Download or read book EFFECT OF CO2 ON THE STRENGTH AND DUCTILITY OF TYPE 304 STAINLESS STEEL AT ELEVATED TEMPERATURES written by and published by . This book was released on 1962 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The mechanisms by which the carbon dioxide coolant affects the strength properties of type 304 stainless steel were investigated in the range 1300 to 1700 deg F (704-927 deg C). Creep- and stress-rupture results obtained on sheet materials in wet and dry CO2 and argon are compared. The effect of annealing in CO2 on the tensile strength and ductility was also investigated. The question of whether the strengthening observed in CO2 was due to oxidation or carburization was determined. Experiments on the effect of various partial pressures of oxygen in argon showed that the creep rate was minimum at approximately 10 ppm. The creep rate is CO2 at equivalent stress and temperature was lower by a factor of 3 than the minimum rate observed in oxygen. Chemical analyses, metallography, and experiments with carbon showed that carburization occurred in pure flowing CO2 in the temperature range studied. From this evidence it was concluded that the strengthening observed in CO2 was primarily due to carburization. The creep- and tensile-fracture strains were adversely affected by exposure to CO2, with the magnitude of the effect dependent on the time and temperature of exposure. (auth).
Download or read book Nuclear Science Abstracts written by and published by . This book was released on 1975-08 with total page 958 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fundamentals and Applications of Supercritical Carbon Dioxide SCO2 Based Power Cycles written by Klaus Brun and published by Woodhead Publishing. This book was released on 2017-01-09 with total page 464 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fundamentals and Applications of Supercritical Carbon Dioxide (SCO2) Based Power Cycles aims to provide engineers and researchers with an authoritative overview of research and technology in this area. Part One introduces the technology and reviews the properties of SCO2 relevant to power cycles. Other sections of the book address components for SCO2 power cycles, such as turbomachinery expanders, compressors, recuperators, and design challenges, such as the need for high-temperature materials. Chapters on key applications, including waste heat, nuclear power, fossil energy, geothermal and concentrated solar power are also included. The final section addresses major international research programs. Readers will learn about the attractive features of SC02 power cycles, which include a lower capital cost potential than the traditional cycle, and the compounding performance benefits from a more efficient thermodynamic cycle on balance of plant requirements, fuel use, and emissions. - Represents the first book to focus exclusively on SC02 power cycles - Contains detailed coverage of cycle fundamentals, key components, and design challenges - Addresses the wide range of applications of SC02 power cycles, from more efficient electricity generation, to ship propulsion
Download or read book Biaxial Stress rupture Properties of Austenitic Stainless Steels in Zirconium gettered Sodium written by W. T. Lee and published by . This book was released on 1967 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advances in Corrosion Science and Technology written by M.G. Fontana and published by Springer Science & Business Media. This book was released on 2013-04-17 with total page 373 pages. Available in PDF, EPUB and Kindle. Book excerpt: This series was organized to provide a forum for review papers in the area of corrosion. The aim of these reviews is to bring certain areas of corrosiou science and technology into a sharp focus. The volumes of this series are published approximately on a yearly basis and each contains three to five reviews. The articles in each volume are selected in such a way as to be of interest both to the corrosion scientists and the corrosion technologists. There is, in fact, a particular aim in juxtaposing these interests because of the importance of mutual interaction and interdisciplinarity so important in corrosion studies. It is hoped that the corrosion scientists in this way may stay abreast of the activities in corrosion technology and vice versa. In this series the term "corrosion" is used in its very broadest sense. It includes, therefore, not only the degradation of metals in aqueous en vironment but also what is commonly referred to as "high-temperature oxidation. " Further, the plan is to be even more general than these topics; the series will include all solids and all environments. Today, engineering solids include not only metals but glasses, ionic solids, polymeric solids, and composites of these. Environments of interest must be extended to liquid metals, a wide variety of gases, nonaqueous electrolytes, and other non aqueous liquids.
Download or read book Corrosion written by and published by . This book was released on 1963 with total page 484 pages. Available in PDF, EPUB and Kindle. Book excerpt: Issues for 1945-1961 include special section called Corrosion abstracts.
Download or read book Keywords Index to U S Government Technical Reports permuted Title Index written by United States. Department of Commerce. Office of Technical Services and published by . This book was released on 1962 with total page 860 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Elevated Temperature Properties as Influenced by Nitrogen Additions to Types 304 and 316 Austenitic Stainless Steels written by and published by ASTM International. This book was released on 1973 with total page 123 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Nuclear Safety written by and published by . This book was released on 1962 with total page 1028 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Keywords Index to U S Government Technical Reports written by and published by . This book was released on 1962 with total page 748 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Elevated Temperature Properties as Influenced by Nitrogen Additions to Types 304 and 316 Austenitic Stainless Steels written by Symposium on Elevated Temperature Properties as Influenced by Nitrogen Additions to Types 304 and 316 Austenitic Stainless Steels and published by . This book was released on 1973 with total page 132 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book U S Government Research Reports written by and published by . This book was released on 1963 with total page 704 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Effect of Environment on the Creep Properties of Type 304 Stainless Steel at Elevated Temperatures written by H. E. McCoy (Jr.) and published by . This book was released on 1962 with total page 64 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Energy Research Abstracts written by and published by . This book was released on 1982 with total page 1744 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Mond Nickel Bulletin written by and published by . This book was released on 1963 with total page 346 pages. Available in PDF, EPUB and Kindle. Book excerpt: Includes sections "Abstracts and references" and "Patents".
Download or read book Technical Publications Announcements with Indexes written by United States. National Aeronautics and Space Administration and published by . This book was released on 1962 with total page 1556 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1987 with total page 952 pages. Available in PDF, EPUB and Kindle. Book excerpt:
