Download or read book Detecting and Gettering Chromium Impurities in Photovoltaic Crystalline Silicon written by Mallory Ann Jensen and published by . This book was released on 2015 with total page 67 pages. Available in PDF, EPUB and Kindle. Book excerpt: Photovoltaic (PV) modules provide a source of renewable electricity by harnessing solar energy. Currently, crystalline silicon dominates the PV market with an approximate market share of 90% and record solar cell efficiencies greater than 20%. However, the PV market must decrease the cost to the consumer to maintain growth and meet global electricity demands. Increasing the solar-to-electricity conversion efficiency is one of the most significant cost levers. Transition metal impurities can degrade silicon wafer-based solar cell efficiencies at concentrations as low as 1010 cm3 . By removing interstitial metals from the bulk and/or collecting interstitial metals at heterogeneous nucleation sites, phosphorous diffusion gettering renders them less detrimental in the final solar cell. While they exist for iron, kinetics process simulation tools do not yet exist for chromium, which has higher capture cross-sections for minority carriers and is therefore more detrimental in both p- and n-type materials. In this thesis, I employ synchrotron-based X-ray fluorescence microscopy to study chromium (Cr) distributions in multicrystalline silicon in as-grown material and after two phosphorous diffusion profiles. I complement quantified precipitate size and spatial distribution with interstitial Cr concentration and minority carrier lifetime measurements to provide insight into chromium gettering kinetics and offer suggestions for minimizing the device impacts of chromium. The data presented in this thesis can be used in development of kinetics process simulation tools for chromium gettering. Finally, I describe a new technique for detecting low concentrations of impurities in n- and p-type silicon. The development of high-performance silicon materials, including n-type, necessitates more sensitive impurity detection techniques, capable of measuring interstitial contaminations below 1010 cm-3. I propose the development of a free-carrier absorption-based technique that incorporates a temperature stage. By measuring injection-dependent lifetimes at a wide range of sample temperatures, the identifying parameters of lifetime-limiting defects can be deduced.

Download or read book Advanced Silicon Materials for Photovoltaic Applications written by Sergio Pizzini and published by John Wiley & Sons. This book was released on 2012-06-07 with total page 412 pages. Available in PDF, EPUB and Kindle. Book excerpt: Today, the silicon feedstock for photovoltaic cells comes from processes which were originally developed for the microelectronic industry. It covers almost 90% of the photovoltaic market, with mass production volume at least one order of magnitude larger than those devoted to microelectronics. However, it is hard to imagine that this kind of feedstock (extremely pure but heavily penalized by its high energy cost) could remain the only source of silicon for a photovoltaic market which is in continuous expansion, and which has a cumulative growth rate in excess of 30% in the last few years. Even though reports suggest that the silicon share will slowly decrease in the next twenty years, finding a way to manufacture a specific solar grade feedstock in large quantities, at a low cost while maintaining the quality needed, still remains a crucial issue. Thin film and quantum confinement-based silicon cells might be a complementary solution. Advanced Silicon Materials for Photovoltaic Applications has been designed to describe the full potentialities of silicon as a multipurpose material and covers: Physical, chemical and structural properties of silicon Production routes including the promise of low cost feedstock for PV applications Defect engineering and the role of impurities and defects Characterization techniques, and advanced analytical techniques for metallic and non-metallic impurities Thin film silicon and thin film solar cells Innovative quantum effects, and 3rd generation solar cells With contributions from internationally recognized authorities, this book gives a comprehensive analysis of the state-of-the-art of process technologies and material properties, essential for anyone interested in the application and development of photovoltaics.

Download or read book Handbook of Photovoltaic Silicon written by Deren Yang and published by Springer. This book was released on 2019-11-28 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: The utilization of sun light is one of the hottest topics in sustainable energy research. To efficiently convert sun power into a reliable energy – electricity – for consumption and storage, silicon and its derivatives have been widely studied and applied in solar cell systems. This handbook covers the photovoltaics of silicon materials and devices, providing a comprehensive summary of the state of the art of photovoltaic silicon sciences and technologies. This work is divided into various areas including but not limited to fundamental principles, design methodologies, wafering techniques/fabrications, characterizations, applications, current research trends and challenges. It offers the most updated and self-explanatory reference to all levels of students and acts as a quick reference to the experts from the fields of chemistry, material science, physics, chemical engineering, electrical engineering, solar energy, etc..

Download or read book Metal Impurities in Silicon Device Fabrication written by Klaus Graff and published by Springer Science & Business Media. This book was released on 2013-03-08 with total page 228 pages. Available in PDF, EPUB and Kindle. Book excerpt: A discussion of the different mechanisms responsible for contamination together with a survey of their impact on device performance. The author examines the specific properties of main and rare impurities in silicon, as well as the detection methods and requirements in modern technology. Finally, impurity gettering is studied along with modern techniques to determine gettering efficiency. Throughout all of these subjects, the book presents only reliable and up-to-date data so as to provide a thorough review of recent scientific investigations.

Download or read book Metal Impurities in Silicon and Germanium Based Technologies written by Cor Claeys and published by Springer. This book was released on 2018-08-13 with total page 464 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a unique review of various aspects of metallic contamination in Si and Ge-based semiconductors. It discusses all of the important metals including their origin during crystal and/or device manufacturing, their fundamental properties, their characterization techniques and their impact on electrical devices’ performance. Several control and possible gettering approaches are addressed. The book offers a valuable reference guide for all researchers and engineers studying advanced and state-of-the-art micro- and nano-electronic semiconductor devices and circuits. Adopting an interdisciplinary approach, it combines perspectives from e.g. material science, defect engineering, device processing, defect and device characterization, and device physics and engineering.

Download or read book Crystal Growth and Evaluation of Silicon for VLSI and ULSI written by Golla Eranna and published by CRC Press. This book was released on 2014-12-08 with total page 432 pages. Available in PDF, EPUB and Kindle. Book excerpt: Silicon, as a single-crystal semiconductor, has sparked a revolution in the field of electronics and touched nearly every field of science and technology. Though available abundantly as silica and in various other forms in nature, silicon is difficult to separate from its chemical compounds because of its reactivity. As a solid, silicon is chemically inert and stable, but growing it as a single crystal creates many technological challenges. Crystal Growth and Evaluation of Silicon for VLSI and ULSI is one of the first books to cover the systematic growth of silicon single crystals and the complete evaluation of silicon, from sand to useful wafers for device fabrication. Written for engineers and researchers working in semiconductor fabrication industries, this practical text: Describes different techniques used to grow silicon single crystals Explains how grown single-crystal ingots become a complete silicon wafer for integrated-circuit fabrication Reviews different methods to evaluate silicon wafers to determine suitability for device applications Analyzes silicon wafers in terms of resistivity and impurity concentration mapping Examines the effect of intentional and unintentional impurities Explores the defects found in regular silicon-crystal lattice Discusses silicon wafer preparation for VLSI and ULSI processing Crystal Growth and Evaluation of Silicon for VLSI and ULSI is an essential reference for different approaches to the selection of the basic silicon-containing compound, separation of silicon as metallurgical-grade pure silicon, subsequent purification, single-crystal growth, and defects and evaluation of the deviations within the grown crystals.

Download or read book Properties of Crystalline Silicon written by Robert Hull and published by IET. This book was released on 1999 with total page 1054 pages. Available in PDF, EPUB and Kindle. Book excerpt: A unique and well-organized reference, this book provides illuminating data, distinctive insight and expert guidance on silicon properties.

Download or read book NASA Tech Briefs written by and published by . This book was released on 1988 with total page 424 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Energy Research Abstracts written by and published by . This book was released on 1993 with total page 922 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Cumulative Index to NASA Tech Briefs written by and published by . This book was released on with total page 428 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Extended Abstracts written by Electrochemical Society and published by . This book was released on 1982 with total page 1192 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Future of solar photovoltaic written by International Renewable Energy Agency IRENA and published by International Renewable Energy Agency (IRENA). This book was released on 2019-11-01 with total page 145 pages. Available in PDF, EPUB and Kindle. Book excerpt: This study presents options to fully unlock the world’s vast solar PV potential over the period until 2050. It builds on IRENA’s global roadmap to scale up renewables and meet climate goals.

Download or read book Solar PV Power written by Rabindra Kumar Satpathy and published by Academic Press. This book was released on 2020-11-28 with total page 520 pages. Available in PDF, EPUB and Kindle. Book excerpt: Solar PV Power: Design, Manufacturing and Applications from Sand to Systems details developments in the solar cell manufacturing process, including information from system design straight through to the entire value chain of Solar PV Manufacturing. In addition, the book includes aspects of ground mounted grid connected solar PV systems and optimization for solar PV plants, economic analyses, and reliability and performance. The advances and processes of solar product technology and reliability, along with the performance of solar PV plants and operational and maintenance aspects with advance diagnostic techniques are also presented, making this an ideal resource. With rapid change in the manufacturing process, it is crucial for solar cells and solar PV modules to adapt to new developments in solar products, especially with regard to reliability, financial aspects and performance. - Includes detailed solar panel module assembly and analysis - Offers new concepts for solar PV system design that are presented alongside field related issues and examples - Saves time and resources by collecting all pieces of information needed by engineers in the same text

Download or read book Sixteenth European Photovoltaic Solar Energy Conference written by H. Scheer and published by Routledge. This book was released on 2020-11-25 with total page 3235 pages. Available in PDF, EPUB and Kindle. Book excerpt: The European Photovoltaic Solar Energy Conferences are dedicated to accelerating the impetus towards sustainable development of global PV markets. The 16th in the series, held in Glasgow UK, brought together more than 1500 delegates from 72 countries, and provided an important and vital forum for information exchange in the field. The Conference Proceedings place on record a new phase of market development and scientific endeavour in the PV industry, representing current and innovative thinking in all aspects of the science, technology, markets and business of photovoltaics. In three volumes, the Proceedings present some 790 papers selected for presentation by the scientific review committee of the 16th European Photovoltaic Solar Energy Conference. The comprehensive range of topics covered comprise: * Fundamentals, Novel Devices and New Materials * Thin Film Cells and Technologies * Space Cells and Systems * Crystalline Silicon Solar Cells and Technologies * PV Integration in Buildings * PV Modules and Components of PV Systems * Implementation, Strategies, National Programs and Financing Schemes * Market Deployment in Developing Countries These proceedings are an essential reference for all involved in the global PV industry- scientists, researchers, technologists and those with an interest in global market trends. The conference was organised by WIP-Renewable Energies, Munich, Germany.

Download or read book Advances in CMP Polishing Technologies written by Toshiro Doi and published by William Andrew. This book was released on 2011-12-06 with total page 330 pages. Available in PDF, EPUB and Kindle. Book excerpt: CMP and polishing are the most precise processes used to finish the surfaces of mechanical and electronic or semiconductor components. Advances in CMP/Polishing Technologies for Manufacture of Electronic Devices presents the latest developments and technological innovations in the field - making cutting-edge R&D accessible to the wider engineering community. Most of the applications of these processes are kept as confidential as possible (proprietary information), and specific details are not seen in professional or technical journals and magazines. This book makes these processes and applications accessible to a wider industrial and academic audience. Building on the fundamentals of tribology - the science of friction, wear and lubrication - the authors explore the practical applications of CMP and polishing across various market sectors. Due to the high pace of development of the electronics and semiconductors industry, many of the presented processes and applications come from these industries. Demystifies scientific developments and technological innovations, opening them up for new applications and process improvements in the semiconductor industry and other areas of precision engineering Explores stock removal mechanisms in CMP and polishing, and the challenges involved in predicting the outcomes of abrasive processes in high-precision environments The authors bring together the latest innovations and research from the USA and Japan

Download or read book Solar Cells and Modules written by Arvind Shah and published by Springer Nature. This book was released on 2020-07-16 with total page 357 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book gives a comprehensive introduction to the field of photovoltaic (PV) solar cells and modules. In thirteen chapters, it addresses a wide range of topics including the spectrum of light received by PV devices, the basic functioning of a solar cell, and the physical factors limiting the efficiency of solar cells. It places particular emphasis on crystalline silicon solar cells and modules, which constitute today more than 90 % of all modules sold worldwide. Describing in great detail both the manufacturing process and resulting module performance, the book also touches on the newest developments in this sector, such as Tunnel Oxide Passivated Contact (TOPCON) and heterojunction modules, while dedicating a major chapter to general questions of module design and fabrication. Overall, it presents the essential theoretical and practical concepts of PV solar cells and modules in an easy-to-understand manner and discusses current challenges facing the global research and development community.

Download or read book Perovskite Photovoltaics written by Aparna Thankappan and published by Academic Press. This book was released on 2018-06-29 with total page 521 pages. Available in PDF, EPUB and Kindle. Book excerpt: Perovskite Photovoltaics: Basic to Advanced Concepts and Implementation examines the emergence of perovskite photovoltaics, associated challenges and opportunities, and how to achieve broader development. Consolidating developments in perovskite photovoltaics, including recent progress solar cells, this text also highlights advances and the research necessary for sustaining energy. Addressing different photovoltaics fields with tailored content for what makes perovskite solar cells suitable, and including commercialization examples of large-scale perovskite solar technology. The book also contains a detailed analysis of the implementation and economic viability of perovskite solar cells, highlighting what photovoltaic devices need to be generated by low cost, non-toxic, earth abundant materials using environmentally scalable processes. This book is a valuable resource engineers, scientists and researchers, and all those who wish to broaden their knowledge on flexible perovskite solar cells. - Includes contributions by leading solar cell academics, industrialists, researchers and institutions across the globe - Addresses different photovoltaics fields with tailored content for what makes perovskite solar cells different - Provides commercialization examples of large-scale perovskite solar technology, giving users detailed analysis on the implementation, technical challenges and economic viability of perovskite solar cells