Download or read book Avoidance and Detection of Internal Corrosion of Gas Cylinders written by British Compressed Gases Association and published by . This book was released on 2010 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Avoidance and Detection of Internal Corrosion of Gas Cylinders written by and published by . This book was released on 2021 with total page 12 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Methods to Avoid and Detect Internal Gas Cylinder Corrosion written by Compressed Gas Association and published by . This book was released on 2008 with total page 6 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Pressure Systems Casebook written by John Wintle and published by John Wiley & Sons. This book was released on 2004-07-02 with total page 170 pages. Available in PDF, EPUB and Kindle. Book excerpt: Pressure Systems Casebook contains a collection of papers drawn from two IMechE seminars that will be of particular interest to students and engineers who want to broaden their knowledge and learn from experience and history. The authors' backgrounds cover a range of perspectives, from representing industrial users of pressure systems to regulators, research, and engineering consultants. Complete contents: Lessons from failures of gas cylinders used for dispensing beverages Experience from Health and Safety laboratory investigations Insurance aspects of pressure systems failures Failure investigation for commercial purposes - system failures leading to the collapse of storage vessels under partial vacuum Reliable technical failure investigation Failure design procedures in the new European Pressure Vessel Standard EN 13445 Causes of vibration fatigue in process pipework - a new methodology to assess the risk Avoiding vibration-induced fatigue failures in process pipework Lessons learned from pressure system failures Pressure systems contain stored energy and the threat of damaging failure is ever present. Failures of pressure systems still occur and are costly to those affected; yet the main causes, consequences, and methods of investigation are not widely known. Pre-existing defects are a major cause of failures and near-failures in pressure systems, yet many can be avoided by greater awareness of the circumstances in which they arise.
Download or read book Lees Loss Prevention in the Process Industries written by Frank Lees and published by Butterworth-Heinemann. This book was released on 2012-11-05 with total page 3685 pages. Available in PDF, EPUB and Kindle. Book excerpt: Safety in the process industries is critical for those who work with chemicals and hazardous substances or processes. The field of loss prevention is, and continues to be, of supreme importance to countless companies, municipalities and governments around the world, and Lees' is a detailed reference to defending against hazards. Recognized as the standard work for chemical and process engineering safety professionals, it provides the most complete collection of information on the theory, practice, design elements, equipment, regulations and laws covering the field of process safety. An entire library of alternative books (and cross-referencing systems) would be needed to replace or improve upon it, but everything of importance to safety professionals, engineers and managers can be found in this all-encompassing three volume reference instead. - The process safety encyclopedia, trusted worldwide for over 30 years - Now available in print and online, to aid searchability and portability - Over 3,600 print pages cover the full scope of process safety and loss prevention, compiling theory, practice, standards, legislation, case studies and lessons learned in one resource as opposed to multiple sources
Download or read book Periodic Inspection of Compressed Gas Cylinders and Transport Vessels by Using Acoustic Emission Testing written by HM. Barthélémy and published by . This book was released on 1991 with total page 14 pages. Available in PDF, EPUB and Kindle. Book excerpt: Gas cylinders and large transport vessels used for industrial compressed gases are subjected to hydrostatic retests. In this paper are presented results of an investigation concerning how to apply acoustic emission tests during such periodic inspections to detect flaws, i.e. internal corrosion and cracks. In conclusion a method for the periodic inspection (hydrostatic test with an acoustic emission testing) of such vessels is proposed. This method allows safe extension of the interval between re-tests.
Download or read book Combating the Silent Threat written by Jacks and published by Tredition Gmbh. This book was released on 2024-06-22 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Combating the Silent Threat: Internal Corrosion Control in Oil & Gas Pipelines delves into the unseen enemy that plagues the oil and gas industry: internal corrosion of pipelines. This insidious process weakens pipelines from the inside out, posing a significant threat to safety, the environment, and operational efficiency. The book equips you with the knowledge to combat this silent threat. You'll gain a comprehensive understanding of the different types of internal corrosion, the factors that contribute to their development, and the most effective strategies for prevention and mitigation. Combating the Silent Threat explores various non-destructive testing (NDT) techniques to identify corrosion early before it leads to catastrophic failures. Additionally, the book provides insights into industry standards and regulations for pipeline integrity management. Whether you're a pipeline engineer, inspector, or technician, this book is a critical resource for safeguarding the integrity of oil and gas pipelines.
Download or read book Corrosion of Gas Cylinders for Beverage Gas Use written by J. Joel and published by . This book was released on 2006 with total page 97 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Gas Cylinders Gases and Gas Mixtures Determination of Oxidizing Ability of Toxic and Corrosive Gases and Gas Mixtures written by British Standards Institute Staff and published by . This book was released on 2006-07 with total page 16 pages. Available in PDF, EPUB and Kindle. Book excerpt: Gas cylinders, Pressure vessels, Gases, Gas mixtures, Gas technology, Toxic gases, Toxic materials, Corrosive materials, Oxidation-resistance tests, Mathematical calculations, Flammability
Download or read book On Corrosion of High pressure Steel Gas Cylinders written by M. Fromberg and published by . This book was released on 1983 with total page 17 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book MONITORING TECHNOLOGY FOR EARLY DETECTION OF INTERNAL CORROSION FOR PIPELINE INTEGRITY written by Glenn M. Light and published by . This book was released on 2003 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt: Transmission gas pipelines are an important part of energy-transportation infrastructure vital to the national economy. The prevention of failures and continued safe operation of these pipelines are therefore of national interest. These lines, mostly buried, are protected and maintained by protective coating and cathodic protection systems, supplemented by periodic inspection equipped with sensors for inspection. The primary method for inspection is ''smart pigging'' with an internal inspection device that traverses the pipeline. However, some transmission lines are however not suitable for ''pigging'' operation. Because inspection of these ''unpiggable'' lines requires excavation, it is cost-prohibitive, and the development of a methodology for cost-effectively assessing the structural integrity of ''unpiggable'' lines is needed. This report describes the laboratory and field evaluation of a technology called ''magnetostrictive sensor (MsS)'' for monitoring and early detection of internal corrosion in known susceptible sections of transmission pipelines. With the MsS technology, developed by Southwest Research Institute{reg_sign} (SwRI{reg_sign}), a pulse of a relatively low frequency (typically under 100-kHz) mechanical wave (called guided wave) is launched along the pipeline and signals reflected from defects or welds are detected at the launch location in the pulse-echo mode. This technology can quickly examine a long length of piping for defects, such as corrosion wastage and cracking in circumferential direction, from a single test location, and has been in commercial use for inspection of above-ground piping in refineries and chemical plants. The MsS technology is operated primarily in torsional guided waves using a probe consisting of a thin ferromagnetic strip (typically nickel) bonded to a pipe and a number of coil-turns (typically twenty or so turns) wound over the strip. The MsS probe is relatively inexpensive compared to other guided wave approaches, and can be permanently mounted and buried on a pipe at a modest cost to allow long-term periodic data collection and comparison for accurate tracking of condition changes for cost-effective assessment of the integrity of the susceptible sections of pipeline. The results of work conducted in this project, with the collaboration from Clock Spring{reg_sign} and cooperation with El Paso Corporation, showed that the MsS probe indeed can be permanently installed on a pipe and buried for long-term monitoring of pipe condition changes. It was found however that the application of the MsS to monitoring of bitumen-coated pipelines is presently limited because of very high wave attenuation caused by the bitumen-coating and surrounding soil and resulting loss in defect detection sensitivity and reduction in monitoring range. Based on these results, it is recommended that the MsS monitoring methodology be used in benign, relatively low-attenuation sections of pipelines (for example, sleeved sections of pipeline frequently found at road crossings and pipelines with fusion epoxy coating). For bitumen-coated pipeline applications, the MsS methodology needs to increase its power to overcome the high wave attenuation problem and to achieve reasonable inspection and monitoring capability.
Download or read book Gas Cylinders written by International Organization for Standardization and published by . This book was released on 2005 with total page 7 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scuba Cylinder Internal Corrosion written by Richard Emile Peyser and published by . This book was released on 1970 with total page 156 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Handbook of Compressed Gases written by Compressed Gas Association and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 664 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the field of compressed gases and related equipment, there is an expanding core of essential knowledge that people handling and using these materials should be familiar with or should know where to find when necessary. The focus of this book concerns the properties and the accepted means of trans portation, storage, and handling of compressed gases. This Handbook is simul taneously intended as an overview of the subject and a source of supplementary information. It is also intended to serve as a guide to pertinent federal regulatory requirements and published standards of the Compressed Gas Association and other standards-writing bodies. Readers are advised that the CGA technical pamphlets remain the official state ment of policy by the Association on a particular matter. Reference is made throughout this text to the numerous technical pamphlets published by the Com pressed Gas Association. Some of these publications have been incorporated by reference into federal, state, provincial, and local regulations. Since these pam phlets are reviewed on a periodic basis, wherever the text of this Handbook may be found in conflict with corresponding information in the CGA technical pam phlets, the latter shall take precedence.
Download or read book Field Guide to Internal Corrosion Mitigation and Monitoring for Pipelines written by Richard B. Eckert and published by . This book was released on 2016 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is intended to help oil and gas pipeline operators, corrosion professionals, integrity experts and risk management practitioners assess, control, and manage the effects of internal corrosion on pipeline systems, thus improving the safety, reliability and integrity of their operations. While the focus of this book is on pipelines, the content is broadly applicable to upstream equipment, processing facilities, mid-stream pipelines, liquid and gas storage assets, and delivery/distribution assets. Another intention of this book is to not only provide technical information about internal corrosion control, but also to provide suggestions and potential strategies for applying this information. The fundamental process of managing internal corrosion consists of threat assessment, mitigation selection and implementation, and monitoring the effectiveness of mitigation. This book is divided into these three main sections to help emphasize the point that corrosion management is a process, not a one-time event.
Download or read book Underground Pipeline Corrosion written by Mark Orazem and published by Elsevier. This book was released on 2014-02-17 with total page 343 pages. Available in PDF, EPUB and Kindle. Book excerpt: Underground pipelines transporting liquid petroleum products and natural gas are critical components of civil infrastructure, making corrosion prevention an essential part of asset-protection strategy. Underground Pipeline Corrosion provides a basic understanding of the problems associated with corrosion detection and mitigation, and of the state of the art in corrosion prevention. The topics covered in part one include: basic principles for corrosion in underground pipelines, AC-induced corrosion of underground pipelines, significance of corrosion in onshore oil and gas pipelines, numerical simulations for cathodic protection of pipelines, and use of corrosion inhibitors in managing corrosion in underground pipelines. The methods described in part two for detecting corrosion in underground pipelines include: magnetic flux leakage, close interval potential surveys (CIS/CIPS), Pearson surveys, in-line inspection, and use of both electrochemical and optical probes. While the emphasis is on pipelines transporting fossil fuels, the concepts apply as well to metallic pipes for delivery of water and other liquids. Underground Pipeline Corrosion is a comprehensive resource for corrosion, materials, chemical, petroleum, and civil engineers constructing or managing both onshore and offshore pipeline assets; professionals in steel and coating companies; and academic researchers and professors with an interest in corrosion and pipeline engineering. - Reviews the causes and considers the detection and prevention of corrosion to underground pipes - Addresses a lack of current, readily available information on the subject - Case studies demonstrate how corrosion is managed in the underground pipeline industry
