Download or read book Catalytic Oxidation of Carbon Monoxide at Low Concentrations written by Avinash Mulay (G.) and published by . This book was released on 1961 with total page 130 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Catalytic Oxidation of Carbon Monoxide at Low Concentrations written by Avinash G. Mulay and published by . This book was released on 1961 with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Toxicological Profile for Carbon Monoxide written by U.s. Department of Health and Human Services and published by Createspace Independent Publishing Platform. This book was released on 2014-01-22 with total page 348 pages. Available in PDF, EPUB and Kindle. Book excerpt: This toxicological profile is prepared in accordance with guidelines developed by the Agency for Toxic Substances and Disease Registry (ATSDR) and the Environmental Protection Agency (EPA). The original guidelines were published in the Federal Register on April 17, 1987. Each profile will be revised and republished as necessary. The ATSDR toxicological profile succinctly characterizes the toxicologic and adverse health effects information for the toxic substances each profile describes. Each peer-reviewed profile identifies and reviews the key literature that describes a substance's toxicologic properties. Other pertinent literature is also presented but is described in less detail than the key studies. The profile is not intended to be an exhaustive document; however, more comprehensive sources of specialty information are referenced. The profiles focus on health and toxicologic information; therefore, each toxicological profile begins with a public health statement that describes, in nontechnical language, a substance's relevant toxicological properties. Following the public health statement is information concerning levels of significant human exposure and, where known, significant health effects. A health effects summary describes the adequacy of information to determine a substance's health effects. ATSDR identifies data needs that are significant to protection of public health. Each profile: (A) Examines, summarizes, and interprets available toxicologic information and epidemiologic evaluations on a toxic substance to ascertain the levels of significant human exposure for the substance and the associated acute, subacute, and chronic health effects; (B) Determines whether adequate information on the health effects of each substance is available or being developed to determine levels of exposure that present a significant risk to human health of acute, subacute, and chronic health effects; and (C) Where appropriate, identifies toxicologic testing needed to identify the types or levels of exposure that may present significant risk of adverse health effects in humans.
Download or read book Catalytic Oxidation of Hydrocarbons written by Karl C. Stein and published by . This book was released on 1963 with total page 1200 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Destruction of Chlorinated Hydrocarbons by Catalytic Oxidation written by and published by . This book was released on 1986 with total page 156 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report provides the results of a study conducted to determine the effectiveness of catalytic oxidation for destroying vapor phase chlorinated hydrocarbons. The study was conducted on two pilot scale catalytic incinerator systems leased from vendors. One system employed a metal oxide catalyst in a fluidized bed configuration. The other system used a fixed bed proprietary catalyst, supplemented with UV light and ozone injection. Both systems were tested under a variety of temperatures and space velocities. The test vapor streams consisted of low concentrations (3 to 200 ppmv) mixtures of organic compounds, and included three streams which represented the emissions from air strippers used to treat contaminated groundwater at U.S. Air Force bases. The study results showed that the fluidized bed catalytic incinerator system was capable of achieving total organic destruction efficiencies of greater than 98%. The UV/ozone catalytic system failed to achieve high destruction efficiencies; with ozone injection, total destruction was 75%; without ozone, the maximum destruction efficiency was 64%.
Download or read book Sulfuric Acid Manufacture written by Matt King and published by Newnes. This book was released on 2013-05-11 with total page 528 pages. Available in PDF, EPUB and Kindle. Book excerpt: By some measure the most widely produced chemical in the world today, sulfuric acid has an extraordinary range of modern uses, including phosphate fertilizer production, explosives, glue, wood preservative and lead-acid batteries. An exceptionally corrosive and dangerous acid, production of sulfuric acid requires stringent adherence to environmental regulatory guidance within cost-efficient standards of production. This work provides an experience-based review of how sulfuric acid plants work, how they should be designed and how they should be operated for maximum sulfur capture and minimum environmental impact. Using a combination of practical experience and deep physical analysis, Davenport and King review sulfur manufacturing in the contemporary world where regulatory guidance is becoming ever tighter (and where new processes are being required to meet them), and where water consumption and energy considerations are being brought to bear on sulfuric acid plant operations. This 2e will examine in particular newly developed acid-making processes and new methods of minimizing unwanted sulfur emissions. The target readers are recently graduated science and engineering students who are entering the chemical industry and experienced professionals within chemical plant design companies, chemical plant production companies, sulfuric acid recycling companies and sulfuric acid users. They will use the book to design, control, optimize and operate sulfuric acid plants around the world. Unique mathematical analysis of sulfuric acid manufacturing processes, providing a sound basis for optimizing sulfuric acid manufacturing processes Analysis of recently developed sulfuric acid manufacturing techniques suggests advantages and disadvantages of the new processes from the energy and environmental points of view Analysis of tail gas sulfur capture processes indicates the best way to combine sulfuric acid making and tailgas sulfur-capture processes from the energy and environmental points of view Draws on industrial connections of the authors through years of hands-on experience in sulfuric acid manufacture
Download or read book Studies in the Catalytic Oxidation of Carbon Monoxide written by S. Raghuram and published by . This book was released on 1975 with total page 392 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Ongoing Challenge of Managing Carbon Monoxide Pollution in Fairbanks Alaska written by National Research Council and published by National Academies Press. This book was released on 2002-08-22 with total page 158 pages. Available in PDF, EPUB and Kindle. Book excerpt: Carbon monoxide (CO) is a toxic air pollutant produced largely from vehicle emissions. Breathing CO at high concentrations leads to reduced oxygen transport by hemoglobin, which has health effects that include impaired reaction timing, headaches, lightheadedness, nausea, vomiting, weakness, clouding of consciousness, coma, and, at high enough concentrations and long enough exposure, death. In recognition of those health effects, the U.S. Environmental Protection Agency (EPA), as directed by the Clean Air Act, established the health-based National Ambient Air Quality Standards (NAAQS) for CO in 1971. Most areas that were previously designated as "nonattainment" areas have come into compliance with the NAAQS for CO, but some locations still have difficulty in attaining the CO standards. Those locations tend to have topographical or meteorological characteristics that exacerbate pollution. In view of the challenges posed for some areas to attain compliance with the NAAQS for CO, congress asked the National Research Council to investigate the problem of CO in areas with meteorological and topographical problems. This interim report deals specifically with Fairbanks, Alaska. Fairbanks was chosen as a case study because its meteorological and topographical characteristics make it susceptible to severe winter inversions that trap CO and other pollutants at ground level.
Download or read book Carbon Monoxide written by Anna Grossman-Cooper and published by . This book was released on 1966 with total page 464 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bridging the Materials and Pressure Gaps written by Henry D. Lewis and published by . This book was released on 2003 with total page 396 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Technology of Catalytic Oxidations written by Philippe Arpentinier and published by Editions TECHNIP. This book was released on 2001 with total page 490 pages. Available in PDF, EPUB and Kindle. Book excerpt: Volume 1 covers the most important technological aspects of the use of molecular oxygen for catalytic oxidation reactions.Volume 2 addresses the safety issues associated with the use of oxygen in catalytic oxidation reactions.Contents Vol. 1: 1. Introduction. 2. Chemical-physical properties of molecular oxygen. 3. Oxygen production technologies. 4. Chemical fundamentals of oxidation reactions. 5. Reactor technologies for multiphase systems. 6. Liquid phase oxidations. 7. Gas phase selective oxidations. 8. Selective oxidation of paraffins. References. Index. Vol. 2: 9. Introduction to safety problems in the chemical industry. 10. Chemical aspects of combustion in the gaseous phase. 11. Homogeneous chemical explosions: autoignition or spontaneous ignition. 12. Deflagration or propagation of flame. 13. Conditions governing flame propagation capability. 14. Detonation in the gaseous phase. 15. Prevention of and protection against explosions. References. Index.
Download or read book DC electric Field Effect on the Catalytic Oxidation of Carbon Monoxide on Nickel Oxide written by Mazen Ahmad Shalabi and published by . This book was released on 1972 with total page 178 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Catalytic Oxidation of Light Hydrocarbons at Low Concentrations in Air by a Copper Oxide alumina Catalyst written by Mauro Anthony Accomazzo and published by . This book was released on 1963 with total page 214 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Surface Science written by Russel F. Howe and published by Springer Science & Business Media. This book was released on 2013-03-07 with total page 307 pages. Available in PDF, EPUB and Kindle. Book excerpt: Surface science has existed as a recognized discipline for more than 20 years. During this period, the subject has expanded in two important ways. On the one hand, the techniques available for studying surfaces, both experimental and theoretical, have grown in number and in sophistication. On the other hand, surface science has been applied to an increasing number of areas of technology, such as catalysis, semicon ductor processing, new materials development, corrosion prevention, adhesion and tribology. . There is, however, no sharp division between fundamental and applied surface science. New techniques can immediately be applied to technologically important problems. Improvements in understanding of fundamental phenomena such as epi taxial growth of one metal on another, or the bonding of hydrocarbons to metal sur faces, to name just two examples, have direct consequences for technology. Surface science has also become very much an interdisciplinary subject; physics, chemistry, materials science, chemical and electronical engineering all draw upon and contribute to surface science. The intimate relationship between principles and applications of surface science forms the theme of this proceedings volume. The contributions were all presented as invited lectures at an Australian-German Workshop on Surface Science held at Coogee Beach, Sydney, Australia, in December 1991. The contributors, all active surface scientists in their respective countries, were asked to highlight recent develop ments in their own areas of activity involving new techniques, advances in funda mental understanding or new applications in technology.
Download or read book Bulletin written by and published by . This book was released on 1962 with total page 624 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Carbon Dioxide Utilization for Global Sustainability written by Sang-Eon Park and published by Elsevier. This book was released on 2004-10-27 with total page 626 pages. Available in PDF, EPUB and Kindle. Book excerpt: Addressing global environmental problems, such as global warming is essential to global sustainability. Continued research leads to advancement in standard methods and produces new data. Carbon Dioxide Utilization for Global Sustainability: Proceedings of the 7th ICCDU (International Conference on Carbon Dioxide Utilization) reflects the most recent research results, as well as stimulating scientific discussions with new challenges in advancing the development of carbon dioxide utilization. Drawing on a wealth of information, this well structured book will benefit students, researchers and consultants looking to catch up on current developments in environmental and chemical engineering. * Provides comprehensive data on CO2 utilisation* Contains up-to-date information, including recent research trends* Is written for students, researchers and consultants in environmental and chemical engineering
Download or read book The Adsorption and Catalytic Oxidation of Carbon Monoxide on Small Pd Particles written by Spyridon Ladas and published by . This book was released on 1979 with total page 438 pages. Available in PDF, EPUB and Kindle. Book excerpt:
