Download or read book Effect of Operating Conditions on the Particulates from a Single Cylinder Diesel Engine written by Henry Richard Deighton Simpson and published by . This book was released on 1980 with total page 109 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Effect of Operating Conditions on the Particulates from a Single Cylinder Diesel Engine written by Henry Richard Deighton Simpson (II.) and published by . This book was released on 1983 with total page 14 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Effect of Engine Operating Conditions on the Size and Morphology of Diesel Particulate Emissions written by Adam Neer and published by . This book was released on 2005 with total page 118 pages. Available in PDF, EPUB and Kindle. Book excerpt: "The size, morphology and volume fraction of sub-micron particulate matter emitted from a compression ignition (diesel) engine was investigated using thermophoretic sampling experiments followed by direct visual characterizations under transmission electron microscopy"--Abstract, leaf iii.
Download or read book Effect of Particulate Matter and Exhaust Gas Composition on Diesel Particulate Filter Regenration written by Amy E. Fischer and published by . This book was released on 2009 with total page 162 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Diesel and Gasoline Engine Exhausts and Some Nitroarenes written by IARC Working Group on the Evaluation of Carcinogenic Risks to Humans and published by IARC Monographs on the Evaluat. This book was released on 2015-06-04 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume of the IARC Monographs provides evaluations of the carcinogenicity of diesel and gasoline engine exhausts, and of 10 nitroarenes found in diesel engine exhaust: 3,7-dinitrofluoranthene, 3,9-dinitrofluoranthene, 1,3-dinitropyrene, 1,6-dinitropyrene, 1,8-dinitropyrene, 6-nitrochrysene, 2-nitrofluorene, 1-nitropyrene, 4-nitropyrene, and 3-nitrobenzanthrone. Diesel engines are used for transport on and off roads (e.g. passenger cars, buses, trucks, trains, ships), for machinery in various industrial sectors (e.g. mining, construction), and for electricity generators, particularly in developing countries. Gasoline engines are used in cars and hand-held equipment (e.g. chainsaws). The emissions from such combustion engines comprise a complex and varying mixture of gases (e.g. carbon monoxide, nitrogen oxides), particles (e.g. PM10, PM2.5, ultrafine particles, elemental carbon, organic carbon, ash, sulfate, and metals), volatile organic compunds (e.g. benzene, formaldehyde) and semi-volatile organic compounds (e.g. polycyclic aromatic hydrocarbons) including oxygenated and nitrated derivatives of polycyclic aromatic hydrocarbons. Diesel and gasoline engines thus make a significant contribution to a broad range of air pollutants to which people are exposed in the general population as well as in different occupational settings. An IARC Monographs Working Group reviewed epidemiological evidence, animal bioassays, and mechanistic and other relevant data to reach conclusions as to the carcinogenic hazard to humans of environmental or occupational exposure to diesel and gasoline engine exhausts (including those associated with the mining, railroad, construction, and transportation industries) and to 10 selected nitroarenes. -- Back cover.
Download or read book Biokerosene written by Martin Kaltschmitt and published by Springer. This book was released on 2017-08-09 with total page 761 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a detailed overview of aspects related to the overall provision chain for biokerosene as part of the global civil aviation business. Starting with a review of the current market situation for aviation fuels and airplanes and their demands, it then presents in-depth descriptions of classical and especially new types of non-edible biomass feedstock suitable for biokerosene provision. Subsequent chapters discuss those fuel provision processes that are already available and those still under development based on various biomass feedstock materials, and present e.g. an overview of the current state of the art in the production of a liquid biomass-based fuel fulfilling the specifications for kerosene. Further, given the growing interest of the aviation industry and airlines in biofuels for aviation, the experiences of an air-carrier are presented. In closing, the book provides a market outlook for biokerosene. Addressing a broad range of aspects related to the pros and cons of biokerosene as a renewable fuel for aviation, the book offers a unique resource.
Download or read book Size Distribution and Mass Output of Particulates from Diesel Engine Exhausts written by John A. Breslin and published by . This book was released on 1976 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Diesel Engine written by Saiful Bari and published by BoD – Books on Demand. This book was released on 2013-04-30 with total page 282 pages. Available in PDF, EPUB and Kindle. Book excerpt: Diesel engines, also known as CI engines, possess a wide field of applications as energy converters because of their higher efficiency. However, diesel engines are a major source of NOX and particulate matter (PM) emissions. Because of its importance, five chapters in this book have been devoted to the formulation and control of these pollutants. The world is currently experiencing an oil crisis. Gaseous fuels like natural gas, pure hydrogen gas, biomass-based and coke-based syngas can be considered as alternative fuels for diesel engines. Their combustion and exhaust emissions characteristics are described in this book. Reliable early detection of malfunction and failure of any parts in diesel engines can save the engine from failing completely and save high repair cost. Tools are discussed in this book to detect common failure modes of diesel engine that can detect early signs of failure.
Download or read book Diesel Combustion and Emissions written by Society of Automotive Engineers and published by . This book was released on 1981 with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Diesel Particulate Emissions Landmark Research 1994 2001 written by John H Johnson and published by SAE International. This book was released on 2002-02-20 with total page 636 pages. Available in PDF, EPUB and Kindle. Book excerpt: The need for manufacturers to meet U.S. Environmental Protection Agency (EPA) mobile source diesel emissions standards for on-highway light duty and heavy duty vehicles has been the driving force for the control of diesel particulate and NOx emissions reductions. Diesel Particulate Emissions: Landmark Research 1994-2001 contains the latest research and development findings that will help guide engineers to achieve low particulate emissions from future engines. Based on extensive SAE literature from the past seven years, the 45 papers in this book have been selected from the SAE Transactions Journals.
Download or read book Effect of Engine Operating Parameters and Fuel Characteristics on Diesel Engine Emissions written by Joseph Acar and published by . This book was released on 2005 with total page 64 pages. Available in PDF, EPUB and Kindle. Book excerpt: To examine the effects of using synthetic Fischer-Tropsch (FT) diesel fuel in a modern compression ignition engine, experiments were conducted on a MY 2002 Cummins 5.9 L diesel engine outfitted with high pressure, common rail fuel injection, a variable geometry turbo charger, cooled EGR and a fully configurable engine management computer. Additionally, the effect of varied injection timing and EGR rates were studied to examine how the engine can be optimized for FT fuel. The test fuels included two standard diesel fuels, one with 400 PPM sulfur content and the other 15 PPM sulfur. The experimental fuels were Syntroleum Corporation's S-1 fuel, as well as blends of 25% S-1 with a balance of 15 or 400 PPM D2. Tests were conducted with three engine operating conditions: 1682 RPM, 474 kPa BMEP; 2011 RPM, 1000 kPa BMEP; 2011 RPM, 1400 kPa BMEP. It was found that FT fuel reduced NOx emissions 19% in low load tests, but alone had little effect in higher load tests. FT fuel reduced particulate matter (PM) emissions in almost all test case, on the order of 25 to 75%. Retarding injection timing and increasing EGR both reduce NOx emissions. In the case of standard fuels, these reduction come at the expense of increased PM. However, FT fuel reduced this effect and allows for more retarded timing and further increased EGR rates to control NO. Blended fuels, containing 25% FT, by volume, and a balance of 15 PPM or 400 PPM fuel, were found to provide most of the benefit of straight FT fuel. The FT/15 blend reduced PM 40% and the FT/400 blend reduced PM 60%.
Download or read book Assessment of Fuel Economy Technologies for Light Duty Vehicles written by National Research Council and published by National Academies Press. This book was released on 2011-06-03 with total page 373 pages. Available in PDF, EPUB and Kindle. Book excerpt: Various combinations of commercially available technologies could greatly reduce fuel consumption in passenger cars, sport-utility vehicles, minivans, and other light-duty vehicles without compromising vehicle performance or safety. Assessment of Technologies for Improving Light Duty Vehicle Fuel Economy estimates the potential fuel savings and costs to consumers of available technology combinations for three types of engines: spark-ignition gasoline, compression-ignition diesel, and hybrid. According to its estimates, adopting the full combination of improved technologies in medium and large cars and pickup trucks with spark-ignition engines could reduce fuel consumption by 29 percent at an additional cost of $2,200 to the consumer. Replacing spark-ignition engines with diesel engines and components would yield fuel savings of about 37 percent at an added cost of approximately $5,900 per vehicle, and replacing spark-ignition engines with hybrid engines and components would reduce fuel consumption by 43 percent at an increase of $6,000 per vehicle. The book focuses on fuel consumption-the amount of fuel consumed in a given driving distance-because energy savings are directly related to the amount of fuel used. In contrast, fuel economy measures how far a vehicle will travel with a gallon of fuel. Because fuel consumption data indicate money saved on fuel purchases and reductions in carbon dioxide emissions, the book finds that vehicle stickers should provide consumers with fuel consumption data in addition to fuel economy information.
Download or read book The Impact of Oil Consumption Mechanisms on Diesel Exhaust Particle Size Distributions and Detailed Exhaust Chemical Composition written by D. Foster and published by . This book was released on 2003 with total page 9 pages. Available in PDF, EPUB and Kindle. Book excerpt: Detailed exhaust emission data have been taken from a Cummins N-14 single cylinder research engine in which the oil consumption was varied by different engine modifications. Low sulfur fuel was used, and oil consumption was varied by modifying the intake valve stem seals, the exhaust valve stem seals, the oil control ring and combinations of these modifications. Detailed measurements of exhaust gas particle size distributions and chemical composition were made for the various oil consumption configurations for a range of engine loads and speeds. The particulate mass was measured with TEOM and traditional gravimetric filter methods. Filter data for EC/OC, sulfates and trace metals have been taken and analyzed. The trace metals in the particulate mass serve as the basis for assessing oil consumption at the different operating conditions. The data indicate that the oil consumption for the steady state testing done here was approximately an order of magnitude below oil consumption values cited in the literature. We did measure changes in the details of the chemical composition of the particulate for the different engine operating conditions, but it did not correlate with changes in the oil consumption. Furthermore, the data indicate that the particle size distribution is not strongly impacted by low level oil consumption variations observed in this work.
Download or read book Particulate Carbon written by Donald Siegla and published by Springer Science & Business Media. This book was released on 2013-11-11 with total page 500 pages. Available in PDF, EPUB and Kindle. Book excerpt: The goal of the symposium, "Particulate Carbon: Formation During Combustion", held at the General Motors Research Laboratories on October 15 and 16, 1980, was to discuss fundamental aspects of soot formation and oxidation in combustion systems and to stimulate new research by extensive interactions among the participants. This book contains lhe papers and discussions of that symposium, the 26th in an annual series covering many different disciplines which are timely and of interest to both General Motors and the technical community at large. The subject of this symposium has considerable relevance for man in his effort to control and preserve his environment. Emission of particulate carbon into the atmos phere from combustion sources is of concern to scientists and laymen alike. The hope of reducing this emission clearly requires an understanding of its formation during the combustion process, itself an area of considerable long-term research interest. It is our hope that this symposium has served to summarize what is known so that what remains to be learned can be pursued with greater vigor.
Download or read book Engine Exhaust Particulates written by Avinash Kumar Agarwal and published by Springer. This book was released on 2018-11-01 with total page 269 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a comparative analysis of both diesel and gasoline engine particulates, and also of the emissions resulting from the use of alternative fuels. Written by respected experts, it offers comprehensive insights into motor vehicle particulates, their formation, composition, location, measurement, characterisation and toxicology. It also addresses exhaust-gas treatment and legal, measurement-related and technological advancements concerning emissions. The book will serve as a valuable resource for academic researchers and professional automotive engineers alike.
Download or read book The Effects of Lubricating Oil Consumption on the Detailed Characteristics of Diesel Particulate Matter written by Nathan D. Forster and published by . This book was released on 2003 with total page 298 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Analysis of Diesel Particulate Matter of Single Cylinder Diesel Engine Running on Tire Derivated Fuel written by Nur Ain Afiqah Abdul Latiff and published by . This book was released on 2012 with total page 66 pages. Available in PDF, EPUB and Kindle. Book excerpt:
