Download or read book Design and Analysis Techniques for Cavity Beam Position Monitor Systems for Electron Accelerators written by Nirav Yashvantray Joshi and published by . This book was released on 2013 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Performance of a High Resolution Cavity Beam Position Monitor System written by and published by . This book was released on 2006 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt: It has been estimated that an RF cavity Beam Position Monitor (BPM) could provide a position measurement resolution of less than one nanometer. We have developed a high resolution cavity BPM and associated electronics. A triplet comprised of these BPMs was installed in the extraction line of the Accelerator Test Facility (ATF) at the High Energy Accelerator Research Organization (KEK) for testing with its ultra-low emittance beam. The three BPMs were each rigidly mounted inside an alignment frame on six variable-length struts which could be used to move the BPMs in position and angle. We have developed novel methods for extracting the position and tilt information from the BPM signals including a robust calibration algorithm which is immune to beam jitter. To date, we have demonstrated a position resolution of 15.6 nm and a tilt resolution of 2.1 [mu]rad over a dynamic range of approximately ± 20 [mu]m.
Download or read book Nuclear Science Abstracts written by and published by . This book was released on 1976 with total page 658 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Beam Diagnostics in Superconducting Accelerating Cavities written by Pei Zhang and published by Springer Science & Business Media. This book was released on 2013-07-24 with total page 128 pages. Available in PDF, EPUB and Kindle. Book excerpt: An energetic charged particle beam introduced to an rf cavity excites a wakefield therein. This wakefield can be decomposed into a series of higher order modes and multipoles, which for sufficiently small beam offsets are dominated by the dipole component. This work focuses on using these dipole modes to detect the beam position in third harmonic superconducting S-band cavities for light source applications. A rigorous examination of several means of analysing the beam position based on signals radiated to higher order modes ports is presented. Experimental results indicate a position resolution, based on this technique, of 20 microns over a complete module of 4 cavities. Methods are also indicated for improving the resolution and for applying this method to other cavity configurations. This work is distinguished by its clarity and potential for application to several other international facilities. The material is presented in a didactic style and is recommended both for students new to the field, and for scientists well-versed in the field of rf diagnostics.
Download or read book Nuclear Science Abstracts written by and published by . This book was released on 1974 with total page 1036 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Resolution of a High Performance Cavity Beam Position Monitor System written by and published by . This book was released on 2005 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: International Linear Collider (ILC) interaction region beam sizes and component position stability requirements will be as small as a few nanometers. It is important to the ILC design effort to demonstrate that these tolerances can be achieved - ideally using beam-based stability measurements. It has been estimated that RF cavity beam position monitors (BPMs) could provide position measurement resolutions of less than one nanometer and could form the basis of the desired beam-based stability measurement. We have developed a high resolution RF cavity BPM system. A triplet of these BPMs has been installed in the extraction line of the KEK Accelerator Test Facility (ATF) for testing with its ultra-low emittance beam. A metrology system for the three BPMs was recently installed. This system employed optical encoders to measure each BPM's position and orientation relative to a zero-coefficient of thermal expansion carbon fiber frame and has demonstrated that the three BPMs behave as a rigid-body to less than 5 nm. To date, we have demonstrated a BPM resolution of less than 20 nm over a dynamic range of +/- 20 microns.
Download or read book Beam Handling Techniques for Electron Linear Accelerators written by Samuel Penner and published by . This book was released on 1970 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Energy Research Abstracts written by and published by . This book was released on 1995 with total page 782 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1990 with total page 490 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book INIS Atomindex written by and published by . This book was released on 1996 with total page 794 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book ERDA Energy Research Abstracts written by United States. Energy Research and Development Administration and published by . This book was released on 1976 with total page 700 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Design of a Standing Wave Multi Cavity Beam Monitor for Simultaneous Beam Position and Emittance Measurements written by R. Miller and published by . This book was released on 2005 with total page 7 pages. Available in PDF, EPUB and Kindle. Book excerpt: A high precision emittance measurement requires precise beam position at the measurement location. At present there is no existing technique, commercial or otherwise, for non-destructive pulse-to-pulse simultaneous beam position and emittance measurement. FARTECH, Inc. is currently developing a high precision cavity-based beam monitor for simultaneous beam position and emittance measurements pulse-to-pulse, without beam interception and without moving parts. The design and analysis of a multi-cavity standing wave structure for a pulse-to-pulse emittance measurement system in which the quadrupole and the dipole standing wave modes resonate at harmonics of the beam operating frequency is presented. Considering the Next Linear Collider beams, an optimized 9-cavity standing wave system is designed for simultaneous high precision beam position and emittance measurements. It operates with the {pi}-quadrupole mode resonating at 16th harmonic of the NLC bunch frequency, and the 3 {pi}/4 dipole mode at 12th harmonic (8.568 GHz). The 9-cavity system design indicates that the two dipoles resonate almost at the same frequency 8.583 GHz and the quadrupole at 11.427 GHz according to the scattering parameter calculations. The design can be trivially scaled so that the dipole frequency is at 8.568 GHz, and the quadrupole frequency can then be tuned during fabrication to achieve the desired 11.424 GHz. The output powers from these modes are estimated for the NLC beams. An estimated rms-beam size resolution is sub micro-meters and beam positions in sub nano-meters.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1984-03 with total page 600 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book European Particle Accelerator Conference Epac 94 In 3 Volumes written by Christine Petit-jean-genaz and published by World Scientific. This book was released on 1994-11-26 with total page 2968 pages. Available in PDF, EPUB and Kindle. Book excerpt: These proceedings aim to provide a comprehensive overview of research, technology and applications in the field of accelerators. Contributions from the entire field of accelerators are presented, including low and high energy machines, and medical and industrial accelerators.
Download or read book AN X BAND CAVITY FOR A HIGH PRECISION BEAM POSITION MONITOR written by R. Johnson and published by . This book was released on 2003 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: The next generation of accelerators will require increasingly precise control of beam position. For example designs for the next linear collider require beam-position monitors (BPMs) with 300 nm resolution. The accelerator designs also place difficult requirements on accuracy and stability. To meet these requirements a cavity BPM operating at 11.424 GHz was designed. The BPM consists of two cavities: an xy-cavity tuned to the dipole mode and a phase cavity tuned to the monopole mode. The xy-cavity uses a novel-coupling scheme that (in principal) has zero coupling to the monopole mode. This report will present the mechanical design, simulations, and test results of a prototype BPM. In addition BPM designs with even higher precision will be discussed.
Download or read book The Engineering Index Annual written by and published by . This book was released on 1992 with total page 2264 pages. Available in PDF, EPUB and Kindle. Book excerpt: Since its creation in 1884, Engineering Index has covered virtually every major engineering innovation from around the world. It serves as the historical record of virtually every major engineering innovation of the 20th century. Recent content is a vital resource for current awareness, new production information, technological forecasting and competitive intelligence. The world?s most comprehensive interdisciplinary engineering database, Engineering Index contains over 10.7 million records. Each year, over 500,000 new abstracts are added from over 5,000 scholarly journals, trade magazines, and conference proceedings. Coverage spans over 175 engineering disciplines from over 80 countries. Updated weekly.
Download or read book Beam Position Monitor and Energy Analysis at the Fermilab Accelerator Science and Technology Facility written by and published by . This book was released on 2015 with total page 56 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fermilab Accelerator Science and Technology Facility has produced its first beam with an energy of 20 MeV. This energy is obtained by the acceleration at the Electron Gun and the Capture Cavity 2 (CC2). When fully completed, the accelerator will consist of a photoinjector, one International Liner Collider (ILC)-type cryomodule, multiple accelerator R & D beamlines, and a downstream beamline to inject 300 MeV electrons into the Integrable Optics Test Accelerator (IOTA). We calculated the total energy of the beam and the corresponding energy to the Electron Gun and CC2. Subsequently, a Beam Position Monitors (BPM) error analysis was done, to calculate the device actual resolution.
