Download or read book Evaluation of Roadware 10 Minute Concrete Mender for PCC Bridge Deck Crack Sealing written by Khader Abu Al-eis and published by . This book was released on 2004 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Concrete Bridge Deck Crack Sealing written by Ashraf M. Rahim and published by . This book was released on 2006 with total page 96 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Development and Layout of a Protocol for the Field Performance of Concrete Deck and Crack Sealants written by José Antonio Pincheira and published by . This book was released on 2009 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt: The main objective of this project was to develop and layout a protocol for the long-term monitoring and assessment of the performance of concrete deck and crack sealants in the field. To accomplish this goal, a total of six bridge decks were chosen for study. The decks have ages that vary from 4 to 30 years old, are all in good condition, though some presented a variety of longitudinal, transverse and diagonal cracking. In each deck, test segments were laid out along one lane in four of the six bridges. Drill powder samples were extracted in each segment in order to determine the in-situ, near-surface chloride ion content of the deck. Laboratory analyses of the samples showed that the chloride ion content varied between 3.2 lb/cy for the younger decks (3 years old) and 20.8 lb/cy for the older decks (28 years old). Based on the recommendations of a previous laboratory investigation, a pool of the best performing deck and crack sealants were selected to be applied in the decks. In two bridges, deck segments were sealed with four deck sealants while one segment was left unsealed to be used as a control segment. Additionally, the cracks in each of these segments were sealed with five crack sealants. While two other decks were also scheduled for sealing as part of this phase of the project, they were not done because the required curing time for some of the products was longer than deemed acceptable by DOT crews for these high traffic bridges. It is recommended, however, that every effort be made to have these decks be sealed in the near future. The remaining two bridges had been sealed at the time of construction. While no specific information could be secured about the product used in these decks, the low chloride ion content in these decks suggested that the applied product has helped reduce the ingress of chloride ions. Therefore, it is recommended that these decks continue to be monitored over time. Based on the inspections and the data collected in the field, a protocol and schedule for the continuing monitoring of sealant performance is presented.
Download or read book Protective Coatings for Concrete Bridge Decks written by Richard J. Irwin and published by . This book was released on 1969 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt: Performance of protective coatings for bridge decks is evaluated. Applications to bridges on the New York State highway system from 1961 through 1967 included 1) surface overlays, 2) membranes between the structural slab and bituminous wearing course, and 3) surface sealants. Overlays and membranes consisted of epoxies, polyesters, polyurethanes, latexes, neoprenes, silicone rubbers, and asphalt cutbacks. Surface sealants included silicones, distillate oils, and linseed oil. None of the surface overlays lasted more than 2 to 3 yr. However, a flexible polyester resin with fiber glass has provided satisfactory service for 1-1/2 yr and will remain under observation. Leakage of box-girder bridges with a membrane was primarily due to shear-key construction (since modified), while the same materials applied to composite bridges were associated with leakage that could not be explained. A more comprehensive survey of membranes is planned. Silicone and distillate oil sealants on non-air-entrained concrete did not improve long-term durability. Air-entrained concrete, both with and without linseed oil treatment, showed no evidence of deterioration after 4 yr of exposure.
Download or read book Bridge Deck Concrete Sealers written by John D. Wenzlick and published by . This book was released on 2007 with total page 17 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the last several years, MoDOT has experienced problems with excessive amounts of cracking on some new concrete bridge decks. This has led to various concrete sealers being used for sealing cracks as well as whole decks, instead of applying linseed oil. Linseed oil is the only concrete sealer listed in Missouri's Standard Specifications, and is used for resistance to scaling on new bridge decks. Secondly, some recent projects re-texturing decks built with dense concrete overlays have specified penetrating concrete sealers. The concern was if linseed oil was used on the diamond ground surface, it might not have good frictional properties. Either extra linseed oil might be left on the surface or the linseed oil might not cure quickly enough to switch traffic onto it after short lane closures. It was decided that new penetrating sealers be used in these situations by special provision to the contract. Four types of penetrating sealers were tested against linseed oil in the laboratory to rate their effectiveness, pick criteria for testing needed in accepting sealers and write a new specification to best protect concrete bridge decks from deterioration. In the case of new concrete decks it is recognized by American Concrete Institute that cracks smaller than 0.18 mm do not let chloride ions from salt penetrate through them. It was concluded that if there are very few cracks bigger than this, those cracks do not need to be sealed, and linseed oil can be used to help prevent scaling. If cracks were bigger than this it would be better to forego the linseed oil treatment and use a crack sealer. A table with concrete sealers classified into three performance groups is presented with the sealers ranked by performance and including cost per ft. 2. It was found from this study that penetrating sealers are not good at sealing large cracks. Although an Ohio DOT test was used in this study to measure crack sealing capabilities, it did not give consistent answers. It did help identify what size cracks need to be sealed by a better crack sealer, such as a two-part epoxy. It was found that cracks in the range of 0.30 mm to 0.64 mm start to allow a saline solution to leak through the concrete very swiftly. So even if a penetrating sealer is used on a deck with many cracks, those 0.64 mm cracks and bigger need a more appropriate crack filler/sealer to seal the individual big cracks first. Sealing cracks on existing older decks should be done using less expensive products that seal the entire small and medium-sized cracks and are effective for 2-4 years. A table listing these crack sealers is also presented. As a result of testing in this study one of these products was approved for preventive maintenance use statewide.
Download or read book Effectiveness and Relative Performance of Concrete Bridge Deck and Crack Sealants written by Melissa A. Dorshorst and published by . This book was released on 2005 with total page 374 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Waterproofing Membranes for Concrete Bridge Decks written by David G. Manning and published by Transportation Research Board. This book was released on 1995 with total page 80 pages. Available in PDF, EPUB and Kindle. Book excerpt: This synthesis will be of interest to research, specifications, materials, design, and construction engineers; contract and specification administrators; agency project managers and staff; and concrete bridge deck construction contractors. This synthesis describes the state of the practice with respect to the development and present status of waterproofing membranes for concrete bridge decks. This report of the Transportation Research Board describes the use of waterproofing systems applied to new bridge decks and the rehabilitation of deteriorated concrete bridge decks. In addition, this synthesis describes current practice with regard to methods for assessing the effectiveness of membranes, criteria for use, installation practices, and factors that affect the performance of waterproofing systems in new construction and rehabilitation. Suggestions for future research are also included.
Download or read book Sealing of Cracks on Florida Bridge Decks with Steel Girders written by Adel ElSafty and published by . This book was released on 2012 with total page 182 pages. Available in PDF, EPUB and Kindle. Book excerpt: One of the biggest problems affecting bridges is the transverse cracking and deterioration of concrete bridge decks. This research identifies suitable sealing materials for deck cracks showing their ability to span cracks of various widths and achieving performance criteria such as penetration depth, bond strength to crack walls, elongation, viscosity, penetration, and suitability of the type of sealant. Sealant performance was investigated by testing core samples to determine the depth of sealant penetration, bond, and tensile strength. Sealer samples were tested to verify their strength, modulus of elasticity, and elongation. A finite element model was developed to investigate the factors affecting tensile stresses and crack tendency. It also checks the live-load deflection limit, which is an important factor in bridge deck cracking. An Excel spreadsheet was also developed to predict the deck cracking accounting for shrinkage, thermal effect, creep, concrete mix design, deck restraint, loading, and environmental effects.
Download or read book Control and Repair of Bridge Deck Cracking written by Robert J. Frosch and published by . This book was released on 2010-11-15 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Concrete Bridge Deck Crack Sealant Evaluation and Implementation written by and published by . This book was released on 2014 with total page 164 pages. Available in PDF, EPUB and Kindle. Book excerpt: A total of 12 sealant products were applied on the Smith Avenue High Bridge in St. Paul and evaluated over a three-year period. Details, such as surface preparation and application methods, were documented for each product and are conditions specific to each product. Sealant performance was evaluated through field permeability testing, visual observations, and petrographic examination. Visual observations provided evidence that approximately 67 percent of test sections were performing effectively after one winter but only 4 percent after two winters. After three winters, 58 percent of the test locations were visually characterized as ineffective and 42 percent as partially effective. Product performance significantly reduced over the third winter, primarily due to major loss of sealant and surface sand materials. Coring was performed after the second winter, and the cores were photographed and subjected to a petrographic evaluation. The observed depth of sealant penetration was highly variable and likely is dependent on the presence of debris within the crack, original crack width, and the deck temperatures during application. The predominant failure mode observed under magnification was detachment from the crack face and not within the sealant materials. Based on numerous factors, four epoxy and three methacrylate products were recommended for consideration on MnDOT's Approved Products List. Each product recommendation contains the surface preparation and application method conditions under which they were applied. It is also recommended that MnDOT look into increasing the frequency of its routine crack sealing maintenance program from the current five-year cycle.
Download or read book Cracking in Concrete Bridge Decks written by Tony R. Schmitt and published by . This book was released on 1995 with total page 174 pages. Available in PDF, EPUB and Kindle. Book excerpt: The causes of cracking in bridge decks are investigated and procedures are recommended to alleviate the problem. Forty continuous steel girder bridges, thirty-seven composite and three noncomposite bridges are evaluated. Field surveys conducted to document cracking patterns and to determine the crack density of each bridge are described. Information collected from construction documents, field books, and weather data logs is presented and compared to the observed levels of cracking to identify correlations between cracking and the variables studied. Thirty-one variables are considered such as material properties, site conditions, construction procedures, design specifications, age of bridge and traffic volume. Based on the research reported herein, cracking in monolithic bridge decks increases with increasing values of concrete slump, percent volume of water and cement, water content, and compressive strength, and decreasing values of air content (especially below 6.0%). Bridge deck overlays placed with zero slump concrete consistently exhibit high levels of cracking. Cracking in overlays also increases as placement lengths increase. High maximum air temperatures and large changes in air temperature on the day of casting aggravate cracking in monolithic bridge decks. High average air temperatures and large changes in air temperature similarly aggravate cracking in bridge deck overlays. Both monolithic and two layer bridges with fixed-ended girders exhibit increased cracking near the abutments compared to those with pin-ended girders.
Download or read book Crack and Concrete Deck Sealant Performance written by Karl Andrew Johnson and published by . This book was released on 2013 with total page 184 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Watertight Bridge Deck Joint Seals written by United States. Federal Highway Administration. Office of Highway Operations. Experimental Construction and Applications Branch and published by . This book was released on 1977 with total page 140 pages. Available in PDF, EPUB and Kindle. Book excerpt: Participating states -- Bridge deck joint ratings -- Expansion joint devices (illustrations) -- States reports.
Download or read book Evaluation of Bridge Deck Repair and Protective Systems written by Herbert N. Swanson and published by . This book was released on 1977 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bridge Deck Repair and Protective Systems written by Herbert N. Swanson and published by . This book was released on 1984 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Concrete Bridge Protection and Rehabilitation written by Michael M. Sprinkel and published by Strategic Highway Research Program (Shrp). This book was released on 1993 with total page 124 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report presents the rapid methods used by state highway agencies for the protection, repair and rehabilitation of bridge decks. The report is based on a review of the literature; the responses to questionnaires sent to state departments of transportation, Canadian provinces, selected turnpike and thruway authorities, technology transfer centers, and material suppliers; and the evaluation of 50 bridge decks located in seven states. Polymer overlays, sealers, high-early strength hydraulic cement concrete overlays, and patches are compared for their performance characteristics and service life.
Download or read book Evaluation of Concrete Deck and Crack Sealers written by José Antonio Pincheira and published by . This book was released on 2005 with total page 166 pages. Available in PDF, EPUB and Kindle. Book excerpt:
