Download or read book Wind induced Motion of Tall Buildings written by Kenny C. S. Kwok and published by . This book was released on 2015 with total page 66 pages. Available in PDF, EPUB and Kindle. Book excerpt: This state-of-the-art report describes various facets of the human response to wind-induced motion in tall buildings and identifies design strategies to mitigate the effects of such motion on building occupants.
Download or read book Building Motion in Wind written by N. Isyumov and published by . This book was released on 1986 with total page 124 pages. Available in PDF, EPUB and Kindle. Book excerpt: Proceedings of a session at the ASCE Convention, held in Seattle, Washington, April 8, 1986. Sponsored by the Aerodynamics Committee of the Aerospace Division and the Wind Effects Committee of the Structural Division of ASCE. This collection contains six papers examining the motions of buildings produced by wind. The trend towards higher structural efficiency and lower cost has resulted in a generation of lighter and more flexible buildings with a lower inherent capacity for energy dissipation or damping. Unfortunately, this trend has produced structures that are more sensitive to the dynamic action of wind. The emphasis in the design of modern tall buildings has therefore shifted to requirements that control building movements or drift and that limit wind-induced accelerations. Two papers deal with the action of wind on two important tall buildings where designers relied on wind tunnel model tests for information on wind-induced loads and building motions. The design of the Columbia Seafirst Center took advantage of economies possible as a result of wind tunnel studies., and viscoelastic dampers were added to limit the building's motion and wind-induced acceleration. The recorded response of the Allied Bank Plaza during Hurricane Alicia is an extremely important contribution to the understanding of the action of wind on tall buildings; this is the only existing record of the response of a major building under the action of design winds. Another paper discusses a survey of structural damping found in tall buildings, presenting typical damping values for steel and concrete buildings and discussing the variability of such estimates and its implication on design. The final papers consider damping systems that can be added to tall buildings in order to limit their motion. The use of tuned mass dampers and viscoelastic damping units is discussed and examples are presented to show their practical effectiveness. The viscoelastic dampers used in the Columbia Seafirst Center are described.
Download or read book Vibration Analysis and Control in Mechanical Structures and Wind Energy Conversion Systems written by Francisco Beltran-Carbajal and published by BoD – Books on Demand. This book was released on 2018-04-18 with total page 132 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book focuses on recent and innovative methods on vibration analysis, system identification, and diverse control design methods for both wind energy conversion systems and vibrating systems. Advances on both theoretical and experimental studies about analysis and control of oscillating systems in several engineering disciplines are discussed. Various control devices are synthesized and implemented for vibration attenuation tasks. The book is addressed to researchers and practitioners on the subject, as well as undergraduate and postgraduate students and other experts and newcomers seeking more information about the state of the art, new challenges, innovative solutions, and new trends and developments in these areas. The six chapters of the book cover a wide range of interesting issues related to modeling, vibration control, parameter identification, active vehicle suspensions, tuned vibration absorbers, electronically controlled wind energy conversion systems, and other relevant case studies.
Download or read book Wind Tunnel Testing of High Rise Buildings written by Peter Irwin and published by Routledge. This book was released on 2013-06-19 with total page 144 pages. Available in PDF, EPUB and Kindle. Book excerpt: Since the 1960s, wind tunnel testing has become a commonly used tool in the design of tall buildings. It was pioneered, in large part, during the design of the World Trade Center Towers in New York. Since those early days of wind engineering, wind tunnel testing techniques have developed in sophistication, but these techniques are not widely understood by the designers using the results. As a direct result, the CTBUH Wind Engineering Working Group was formed to develop a concise guide for the non-specialist. The primary goal of this guide is to provide an overview of the wind tunnel testing process for design professionals. This knowledge allows readers to ask the correct questions of their wind engineering consultants throughout the design process. This is not an in-depth guide to the technical intricacies of wind tunnel testing, it focusses instead on the information the design community needs, including: a unique methodology for the presentation of wind tunnel results to allow straightforward comparison of results from different wind tunnel laboratories. advice on when a tall building is likely to be sufficiently sensitive to wind effects to benefit from a wind tunnel test background for assessing whether design codes and standards are applicable details of the types of tests that are commonly conducted descriptions of the fundamentals of wind climate and the interaction of wind and tall buildings This unique book is an essential guide for all designers of tall buildings, and anyone else interested in the process of wind tunnel testing for tall buildings.
Download or read book Advanced Structural Wind Engineering written by Yukio Tamura and published by Springer Science & Business Media. This book was released on 2013-07-19 with total page 414 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book serves as a textbook for advanced courses as it introduces state-of-the-art information and the latest research results on diverse problems in the structural wind engineering field. The topics include wind climates, design wind speed estimation, bluff body aerodynamics and applications, wind-induced building responses, wind, gust factor approach, wind loads on components and cladding, debris impacts, wind loading codes and standards, computational tools and computational fluid dynamics techniques, habitability to building vibrations, damping in buildings, and suppression of wind-induced vibrations. Graduate students and expert engineers will find the book especially interesting and relevant to their research and work.
Download or read book Structural Analysis and Design of Tall Buildings written by Bungale S. Taranath and published by CRC Press. This book was released on 2016-04-19 with total page 713 pages. Available in PDF, EPUB and Kindle. Book excerpt: As software skills rise to the forefront of design concerns, the art of structural conceptualization is often minimized. Structural engineering, however, requires the marriage of artistic and intuitive designs with mathematical accuracy and detail. Computer analysis works to solidify and extend the creative idea or concept that might have started o
Download or read book Tall Building Design written by Bungale S. Taranath and published by CRC Press. This book was released on 2016-10-04 with total page 872 pages. Available in PDF, EPUB and Kindle. Book excerpt: Addresses the Question Frequently Proposed to the Designer by Architects: "Can We Do This? Offering guidance on how to use code-based procedures while at the same time providing an understanding of why provisions are necessary, Tall Building Design: Steel, Concrete, and Composite Systems methodically explores the structural behavior of steel, concrete, and composite members and systems. This text establishes the notion that design is a creative process, and not just an execution of framing proposals. It cultivates imaginative approaches by presenting examples specifically related to essential building codes and standards. Tying together precision and accuracy—it also bridges the gap between two design approaches—one based on initiative skill and the other based on computer skill. The book explains loads and load combinations typically used in building design, explores methods for determining design wind loads using the provisions of ASCE 7-10, and examines wind tunnel procedures. It defines conceptual seismic design, as the avoidance or minimization of problems created by the effects of seismic excitation. It introduces the concept of performance-based design (PBD). It also addresses serviceability considerations, prediction of tall building motions, damping devices, seismic isolation, blast-resistant design, and progressive collapse. The final chapters explain gravity and lateral systems for steel, concrete, and composite buildings. The Book Also Considers: Preliminary analysis and design techniques The structural rehabilitation of seismically vulnerable steel and concrete buildings Design differences between code-sponsored approaches The concept of ductility trade-off for strength Tall Building Design: Steel, Concrete, and Composite Systems is a structural design guide and reference for practicing engineers and educators, as well as recent graduates entering the structural engineering profession. This text examines all major concrete, steel, and composite building systems, and uses the most up-to-date building codes.
Download or read book Proceedings of the Fourth International Conference on Wind Effects on Buildings and Structures written by Keith John Eaton and published by Cambridge University Press. This book was released on 1977 with total page 864 pages. Available in PDF, EPUB and Kindle. Book excerpt: Describes developments in the areas of meteorology, aerodynamics and structural engineering, which effects the wind on buildings and structures.
Download or read book High Rise Buildings under Multi Hazard Environment written by Mingfeng Huang and published by Springer. This book was released on 2016-08-15 with total page 232 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book discusses performance-based seismic and wind-resistant design for high-rise building structures, with a particular focus on establishing an integrated approach for performance-based wind engineering, which is currently less advanced than seismic engineering. This book also provides a state-of-the-art review of numerous methodologies, including computational fluid dynamics (CFD), extreme value analysis, structural optimization, vibration control, pushover analysis, response spectrum analysis, modal parameter identification for the assessment of the wind-resistant and seismic performance of tall buildings in the design stage and actual tall buildings in use. Several new structural optimization methods, including the augmented optimality criteria method, have been developed and employed in the context of performance-based design. This book is a valuable resource for students, researchers and engineers in the field of civil and structural engineering.
Download or read book Prestandard for Performance based Wind Design written by American Society of Civil Engineers and published by . This book was released on 2019 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: "The purpose of this book is to advance the wind design of tall buildings, enabling the performance-based design, review, acceptance, and construction of buildings using analyses, materials, structural systems, and devices that may or may not be covered by the prescriptive provisions of today's building codes"--
Download or read book Tall Buildings written by Mehmet Halis Günel and published by Routledge. This book was released on 2014-06-27 with total page 259 pages. Available in PDF, EPUB and Kindle. Book excerpt: The structural challenges of building 800 metres into the sky are substantial, and include several factors which do not affect low-rise construction. This book focusses on these areas specifically to provide the architectural and structural knowledge which must be taken into account in order to design tall buildings successfully. In presenting examples of steel, reinforced concrete, and composite structural systems for such buildings, it is shown that wind load has a very important effect on the architectural and structural design. The aerodynamic approach to tall buildings is considered in this context, as is earthquake induced lateral loading. Case studies of some of the world’s most iconic buildings, illustrated with full colour photographs, structural plans and axonometrics, will bring to life the design challenges which they presented to architects and structural engineers. The Empire State Building, the Burj Khalifa, Taipei 101 and the HSB Turning Torso are just a few examples of the buildings whose real-life specifications are used to explain and illustrate core design principles, and their subsequent effect on the finished structure.
Download or read book Wind Loading of Structures written by John D. Holmes and published by CRC Press. This book was released on 2001-06-14 with total page 380 pages. Available in PDF, EPUB and Kindle. Book excerpt: Bridging the gap between wind and structural engineering, Wind Loading of Structures is essential reading for practising civil, structural and mechanical engineers, and graduate students of wind engineering, presenting the principles of wind engineering and providing guidance on the successful design of structures for wind loading by gales, hurricanes, typhoons, thunderstorm downdrafts and tornados.
Download or read book Affordable Housing Construction R D written by United States. Congress. House. Committee on Science, Space, and Technology. Subcommittee on Technology, Environment, and Aviation and published by . This book was released on 1993 with total page 472 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Practical Design of Reinforced Concrete Buildings written by Syed Mehdi Ashraf and published by CRC Press. This book was released on 2017-11-10 with total page 347 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book will provide comprehensive, practical knowledge for the design of reinforced concrete buildings. The approach will be unique as it will focus primarily on the design of various structures and structural elements as done in design offices with an emphasis on compliance with the relevant codes. It will give an overview of the integrated design of buildings and explain the design of various elements such as slabs, beams, columns, walls, and footings. It will be written in easy-to-use format and refer to all the latest relevant American codes of practice (IBC and ASCE) at every stage. The book will compel users to think critically to enhance their intuitive design capabilities.
Download or read book Building Science Series written by and published by . This book was released on 1973-10 with total page 108 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Wind Effects on Structures written by Emil Simiu and published by John Wiley & Sons. This book was released on 2019-03-11 with total page 533 pages. Available in PDF, EPUB and Kindle. Book excerpt: Provides structural engineers with the knowledge and practical tools needed to perform structural designs for wind that incorporate major technological, conceptual, analytical and computational advances achieved in the last two decades. With clear explanations and documentation of the concepts, methods, algorithms, and software available for accounting for wind loads in structural design, it also describes the wind engineer's contributions in sufficient detail that they can be effectively scrutinized by the structural engineer in charge of the design. Wind Effects on Structures: Modern Structural Design for Wind, 4th Edition is organized in four sections. The first covers atmospheric flows, extreme wind speeds, and bluff body aerodynamics. The second examines the design of buildings, and includes chapters on aerodynamic loads; dynamic and effective wind-induced loads; wind effects with specified MRIs; low-rise buildings; tall buildings; and more. The third part is devoted to aeroelastic effects, and covers both fundamentals and applications. The last part considers other structures and special topics such as trussed frameworks; offshore structures; and tornado effects. Offering readers the knowledge and practical tools needed to develop structural designs for wind loadings, this book: Points out significant limitations in the design of buildings based on such techniques as the high-frequency force balance Discusses powerful algorithms, tools, and software needed for the effective design for wind, and provides numerous examples of application Discusses techniques applicable to structures other than buildings, including stacks and suspended-span bridges Features several appendices on Elements of Probability and Statistics; Peaks-over-Threshold Poisson-Process Procedure for Estimating Peaks; estimates of the WTC Towers’ Response to Wind and their shortcomings; and more Wind Effects on Structures: Modern Structural Design for Wind, 4th Edition is an excellent text for structural engineers, wind engineers, and structural engineering students and faculty.
