Download or read book Demonstration of Emerging Technologies for Arsenic Removal Pilot testing written by Yu-Jung Chang and published by American Water Works Association. This book was released on 2005 with total page 252 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is the second of two volumes that presents the results of a cooperative research effort between industry, academia, utilities to evaluate and demonstrate the treatment effectiveness of a wide range of technologies for arsenic removal. (Volume 1; ISBN: 1-58321-310-4; published Feb 2004) This volume focused on larger-scale in-situ demonstration testing of the major technologies reviewed in Volume 1, plus several additional technologies. Objectives were to describe the underlying chemical and physical controls over arsenic removal, consider the operational performance parameters and anticipate where improvements might occur. Sponsored by Arsenic Research Partnership, AWWRF, USEPA, and ACWA.
Download or read book Demonstration of Emerging Technologies for Arsenic Removal Bench scale testing written by Yu-Jung Chang and published by American Water Works Association. This book was released on 2004 with total page 148 pages. Available in PDF, EPUB and Kindle. Book excerpt: This project addresses those technologies deemed most appropriate for small water systems to comply with the Jan '06 USEPA Arsenic Rule Maximum Contaminant Level (MCL). This volume reports on the bench-scale testing of of 4 technologies: ion-exchange processes, sorption kinetics, coupled sorbent-membrane processes and coupled coagulation-ballasted-sedimentation processes. Volume 2 will focus on results of the full-scale demonstration testing.
Download or read book Demonstration of Emerging Technologies for Arsenic Removal Volume 2 written by Yu-Jung Chang and published by American Water Works Association. This book was released on 2005 with total page 256 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is the second of two volumes that presents the results of a cooperative research effort between industry, academia, utilities to evaluate and demonstrate the treatment effectiveness of a wide range of technologies for arsenic removal. (Volume 1; ISBN: 1-58321-310-4; published Feb 2004) This volume focused on larger-scale in-situ demonstration testing of the major technologies reviewed in Volume 1, plus several additional technologies. Objectives were to describe the underlying chemical and physical controls over arsenic removal, consider the operational performance parameters and anticipate where improvements might occur. Sponsored by Arsenic Research Partnership, AWWRF, USEPA, and ACWA.
Download or read book Kirk Othmer Chemical Technology and the Environment 2 Volume Set written by Wiley and published by John Wiley & Sons. This book was released on 2007-05-21 with total page 2597 pages. Available in PDF, EPUB and Kindle. Book excerpt: The two-volume reference work Chemical Technology and the Environment provides readers with knowledge on contemporary issues in environmental pollution, prevention and control, as well as regulatory, health and safety issues as related to chemical technology. It introduces and expands the knowledge on emerging "green" materials and processes and "greener" energy technology, as well as more general concepts and methodology including sustainable development and chemistry and green chemistry. Based on Wiley's renowned, Kirk-Othmer Encyclopedia of Chemical Technology, this compact reference features the same breadth and quality of coverage and clarity of presentation found in the original.
Download or read book Emerging Technology for Bioremediation of Metals written by Battelle Memorial In and published by CRC Press. This book was released on 1994-02-16 with total page 162 pages. Available in PDF, EPUB and Kindle. Book excerpt: Bioremediation techniques for treating metals-contaminated soil and water are in an emerging state of development. Unlike organic compounds that can be broken down into harmless compounds such as CO2 and water, metals and their salts generally inhibit biological activity. They must be converted into more complex states, be sorbed, or undergo valence state changes before biodegradation by activated sludge treatment or other complex reactions such as air stripping can occur. This book introduces various treatment technologies and options for the bioremediation of metals. The chapters, written by researchers and practitioners from North America and Europe, represent the most recent compilation of state-of-the-art techniques and methods for metals biotreatment. These topics and more are addressed:
Download or read book EPA National Publications Catalog written by United States. Environmental Protection Agency and published by . This book was released on 2003 with total page 222 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1979 with total page 1096 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Federal Register written by and published by . This book was released on 2000-10-18 with total page 1610 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Arsenic Treatment Technologies for Soil Waste and Water written by and published by DIANE Publishing. This book was released on 2002 with total page 132 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Ion Exchange Technology I written by Inamuddin Dr. and published by Springer Science & Business Media. This book was released on 2012-06-02 with total page 561 pages. Available in PDF, EPUB and Kindle. Book excerpt: Ion-exchange Technology I: Theory and Materials describes the theoretical principles of ion-exchange processes. More specifically, this volume focuses on the synthesis, characterization, and modelling of ion-exchange materials and their associated kinetics and equilibria. This title is a highly valuable source not only to postgraduate students and researchers but also to industrial R&D specialists in chemistry, chemical, and biochemical technology as well as to engineers and industrialists.
Download or read book Best Practice Guide on Metals Removal From Drinking Water By Treatment written by Mustafa Ersoz and published by IWA Publishing. This book was released on 2012-05-31 with total page 120 pages. Available in PDF, EPUB and Kindle. Book excerpt: Part of Metals and Related Substances in Drinking Water Set - buy all five books together to save over 30%! The EU Drinking Water Directive sets a range of standards for metals and related substances in drinking water, many of which are concerned with health protection. A number of these standards are very stringent and require compliance to be assessed at the point of use. Because of the difficulties associated with monitoring, historic practices in many countries have concentrated on the quality of water within the distribution network. As a result, the magnitude of problems with some metals and related substances in drinking water is not fully appreciated in all European countries, and the extent and nature of corrective actions differ widely. This Best Practice Guide on Metals Removal From Drinking Water By Treatment describes drinking water standards and regulations, and explains the impact of a range of water treatment processes on metal levels in drinking water. Its objectives are to provide a basis for assessing the extent of problems and to identify appropriate water treatment options. The Guide provides a reasoned guide to selection of key water treatment processes. Each chapter focuses on a specific water treatment process and has been written by experts in that particular process. Best Practice Guide on Metals Removal From Drinking Water By Treatment provides practice-based knowledge for water engineers and scientists in large and small water utilities, regulatory agencies, health agencies and local municipalities (from cities through to small rural communities). It also supports university level teaching in degree schemes that relate to water management. This Guide is one of a series produced by the International Water Association’s Specialist Group on Metals and Related Substances in Drinking Water. The series is an up-to-date compilation of a range of scientific, engineering, regulatory and operational issues concerned with the control and removal of metals from drinking water.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1994-11 with total page 486 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Remediation of Heavy Metals in the Environment written by Jiaping Paul Chen and published by CRC Press. This book was released on 2016-11-18 with total page 662 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides in-depth coverage of environmental pollution sources, waste characteristics, control technologies, management strategies, facility innovations, process alternatives, costs, case histories, effluent standards, and future trends in waste treatment processes. It delineates methodologies, technologies, and the regional and global effects of important pollution control practices. It focuses on toxic heavy metals in the environment, various heavy metal decontamination technologies, brownfield restoration, and industrial, agricultural, and radioactive waste management. It discusses the importance of metals such as lead, chromium, cadmium, zinc, copper, nickel, iron, and mercury.
Download or read book Handbook of Advanced Industrial and Hazardous Wastes Management written by Lawrence K. Wang and published by CRC Press. This book was released on 2017-10-30 with total page 1174 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume provides in-depth coverage of environmental pollution sources, waste characteristics, control technologies, management strategies, facility innovations, process alternatives, costs, case histories, effluent standards, and future trends in waste treatment processes. It delineates methodologies, technologies, and the regional and global effects of important pollution control practices. It focuses on specific industrial and manufacturing wastes and their remediation. Topics include: heavy metals, electronics, chemical, and textile manufacturing.
Download or read book Heavy Metals in the Environment written by Lawrence K. Wang and published by CRC Press. This book was released on 2009-06-23 with total page 528 pages. Available in PDF, EPUB and Kindle. Book excerpt: A successful modern heavy metal control program for any industry will include not only traditional water pollution control, but also air pollution control, soil conservation, site remediation, groundwater protection, public health management, solid waste disposal, and combined industrial-municipal heavy metal waste management. In fact, it should be
Download or read book Catalog of Superfund Program Information Products 1994 written by United States. Environmental Protection Agency. Office of Emergency and Remedial Response and published by . This book was released on 1994 with total page 532 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Plants Under Metal and Metalloid Stress written by Mirza Hasanuzzaman and published by Springer. This book was released on 2018-11-30 with total page 437 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the industrial era, the most important potential threat to crop production is abiotic stress, including toxic metal/metalloid stress. Growing populations and rapid industrialization lead to the generation and release of huge amounts of toxic metals/metalloids into the environment, altering plant physiological processes and reducing yields. In the last few decades, there has been extensive research to elucidate the mechanisms of tolerance to metal/metalloid toxicity and ways to improve the defense system in plants. Use of exogenous photoprotectants such as osmoprotectants, plant nutrients, phytohormones, signaling molecules, antioxidants, amino acids and organic acids are widely being used to improve plants’ tolerance to metal/metalloid stress. Recently, phytoremediation approaches have been effectively employed to remediate metal/metalloid pollution. This book presents the latest insights into plant responses and tolerance in plants grown under metal/metalloids stress to provide a better understanding of the topic and the future outlook.
