Download or read book Autoxidation of Hydrocarbons and Polyolefins written by Leo Reich and published by . This book was released on 1969 with total page 546 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aspects of Degradation and Stabilization of Polymers written by Hans Helmut Gunter Jellinek and published by Elsevier Science & Technology. This book was released on 1978 with total page 708 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Physical Properties of Polymers written by James E. Mark and published by . This book was released on 1993 with total page 430 pages. Available in PDF, EPUB and Kindle. Book excerpt: The contents have been divided into sections on physical states of polymers and characterization techniques. Chapters on physical states include discussions of the rubber elastic state, the glassy state, melts and concentrated solutions, the crystalline state, and the mesomorphic state. Characterization techniques described are molecular spectroscopy and scattering techniques.
Download or read book Photostabilization of Polymers written by J.F. Rabek and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 607 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the last two decades, the production of polymers and plastics has been increasing rapidly. In spite of developing new polymers and polymeric materials, only 40-60 are used commercially on a large scale. It has been estimated that half of the annual production of polymers is employed outdoors. Increasing the stability of polymers and plastics towards heat, light, atmospheric oxygen and other environmental agents and weathering conditions has always been a very important problem. The photochemical instability of most of polymers limits them to outdoor application, where they are photo degraded fast over periods ranging from months to a few years. To the despair of technologists and consumers alike, photodegrada tion and environmental ageing of polymers occur much faster than can be expected from knowledge collected in laboratories. In many cases, improved methods of preparation and purification of both monomers and polymers yield products of better quality and higher resistance to heat and light. However, without stabilization of polymers by applica tion of antioxidants (to decrease thermal oxidative degradation) and photostabilizers (to decrease photo-oxidative degradation) it would be impossible to employ polymers and plastics in everyday use.
Download or read book Thermal Degradation of Polymeric Materials written by Krzysztof Pielichowski and published by iSmithers Rapra Publishing. This book was released on 2005 with total page 324 pages. Available in PDF, EPUB and Kindle. Book excerpt: Understanding the thermal degradation of polymers is of paramount importance for developing a rational technology of polymer processing and higher-temperature applications. Controlling degradation requires understanding of many different phenomena, including chemical mechanisms, the influence of polymer morphology, the complexities of oxidation chemistry, and the effects of stabilisers, fillers and other additives. This book offers a wealth of information for polymer researchers and processors requiring an understanding of the implications of thermal degradation on material and product performance.
Download or read book Antioxidant Polymers written by Giuseppe Cirillo and published by John Wiley & Sons. This book was released on 2012-06-07 with total page 601 pages. Available in PDF, EPUB and Kindle. Book excerpt: Antioxidant Polymers is an exhaustive overview of the recent developments in the field of polymeric materials showing antioxidant properties. This research area has grown rapidly in the last decade because antioxidant polymers have wide industry applications ranging from materials science to biomedical, pharmaceuticals and cosmetics.
Download or read book Stabilisers for Polyolefins written by C. Krohnke and published by iSmithers Rapra Publishing. This book was released on 2001 with total page 142 pages. Available in PDF, EPUB and Kindle. Book excerpt: This review describes the main types of stabilisers with the focus on those categories for polyolefins. It also elucidates some of the physical and chemical aspects of such products when incorporated into the polymer matrix, discussing stability during weathering, heat ageing and processing. The review is supported by several hundred relevant abstracts selected from the Polymer Library.
Download or read book Marine Anthropogenic Litter written by Melanie Bergmann and published by Springer. This book was released on 2015-06-01 with total page 456 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book describes how man-made litter, primarily plastic, has spread into the remotest parts of the oceans and covers all aspects of this pollution problem from the impacts on wildlife and human health to socio-economic and political issues. Marine litter is a prime threat to marine wildlife, habitats and food webs worldwide. The book illustrates how advanced technologies from deep-sea research, microbiology and mathematic modelling as well as classic beach litter counts by volunteers contributed to the broad awareness of marine litter as a problem of global significance. The authors summarise more than five decades of marine litter research, which receives growing attention after the recent discovery of great oceanic garbage patches and the ubiquity of microscopic plastic particles in marine organisms and habitats. In 16 chapters, authors from all over the world have created a universal view on the diverse field of marine litter pollution, the biological impacts, dedicated research activities, and the various national and international legislative efforts to combat this environmental problem. They recommend future research directions necessary for a comprehensive understanding of this environmental issue and the development of efficient management strategies. This book addresses scientists, and it provides a solid knowledge base for policy makers, NGOs, and the broader public.
Download or read book Handbook of Polyolefins written by Cornelia Vasile and published by CRC Press. This book was released on 2000-06-21 with total page 1040 pages. Available in PDF, EPUB and Kindle. Book excerpt: A handbook on polyolefins. This second edition includes new material on the structure, morphology and properties of polyolefin (PO) synthesis. It focuses on synthetic advances, the use of additives, special coverage of PO blends, composites and fibres, and surface treatments. It also addresses the problem of interfacial and superficial phenomena.
Download or read book New Developments in Polymer Analysis Stabilization and Degradation written by Gennadiĭ Efremovich Zaikov and published by Nova Publishers. This book was released on 2005 with total page 168 pages. Available in PDF, EPUB and Kindle. Book excerpt: New Developments in Polymer Analysis, Stabilisation & Degradation
Download or read book Photodegradation of Polymers written by Jan F. Rabek and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 222 pages. Available in PDF, EPUB and Kindle. Book excerpt: In this book on physical characteristics and practical aspects of polymer photodegradation Rabek emphasizes the experimental work on the subject. The most important feature of the book is the physical interpretation of polymer degradation, e.g. mechanism of UV/light absorption, formation of excited states, energy transfer mechanism, kinetics, dependence on physical properties of macromolecules and polymer matrices, formation of mechanical defects, practics during environmental ageing. He includes also some aspects of polymer photodegradation in environmental and space condition.
Download or read book Mechanisms of Polymer Degradation and Stabilisation written by G. Scott and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 336 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this publication is two-fold. In the first place it is intended to review progress in the development of practical stabilising systems for a wide range of polymers and applications. A complemen tary and ultimately more important objective is to accommodate these practical developments within the framework of antioxidant theory, since there can be little question that further major advances in the practice of stabilisation technology will only be possible on a firm mechanistic foundation. With the continual increase in the number of commercial anti oxidants and stabilisers, often functioning by mechanisms not even considered ten years ago, there is a need for a general theory which will allow the potential user to predict the performance of a particular antioxidant structure under specific practical conditions. Any such predictive tool must involve a simplified kinetic approach to inhibited oxidation and, in Chapter 1, Denisov outlines a possible mechanistic approach with the potential to predict the most useful antioxidant to use and the limits of its usefulness. In Chapter 2, Schwetlick reviews the current state of knowledge on the antioxidant mechanisms of the phosphite esters with particular emphasis on their catalytic peroxidolytic activity. Dithiophosphate v vi PREFACE derivatives show a similar behaviour but for quite different reasons and, in Chapter 3, AI-Malaika reviews information available from analytical studies, particularly using 31p_NMR spectroscopy, to elucid ate the complex chemistry that leads to the formation of the antioxidant -active agents.
Download or read book Degradation and Stabilization of Polymers written by Hans Helmut Gunter Jellinek and published by Elsevier Publishing Company. This book was released on 1983 with total page 700 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Polymer Photodegradation written by J.F. Rabek and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 679 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the last two decades, the production of polymers and plastics has been increasing rapidly. In spite of developing new polymers and polymeric materials, only 40~60 are used commercially on a large scale. It has been estimated that half of the annual production of polymers is employed outdoors. The photochemical instability of most polymers limits their outdoor application as they are photodegraded quickly over periods from months to a few years. To the despair of technologists and consumers alike, photodegradation and environmental ageing of polymers occur much faster than can be expected from knowledge collected in laboratories. In order to improve polymer photostability there has been a very big effort during the last 30 years to understand the mechanisms involved in photodegradation and environmental ageing. This book represents the author's attempt, based on his 25 years' experience in research on photodegradation and photo stabilization, to collect and generalize a number of available data on the photodegradation of polymers. The space limitation and the tremendous number of publications in the past two decades have made a detailed presentation of all important results and data difficult. The author apologizes to those whose work has not been quoted or widely presented in this book. Because many published results are very often contradictory, it has been difficult to present a fully critical review of collected knowledge, without antagonizing authors. For that reason, all available theories, mechanisms and different suggestions have been presented together, and only practice can evaluate which of them are valid.
Download or read book Reviews of Environmental Contamination and Toxicology Volume 227 written by David M. Whitacre and published by Springer Science & Business Media. This book was released on 2013-10-25 with total page 171 pages. Available in PDF, EPUB and Kindle. Book excerpt: Reviews of Environmental Contamination and Toxicology attempts to provide concise, critical reviews of timely advances, philosophy and significant areas of accomplished or needed endeavor in the total field of xenobiotics, in any segment of the environment, as well as toxicological implications.
Download or read book Bamboo Fiber Composites written by Mohammad Jawaid and published by Springer Nature. This book was released on 2020-11-18 with total page 302 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book summarizes many of the recent developments in the area of bamboo composites with emphasis on new challenges for the synthesis characterization, properties of bamboo composites and practical applications. The book provides an update of all the important areas of (synthesis, processing, properties and application) bamboo fibers and its composites in a comprehensive manner. The chapters contributed by leading researchers from industry, academy, government and private research institutions across the globe benefit academics, researchers, scientists, engineers and students in the field of natural fiber composites.
Download or read book The Science and Technology of Carbon Nanotubes written by T. Yamabe and published by Elsevier. This book was released on 1999-08-17 with total page 203 pages. Available in PDF, EPUB and Kindle. Book excerpt: Carbon Nanotubes (CNT) is the material lying between fullerenes and graphite as a new member of carbon allotropes. The study of CNT has gradually become more and more independent from that of fullerenes. As a novel carbon material, CNTs will be far more useful and important than fullerenes from a practical point of view, in that they will be directly related to an ample field of nanotechnology. This book presents a timely, second-generation monograph covering as far as practical, application of CNT as the newest science of these materials. Most updated summaries for preparation, purification and structural characterisation of single walled CNT and multi walled CNT are given. Similarly, the most recent developments in the theoretical treatments of electronic structures and vibrational structures are covered. The newest magnetic, optical and electrical solid-state properties providing a vital base to actual application technologies are described. Explosive research trends towards application of CNTs, including the prospect for large-scale synthesis, are also introduced. It is the most remarkable feature of this monograph that it devotes more than a half of the whole volume to practical aspects and offers readers the newest developments of the science and technological aspects of CNTs.
