Download or read book CMOS PLL Synthesizers Analysis and Design written by Keliu Shu and published by Springer Science & Business Media. This book was released on 2006-01-20 with total page 227 pages. Available in PDF, EPUB and Kindle. Book excerpt: Thanks to the advance of semiconductor and communication technology, the wireless communication market has been booming in the last two decades. It evolved from simple pagers to emerging third-generation (3G) cellular phones. In the meanwhile, broadband communication market has also gained a rapid growth. As the market always demands hi- performance and low-cost products, circuit designers are seeking hi- integration communication devices in cheap CMOS technology. The phase-locked loop frequency synthesizer is a critical component in communication devices. It works as a local oscillator for frequency translation and channel selection in wireless transceivers and broadband cable tuners. It also plays an important role as the clock synthesizer for data converters in the analog-and-digital signal interface. This book covers the design and analysis of PLL synthesizers. It includes both fundamentals and a review of the state-of-the-art techniques. The transient analysis of the third-order charge-pump PLL reveals its locking behavior accurately. The behavioral-level simulation of PLL further clarifies its stability limit. Design examples are given to clearly illustrate the design procedure of PLL synthesizers. A complete derivation of reference spurs in the charge-pump PLL is also presented in this book. The in-depth investigation of the digital CA modulator for fractional-N synthesizers provides insightful design guidelines for this important block.
Download or read book Design of CMOS Phase Locked Loops written by Behzad Razavi and published by Cambridge University Press. This book was released on 2020-01-30 with total page 509 pages. Available in PDF, EPUB and Kindle. Book excerpt: This modern, pedagogic textbook from leading author Behzad Razavi provides a comprehensive and rigorous introduction to CMOS PLL design, featuring intuitive presentation of theoretical concepts, extensive circuit simulations, over 200 worked examples, and 250 end-of-chapter problems. The perfect text for senior undergraduate and graduate students.
Download or read book Pll Performance Simulation and Design written by Dean Banerjee and published by Dog Ear Publishing. This book was released on 2006-08 with total page 346 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is intended for the reader who wishes to gain a solid understanding of Phase Locked Loop architectures and their applications. It provides a unique balance between both theoretical perspectives and practical design trade-offs. Engineers faced with real world design problems will find this book to be a valuable reference providing example implementations, the underlying equations that describe synthesizer behavior, and measured results that will improve confidence that the equations are a reliable predictor of system behavior. New material in the Fourth Edition includes partially integrated loop filter implementations, voltage controlled oscillators, and modulation using the PLL.
Download or read book Multi GHz Frequency Synthesis Division written by Hamid R. Rategh and published by Springer Science & Business Media. This book was released on 2007-05-08 with total page 157 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the past 10 years extensive effort has been dedicated to commercial wireless local area network (WLAN) systems. Despite all these efforts, however, none of the existing systems has been successful, mainly due to their low data rates. The increasing demand for WLAN systems that can support data rates in excess of 20 Mb/s enticed the FCC to create an unlicensed national information infrastructure (U–NII) band at 5 GHz. This frequency band provides 300 MHz of spectrum in two segments: a 200 MHz(5.15–5.35 GHz) and a 100 MHz (5.725–5.825 GHz) frequency band. This newly released spectrum, and the fast trend of CMOS scaling, provide an opportunity to design WLAN systems with high data rate and low cost. One of the existing standards at 5 GHz is the European high performance radio LAN (HIPERLAN) standard that supports data rates as high as 20 Mb/s. One of the main building blocks of each wireless system is the f- quency synthesizer. Phase–locked loops (PLLs) are universally used to design radio frequency synthesizers. Reducing the power consumption of the frequency dividers of a PLL has always been a challenge. In this book, we introduce an alternative solution for conventional flipflop based xiv MULTI–GHZ FREQUENCY SYNTHESIS & DIVISION frequency dividers. An injection–locked frequency divider (ILFD) takes advantage of the narrowband nature of the wireless systems and employs resonators to trade off bandwidth for power.
Download or read book Architectures for RF Frequency Synthesizers written by Cicero S. Vaucher and published by Springer Science & Business Media. This book was released on 2006-04-18 with total page 268 pages. Available in PDF, EPUB and Kindle. Book excerpt: This text describes a conceptual framework for analyzing the performance of PLL frequency synthesizers, and presents optimization procedures for the different performance aspects. It contains basic information and in-depth knowledge, widely illustrated with practical design examples used in industrial products.
Download or read book Monolithic Phase Locked Loops and Clock Recovery Circuits written by Behzad Razavi and published by John Wiley & Sons. This book was released on 1996-04-18 with total page 516 pages. Available in PDF, EPUB and Kindle. Book excerpt: Featuring an extensive 40 page tutorial introduction, this carefully compiled anthology of 65 of the most important papers on phase-locked loops and clock recovery circuits brings you comprehensive coverage of the field-all in one self-contained volume. You'll gain an understanding of the analysis, design, simulation, and implementation of phase-locked loops and clock recovery circuits in CMOS and bipolar technologies along with valuable insights into the issues and trade-offs associated with phase locked systems for high speed, low power, and low noise.
Download or read book Digital Frequency Synthesis Demystified written by Bar-Giora Goldberg and published by Elsevier. This book was released on 2000-02-20 with total page 354 pages. Available in PDF, EPUB and Kindle. Book excerpt: · In-depth coverage of modern digital implementations of frequency synthesis architectures· Numerous design examples drawn from actual engineering projectsDigital frequency synthesis is used in modern wireless and communications technologies such as radar, cellular telephony, satellite communications, electronic imaging, and spectroscopy. This is book is a comprehensive overview of digital frequency synthesis theory and applications, with a particular emphasis on the latest approaches using fractional-N phase-locked loop technology. In-depth coverage of modern digital implementations of frequency synthesis architectures Numerous design examples drawn from actual engineering projects
Download or read book Phase locked Loops written by Roland E. Best and published by McGraw-Hill Companies. This book was released on 1993 with total page 388 pages. Available in PDF, EPUB and Kindle. Book excerpt: Unique book/disk set that makes PLL circuit design easier than ever. Table of Contents: PLL Fundamentals; Classification of PLL Types; The Linear PLL (LPLL); The Classical Digital PLL (DPLL); The All-Digital PLL (ADPLL); The Software PLL (SPLL); State Of The Art of Commercial PLL Integrated Circuits; Appendices; Index. Includes a 5 1/4" disk. 100 illustrations.
Download or read book Design of High Performance CMOS Voltage Controlled Oscillators written by Liang Dai and published by Springer Science & Business Media. This book was released on 2003 with total page 186 pages. Available in PDF, EPUB and Kindle. Book excerpt: Design of High-Performance CMOS Voltage-Controlled Oscillators presents a phase noise modeling framework for CMOS ring oscillators. The analysis considers both linear and nonlinear operation. It indicates that fast rail-to-rail switching has to be achieved to minimize phase noise. Additionally, in conventional design the flicker noise in the bias circuit can potentially dominate the phase noise at low offset frequencies. Therefore, for narrow bandwidth PLLs, noise up conversion for the bias circuits should be minimized. We define the effective Q factor (Qeff) for ring oscillators and predict its increase for CMOS processes with smaller feature sizes. Our phase noise analysis is validated via simulation and measurement results. The digital switching noise coupled through the power supply and substrate is usually the dominant source of clock jitter. Improving the supply and substrate noise immunity of a PLL is a challenging job in hostile environments such as a microprocessor chip where millions of digital gates are present.
Download or read book Proceedings written by and published by . This book was released on 2001 with total page 534 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Design and Implementation of Low Power CMOS Radio Receivers written by Derek Shaeffer and published by Springer Science & Business Media. This book was released on 2007-05-08 with total page 208 pages. Available in PDF, EPUB and Kindle. Book excerpt: It is hardly a profound observation to note that we remain in the midst of a wireless revolution. In 1998 alone, over 150 million cell phones were sold worldwide, representing an astonishing 50% increase over the previous year. Maintaining such a remarkable growth rate requires constant innovation to decrease cost while increasing performance and functionality. Traditionally, wireless products have depended on a mixture of semicond- tor technologies, spanning GaAs, bipolar and BiCMOS, just to name a few. A question that has been hotly debated is whether CMOS could ever be suitable for RF applications. However, given the acknowledged inferiority of CMOS transistors relative to those in other candidate technologies, it has been argued by many that “CMOS RF” is an oxymoron, an endeavor best left cloistered in the ivory towers of academia. In rebuttal, there are several compelling reasons to consider CMOS for wi- less applications. Aside from the exponential device and density improvements delivered regularly by Moore’s law, only CMOS offers a technology path for integrating RF and digital elements, potentially leading to exceptionally c- pact and low-cost devices. To enable this achievement, several thorny issues need to be resolved. Among these are the problem of poor passive com- nents, broadband noise in MOSFETs, and phase noise in oscillators made with CMOS. Beyond the component level, there is also the important question of whether there are different architectural choices that one would make if CMOS were used, given the different constraints.
Download or read book The Design of CMOS Radio Frequency Integrated Circuits written by Thomas H. Lee and published by Cambridge University Press. This book was released on 2004 with total page 232 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book, first published in 2004, is an expanded and revised edition of Tom Lee's acclaimed RFIC text.
Download or read book Phase locked Loop Circuit Design written by Dan H. Wolaver and published by . This book was released on 1991 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume introduces phase-locked loop applications and circuit design. Drawing theory and practice together, the book emphasizes electronics design tools and circuits, using specific design examples, addresses the practical details that lead to a working design. Wolaver assumes no specialized knowledge in the area covered, reviewing basics as necessary; makes heavy use of figures to support the understanding of phase-locked loop theory and circuit operation; extensively discusses frequency acquisition means, an intensely nonlinear phenomenon; treats injection locking, a practical and often confounding problem; and takes a unique approach to characterizing the phase-locked loop parameters.
Download or read book CMOS written by R. Jacob Baker and published by John Wiley & Sons. This book was released on 2008 with total page 1074 pages. Available in PDF, EPUB and Kindle. Book excerpt: This edition provides an important contemporary view of a wide range of analog/digital circuit blocks, the BSIM model, data converter architectures, and more. The authors develop design techniques for both long- and short-channel CMOS technologies and then compare the two.
Download or read book All Digital Frequency Synthesizer in Deep Submicron CMOS written by Robert Bogdan Staszewski and published by John Wiley & Sons. This book was released on 2006-09-22 with total page 281 pages. Available in PDF, EPUB and Kindle. Book excerpt: A new and innovative paradigm for RF frequency synthesis and wireless transmitter design Learn the techniques for designing and implementing an all-digital RF frequency synthesizer. In contrast to traditional RF techniques, this innovative book sets forth digitally intensive design techniques that lead the way to the development of low-cost, low-power, and highly integrated circuits for RF functions in deep submicron CMOS processes. Furthermore, the authors demonstrate how the architecture enables readers to integrate an RF front-end with the digital back-end onto a single silicon die using standard ASIC design flow. Taking a bottom-up approach that progressively builds skills and knowledge, the book begins with an introduction to basic concepts of frequency synthesis and then guides the reader through an all-digital RF frequency synthesizer design: Chapter 2 presents a digitally controlled oscillator (DCO), which is the foundation of a novel architecture, and introduces a time-domain model used for analysis and VHDL simulation Chapter 3 adds a hierarchical layer of arithmetic abstraction to the DCO that makes it easier to operate algorithmically Chapter 4 builds a phase correction mechanism around the DCO such that the system's frequency drift or wander performance matches that of the stable external frequency reference Chapter 5 presents an application of the all-digital RF synthesizer Chapter 6 describes the behavioral modeling and simulation methodology used in design The final chapter presents the implementation of a full transmitter and experimental results. The novel ideas presented here have been implemented and proven in two high-volume, commercial single-chip radios developed at Texas Instruments: Bluetooth and GSM. While the focus of the book is on RF frequency synthesizer design, the techniques can be applied to the design of other digitally assisted analog circuits as well. This book is a must-read for students and engineers who want to learn a new paradigm for RF frequency synthesis and wireless transmitter design using digitally intensive design techniques.
Download or read book Technical Abstract Bulletin written by and published by . This book was released on 1980 with total page 356 pages. Available in PDF, EPUB and Kindle. Book excerpt:
