Download or read book Effects of Pavement Surface Texture on Noise and Frictional Characteristics written by Ron Ridnour and published by . This book was released on 1987 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Relationship Between Pavement Surface Texture and Highway Traffic Noise written by Roger L. Wayson and published by Transportation Research Board. This book was released on 1998 with total page 96 pages. Available in PDF, EPUB and Kindle. Book excerpt: "This report will be of interest to state DOT pavement engineers, environmental specialists, and noise analysts. The relationship between pavement surface texture and highway traffic noise is discussed. Information for the synthesis was collected by surveying state transportation agencies and by conducting a literature search of both domestic and foreign publications."--Avant-propos.
Download or read book Guide for Pavement Friction written by and published by AASHTO. This book was released on 2008 with total page 87 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report contains guidelines and recommendations for managing and designing for friction on highway pavements. The contents of this report will be of interest to highway materials, construction, pavement management, safety, design, and research engineers, as well as others concerned with the friction and related surface characteristics of highway pavements.
Download or read book Impacts Related to Pavement Texture Selection written by and published by . This book was released on 1997 with total page 58 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Evaluation of Pavement Friction Characteristics written by John Jewett Henry and published by Transportation Research Board. This book was released on 2000 with total page 76 pages. Available in PDF, EPUB and Kindle. Book excerpt: This synthesis report will be of interest to pavement design, construction, management, and research engineers, highway safety officials, and others concerned with pavement friction characteristics. It describes the current state of the practice and discusses the methods used for evaluating wet pavement friction characteristics of new and restored pavements. This synthesis reviews models used for measuring and evaluating friction and texture, causes for friction changes over time, and aggregate and mix design to provide adequate friction. Also presented are construction and surface restoration practices for providing good pavement surface characteristics. In addition, considerations of noise and ride quality are discussed when compromise may be required.
Download or read book Texturing of Concrete Pavements written by Jim W. Hall and published by Transportation Research Board. This book was released on 2009 with total page 109 pages. Available in PDF, EPUB and Kindle. Book excerpt: Explores a recommended process for determining the type of concrete pavement texture that may be used for a specific highway project. The process considers the effects of texture type on friction and noise characteristics.
Download or read book Hot Mix Asphalt Surface Characteristics Related to Ride Texture Friction Noise and Durability written by Tyler Dare and published by . This book was released on 2014 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt: The objective of this investigation was to develop a model to predict on-board sound intensity (OBSI) on hot mix asphalt pavements using on-site and laboratory data. The data used included noise and physical property data collected on 25 asphalt-surfaced roadway test sections at the MnROAD pavement testing facility. These test sections were constructed mainly in 2007 and 2008 using a variety of materials, mixtures and layer thicknesses. A modeling approach called the mechanism decomposition approach was used to develop the models. In this approach, the contributions of different noise mechanisms to the overall noise level and to noise in certain frequency ranges are modeled separately then are combined to form the total noise spectrum. Ultimately, two nonlinear statistical models were developed that predict one-third octave band and overall sound intensity levels on asphalt-surfaced pavements. The models incorporate the pavement parameters that were found to have the most significant effects on tire-pavement noise including pavement macrotexture, air temperature, modulus of the pavement surface layer, and the combined effect of temperature and modulus. The models differ in the type of texture data used as an input parameter. The models have been found to predict the overall OBSI sound intensity level to within 1.5 dB and the onethird octave bands to within 2 dB for most of the pavements tested. Other metrics and evaluation of the model accuracy by cell, year, temperature and other factors are also reported. The models are provided in an Excel spreadsheet.
Download or read book The Significance of Pavement Texture written by Glenn G. Balmer and published by . This book was released on 1975 with total page 48 pages. Available in PDF, EPUB and Kindle. Book excerpt: "This paper discusses the influence of roadway surface textures on the skid resistance, the speed-gradient, the wet-pavement accident rate, pavement wear, and the generation of tire-road interaction noise. The tendency of a vehicle to hydroplane is reduced by increasing the texture magnitude. Appropriate textures are developed by using open-graded asphalt friction surface courses and by grooving portland cement concrete with steel tines or a vibrating float while the concrete is plastic. Hardened pavements can be textured by grooving with a diamond saw or by resurfacing with an overlay. More development is needed in texture measurement techniques, especially in automating the stereo-photo interpretation method and the linear polarized laser technique"--Technical report documentation page
Download or read book Tire pavement Interaction Experimental Measurements and Modeling written by Mohammad O. Al-Assi and published by . This book was released on 2019 with total page 432 pages. Available in PDF, EPUB and Kindle. Book excerpt: Providing an adequate level of skid resistance is essential for the safety of motorists. Previous studies demonstrated that the number of crashes is reduced if pavements have sufficient friction, especially in wet conditions. Adequate pavement friction prevents the vehicle from sliding on the pavement surface and provides the grip needed to maintain control over the vehicle. The first phase of this study investigated experimentally the two major friction mechanisms (i.e., adhesion and hysteresis) that contribute to tire-pavement friction. It is postulated that the adhesion between rubber tires and pavements is highly influenced by the surface free energy. However, there are no previous studies carried out to investigate the adhesion between rubber tires and pavements using the surface free energy. The results demonstrated that adhesion friction can be quantified by measuring the surface free energy components of pavement surface aggregates and rubber materials. There was a fair correlation between the adhesive bond energy and the measured coefficient of friction. Higher adhesion between rubber materials and pavement surface provided higher friction. These results provide a fundamental understanding of the mechanisms of rubber-pavement friction and verification of the relationship between adhesion and friction. In addition, there was a strong correlation between friction and rubber rheological properties. Rubber materials with lower modulus provided higher friction compared to those with higher modulus. These results explain the change in skid resistance with temperature throughout the year. The second phase of this study examined different factors that affect skid resistance of pavement surfaces. These parameters included macrotexture, microtexture, and driving speed. The macrotexture of the pavement is related to aggregate gradation of the mix or surface texture pattern. The microtexture is influenced by the roughness of the aggregate particles and their resistance to abrasion and polishing under traffic. This study proposed a new model that can be used to estimate the skid number at a given speed between 20 mph and 60 mph as a function of both macrotexture and microtexture of pavement surface. This model was developed based on the measured frictional characteristics of field test sections. The proposed model can be used if the full-scale friction tester is not available or cannot be used due to the limited length of the test section (e.g., bridge deck). In addition, the model provides a tool to the pavement engineers to ensure adequate skid resistance at various operation speeds during the mix design stage and before the mix is used in the field. A given mix design can be modified to improve its frictional characteristics at early stage which leads to cost savings often spent on the application of surface treatments. The third phase of this study utilized the close-range photogrammetry (CRP) technique to measure the pavement macrotexture and microtexture. Texture parameters were calculated from the collected and analyzed images of the pavement surface. The results of the CRP texture measurements were compared to standard test methods. The CRP texture measurements had excellent correlation with the standard methods; however, the CRP offers simple and accurate, yet inexpensive alternative to the current methods used to measure surface macrotexture and microtexture. In addition, the CRP texture parameters were incorporated in the Persson friction model to predict skid friction as a function of rubber properties. The results demonstrated excellent correlation between measured and predicted friction. This study greatly simplified the texture parameter calculations needed in the Persson friction model with good accuracy.The last component of this study developed a 3D finite element model to investigate the effect of surface characteristics along with rubber properties on the contact stress between the standard skid test tire and pavement surface. Such simulation provides an in-depth understanding of tire-pavement interaction that would require expensive resources to examine in the field. Study parameters included various coefficient of friction, texture (e.g., smooth, and grooved), tire rolling conditions (fully skidding and free rolling) as well as temperature. The developed 3D FE model of the test tire was first validated with laboratory measurements before it was used to examine the effect of the study parameters on tire-pavement contact stresses. The results of the finite element simulations demonstrated that the stress distribution at the tire-pavement interface is non-uniform with maximum values towards the edges of the tire. These findings were consistent with the wearing pattern of the test tire in the field. In addition, the results also demonstrated that the shear stresses increased with surface friction while there was no significant change in the vertical stresses. The grooved surface exhibited higher vertical and shear stresses compared to pavement with smooth texture. The grooved texture is used to improve skid resistance and reduce the noise of pavement surfaces. In addition, temperature was found to have significant impact on the stresses at the tire-pavement interface. The finite element simulation results agreed with the laboratory and field measurements of pavement friction.
Download or read book Correlating Pavement Texture Noise and Friction Properties written by Ruohan Li (M.S. in civil engineering) and published by . This book was released on 2020 with total page 244 pages. Available in PDF, EPUB and Kindle. Book excerpt: This thesis uses texture, friction, and noise data collected along eight asphalt pavements with different surface types across Texas to explore the intercorrelation between the three properties, both within each pavement surface type and across different types. It was found that across all surface types, the entire frequency band of noise from 400 to 5000 Hz correlates the strongest with texture of wavelengths from 31.5 mm to 2.5 mm positively. This means that regardless of the surface type, pavements with a higher texture level in the wavelength spectrum of 31.5 mm to 2.5 mm tend to generate a higher level of noise in the frequency band of 400 to 5000 Hz. When noise is broken down into 1/3 octave bands in frequency, the strongest positive correlation is found between noise of 630 Hz and texture of 50 mm wavelength. A negative correlation, however, is found between higher frequency (f > 1000 Hz) noise and shorter wavelength ([lambda]
Download or read book Pavement Engineering written by Rajib B. Mallick and published by CRC Press. This book was released on 2022-12-30 with total page 819 pages. Available in PDF, EPUB and Kindle. Book excerpt: Pavement Engineering: Principles and Practice examines a wide range of topics in asphalt and concrete pavements from soil preparation and structural design to life cycle costing and economic analysis. This updated Fourth Edition covers all concepts and practices of pavement engineering in terms of materials, design, and construction methods for both flexible and rigid pavements and includes the latest developments in recycling, sustainable pavement materials, and resilient infrastructure. New and updated topics include material characterization concepts and tests, pavement management concepts, probabilistic examples of life cycle cost analysis, end-of-life considerations, waste plastic in asphalt, pervious concrete, pavement monitoring instrumentation and data acquisition, and more. The latest updated references, state of the art reviews, and online resources have also been included.
Download or read book Tyre Road Noise written by Ulf Sandberg and published by . This book was released on 2002 with total page 616 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Surface Texture Versus Skidding Measurements Frictional Aspects and Safety Features of Tire Pavement Interactions written by and published by . This book was released on 1975 with total page 168 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Nchrp Synthesis 401 written by and published by Transportation Research Board. This book was released on with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Pavement Surface Texture Significance and Measurement Volume I Summary Report written by James C. Wambold and published by . This book was released on 1984 with total page 104 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tire Pavement Noise and Safety Performance written by Bradley O. Hibbs and published by . This book was released on 1996 with total page 102 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Physics of Tire Traction written by Donald Hays and published by Springer Science & Business Media. This book was released on 2013-11-11 with total page 423 pages. Available in PDF, EPUB and Kindle. Book excerpt:
