Download or read book Boundary layer Transition Study of Several Pointed Bodies of Revolution at Supersonic Speeds written by William A. Cassels and published by . This book was released on 1970 with total page 76 pages. Available in PDF, EPUB and Kindle. Book excerpt: Boundary-layer transition by the sublimation and impact-pressure techniques and force tests have been performed on three Haack-Adams bodies of revolution of fineness ratios 7, 10, and 13 at zero angle of attack for free-stream Mach numbers of 2.00, 2.75, and 4.63 and a range of Reynolds numbers based on model length of 6 to 15 X 10(to the 6 power) with and without a roughness strip. The grit method of inducing turbulence was found to provide for a nearly complete turbulent flow over the models at the lower Mach numbers and higher Reynolds numbers considered in this study while the amount of trip drag was less than 8 percent of the model drag with transition fixed. A method of interpreting sublimation data was discussed and used and the results compared well with the impact-pressure results.
Download or read book Boundary Layer Transition at Supersonic Speeds written by E. R. Van Driest and published by . This book was released on 1961 with total page 108 pages. Available in PDF, EPUB and Kindle. Book excerpt: Experiments carried out in the 12-inch supersonic wind tunnel to investigate the effect of three dimensional roughness elements (spheres) on boundary-layer transition on a 10-degree (apex angle) cone without heat transfer are described. The local Mach number for these tests was 2.71. The data show clearly that the minimum (effective) size of trip required to bring transition to its lowest Reynolds number varies power of the distance from the apex of the cone to the trip. Use of available data at other Mach numbers indicates that the Mach number influence for effective tripping is taken into account by a simple expression. Some remarks concerning the roughness variation for transition on a blunt body are made. Finally, a general criterion is introduced which gives insight to the transition phenomenon and anticipates effects of external and internal disturbances, Mach number transfer.
Download or read book Some Effects of Leading edge Sweep on Boundary layer Transition at Supersonic Speeds written by Gary T. Chapman and published by . This book was released on 1961 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Two Techniques for Detecting Boundary layer Transition in Flight at Supersonic Speeds and at Altitudes Above 20 000 Feet written by John G. McTigue and published by . This book was released on 1959 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Comments on Hypersonic Boundary layer Transition written by Kenneth F. Stetson and published by . This book was released on 1990 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is a survey paper on the subject of hypersonic boundary-layer transition. Part 1 discusses boundary-layer stability theory, hypersonic boundary-layer stability experiments, and a comparison between theory and experiment. Part 2 contains comments on how many configuration and flow parameters influence transition. Part 3 discusses some additional general aspects of transition. Part 4 discusses problems of predicting transition and comments on three prediction methods. Part 5 contains some general guidelines for prediction methodology. Keywords: Boundary layer transition, Boundary layer stability, Hypersonic boundary layers.
Download or read book Some Effects of Leading edge Sweep on Boundary layer Transition at Supersonic Speeds written by Gary T. Chapman and published by . This book was released on 1961 with total page 1 pages. Available in PDF, EPUB and Kindle. Book excerpt: The effects of crossflow and shock strength on transition of the laminar boundary layer behind a swept leading edge have been investigated analytically and with the aid of available experimental data. An approximate method of determining the crossflow Reynolds number on a leading edge of circular cross section at supersonic speeds is presented. The applicability of the critical crossflow criterion described by Owen and Randall for transition on swept wings in subsonic flow was examined for the case of supersonic flow over swept circular cylinders. A wide range of applicability of the subsonic critical values is indicated. The corresponding magnitude of crossflow velocity necessary to cause instability on the surface of a swept wing at supersonic speeds was also calculated and found to be small. The effects of shock strength on transition caused by Tollmien-Schlichting type of instability are discussed briefly. Changes in local Reynolds number, due to shock strength, were found analytically to have considerably more effect on transition caused by Tollmien-Schlichting instability than on transition caused by crossflow instability. Changes in the mechanism controlling transition from Tollmien-Schlichting instability to crossflow instability were found to be possible as a wing is swept back and to result in large reductions in the length of laminar flow. (Author).
Download or read book Factors Affecting Transition at Supersonic Speeds written by K. R. Czarnecki and published by . This book was released on 1953 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt: This paper surveys the available material and summarizes what is known to date about boundary-layer transition at supersonic speeds. Variables studied include Mach number, Reynolds number, pressure gradients, heat transfer, surface roughness, and angle of attack. The discussion is limited to bodies of revolution because similar reliable data for wings is lacking.
Download or read book Boundary layer Transition Results from the F 16XL 2 Supersonic Laminar Flow Control Experiment written by Laurie A. Marshall and published by . This book was released on 1999 with total page 58 pages. Available in PDF, EPUB and Kindle. Book excerpt: A variable-porosity suction glove has been flown on the F-16XL-2 aircraft to demonstrate the feasibility of this technology for the proposed High-Speed Civil Transport (HSCT). Boundary-layer transition data have been obtained on the titanium glove primarily at Mach 2.0 and altitudes of 53,000-55,000 ft. The objectives of this supersonic laminar flow control flight experiment have been to achieve 50- to 60-percent-chord laminar flow on a highly swept wing at supersonic speeds and to provide data to validate codes and suction design. The most successful laminar flow results have not been obtained at the glove design point (Mach 1.9 at an altitude of 50,000 ft). At Mach 2.0 and an altitude of 53,000 ft, which corresponds to a Reynolds number of 22.7 multiplied by 10[factor 6], optimum suction levels have allowed long runs of a minimum of 46-percent-chord laminar flow to be achieved. This paper discusses research variables that directly impact the ability to obtain laminar flow and techniques to correct for these variables.
Download or read book Boundary Layer Transition in the Leading Edge Region of a Swept Cylinder in High Speed Flow written by Colin Phillip Coleman and published by . This book was released on 1998 with total page 212 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Survey of Flight Data for Boundary layer Transition at Hypersonic and Supersonic Speeds written by Steven P. Schneider and published by . This book was released on 1998 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Brief Review of Some Mechanisms Causing Boundary Layer Transition at High Speeds written by and published by . This book was released on 1990 with total page 16 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Current Papers written by and published by . This book was released on 1961 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Effect of Distributed Three dimensional Roughness and Surface Cooling on Boundary layer Transition and Lateral Spread of Turbulence at Supersonic Speeds written by Albert L. Braslow and published by . This book was released on 1959 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Transition Reynolds Numbers of Separated Flows at Supersonic Speeds written by Howard K. Larson and published by . This book was released on 1960 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt: Experimental research has been conducted on the effects of wall cooling, Mach number, and unit Reynolds number on the transition Reynolds number of cylindrical separated boudary layers on an ogive-cylinder model. Results were obtained from pressure and temperature measurements and shadowgraph observations. The maximum scope of measurements encompassed Mach numbers between 2.06 and 4.24, Reynolds numbers (based on length of separation) between 60,000 and 400,000, and ratios of wall temperatures to adiabatic wall temperature between 0.35 and 1.0.
Download or read book A Review of Recent Information on Boundary layer Transition at Supersonic Speeds written by Alvin Seiff and published by . This book was released on 1956 with total page 19 pages. Available in PDF, EPUB and Kindle. Book excerpt: Several investigators have found that lowering the surface temperature of a smooth body increases the extent of the laminar boundary layer on it very sharply in some ranges of test conditions. This is consistent with the theory of laminar stability which predicts the existence of a region of complete stability to two-dimensional disturbances at Mach numbers between 1 and 9 when the wall temperature is lowered sufficiently. However, when surface roughness exceeds some critical amount the favorable effects of low wall temperature may be counteracted and roughness can control the position of boundary-layer transition. Existing evidence indicates that this is the case both inside and outside the theoretical region of complete laminar stability. In recent small-scale free-flight tests within the theoretically stable region, it has been observed that laminar stability is improved by raising the Mach number at constant wall-temperature ratio. This increased stability is evidenced by increased Reynolds number of transition on a given surface, and an increase in the permissible roughness height as Mach number is increased.
Download or read book Transition Fixing for Hypersonic Flow written by and published by . This book was released on 1967 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Boundary Layer Transition on the NOL Standard Cone in the Ballistic Research Laboratories Supersonic Wind Tunnels written by J. C. McMullen and published by . This book was released on 1960 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt:
