Download or read book Behavior of cryogenic liquids under compensated gravity and non isothermal boundary conditions written by Nikolai Kulev and published by Cuvillier Verlag. This book was released on 2020-02-04 with total page 172 pages. Available in PDF, EPUB and Kindle. Book excerpt: This study deals with the investigation regarding the behavior of liquid cryogenic propellants in the launcher upper stages under microgravity with superheated tank walls. It contributes in this way to the application-oriented basic research by describing mathematically and quantifying experimentally the influence of evaporation on the interface reorientation of cryogenic liquids. In broader terms this work shows, both in a mathematical and an experimental way, the influence of the heat and mass transfer in the fluid and solid phases on the linear momentum transfer in the liquid phase due to the coupling of the transfer mechanisms. The main assumption behind this study is based on the principle that the solution of a partial differential equation depends on its boundary condition. In this case these are the mass balance boundary conditions at the interface and the contact line. These boundary conditions relate the respective liquid and the interface velocities to the mass flux due to interfacial evaporation, or phase change in general. A mathematical description of the reorientation was developed implementing an equation for the contact line boundary condition which takes explicitly into account the evaporation or the wall superheat at the contact line, respectively. Both the contact line velocity and the contact line angle become functions of the evaporation at the contact line and accordingly of the related dimensionless numbers. The implementation of the contact line boundary condition completes the equation system describing the non-isothermal flow macroscopically. A joint scaling approach of all field equations and boundary conditions was developed through which the influence of evaporation on the capillary-driven motion was expressed mathematically. This influence on the motion of the whole interface was experimentally quantified, too. For that purpose cryogenic liquids were used in drop tower experiments at ZARM, University of Bremen, with varying wall temperature gradients above the liquid-vapor interface. The experiments present the first experimental investigation of the reorientation of cryogenic liquids under non-isothermal boundary conditions. The characteristics of the interface motion were found to vary in dependence on the dimensionless numbers related to evaporation arising from the above mentioned two boundary conditions, especially at the contact line. Thus the variation of the interface dynamics during the reorientation, e.g. an increase of both the oscillation frequency of the interface center point and of the mean velocity of the contact line after its initial transient rise, is attributed to the variation of evaporation. In contrast the influence of capillarity as a driving mechanism of the reorientation remains practically the same.

Download or read book Free Surface Flows under Compensated Gravity Conditions written by Michael Dreyer and published by Springer. This book was released on 2007-04-17 with total page 271 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book considers the behavior of fluids in a low-gravity environment (e.g. spacecraft) with special emphasis on application in PMD (propellant management device) systems. Since PMD designs are not testable on ground and thus completely rely on analytical or numerical concepts, this book treats three different flow problems with analytical, numerical and experimental means. These problems are linked together by the same set of equations and boundary conditions.

Download or read book Low Loss Storage and Handling of Cryogenic Liquids written by Thomas D. Bostock and published by Springer. This book was released on 2019-06-21 with total page 188 pages. Available in PDF, EPUB and Kindle. Book excerpt: The revised second edition of this practical book reviews the fundamentals of cryogenic liquid behaviour in small and large scale storage systems. The text is based on research findings on the convective and evaporative behaviour of cryogenic fluids, aimed at improving the design, construction and operation of low-loss cryogenic liquid storage systems, with a view to minimising cost and improving operational safety. Since the first edition was published in 2006, the breadth of cryogenic applications and the modelling of cryogenic fluid dynamics (CFD) have expanded in several directions. In this second edition, most chapters have been extended to introduce discussions of these new applications and their safety and energy economy. These include advances in the modelling of CFD required in, for example, the design of miniature cryocoolers and condensers and reboilers, large-scale cryogenic liquid mixture properties and their stability, and the understanding that hazards and safety problems in the public domain increase with the scaling up of cryogenic systems. With helpful summaries at the end of each chapter, the book is an essential reference for anyone working on the design and operation of cryogenic liquid storage and transportation systems.

Download or read book Sloshing of Cryogenic Liquids in a Cylindrical Tank under normal Gravity Conditions written by Tim Arndt and published by Cuvillier Verlag. This book was released on 2012-06-04 with total page 212 pages. Available in PDF, EPUB and Kindle. Book excerpt: Particularly in the upper stage development of rockets (launchers), gravity dominated fluid motion in upper stage tanks (sloshing) during flight represents an undesired dynamic effect. On the one hand the sloshing forces lead to disturbances, which have to be compensated by the reaction control system. On the other hand, when cryogenic fluids are considered, the fluctuations in tank pressure may be critical under some circumstances compromising the structural stability of the tank. In this field, the utilization of cryogenic propellants represents a high challenge to layout and design of the propulsion components including the propellant tanks. This work deals with two effects that are directly coupled to the sloshing content inside the propellant tank. To investigate these effects a dedicated test setup has been developed. At first, the damping characteristics of sloshing cryogenic nitrogen - which is used as a substitute for the rocket propellants liquid hydrogen and liquid oxygen - are determined. The results are correlated to the theory based on storable propellants. The main part of this work is linked to a characteristic pressure drop inside the propellant tank caused by the sloshing liquid. For the effect to occur, the tank must be pressurized to enable the formation of a thermal stratification below the liquid surface. Sloshing leads to the mixing of liquid in this region with subcooled liquid from the bulk. This affects the decrease of the temperature at the free surface leading to the condensation of superheated vapor. Thus, the pressure in the tank must decreases. Three different pressurization concepts are introduced in this work; self-pressurization where the tank is pressurized by evaporating liquid caused by the heat flowing into the tank. Furthermore, the tank is pressurized with gaseous nitrogen taken from an external gas bottle and at last gaseous helium from an external supply is used for pressurization purpose. By the application of helium as non-condensable gas, a significant reduction of the pressure drop is expected. The experimental results confirm this working hypothesis and therefore support the theoretical considerations described by an approach of Das & Hopfinger. All results are presented in a non-dimensional form to allow the comparison to data from the literature. Furthermore, the upscaling of the current results enables the prediction for future cryogenic upper stages such as the ESC-B for the European space launcher Ariane 5.

Download or read book Behavior of Liquid vapor Interface of Cryogenic Liquids During Weightlessness written by Clifford E. Siegert and published by . This book was released on 1965 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1993 with total page 528 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Bibliography of Lewis Research Center Technical Publications Announced in 1986 written by and published by . This book was released on 1987 with total page 360 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Experimental Techniques for Low Temperature Measurements written by Jack Ekin and published by Oxford University Press. This book was released on 2006-10-12 with total page 704 pages. Available in PDF, EPUB and Kindle. Book excerpt: Publisher description

Download or read book Fundamentals of Fluid Film Lubrication written by Bernard J. Hamrock and published by CRC Press. This book was released on 2004-03-15 with total page 794 pages. Available in PDF, EPUB and Kindle. Book excerpt: Specifically focusing on fluid film, hydrodynamic, and elastohydrodynamic lubrication, this edition studies the most important principles of fluid film lubrication for the correct design of bearings, gears, and rolling operations, and for the prevention of friction and wear in engineering designs. It explains various theories, procedures, and equations for improved solutions to machining challenges. Providing more than 1120 display equations and an introductory section in each chapter, Fundamentals of Fluid Film Lubrication, Second Edition facilitates the analysis of any machine element that uses fluid film lubrication and strengthens understanding of critical design concepts.

Download or read book Springer Handbook of Experimental Fluid Mechanics written by Cameron Tropea and published by Springer Science & Business Media. This book was released on 2007-10-09 with total page 1570 pages. Available in PDF, EPUB and Kindle. Book excerpt: Accompanying DVD-ROM contains ... "all chapters of the Springer Handbook."--Page 3 of cover.

Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1972 with total page 232 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Capillary transport processes in porous materials experiment and model written by Nicolas Fries and published by Cuvillier Verlag. This book was released on 2010-09-29 with total page 190 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book International Aerospace Abstracts written by and published by . This book was released on 1999 with total page 934 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Liquid Acquisition Devices for Advanced In Space Cryogenic Propulsion Systems written by Jason William Hartwig and published by Academic Press. This book was released on 2015-11-21 with total page 489 pages. Available in PDF, EPUB and Kindle. Book excerpt: Liquid Acquisition Devices for Advanced In-Space Cryogenic Propulsion Systems discusses the importance of reliable cryogenic systems, a pivotal part of everything from engine propulsion to fuel deposits. As some of the most efficient systems involve advanced cryogenic fluid management systems that present challenging issues, the book tackles issues such as the difficulty in obtaining data, the lack of quality data and models, and the complexity in trying to model these systems. The book presents models and experimental data based on rare and hard-to-obtain cryogenic data. Through clear descriptions of practical data and models, readers will explore the development of robust and flexible liquid acquisition devices (LAD) through component-level and full-scale ground experiments, as well as analytical tools. This book presents new and rare experimental data, as well as analytical models, in a fundamental area to the aerospace and space-flight communities. With this data, the reader can consider new and improved ways to design, analyze, and build expensive flight systems. - Presents a definitive reference for design ideas, analysis tools, and performance data on cryogenic liquid acquisition devices - Provides historical perspectives to present fundamental design models and performance data, which are applied to two practical examples throughout the book - Describes a series of models to optimize liquid acquisition device performance, which are confirmed through a variety of parametric component level tests - Includes video clips of experiments on a companion website

Download or read book Modeling in Transport Phenomena written by Ismail Tosun and published by Elsevier. This book was released on 2007-07-17 with total page 629 pages. Available in PDF, EPUB and Kindle. Book excerpt: Modeling in Transport Phenomena, Second Edition presents and clearly explains with example problems the basic concepts and their applications to fluid flow, heat transfer, mass transfer, chemical reaction engineering and thermodynamics. A balanced approach is presented between analysis and synthesis, students will understand how to use the solution in engineering analysis. Systematic derivations of the equations and the physical significance of each term are given in detail, for students to easily understand and follow up the material.There is a strong incentive in science and engineering to understand why a phenomenon behaves the way it does. For this purpose, a complicated real-life problem is transformed into a mathematically tractable problem while preserving the essential features of it. Such a process, known as mathematical modeling, requires understanding of the basic concepts. This book teaches students these basic concepts and shows the similarities between them. Answers to all problems are provided allowing students to check their solutions. Emphasis is on how to get the model equation representing a physical phenomenon and not on exploiting various numerical techniques to solve mathematical equations. - A balanced approach is presented between analysis and synthesis, students will understand how to use the solution in engineering analysis. - Systematic derivations of the equations as well as the physical significance of each term are given in detail - Many more problems and examples are given than in the first edition - answers provided

Download or read book Fundamentals of Stack Gas Dispersion written by Milton R. Beychok and published by Milton R Beychok. This book was released on 1994 with total page 193 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is the new, fourth edition of the book on dispersion modeling of continuous, buoyant air pollution plumes which takes nothing for granted. Every equation is completely derived step-by-step without any complicated or advanced mathematics. Every constraint and assumption is fully explained. A set of self-study exercises is also included with the book.The subjects covered in the book include atmospheric turbulence and stability classes, buoyant plume rise, Gaussian dispersion calculations and modeling, time-averaged concentrations, wind velocity profiles, fumigations, trapped plumes, flare stack plumes and much more ... with a great many example calculations. Copies of the book have been purchased in the U.S.A., Canada, Mexico, South America, Europe, Australia, Africa and Asia (in a total of 57 countries), and are available in over 130 libraries worldwide. The book has been very widely referenced and cited in the technical literature and on the Internet.

Download or read book Generation and Applications of Extra Terrestrial Environments on Earth written by Daniel A. Beysens and published by CRC Press. This book was released on 2022-09-01 with total page 317 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book has been prepared under the auspice of the European Low Gravity Research Association (ELGRA). The main task of ELGRA is to foster the scientific community in Europe and beyond in conducting gravity and space-related research.This publication is dedicated to the science community, and especially to the next generation of scientists and engineers interested in space research and in the means to use Earth to reproduce the space environment. ELGRA provides a comprehensive description of space conditions and the means that have been developed on Earth to perform space environmental and (micro-) gravity related research. .The book covers ground-based research instruments and environments for both life and physical sciences research. It discusses the opportunities and limitations of protocols and instruments to compensate gravity or simulate microgravity, such as clinostats, random positioning machines, levitating magnets, electric fields, vibrations, tail suspension or head down tilt, as well as centrifuges for hyper-g studies. Other space environmental conditions are addressed too, like cosmic radiation or Mars atmospheric and soil properties to be replicated and simulated on Earth. Future long duration of manned missions, personal well-being and crew interaction are major issues dealt with.