Download or read book Coupling of the HOLA Wellbore Simulator with TOUGH2 Reservoir Simulator written by Ashish Bhat and published by . This book was released on 2005 with total page 250 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Progress in Exploration Development and Utilization of Geothermal Energy written by Yinhui Zuo and published by Frontiers Media SA. This book was released on 2022-09-21 with total page 364 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book A Coupled Wellbore reservoir Simulator to Model Multiphase Flow and Temperature Distribution written by Peyman Pourafshary and published by . This book was released on 2007 with total page 570 pages. Available in PDF, EPUB and Kindle. Book excerpt: Hydrocarbon reserves are generally produced through wells drilled into reservoir pay zones. During production, gas liberation from the oil phase occurs due to pressure decline in the wellbore. Thus, we expect multiphase flow in some sections of the wellbore. As a multi-phase/multi-component gas-oil mixture flows from the reservoir to the surface, pressure, temperature, composition, and liquid holdup distributions are interrelated. Modeling these multiphase flow parameters is important to design production strategies such as artificial lift procedures. A wellbore fluid flow model can also be used for pressure transient test analysis and interpretation. Considering heat exchange in the wellbore is important to compute fluid flow parameters accurately. Modeling multiphase fluid flow in the wellbore becomes more complicated due to heat transfer between the wellbore fluids and the surrounding formations. Due to mass, momentum, and energy exchange between the wellbore and the reservoir, the wellbore model should be coupled with a numerical reservoir model to simulate fluid flow accurately. This model should be non-isothermal to consider the effect of temperature. Our research shows that, in some cases, ignoring compositional effects may lead to errors in pressure profile prediction for the wellbore. Nearly all multiphase wellbore simulations are currently performed using the "black oil" approach. The primary objective of this study was to develop a non-isothermal wellbore simulator to model transient fluid flow and temperature and couple the model to a reservoir simulator called General Purpose Adaptive Simulator (GPAS). The coupled wellbore/reservoir simulator can be applied to steady state problems, such as production from, or injection to a reservoir as well as during transient phenomena such as well tests to accurately model wellbore effects. Fluid flow in the wellbore may be modeled either using the blackoil approach or the compositional approach, as required by the complexity of the fluids. The simulation results of the new model were compared with field data for pressure gradients and temperature distribution obtained from wireline conveyed pressure recorder and acoustic fluid level measurements for a gas/oil producer well during a buildup test. The model results are in good agreement with the field data. Our simulator gave us further insights into the wellbore dynamics that occur during transient problems such as phase segregation and counter-current multiphase flow. We show that neglecting these multiphase flow dynamics would lead to unreliable results in well testing analysis.

Download or read book Development of a Coupled Wellbore reservoir Compositional Simulator for Horizontal Wells written by Mahdy Shirdel and published by . This book was released on 2010 with total page 402 pages. Available in PDF, EPUB and Kindle. Book excerpt: Two-phase flow occurs during the production of oil and gas in the wellbores. Modeling this phenomenon is important for monitoring well productivity and designing surface facilities. Since the transient time period in the wellbore is usually shorter than reservoir time steps, stabilized flow is assumed in the wellbore. As such, semi-steady state models are used for modeling wellbore flow dynamics. However, in the case that flow variations happen in a short period of time (i.e., a gas kick during drilling) the use of a transient two-phase model is crucial. Over the last few years, a number of numerical and analytical wellbore simulators have been developed to mimic wellbore-reservoir interaction. However, some issues still remain a concern in these studies. The main issues surrounding a comprehensive wellbore model consist of fluid property calculations, such as black-oil or compositional models, governing equations, such as mechanistic or correlation-based models, effect of temperature variation and non-isothermal assumption, and methods for coupling the wellbore to the reservoir. In most cases, only standalone wellbore models for blackoil have been used to simulate reservoir and wellbore dynamic interactions. Those models are based on simplified assumptions that lead to an unrealistic estimation of pressure and temperature distributions inside the well. In addition, most reservoir simulators use rough estimates for the perforation pressure as a coupling condition between the wellbore and the reservoir, neglecting pressure drops in the horizontal section. In this study, we present an implementation of a compositional, pseudo steady-state, non-isothermal, coupled wellbore-reservoir simulator for fluid flow in wellbores with a vertical section and a horizontal section embedded on the producing reservoir. In addition, we present the implementation of a pseudo-compositional, fully implicit, transient two-fluid model for two-phase flow in wellbores. In this model, we solve gas/liquid mass balance, gas/liquid momentum balance, and two-phase energy equations in order to obtain the five primary variables: liquid velocity, gas velocity, pressure, holdup and temperature. In our simulation, we compared stratified, bubbly, intermittent flow effects on pressure and temperature distributions in either a transient or steady-state condition. We found that flow geometry variation in different regimes can significantly affect the flow parameters. We also observed that there are significant differences in flow rate prediction between a coupled wellbore-reservoir simulator and a stand-alone reservoir simulator, at the early stages of production. The outcome of this research leads to a more accurate and reliable simulation of multiphase flow in the wellbore, which can be applied to surface facility design, well performance optimization, and wellbore damage estimation.

Download or read book Proceedings of the 19th New Zealand Geothermal Workshop 1997 written by S. F. Simmons and published by . This book was released on 1997 with total page 338 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Wellbore Models GWELL GWNACL and HOLA User s Guide written by and published by . This book was released on 1991 with total page 112 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report describes three multi-component, multi-feedzone geothermal wellbore simulators developed. These simulators reproduce the measured flowing temperature and pressure profiles in flowing wells and determine the relative contribution, fluid properties (e.g. enthalpy, temperature) and fluid composition (e.g. CO2, NaCl) of each feedzone for a given discharge condition. The three related wellbore simulators that will be discussed here are HOLA, GWELL and GWNACL. HOLA is a multi-feedzone geothermal wellbore simulator for pure water, modified after the wellbore simulator developed by Bjornsson, 1987 and can now handle deviated wells. The other two simulators GWELL (see also Aunzo, 1990) and GWNACL are modified versions of HOLA that can handle H2O-CO2 and H2O-NaCl systems, respectively. These simulators can handle both single and two-phase flows in vertical and inclined pipes and calculate the flowing temperature and pressure profiles in the well. The simulators solve numerically the differential equations that describe the steady-state energy, mass and momentum flow in a pipe. The codes allow for multiple feedzones, variable grid spacing and well radius. These codes were developed using FORTRAN language on the UNIX system.

Download or read book Renewable Energy Systems written by Martin Kaltschmitt and published by Springer. This book was released on 2012-12-06 with total page 1898 pages. Available in PDF, EPUB and Kindle. Book excerpt: Humanity is facing a steadily diminishing supply of fossil fuels, causing researchers, policy makers, and the population as a whole to turn increasingly to alternative and especially renewable sources of energy to make up this deficit. Gathering over 80 peer-reviewed entries from the Encyclopedia of Sustainability Science and Technologies, Renewable Energy Systems provides an authoritative introduction to a wide variety of renewable energy sources. State-of-the-art coverage includes geothermal power stations, ocean energy, renewable energy from biomass, waste to energy, and wind power. This comprehensive, two-volume work provides an excellent introduction for those entering these fields, as well as new insights for advanced researchers, industry experts, and decision makers.

Download or read book Geothermal Reservoir Engineering written by Malcolm Alister Grant and published by Academic Press. This book was released on 2011-04-01 with total page 379 pages. Available in PDF, EPUB and Kindle. Book excerpt: As nations alike struggle to diversify and secure their power portfolios, geothermal energy, the essentially limitless heat emanating from the earth itself, is being harnessed at an unprecedented rate. For the last 25 years, engineers around the world tasked with taming this raw power have used Geothermal Reservoir Engineering as both a training manual and a professional reference. This long-awaited second edition of Geothermal Reservoir Engineering is a practical guide to the issues and tasks geothermal engineers encounter in the course of their daily jobs. The book focuses particularly on the evaluation of potential sites and provides detailed guidance on the field management of the power plants built on them. With over 100 pages of new material informed by the breakthroughs of the last 25 years, Geothermal Reservoir Engineering remains the only training tool and professional reference dedicated to advising both new and experienced geothermal reservoir engineers. - The only resource available to help geothermal professionals make smart choices in field site selection and reservoir management - Practical focus eschews theory and basics- getting right to the heart of the important issues encountered in the field - Updates include coverage of advances in EGS (enhanced geothermal systems), well stimulation, well modeling, extensive field histories and preparing data for reservoir simulation - Case studies provide cautionary tales and best practices that can only be imparted by a seasoned expert

Download or read book Petroleum Reservoir Simulation written by K. Aziz and published by Springer. This book was released on 1979 with total page 508 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book contains a relatively complete treatment of finite-difference models of black-oil type rservoirs.

Download or read book Reservoir Stimulation written by Michael J. Economides and published by . This book was released on 2000-06-23 with total page 932 pages. Available in PDF, EPUB and Kindle. Book excerpt: Sets forth a rationalisation of stimulation using reservoir engineering concepts, and addresses topics such as formation characterisation, hydraulic fracturing and matrix acidizing. Formation damage, which refers to a loss in reservoir productivity, is also examined comprehensively.

Download or read book Government Reports Annual Index written by and published by . This book was released on 1994 with total page 1224 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Computational Methods for Multiphase Flows in Porous Media written by Zhangxin Chen and published by SIAM. This book was released on 2006-04-01 with total page 551 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book offers a fundamental and practical introduction to the use of computational methods. A thorough discussion of practical aspects of the subject is presented in a consistent manner, and the level of treatment is rigorous without being unnecessarily abstract. Each chapter ends with bibliographic information and exercises.

Download or read book Fundamentals of Reservoir Engineering written by L.P. Dake and published by Elsevier. This book was released on 1983-01-01 with total page 462 pages. Available in PDF, EPUB and Kindle. Book excerpt: "This book is fast becoming the standard text in its field", wrote a reviewer in the Journal of Canadian Petroleum Technology soon after the first appearance of Dake's book. This prediction quickly came true: it has become the standard text and has been reprinted many times. The author's aim - to provide students and teachers with a coherent account of the basic physics of reservoir engineering - has been most successfully achieved. No prior knowledge of reservoir engineering is necessary. The material is dealt with in a concise, unified and applied manner, and only the simplest and most straightforward mathematical techniques are used. This low-priced paperback edition will continue to be an invaluable teaching aid for years to come.

Download or read book Multiphase Flow in Wells written by James P. Brill and published by Henry L. Doherty Memorial Fund of Aime Society of Petroleum. This book was released on 1999 with total page 172 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Geothermal Power Plants written by Ronald DiPippo and published by Elsevier. This book was released on 2011-04-08 with total page 518 pages. Available in PDF, EPUB and Kindle. Book excerpt: Ron DiPippo, Professor Emeritus at the University of Massachusetts Dartmouth, is a world-regarded geothermal expert. This single resource covers all aspects of the utilization of geothermal energy for power generation from fundamental scientific and engineering principles. The thermodynamic basis for the design of geothermal power plants is at the heart of the book and readers are clearly guided on the process of designing and analysing the key types of geothermal energy conversion systems. Its practical emphasis is enhanced by the use of case studies from real plants that increase the reader's understanding of geothermal energy conversion and provide a unique compilation of hard-to-obtain data and experience. An important new chapter covers Environmental Impact and Abatement Technologies, including gaseous and solid emissions; water, noise and thermal pollutions; land usage; disturbance of natural hydrothermal manifestations, habitats and vegetation; minimisation of CO2 emissions and environmental impact assessment.The book is illustrated with over 240 photographs and drawings. Nine chapters include practice problems, with solutions, which enable the book to be used as a course text. Also includes a definitive worldwide compilation of every geothermal power plant that has operated, unit by unit, plus a concise primer on the applicable thermodynamics.* Engineering principles are at the heart of the book, with complete coverage of the thermodynamic basis for the design of geothermal power systems* Practical applications are backed up by an extensive selection of case studies that show how geothermal energy conversion systems have been designed, applied and exploited in practice* World renowned geothermal expert DiPippo has including a new chapter on Environmental Impact and Abatement Technology in this new edition

Download or read book Two phase Pressure Drops written by Herbert Stanford Isbin and published by . This book was released on 1954 with total page 100 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Mechanistic Modeling of Gas liquid Two phase Flow in Pipes written by Ovadia Shoham and published by . This book was released on 2006 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: The objectives of this book are twofold: to provide insight and understanding of two-phase flow phenomena and to develop analytical tools for either designing two-phase flow systems or conducting research in this area. The traditional approach for two-phase flow prediction was based on the development of an empirical correlation from experimental data. This book presents the recent approach, in which mathematical mechanistic models are developed, based on the physical phenomena, to predict two-phase flow behavior. The models can be verified and refined with limited experimental data. However, as these models incorporate the physical phenomena and the important flow variables, they can be extended to different operational conditions and can enable scaleup with significant confidence.