Download or read book Concrete and Cryogenics written by Frederick Henry Turner and published by Cement & Concrete Association of Great Britain. This book was released on 1979 with total page 120 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Cryogenic behaviour of materials for prestressed concrete written by FIB – International Federation for Structural Concrete and published by FIB - International Federation for Structural Concrete. This book was released on 1982-05-01 with total page 87 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advances in Cryogenic Engineering written by Quan-Sheng Shu and published by Springer Science & Business Media. This book was released on 2000-10-31 with total page 984 pages. Available in PDF, EPUB and Kindle. Book excerpt: In recent years, the technology of cryogenic comminution has been widely applied in the field of chemical engineering, food making, medicine production, and particularly in recycling of waste materials. Because of the increasing pollution of waste tires and the shortage of raw rubber resource, the recycling process for waste rubber products has become important and commercially viable. This technology has shown a great number of advantages such as causing no environmental pollution, requiring low energy consumption and producing high quality products. Hence, the normal crusher which was used to reclaim materials, such as waste tires, nylon, plastic and many polymer materials at atmospheric 12 temperature is being replaced by a cryogenic crusher. • In the cryogenic crusher, the property of the milled material is usually very sensitive to temperature change. When a crusher is in operation, it will generate a great deal of heat that causes the material temperature increased. Once the temperature increases over the vitrification temperature, the material property will change and lose the brittle behavior causing the energy consumption to rise sharply. Consequently, the comminution process cannot be continued. Therefore, it is believed that the cryogenic crusher is the most critical component in the cryogenic comminution system. The research on the temperature increase and energy consumption in the cryogenic crusher is not only to reduce the energy consumption of the crasher, but also to reduce the energy consumption of the cryogenic system.
Download or read book Second International Conference on Cryogenic Concrete written by and published by . This book was released on 1984 with total page 252 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Assessment of mechanical properties of structural materials for cryogenic application written by FIB – International Federation for Structural Concrete and published by FIB - International Federation for Structural Concrete. This book was released on 1988-06-01 with total page 100 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advances in Cryogenic Engineering written by K. Timmerhauso and published by Springer Science & Business Media. This book was released on 2013-03-14 with total page 598 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Second International Cryogenic Materials Conference (ICMC) was held in Boulder, Colorado, in conjunction with the 1977 Cryogenic Engineering Con ference (CEC). Special thanks must be given to the University of Colorado for their skillful hosting of these two conferences. Collaboration between the two con ferences has been mutually beneficial, providing the materials special ist with insight into new applications and design concepts and the cryogenic engineer with exposure to modern materials accomplishments and potentials. The Proceedings of the 1977 Cryogenic Engineering Conference are published in Volume 23 of Advances in Cryogenic Engineering. Both conferences will be held again simul taneously in Madison, Wisconsin, in August 1979. The success and growth of the two International Cryogenic Materials Con ferences have led to the formation of an ICMC Board of Directors. The board members will serve a four-year term and include: Chairman, R. P. Reed (U.S.), R. W. Boom (U.S.), A. F. Clark (U.S.), G. Hartwig (W. Germany), J. W. Morris (U.S.), M. Suenaga (U.S.), K. Tachikawa (Japan), J. Tanaka (Japan), and K. A. Yushchenko (USSR).
Download or read book Cement based Composites Materials Mechanical Properties and Performance written by A.M. Brandt and published by CRC Press. This book was released on 2003-09-02 with total page 484 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book considers the properties and behaviour of cement-based materials from the point of view of composite science and technology. It deals particularly with newer forms of cement-based materials and also with a composite approach to conventional materials and their special properties. Emphasis is put on non-conventional reinforcement and desig
Download or read book Cryogenic Concrete written by Concrete Society and published by . This book was released on 1982 with total page 360 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Materials and Structures in Cold Regions written by Jia-Bao Yan and published by Elsevier. This book was released on 2024-08-10 with total page 523 pages. Available in PDF, EPUB and Kindle. Book excerpt: Materials and Structures in Cold Regions: The Impact of Low Temperatures on Construction Materials and the Structural Behaviour of Structural Members is based on the latest research undertaken at Tianjin University, P.R. China and National University of Singapore. The book provides detailed experimental research on the influences of low temperatures on the mechanical properties of constructional materials and structural behavior of typical structural members at low temperatures, e.g., beams, columns, and walls. The theoretical and numerical models in the book on structural members at low temperatures simplifies and provides guidelines for structural engineers working on cold-region projects.The book blends the fundamental development of concepts with the practical specification of materials and structures at low temperatures. - Provides detailed experimental research on the influence of low temperatures on the mechanical properties of constructional materials, and structural behavior of typical structural members at low temperatures, e.g., beams, columns, and walls - Covers fundamental development of concepts, with the practical specification of materials and structures at low temperatures - Presents the latest research, undertaken at Tianjin University, P.R. China and the National University of Singapore, Singapore
Download or read book Advances in Cryogenic Engineering Materials written by R.W. Fast and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 904 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Fourth International Cryogenic Materials Conference (ICMC) was held in San Diego, California in conjunction with the Cryogenic Engineer ing Conference (CEC) on August 10-l4, 1981. The synergism produced by conducting the two conferences together remains very strong. In the ap pl1cation of cryogenic technology, materials continue to be a demanding challenge, and sometimes, an obstacle. The association of materials and cryogenic engineers increases their awareness of recent research in each other's fields and influences the course of future research. Many contributed to the success of the 1981 conference. J. W. Morris of the University of California--Berkeley was ICMC Conference Chairman. E. N. C. Dalder of Lawrence Livermore Laboratories was ICMC Structural Program Chairman; D. C. Larbalestier of the University of Wisconsin- Madison, and D. K. Finnemore of Iowa State University were Superconducting Materials Program Chairmen. Local arrangments were expertly coordinated by R. E. Tatro of General Dynamics--San Diego. The CEC Board, especia11y their conference chairman, T. M. Flynn, of the National Bureau of Stan dards, Boulder, contributed very substantia1ly to conference planning and implementation. All of their efforts provided the foundation of the largest CEC/ICMC ever. We thank the Office of Naval Research and the Office of Fusion Energy and Basic Energy Sciences of the Department of Energy for providing needed financial support for the conference. Fina11y, we especially thank M. Stieg, who prepared the papers for the new procedures and format used in this volume.
Download or read book Concrete International written by and published by . This book was released on 1980 with total page 754 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Cryogenic Valves for Liquefied Natural Gas Plants written by Karan Sotoodeh and published by Gulf Professional Publishing. This book was released on 2022-05-18 with total page 370 pages. Available in PDF, EPUB and Kindle. Book excerpt: Natural gas and liquefied natural gas (LNG) continue to grow as a part of the sustainable energy mix. While oil and gas companies look to lower emissions, one key refinery component that contributes up to 60% of emissions are valves, mainly due to poor design, sealing, and testing. Cryogenic Valves for Liquefied Natural Gas Plants delivers a much-needed reference that focuses on the design, testing, maintenance, material selection, and standards needed to stay environmentally compliant at natural gas refineries. Covering technical definitions, case studies, and Q&A, the reference includes all ranges of natural gas compounds, including LPG, CNG, NGL, and PNG. Key design considerations are included that are specific for cryogenic services, including a case study on cryogenic butterfly valves. The material selection process can be more complex for cryogenic services, so the author goes into more detail about materials that adhere to cryogenic temperature resistance. Most importantly, testing of valves is covered in depth, including shell test, closure or seat test, and thermal shock tests, along with tactics on how to prevent dangerous cryogenic leaks, which are very harmful to the environment. The book is a vital resource for today's natural gas engineers. - Teaches LNG valve design, including sealing selection, wall thickness calculation of the valve body and bonnet, and proper material selection - Provides tactics on how to prevent cryogenic leaks with compliant valve testing - Applies natural gas calculations that will better support the LNG supply chain - Enables readers to understand cryogenic valve standards, including EN, ISO, and MSS SP
Download or read book Advances in Cryogenic Engineering Materials written by Richard P. Reed and published by Springer Science & Business Media. This book was released on 2013-11-11 with total page 1450 pages. Available in PDF, EPUB and Kindle. Book excerpt: Proceedings of the Tenth International Cryogenic Materials Conference (ICMC) held in Albuquerque, New Mexico, July 12-16, 1993.
Download or read book Advances in Cryogenic Engineering written by K. Timmerhaus and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 569 pages. Available in PDF, EPUB and Kindle. Book excerpt: The First International Cryogenic Materials Conference (ICMC) provided a new forum for the presentation of low-temperature materials research. The confer ence, held in conjunction with the 1975 Cryogenic Engineering Conference, provided materials research personnel with excellent exposure to current develop ments in the cryogenics field and beneficial interactions with designers of cryogenic systems. Because of the large response to a late call for papers, the enthusiasm and encouragement at the meeting, and the wide spectrum and high quality of papers, the Second International Cryogenic Materials Conference is being planned along with the 1977 Cryogenic Engineering Conference for Boulder, Colorado, in the summer of 1977. The success of the First International Cryogenic Materials Conference was certainly in large measure due to the excellent hospitality of our Canadian hosts, the Royal Military College of Canada and Queen's University in Kingston, Ontario. In particular, the efforts of A. C. Leonard and his staff ensured an excellent conference and a pleasant and memorable visit to Canada. The Cryogenic Engineering Conference Board was both generous and skillful in helping to initiate this new conference and their guidance and acceptance is gratefully acknowledged. The Cryogenic Engineering Conference program chairman, M. J. Hiza, greatly facilitated the interaction for the two conferences and provided valuable assistance in generat ing a workable program. The proceedings of the 1975 Cryogenic Engineering Conference are published as Volume 21 of the Advances in Cryogenic Engineering and include many papers indicating innovative use of new cryogenic materials properties data.
Download or read book Protection of Concrete written by Ravindra Dhir and published by CRC Press. This book was released on 2003-09-02 with total page 1031 pages. Available in PDF, EPUB and Kindle. Book excerpt: Concrete is arguably the major construction material used worldwide. It has generally served well, yet too often it has failed to achieve the required performance. Although developments in materials and practice have widened the scope for the use of concrete, they have also had effects on its performance. This book presents current thinking and future developments on means of protecting concrete and ensuring its adequate performance in the required application.
Download or read book Cryogenic Engineering Revised and Expanded written by Thomas Flynn and published by CRC Press. This book was released on 2004-11-30 with total page 912 pages. Available in PDF, EPUB and Kindle. Book excerpt: Written by an engineering consultant with over 48 years of experience in the field, this Second Edition provides a reader-friendly and thorough discussion of the fundamental principles and science of cryogenic engineering including the properties of fluids and solids, refrigeration and liquefaction, insulation, instrumentation, natural gas processi
