium of failure analysis in photovoltaic thin film modules. With its overview of the semiconductor physics and technology needed, this practical book is ideal for students, researchers, and manufacturers, as well as for the growing number of engineers and researchers working in companies and institutes on chalcogenide photovoltaics.

Download or read book Studies of Basic Electronic Properties of CdTe Based Solar Cells and Their Evolution During Processing and Stress written by and published by . This book was released on 2007 with total page 132 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report describes basic issues behind CdTe/CdS cell performance and stability, such as the nature and electronic properties of impurities and defects that control the majority carrier concentration, mechanisms of dopant compensation, recombination processes, their nature and properties, migration and transformation of defects under various processing, stress, and operating conditions. We believe that a better basic understanding of the specific influence of grain boundaries, especially for fine-grain materials such as those making up CdTe-based cells, is now one of the most important issues we must address. We need to clarify the role of grain boundaries in forming the film electronic properties, as well as those of the p-n junction.

Download or read book Solar Energy Update written by and published by . This book was released on 1984 with total page 884 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Solar Cells and Modules written by Arvind Shah and published by Springer Nature. This book was released on 2020-07-16 with total page 357 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book gives a comprehensive introduction to the field of photovoltaic (PV) solar cells and modules. In thirteen chapters, it addresses a wide range of topics including the spectrum of light received by PV devices, the basic functioning of a solar cell, and the physical factors limiting the efficiency of solar cells. It places particular emphasis on crystalline silicon solar cells and modules, which constitute today more than 90 % of all modules sold worldwide. Describing in great detail both the manufacturing process and resulting module performance, the book also touches on the newest developments in this sector, such as Tunnel Oxide Passivated Contact (TOPCON) and heterojunction modules, while dedicating a major chapter to general questions of module design and fabrication. Overall, it presents the essential theoretical and practical concepts of PV solar cells and modules in an easy-to-understand manner and discusses current challenges facing the global research and development community.

Download or read book Studies of Basic Electronic Properties of CdTe based Solar Cells and Their Evolution During Processing and Stress written by V. I. Kaydanov and published by . This book was released on 2007 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report describes basic issues behind CdTe/CdS cell performance and stability, such as the nature and electronic properties of impurities and defects that control the majority carrier concentration, mechanisms of dopant compensation, recombination processes, their nature and properties, migration and transformation of defects under various processing, stress, and operating conditions. We believe that a better basic understanding of the specific influence of grain boundaries, especially for fine-grain materials such as those making up CdTe-based cells, is now one of the most important issues we must address. We need to clarify the role of grain boundaries in forming the film electronic properties, as well as those of the p-n junction. This report presents studies relevant to the problems mentioned above that were carried out at Colorado School of Mines during this Thin Film PV Partnership subcontract.

Download or read book Electrical and Optical Characterization of Grain Boundaries in Polycrystalline CdTe written by Thomas Patric Thorpe (Jr.) and published by . This book was released on 1984 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book How Grain Boundaries Affect the Efficiency of Poly CdTe Solar cells written by and published by . This book was released on 2016 with total page 35 pages. Available in PDF, EPUB and Kindle. Book excerpt: It is now widely accepted that grain boundaries in poly-crystalline CdTe thin film devices have a detrimental effect on the minority carrier lifetimes, the open circuit voltage and therefore the overall solar-cell performance. The goal of this project was to develop a fundamental understanding of the role of grain boundaries in CdTe on the carrier life-time, open-circuit voltage, Voc, and the diffusion of impurities. To achieve this goal, i) CdTe bi-crystals were fabricated with various misorientation angels, ii) the atomic- and electronic structures of the grain boundaries were characterized using scanning transmission electron microscopy (STEM), and iii) first-principles density functional theory modeling was performed on the structures determined by STEM to predict the grain boundary potential. The transport properties and minority carrier lifetimes of the bi-crystal grain boundaries were measured using a variety of approaches, including TRPL, and provided feedback to the characterization and modeling effort about the effectiveness of the proposed models.

Download or read book The Morphology Microstructure and Luminescent Properties of CdS CdTe Films written by Mowafak Al-Jassim and published by . This book was released on 1998 with total page 4 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Impurity and Back Contact Effects on CdTe CdS Thin Film Solar Cells written by Hehong Zhao and published by . This book was released on 2008 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: ABSTRACT: CdTe/CdS thin film solar cells are the most promising cost-effective solar cells. The goal of this project is to improve the performance for CdS/CdTe devices by improving the open circuit voltage V[subscript]oc and current density J[subscript]sc. Efforts focused on increasing the V[subscript]oc, which include increasing the doping concentration by introducing Phosphorus and Antimony, finding and testing new back contact materials, and varying the ambient of CSS CdTe. In addition, the effect of Zn2SnO4 on the cells' performance was also studied. Electrical characterization of the thin films and completed devices were carried out by Current-Voltage (J-V), Capacitance-Voltage (C-V), and Spectral Response (SR) measurements. Structural/chemical characterization was done by SEM, XRD and EDS analysis. The ambient of CSS CdTe affects the growth rate, the grain size and electronic properties of CdTe. The N2/O2 mixture with varied ratio (N2/O2=9/1, 7/3, 5/5 and 1/9) was used in this study. The cells' performance and the net carrier concentration were studied as a function of the N2/O2 ratio. The net carrier concentration increases with the increasing O2 concentration. The extrinsic impurities (P and Sb) were incorporated into CdTe layer. Phosphorus was directly introduced into CSS CdTe source. The Sb was incorporated into CdTe by a diffusion process. The effects of the annealing parameters, the excess Sb on CdTe surface, the CdCl2 treatment and the depth of Sb in CdTe were studied. Higher doping concentration up to 1016 cm−3 has been achieved, however, V[subscript]oc is still in the range of 830 mV.

Download or read book Advanced Characterization of Thin Film Solar Cells written by Mowafak Al-Jassim and published by Institution of Engineering and Technology. This book was released on 2020-09-17 with total page 457 pages. Available in PDF, EPUB and Kindle. Book excerpt: Polycrystalline thin-film solar cells have reached a levelized cost of energy that is competitive with all other sources of electricity. The technology has significantly improved in recent years, with laboratory cell efficiencies for cadmium telluride (CdTe), perovskites, and copper indium gallium diselenide (CIGS) each exceeding 22 percent. Both CdTe and CIGS solar panels are now produced at the gigawatt scale. However, there are ongoing challenges, including the continued need to improve performance and stability while reducing cost. Advancing polycrystalline solar cell technology demands an in-depth understanding of efficiency, scaling, and degradation mechanisms, which requires sophisticated characterization methods. These methods will enable researchers and manufacturers to improve future solar modules and systems.